• Korean Chemical Engineering Research
• /
• v.53 no.2
• /
• pp.150-155
• /
• 2015

Recently, LNG receiving terminals have been widely constructed and expanded for an increase in LNG demand. Selection of the storage tank for send-out and estimation of send-out flow rate have significant influence to process operation and economics. In this study, a send-out flow rate of each storage tank is optimized in order to minimize the total BOG generation rate. Considering a size and characteristic of each storage tanks, BOG flow rates are estimated using a dynamic simulation with varying liquid levels in the tanks. The regression model is developed fitting BOG flow rates and tank liquid levels, which are boil off rate model to predict BOG flow rates with particular level data. The objective function and constraints including required total send-out flow rate and level limit in the tanks are formulated to optimize a send-out flow rate of each tank. This method for optimization of send-out operation is applied to the Incheon LNG receiving terminal considering two scenarios for various liquid levels and maximum and minimum required send-out flow rates. For maximum required send-out flow rate, this method achieves BOG reduction of 9% comparing with assumed conventional operation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.12B
• /
• pp.1183-1191
• /
• 2010

In this paper, I propose an adaptive OFDM CP length algorithm for in PLC systems for smart grid. The proposed scheme calculates the channel delay information at the CP controller of the receiver by taking correlation between a received data frame and the following delayed one. The CP controller, immediately, feeds back the channel delay information to the transmitter. Then, the transmitter adapts CP length for next data frame. As an impulsive noise model, Middleton Class A interference model was employed. The performance is evaluated in terms of packet data rate, cumulative packet data rate, and bit error rate (BER). The simulation results showed data gain (which is the amount of the reduced bits) gets larger as the number of packets increase, but the amount of data gain reduced as the number of branches ($N_{br}$) increase. In respects of BER for the cases $N_{br}$ is 3, 4, and 5, performance of the adaptive CP length algorithm and the fixed CP scheme are similar. Therefore, it is confirmed the proposed scheme achieved data rate increment without BER performance reduction compared to the conventional fixed CP length scheme.

• Journal of Veterinary Clinics
• /
• v.30 no.3
• /
• pp.159-165
• /
• 2013

The present study was conducted to evaluate the efficacy of Cinnamomum cassia Blume (CC) extract on the repair of damaged cartilage in a rat model of osteoarthritis (OA) by anterior cruciate ligament transection (ACLT) and medial meniscus resection (MMx). Forty-eight rats were assigned to six groups (n = 8 per group): sham as negative control (NC), positive control (PC), diclofenac sodium (DS, 2 mg/kg), CC 25 mg/kg, CC 50 mg/kg and CC 100 mg/kg groups. Treatments were 12 weeks from 7 days after ACLT + MMx. Loss of cartilage and joint instability were significantly reduced in response to treatment with CC or DS compared to the PC (p < 0.05). CC significantly ameliorated cartilage degradation in a dose-dependent manner as assessed by histological findings (p < 0.01). A reduction in the severity of structural changes and a dose-dependent increase in Safranin-O staining intensity were observed in CC treatments, indicating that cartilage degradation was inhibited. Although DS did not affect the increase in active caspase-3 and cleaved poly(ADP-ribose) polymerase-induced apoptosis during the progression of OA, cells reactive to these apoptotic markers were decreased significantly by CC (p < 0.05). However, treatments with CC or DS did not influence the uptake of 5-bromo-2'-deoxyuridine. The findings suggest that CC can exert a chondroprotective action on OA through anti-inflammatory and anti-apoptotic properties.

• Journal of Korean Society on Water Environment
• /
• v.24 no.4
• /
• pp.473-479
• /
• 2008

Environment problem has been arising in many countries. Especially, soil erosion has been deemed as one of the biggest issues because sediment causes muddy water and pollutants, such as agricultural chemicals, flow in the stream with this sediment. Many studies, regarding soil loss and non-point source pollution from watershed, has been performed while serious problem has been known. Soil loss occurred in most agricultural area by rainfall and runoff. It makes hydraulic structure unstable, causes environmental economical problems because muddy water destroys ecosystem and causes intake water deterioration. As revealing serious effects of muddy water by sediment, many researches have been doing with various methods. Hydraulic structures establishments such as soil erosion control dams and grit chamber are common. Vegetative filter strip is investigated in this study because vegetative filter strip is designed for reducing sediment from upland areas of the watershed, and it has many functions, not only sediment reduction but also runoff water quality improvement and wildlife habitat. With these positive functions of the vegetative filter strip, the study about vegetative filter strip has been increasing for reducing sediment because it is more effective than hydraulic structures from an environmental perspective. But the sediment trapping efficiency by vegetative filter strip, needs to be investigated and designed first. Therefore the model, VFSMOD-W, was used in this study as it can estimate sediment trapping efficiency of vegetative filter strip under various field, vegetation, weather condition. Sensitive factors to sediment trapping efficiency are studied with VFSMOD-W, and sediment trapping efficiency equation has been derived using two most sensitive factors. It is thought that the equation suggested in this study can be used in Soil and Water Assessment Tool (SWAT), to overcome the limit of SWAT filter strip module, which is based solely on filter strip width.

• Journal of Korea Water Resources Association
• /
• v.38 no.4 s.153
• /
• pp.271-280
• /
• 2005

The goal of this study is to recommend a new type of stage-discharge rating curve ($Q=p(h-e)^{\beta}-{\gamma}$) useful for satisfying divergence, and one other seemingly irresolvable problem related to exited rating curves, while also extending this rating curve model. The problem of divergence is that during the finding of the CZF (cease-to-zero flow) parameter e and while minimizing the sum of total errors of the estimated curve, the exponential parameter ${\beta}$ become an abnormally large value. The insoluble problem is that when the value e is greater then the recorded minimum at the gauged stage, it is impossible to have a negative logarithm value (h-e). The two problems above can be satisfied by adapting the control value ${\gamma}$, which affects the reduction of ${\gamma}$ and gives us the possibility of controlling (h-e) over zero. The study results show that the effects of parameter ${\gamma}$ are very similar to that of e when conducting physical and sensitivity analyses. This system can be used towards developing a new stage-discharge rating curve for river discharge, for use in evaluating the acceptability of existing stage-discharge rating curves generated by using hydrologic analyses at all stations.

• Journal of Korea Water Resources Association
• /
• v.48 no.5
• /
• pp.409-423
• /
• 2015

In this study the very short-term rainfall forecasting and storm water forecasting using the weather radar data were implemented in an urban stream basin. As forecasting time increasing, the very short-term rainfall forecasting results show that the correlation coefficient was decreased and the root mean square error was increased and then the forecasting model accuracy was decreased. However, as a result of the correlation coefficient up to 60-minute forecasting time is maintained 0.5 or higher was obtained. As a result of storm water forecasting in an urban area, the reduction in peak flow and outflow volume with increasing forecasting time occurs, the peak time was analyzed that relatively matched. In the application of storm water forecasting by radar rainfall forecast, the errors has occurred that we determined some of the external factors. In the future, we believed to be necessary to perform that the continuous algorithm improvement such as simulation of rapid generation and disappearance phenomenon by precipitation echo, the improvement of extreme rainfall forecasting in urban areas, and the rainfall-runoff model parameter optimizations. The results of this study, not only urban stream basin, but also we obtained the observed data, and expand the real-time flood alarm system over the ungaged basins. In addition, it is possible to take advantage of development of as multi-sensor based very short-term rainfall forecasting technology.

• Journal of Korean Society for Geospatial Information Science
• /
• v.23 no.3
• /
• pp.23-29
• /
• 2015

Due to the characteristics of landslide disasters including debris flow, the rapid speed to downward and difficulty to respond or evacuate from them, it is imperative to identify their potential hazards and prepare the reduction plans. However, the current landslide hazards generated by a variety of methods has been raised its accuracy because of the complexity of input data and their analyses, and the simplification of the landslide model. The main objective of this study is, therefore, to evaluate the preliminary landslide hazard based on the identification of geomorphological features. Especially, two methodologies based on the statistics of the directional data, Vector dispersion and Planarity analyses, are used to find some relationships between geomorphological characteristics and the landslide hazard. Results show that both methods well discriminate geomorphological features between stable and unstable domains in the landslide areas. Geomorphological features are closely related to the landslide hazard and it is imperative to maximize their characteristics by adapting multiple models rather than individual model only. In conclusions, the mechanism of landslide is not determined solely by a simple cause but the complex natural phenomenon caused by the interactions of the numerous factors and it is of primary importance to require additional researches for the outbreaking mechanism that are based on various methodologies.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.16 no.2
• /
• pp.88-96
• /
• 1983

The effect of lowering water activity of various humectants has been reported in the previous papers. In this study, that effect of humectants used in combination with each other was discussed. Additionally, the Aw measurements were also compared to the predicted values of Aw derived from the equation of Raoult's law and the linear slope method by Sloan and Labuza. Each mixed humectant was thought to be salted-out by the other, and thus Aw values were observed to be somewhat lower as the result in all model preparations. The effect of lowering water activity by NaCl was the highest, and the efficiency of reduction of Aw was decreased in the order of NaCl, sodium lactate, glycerin, propylene glycol and sorbitol when each of them was combinated with other humectants. Aw values calculated by the equation of Raoult's law were not agreed so well to the measured Aw, so it was likely not to be the useful method for predicting Aw values in mixed humectants to far as they have showed higher ability for lowering Aw in the previous papers. The equations of prediction were derived from Aw values to be measured actually in the model Kamaboko.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.7 no.3
• /
• pp.196-208
• /
• 2007

An analytical model is proposed for an optically controlled Metal Semiconductor Field Effect Transistor (MESFET), known as Optical Field Effect Transistor (OPFET) considering the diffusion fabrication process. The electrical parameters such as threshold voltage, drain-source current, gate capacitances and switching response have been determined for the dark and various illuminated conditions. The Photovoltaic effect due to photogenerated carriers under illumination is shown to modulate the channel cross-section, which in turn significantly changes the threshold voltage, drainsource current, the gate capacitances and the device switching speed. The threshold voltage $V_T$ is reduced under optical illumination condition, which leads the device to change the device property from enhancement mode to depletion mode depending on photon impurity flux density. The resulting I-V characteristics show that the drain-source current IDS for different gate-source voltage $V_{gs}$ is significantly increased with optical illumination for photon flux densities of ${\Phi}=10^{15}\;and\;10^{17}/cm^2s$ compared to the dark condition. Further more, the drain-source current as a function of drain-source voltage $V_{DS}$ is evaluated to find the I-V characteristics for various pinch-off voltages $V_P$ for optimization of impurity flux density $Q_{Diff}$ by diffusion process. The resulting I-V characteristics also show that the diffusion process introduces less process-induced damage compared to ion implantation, which suffers from current reduction due to a large number of defects introduced by the ion implantation process. Further the results show significant increase in gate-source capacitance $C_{gs}$ and gate-drain capacitance $C_{gd}$ for optical illuminations, where the photo-induced voltage has a significant role on gate capacitances. The switching time ${\tau}$ of the OPFET device is computed for dark and illumination conditions. The switching time ${\tau}$ is greatly reduced by optical illumination and is also a function of device active layer thickness and corresponding impurity flux density $Q_{Diff}$. Thus it is shown that the diffusion process shows great potential for improvement of optoelectronic devices in quantum efficiency and other performance areas.

• Journal of the Korean Ceramic Society
• /
• v.37 no.3
• /
• pp.256-262
• /
• 2000

The dielectric properties of complex perovskite ($Pb_{1-x}Ca_{x}$)($Fe_{0.5}Ta_{0.5}$)$O_{3}$ with >($0.5{\le}x{\ge}0.65$ were investigated at microwave frequencies. Dilectric constant decreased with increasing Ca content, and was directly proportional to the cube of average ionic ra야 of A-site. For the specimen of x=0.6 sintered at $1250^{\circ}C$ for 3 h in air, dielectric constant (k) of 63, QF of 11000 GHz, and the temperature coefficient of resonant frequency(TCF) of -14ppm/$^{\circ}C$ were obtained. As Ca content increased, TCF of the specimen negatively increased due to the reduction of the tolerance factor(t). Changes in intrinsic loss with varying Ca content was investigated by the infrared reflectivity spectra ranging 50 to 4000 $cm^{-1}$, which were calculated by the Kramers-Kronig analysis and classical oscillator model. The relative tendency of microwave dielectric properties of the ($Pb_{1-x}Ca_{x}$)($Fe_{0.5}Ta_{0.5}$)$O_{3}$ specimens calculated from the reflectivity data were in good agreement with the results by the post resonant method.