• 비파괴검사학회지
• /
• 제27권3호
• /
• pp.217-223
• /
• 2007

This paper introduces an active sensing node using radio-frequency (RF) telemetry. This device has brought the traditional impedance-based structural health monitoring (SHM) technique to a new paradigm. The RF active sensing node consists of a miniaturized impedance measuring device (AD5933), a microcontroller (ATmega128L), and a radio frequency (RF) transmitter (XBee). A macro-fiber composite (MFC) patch interrogates a host structure by using a self-sensing technique of the miniaturized impedance measuring device. All the process including structural interrogation, data acquisition, signal processing, and damage diagnostic is being performed at the sensor location by the microcontroller. The RF transmitter is used to communicate the current status of the host structure. The feasibility of the proposed SHM strategy is verified through an experimental study inspecting loose bolts in a bolt-jointed aluminum structure.

• 한국안전학회지
• /
• 제27권5호
• /
• pp.49-54
• /
• 2012

There is a possibility that electrical sparks may occur at discontinuities in metallic structures from distance of close to high power radio/radar transmitters. Voltage may be induced on these metallic structures by the radio-frequency transmitter. In this case, a person who comes into contact with these structure may be undergone a severe electrical shock. In this paper, assessment of the electrical shock and ignition hazards was investigated through experimental which are consisted radio transmitter and metallic loop-type structure in shield room. We measured that the induced voltage was highest at 61 MHz of transmission frequency, and confirmed the possibility of electric shock and explosion induced by a voltage or spark. But it is needed additional research where is opened site.

• 한국정보통신설비학회:학술대회논문집
• /
• 한국정보통신설비학회 2009년도 정보통신설비 학술대회
• /
• pp.242-247
• /
• 2009

In this paper, we investigate interference between short-range radiocommunication devices (SRDs) with frequency hopping spread spectrum (FHSS) and direct sequence spread spectrum (DSSS) methods when they are in the same frequency bands. In order to analyze interference from unwanted emission of SRD with DSSS to that of FHSS, Monte-Carlo (MC) simulation method is employed and interference probabilities are calculated. We simulate interference scenarios in accordance with several duty cycles and bandwidths. It is also assumed that the propagation model is free space The effect of distance between interfering transmitter and victim receiver is analyzed and bit error rate (BER) is simulated. From the interference analysis results, it is shown that duty cycle affects compatibility more than bandwidth does. Also, we can make sure of the separation distance which satisfies BER criterion when there are only one interfering transmitter and multiple interfering transmitters.

• 전자공학회논문지CI
• /
• 제44권4호통권316호
• /
• pp.45-49
• /
• 2007

송신 시스템과 수신 시스템에 동일한 주파수를 사용하는 pulse-modulated 방식의 RFID (Radio Frequency IDentification) 시스템에서 송신 시스템과 수신 시스템 사이의 isolation특성은 중요한 문제점이다. 제안된 방법은 송신 시스템에 스위치와 믹서 오실레이터를 사용하여 RFID 시스템의 송신 시스템과 수신 시스템 사이의 isolation 특성을 개선하였다. 제안된 시스템은 송신 시스템에서 up-convert된 출력 신호와 수신 신호의 주파수를 다르게 하여 isolation 특성을 개선한 것이다. 이 방법을 사용하여 20 dB의 isolation 특성 개선 효과를 얻었다.

• 디지털융복합연구
• /
• 제12권12호
• /
• pp.257-264
• /
• 2014

무선 모듈을 사용하여 무선 데이터를 mcu모듈과 PC와의 사이에 통신을 하고자 할때는 우선 PC를 기본으로하는 시리얼 통신을 PC자체적으로 구현한 후 구현된 프로그램을 사용하여 MCU와의 통신을 시행한다. PC자체적으로 시리얼 통신을 시행코자 할때는 RS-232C를 사용하여 데이터를 교환한다. 교환된 데이터를 rf모듈을 사용 UART기반 시리얼 통신 원격제어를 MCU를 사용하여 시행한다. MCU 인터페이스 원격제어가 실현되면 통신시스템이 구현된 것이다.

• 제어로봇시스템학회논문지
• /
• 제17권12호
• /
• pp.1240-1247
• /
• 2011

The localization of mobile robot in environment is a major concern in mobile robot navigation. So, many kinds of localization techniques have been researched for several years. Among them, the positioning system using ultrasound has received attention. Most of these ultrasonic positioning systems to synchronize the transmitters and receivers are used for RF (Radio Frequencies). However, due to the use of RF, the interference problems can not be avoided and the performance of radio frequencies directly affects the positioning performance. So we proposed the ultrasonic positioning system without synchronizing RF. The proposed system is based on existing USAT (Ultrasonic Satellite System) adopted infrastructure transmitting type, and consists of transmitter and receiver synchronizing modules instead of the radio frequency transmitters and receiver. The ultrasonic transmitters and receivers are synchronized individually by the transmitter and receiver synchronizing modules. In order to calculate the bias between the transmitter and receiver synchronizing modules, new positioning algorithm similar to GPS was proposed. The positioning performance of the improved USAT without synchronizing RF and the validity of the proposed positioning algorithm are verified and evaluated by experiments.

• 대한의용생체공학회:의공학회지
• /
• 제3권2호
• /
• pp.113-118
• /
• 1982

This paper presents a frequency modulated radio-telemetry, transmitter for monitoring and transmitting an exercise electrocardiogram (ECG) and respiration activity simultaneously on single carrier frequency in the standard FM broadcast band of 88-108 MHz. We have evaluated the performance of the FM telemetry transmitter which is proposed on the basis of an exercise ECG test in the treadmill.

• 한국항행학회논문지
• /
• 제13권4호
• /
• pp.475-481
• /
• 2009

본 논문에서는 안전하고 정확한 운용을 지원하기 위한 열차무선 시스템의 특성 개선에 초점을 맞추었다. 열차무선 시스템의 고장 및 특성 변화의 원인을 분석하고 측정 지표를 선택하였다. 열차의 진동에 의한 송신기의 주파수 변화를 보이고, 방진패드를 이용하여 주파수 안정도가 향상되는 것을 확인하였다.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2001년도 춘계학술대회 논문집
• /
• pp.327-332
• /
• 2001

This paper proposes the system to describe the data transmission methods using the simply frequency transmission methods between a railway track and the train. This system can control the railway signals through the ABS or ATS system located in the train and stations, having the frequency about 433.92 MHz. It shows the advanced system to send a lot of data through the microprocessor installed in a transmitter and transmitter-receiver at the train and railway.

• 방송공학회논문지
• /
• 제12권3호
• /
• pp.266-277
• /
• 2007

최근 들어 ATSC-DTV의 미래형 핵심기술로 손꼽히고 있는 송신기 식별기술(TxID ; Transmitter Identification)이 새로운 신기술로 대두되고 있으며, 이에 대한 구현성 검증은 현재 활발하게 논의 중인 동일채널중계기(EDOCR)와 연계된 단일주파수망(SFN; Single Frequency Network)기술의 실용화를 위한 핵심적 역할을 한다고 볼 수 있다. 하지만 종래의 TxID 기술은 긴 주기의 워터마킹용 확산코드를 사용하므로 수신기 입장에서 하드웨어 부피 및 연산량이 크게 증가되는 문제점을 갖고 있다. 따라서 본 논문에서는 TxID 수신기 하드웨어 부피를 크게 경감시킬 수 있는 새로운 Decimation 알고리즘을 이용한 DTV TxID 수신 신호의 효율적인 신호처리 기법을 제시하였으며, 모의실험을 통한 성능평가를 통해 제안한 알고리즘의 유용성을 입증하였다.