• Journal of Korean Society for Atmospheric Environment
• /
• v.29 no.1
• /
• pp.56-63
• /
• 2013

This study was aimed at developing and evaluating a diffusive sampling method using a barium hydroxide solution as an absorbent for measuring carbon dioxide ($CO_2$) in ambient air. The collected $CO_2$ concentration was calculated by the change of conductivity resulted in the reaction of $CO_3{^{2-}}$ and $Ba^{2+}$ in aqueous solution. The sampling rate for the diffusive sampler was determined 0.218 mL/min, as obtained from the slope of the linear correlation between the $CO_2$ mass collected by the diffusive sampler and the time-weighted $CO_2$ concentration with the active sampling method. The unexposed blank sampler sealed in aluminium foil-polyethylene laminated packets has remained stable during at least one-month storage period. A good correlation was observed between the diffusive sampler and active sampler with a coefficient of determination of 0.956. This diffusive sampler would be suitable for the indoor $CO_2$ concentration monitoring.

• Journal of Microbiology and Biotechnology
• /
• v.22 no.11
• /
• pp.1575-1579
• /
• 2012

Paenibacillus polymyxa is known to be a plant-growth-promoting rhizobacterium. The present study describes a quantitative polymerase chain reaction (qPCR) assay for the specific detection and quantitation of P. polymyxa using a primer pair based on the sequence of a membrane-fusion protein for the amplification of a 268 bp DNA fragment. This study reports that the qPCR-based method is applicable for the rapid and sensitive detection of P. polymyxa and can be used as an alternative method for agricultural soil monitoring.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2001.04a
• /
• pp.540-544
• /
• 2001

This paper addresses a hybrid control architecture for the hospital service robot, SmartHelper. In hybrid architecture, the deliberation takes place at planning layer while the reaction is dealt through the parallel execution of operations. Hence, the system presents both a hierarchical and an heterarchical decomposition, being able to show a predictable response while keeping rapid reactivity to the dynamic environment. The deliberative controller accomplishes four functions which are path generation, selection of navigation way, command and monitoring. The reactive controller uses fuzzy and potential field method for robot navigation. Through simulation under a virtual environment IGRIP, the effectiveness of the hybrid architecture is verified.

• Asian-Australasian Journal of Animal Sciences
• /
• v.1 no.2
• /
• pp.99-106
• /
• 1988

A high performance liquid chromatographic procedure is described for the direct determination of the picomole amount of palmitoyl-Coenzyme A and stearoyl-Coenzyme A, using a stainless steel column packed with C-18 derivatized porous silica ($5{\mu}m$), an isocratic elution with a mixture of 33 mM $KH_2PO_4$/acetonitrile as a mobile phase and a UV detector. The long-chain acyl-Coenzyme A esters were determined in incubated microsomal fractions of a bovine liver to demonstrate the utility of this method for monitoring acyl-CoA synthesis in biological samples. The reaction rate of palmitate was higher than that of stearate. After a 60 minute incubation period, the generated amount of palmitoyl-Coenzyme A and stearoyl-Coenzyme A were approximately 70 and 20 n mol/mg micresomal protein, respectively. The advantage of this method are in that no decomposition of the CoA esters is involved, while the constituent molecular species is detected.

• Journal of Korean Society for Atmospheric Environment
• /
• v.20 no.6
• /
• pp.793-801
• /
• 2004

A passive sampler has been developed for measuring formaldehyde in air using methyl yellow and methyl orange indicator. It is based on the color change of the TLC plate on reaction with formaldehyde. TLC plates impregnated with three kinds of solutions containing methyl orange, methyl yellow, mixing of methyl yellow and methyl orange were shown rectilinear response to formaldehyde concentration at constant exposure time. The color change of impregnated TLC plate with criteria air pollution, such as NO$_2$, SO$_2$, CO, $O_3$ was investigated. The color change of TLC plate with $O_3$ is larger than other gases.

• Journal of environmental and Sanitary engineering
• /
• v.9 no.2
• /
• pp.32-40
• /
• 1994

The concentration of ozone in 5 major cities in Korea( Seoul, Pusan, Taegu, Kwangjoo, Incheon ) has been shown increasing trend after 1984, while decreasing trend in Hsan. According to the data from 12 monitoring stations in 9 cities of metropolitan area from January 1994 to August 1994, ozone concentration exceeded short term standard 99 times and 87%(861imes) of those was occurred during July and Augusta while the maximum ozone concentration was appeared mainly between 14: 00 and 17: 00 daily. As the result of epidemiological survey, main substances which irritate eyes were identified to be PAN and formaldehyde rather than ozone while ozone was identified to be reachable to deep part of respiratory system main target organ of ozone.

• Korean Journal of Clinical Laboratory Science
• /
• v.43 no.3
• /
• pp.120-123
• /
• 2011

A total of 30 water samples were collected from 30 different public baths in Seoul, Korea. Contamination of public bath water by waterborne pathogens can cause disease outbreaks and contribute to increase background rates of disease. Pathogens in water was filtered by nitrocellulose membrane with $0.45{\mu}m$ pore size. The membrane filters were analyzed by both cultivation and polymerase chain reaction (PCR) amplification of partial 16S rRNA gene. Various microorganisms including 4 Escherichia coli/Shigella spp. 1 Salmonella spp. 3 Pseudomonas aeruginosa and 2 Mycobacterium spp. were identified by reverse blot hybridization assay (REBA). PCR-REBA was able to identify many bacterial genera in one assay. Our results suggest that appropriate hygiene practice and continuous monitoring is needed for reducing health risk associated with public bath houses.

• Journal of Sensor Science and Technology
• /
• v.26 no.4
• /
• pp.228-234
• /
• 2017

Gas sensors based on metal-oxide-semiconductors are predominantly used in numerous applications including monitoring indoor air quality and detecting harmful substances such as volatile organic compounds. Nanostructures, e.g., nanoparticles, nanotubes, nanodomes, or nanofibers, have been widely utilized to improve the gas sensing properties of metal-oxide-semiconductors by increasing the effective surface area participating in the surface reaction with target gas molecules. Recently, 1-dimensional (1D) metal oxide nanostructures fabricated using glancing angle deposition (GAD) method with e-beam evaporation have been widely employed to increase the surface-to-volume ratio significantly with large-area uniformity and reproducibility, leading to promising gas sensing properties. Herein, we provide a brief overview of 1D metal oxide nanostructures fabricated using GAD and their gas sensing properties in terms of fabrication methods, morphologies, and additives. Moreover, the gas sensing mechanisms and perspectives are presented.

• Proceedings of the KSR Conference
• /
• 2009.05a
• /
• pp.113-118
• /
• 2009

It is of utmost important that track loads at rail induced by running train was usually obtained for track performance evaluation. A reaction force of track was measured wheel loads and lateral force by strain gauges on the rail, and then it was obtained to derailment coefficient and variational ratio of wheel load from its relationship. In this study, a existing monitoring system methods with many manpower working were reviewed about measurements, process of testing, and how to obtain accurately measured data.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2018.10a
• /
• pp.161-162
• /
• 2018

In this paper, we consider the development the database configuration to the search and management of the object information from GPS sensor and video sensor. Also, the design that the object trace of the video sensor to recognized object would be considered.