• Proceedings of the KIEE Conference
• /
• 1996.11a
• /
• pp.99-102
• /
• 1996

In general, real power system is not stopped for reason of its test. And then we have no way to verify its reliability on real power system. In this paper we present the real time simulation technique of the APRS(Automatic Power Reconfiguration System) before it is applied in real power system. We used the Real Time Digital Simulator constructed in KEPRL And we applied the power system model which is reduced because of RTDS capacity. Also, We prescent the method Interface between target system(APRS) and RTDS. Last, We provide the test results and the meaning.

• Journal of the Chungcheong Mathematical Society
• /
• v.15 no.1
• /
• pp.25-33
• /
• 2002

We prove the generalized Hyers-Ulam-Rassias stability of linear operators in a Hilbert module over a unital $C^*$-algebra.

• Proceedings of the KIEE Conference
• /
• 1997.07c
• /
• pp.851-853
• /
• 1997

This paper presents an algorithm for real-time restoration of radially operated 154kV loop system. Restoration procedure consists of 4 procedures; recognition of faults, identification of fault locations, seperation of fault locations and restoration of blackout areas. This algorithm adopts expert's knowledge for safe and accurate operation of the real-time restoration system (APRS: Automatic Power Reconfiguration System).

• Proceedings of the KIEE Conference
• /
• 1998.07c
• /
• pp.880-883
• /
• 1998

In this paper, sensitivity based approach to estimate BITC(bilateral interchange transfer capacity) considering the real power flow control function of FACTS device is presented. The real power flow setting of the FACTS device is adjusted so that it transfer the power flow from the first violation point of transmission capacity to other transmission lines in the power system, thus allowing more power to be transferred from the specified generator bus to the specified load bus. The transfer between the two bus locations is increased from this new operating condition until a violation of transmission capacity limits occurs or until the setting of the FACTS device can no longer be adjusted. The proposed algorithm is illustrated using examples of small and real life power system.

• Proceedings of the KIEE Conference
• /
• 2001.05a
• /
• pp.49-51
• /
• 2001

Recently, according to a rapid increase of the power demand, the KEPCO's 154kV lines are continuously expanded and become to the more complex loop system. As a result of increase of the fault capacity and the unbalance of power load flow, the circuit breaker have been exceeding the capacity limit of those in the loop power system. To solve this problem, APRS application will be necessary more and more.

• Proceedings of the KIEE Conference
• /
• 2004.11b
• /
• pp.72-74
• /
• 2004

Nowadays there are many kinds of large scale loads and they make the power quality deteriorated. As the uses of nonlinear loads increase, there are the influences on the other kinds of loads (mainly light loads) in the same distribution system. Especially the voltage variation by the loads which draw the large and instantaneous currents can cause the appreciable light flicker. This is called the voltage flicker or, briefly, the flicker. This paper deals with the digital and time domain algorithm of measuring flicker based on IEC 61000-4-15 and the real time measurement of flicker through the proposed power quality monitoring system.

• KIEE International Transactions on Power Engineering
• /
• v.11A no.4
• /
• pp.33-38
• /
• 2001

The KEPS(KEPCO＇s Enhanced Power system Simulator) Real Time Digital Simulator(RTDS) is the largest real time power system simulator ever built. A power system which includes 320 (3-phase) buses and 90 generators has been modeled and run in real time. Since such large-scale systems were involved, it was not practical to validate them using non-real time electro-magnetic transient programs such as EMTDC™ or EMTP. Instead, the results of the real time electromagnetic transient simulation were validated by comparing to transient stability simulations run using PTI's PSS/E™ program. The comparison of results from the two programs is very good in almost all cases. However, as expected, some differences did exist and were investigated. The differences in the results were primarily traced to the fact that the electromagnetic transient solution algorithm provides more detail solutions and therefore greater accuracy than the transient stability algorithm. After finding very good comparison of results between RTDS Simulator and PSS/E, and after investigating the discrepancies found, KEPCO gained the necessary confidence to use the large-scale real time simulator to analyze and develop their power system.

• Proceedings of the KIEE Conference
• /
• 2005.07a
• /
• pp.319-322
• /
• 2005

This paper describes practical tuning methods and testing of a digital PSS, which uses both frequency and power, with the 220MVA Chungpyung P/P #1 in the KEPCO system to enhance the damping of local modes. In the first step, the objective phase of PSS is computed through a phase leading function to provide compensation between the exciter reference point and the generator air-gap torque before tuning the PSS's time constants. In addition, eigenvalue analysis was used to determine a range of PSS's gain, whichis the more useful for field testing rather than a single gain value. The Real-Time Digital Simulator was used to verify safe operations of the PSS in the presence of disturbances, such as AVR step and three phase fault.

• Proceedings of the KIEE Conference
• /
• 1999.07b
• /
• pp.942-944
• /
• 1999

This paper presents a genetic learning algorithm with partial update technique in application to active control system. Proposed algorithm divides active control system into two parts, real time control part and control parameter update part. This genetic algorithm has global convergent advantage and is expected to be applied easily to real time active noise and vibration control systems. Computer simulation was performed.

• Proceedings of the KIEE Conference
• /
• 2001.07a
• /
• pp.101-105
• /
• 2001

본 논문에서는 한전 전력연구원에서 개발한 전력계통 해석용 시뮬레이터(이하 KEPS)를 이용하여 대규모 전력계통을 실시간으로 해석하는 방법 및 그 결과를 제시하고자 한다. KEPS는 캐나다 RTI사에서 개발한 RTDS(Real-Time Digital Simulator)를 근간으로 하는 대규모 디지털 실시간 시뮬레이터로써 총 26랙으로 구성되어 있으며 대규모 전력계통을 $50{\mu}sec{\sim}70{\mu}sec$의 타임스텝으로 계산할 수 있는 전력계통 전자기 과도현상 모의해석 장치이다. 본 논문에서는 KEPS를 이용하여 한전의 2000년 계통을 실시간으로 해석하고, 전력계통 안정화장치 (PSS), 계전기등 외부기기를 실시간으로 해석, 검증한 결과를 소개하기로 한다.