• Journal of the Korean Wood Science and Technology
• /
• 제32권4호
• /
• pp.18-26
• /
• 2004

변장 14 cm 재장 2.4 m인 대단면재의 전도가열, 고주파가열 및 복합가열에 의한 진공건조특성을 조사하였다. 건조속도는 복합가열에서 가장 컸고, 고주파가열에서 가장 적었다. 비에너지는 고주파가열에서 가장 컸고, 전도가열에서 가장 적었다. 진공건조목재의 횡단방향 함수율분포는 전도가열과 복합가열의 경우 불록한 형태를 나타냈으나, 고주파가열의 경우는 한쪽 표층에서 반대쪽 표층으로 향해 증가하는 경향을 나타내었다. 건조목재의 재장방향 함수율은 전도가열과 복합가열의 경우 횡단면이 중심부위보다 낮았고 고주파가열의 경우 횡단면이 중심보다 높았다. 표면할렬과 횡단면할렬은 전도가열진공건조에서 가장 심하였다. 내부할렬은 어떠한 가열방법에 의한 건조에서도 발생하지 않았다. 복합가열 진공건조 특성은 전도가열과 고주파가열간의 절충된 중간적 경향을 나타냈다.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2009년도 제38회 동계학술대회 초록집
• /
• pp.289-289
• /
• 2010

정상 세포로부터 암과 같은 종양세포를 제거하는 방법으로 암세포가 사멸되는 임계온도 보다 높게 악성조직에 열을 가하는 방법이 연구되어지고 있다 [1]. 전류가 흐를 수 있는 4개의 전기탐침을 종양조직에 삽입하여 국부적으로 열을 발생시키는 발열요법으로 암을 치료하는 연구가 고려되고 있다. 발열요법은 1960년대에 시작하여 우리나라에서는 1985년 연세 암센터에서 capacitive type의 RF heating 또는 전자파에 의한 국소가온법과 방사선치료와 병용으로 이용되고 있다. 주로 이용되는 방법은 Radio frequency heating, Microwave heating, ultrasound heating을 들수 있다. 라디오주파수는 보통 300 MHz 이하의 주파수를 가리킨다. 본 연구에서는 교류파 대신에 직류전원에 의해 열을 발생하는 경우에 관한 연구이다. 전극에 의해 형성되는 전기장에 대한 방정식은 전도매질에서의 DC 응용모드이고, 조직 내에서의 직류 전류에 의해 발생되는 온도 분포를 모델링하는 bioheat 방정식과 연계된 문제이다. 전기장에 의해 발생되는 열의 근원은 resistive heat 또는 Joule 열이다. 본 연구에서는 교류 전류에 의한 RF heating 대신 단순한 모델의 경우로 직류 전류에 의한 열 발생에 관한 이론적 연구를 수행하였다. 종양 조직 내에 삽입된 전극에 22V를 인가하면 60초 이내에 $80^{\circ}C$까지 급속히 증가 된 후, 서서히 $90^{\circ}C$에 까지 도달한다. 4 개의 전극에 대칭적인 전위가 인가 된 경우 $50^{\circ}C$ 이상의 온도 분포를 암 조직의 모양과 유사하게 분포하게 하여 효과적인 치료를 수행 할 수 있는 조건을 제시한다.

• 한국원자력학회:학술대회논문집
• /
• 한국원자력학회 1998년도 춘계학술발표회논문집(2)
• /
• pp.935-940
• /
• 1998

The Korea Superconducting Tokamak Research (KSTAR) tokamak will have 6 MW of radio-frequency (rf) heating in the ion cyclotron range of frequencies (ICRF). The response of the antenna to the heat loads is analyzed and the resulting stresses in the Faraday shield during the normal operation is calculated. Various heat loading conditions including in the analyzes are the heat loads from the plasma, the ripple-trapped beam particles and the rf loss.

• 센서학회지
• /
• 제24권5호
• /
• pp.348-352
• /
• 2015

Thin nickel oxide films formed on uncooled and cooled $SiO_2/Si$ substrates using a radio frequency (RF) magnetron sputter powered by 200 W in a mixed atmosphere of argon and oxygen. Grazing-incidence X-ray diffraction and field emission scanning electron microscopy are used for the structural analysis of nickel oxide films. The electrical conductivity required for better bolometric performance is estimated by means of a four-point probe system. Columnar and (200) preferred orientations are discovered in both films regardless of substrate cooling. Electric resistivity, however, is greatly influenced by the substrate cooling. Oxygen partial pressure increase during the nickel oxide deposition leads to a rapid decrease in resistivity, and the resistivity is higher in the cooled nickel oxide samples. Even when small microstructure variations are applied, lower resistivity in favor of low noise performance is acquired in the uncooled samples.

• 동아시아식생활학회지
• /
• 제25권5호
• /
• pp.893-901
• /
• 2015

This study investigated the effects of thawing conditions on physiological activities and quality of peeled garlic. Peeled frozen garlic was analyzed after thawing at low temperature ($4^{\circ}C$), room temperature ($20^{\circ}C$), tap water ($20^{\circ}C$), radio frequency of 27.12 MHz, and 2.45 GHz in a microwave. As a result, the time required to thaw garlic to $0^{\circ}C$ by various thawing methods was shortest at2.45 GHz in a microwave, followed by $20^{\circ}C$ tap water, radio frequency of 27.12 MHz, $20^{\circ}C$, and $4^{\circ}C$. Microwave thawing was faster than other methods, but it resulted in significant non-uniformity of heating. The hardness of peeled garlic significantly decreased upon freeze-thawing, whereas it showed improved hardness upon radio-frequency thawing. Total color difference in garlic increased upon freeze-thawing, and it was not improved by various thawing methods. Antioxidant activities were determined for DPPH radical scavenging ability, SOD-like activity, and reducing power. Total phenolic compounds and flavonoids in garlic extract were measured as $3.222{\pm}0.214{\mu}g$ GAE/g and $0.149{\pm}0.03{\mu}g$ QE/g, respectively. The content of total phenolic compounds was significantly reduced by 2.45 GHz microwave thawing ($1.90{\pm}0.02{\mu}g$ GAE/g); however, flavonoid contents were slightly reduced under freezing and thawing conditions. The DPPH radical scavenging ability of garlic extracts was not affected by thawing methods; however, SOD-like activity and reducing power were slightly reduced by freeze-thawing. These results indicate that physiological activities were not improved by radio-frequency thawing; however, thawing time and maintain hardness were reduced compared with conventional thawing methods.

• 한국농업기계학회:학술대회논문집
• /
• 한국농업기계학회 1996년도 International Conference on Agricultural Machinery Engineering Proceedings
• /
• pp.293-304
• /
• 1996

Historical interest in dielectric properties of agricultural products and definitions of dielectric terms and basic principles governing their influence on elelctromagnetic energy are presented briefly . The nature of dielectric properties variation with frequency, temperature , and product density is discussed, Graphical data on the dielectric properties of products are presented that illustrate the dependence of these properties on moisture content, frequency, temperature, and density. Applications microwave dielectric properties of agricultural products are cited that include radio-frequency (RF) and microwave heating for seed treatment, improvement of nutritional and keeping qualities of some products, and controlling insects in grain. Uses of dielectric properties for product quality measurement and the rapid determination of moisture content are described. Principle of moisture determination in bulk grain by RF and microwave measurements are briefly presented.

• Journal of the Korean Wood Science and Technology
• /
• 제39권2호
• /
• pp.132-139
• /
• 2011

This study examined the characteristics of radio-frequency/vacuum dried Korean red pine ($Pinus$ $densoflora$) heavy timbers with 250 ${\times}$ 250 mm (S), 300 ${\times}$ 300 mm (L) in cross section and 300 mm in diameter, and 3,600 mm in length, which were subjected to compressive loading after a kerf pretreatment. The following results were obtained : The drying time was short and the drying rate was high in spite of the large cross section of specimens. The moisture gradient inall specimens was gentle in both longitudinal and transverse directions owing to dielectric heating. The shrinkage of the width in the direction perpendicular to was 21 percent ~ 76 percent of that of the thickness of square timbers in the direction parallel to the mechanical pressure. The casehardening for all specimens was very slight because of significantly reduced ratio of the tangential to radial shrinkage of specimens and kerfing. The surface checks somewhat severely occurred although the occurrence extent of the surface checks on the kerfed specimens was slight compared withthat on the control specimen.

• Transactions on Electrical and Electronic Materials
• /
• 제12권5호
• /
• pp.209-212
• /
• 2011

Hafnium nitride (HfN) thin films were deposited onto a silicon substrate by inductive coupled nitrogen plasma-assisted radio frequency magnetron sputtering. The films were prepared without intentional substrate heating and a substrate negative bias voltage ($-V_b$) was varied from -50 to -150 V to accelerate the effects of nitrogen ions ($N^+$) on the substrate. X-ray diffractometer patterns showed that the structure of the films was strongly affected by the negative substrate bias voltage, and thin film crystallization in the HfN (100) plane was observed under deposition conditions of -100 $V_b$ (bias voltage). Atomic force microscopy results showed that surface roughness also varied significantly with substrate bias voltage. Films deposited under conditions of -150 $V_b$ (bias voltage) exhibited higher hardness than other films.

• KIEE International Transactions on Electrophysics and Applications
• /
• 제2C권5호
• /
• pp.246-252
• /
• 2002

Two-dimensional steady state simulations of planar type radio frequency inductively coupled plasma (RFICP) have been performed. The characteristics of RFICP were investigated in terms of power transfer efficiency, equivalent circuit analysis, spatial distribution of plasma density and electron temperature. Plasma density and electron temperature were determined from the equations of ambipolar diffusion and energy conservation. Joule heating, ionization, excitation and elastic collision loss were included as the source terms of the electron energy equation. The electromagnetic field was calculated from the vector potential formulation of ampere's law. The peak electron temperature decreases from about 4eV to 2eV as pressure increases from 5 mTorr to 100 mTorr. The peak density increases with increasing pressure. Electron temperatures at the center of the chamber are almost independent of input power and electron densities linearly increase with power level. The results agree well with theoretical analysis and experimental results. A single turn, edge feeding antenna configuration shows better density uniformity than a four-turn antenna system at relatively low pressure conditions. The thickness of the dielectric window should be minimized to reduce power loss. The equivalent resistance of the system increases with both power and pressure, which reflects the improvement of power transfer efficiency.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 추계학술대회 논문집 Vol.17
• /
• pp.611-615
• /
• 2004

In recent, there have been several developments in lamp technology that promise savings in electrical power consumption and improved quality of the lighting space. Above all, Electrodeless fluorescent lamp is the removal of internal electrodes and heating filaments that are a light-limiting factor of conventional fluorescent lamps. The electrodeless fluorescent lamp is intended as a high efficacy replacement for the incandescent reflector lamp in many applications. Therefore, the electrodeless fluorescent lamps is substantially higher than that of conventional fluorescent lamps and last up to 60,000 hours. In this paper, electron temperature and electron density were measured in a radio-frequency inductively coupled plasma using a Langmuir probe method for emission characteristics. Measurement was conducted in an argon discharge for pressure from 10 [mTorr] and input RF power 100 [W] to 150 [W]. As for the electron density, a electron temperature was more distinguished for a emission characteristic. The results of ideal may contribute to systematic understanding of a electrodeless fluorescent lamps of emission characteristics.