• Journal of Korea Water Resources Association
• /
• v.40 no.1 s.174
• /
• pp.39-50
• /
• 2007

This paper presents applications of the log-linear ROCOF(rate-of-occurrence-of-failure) and the Weibull ROCOF to model the failure rate of individual cast iron pipes in a water distribution system and provides a method of estimating the economically optimal replacement time of the pipes using the 'modified time-scale'. The performance of the two ROCOFs is examined using the maximized log-likelihood estimates of the ROCOFs for the two types of failure data: 'failure-time data' and 'failure-number data'. The optimal replacement time equations for the two models are developed by applying the 'modified time-scale' to ensure the numerical convergence of the estimated values of the model parameters. The methodology is applied to the case study water distribution cast iron pipes and it is found that the log-linear ROCOF has better modeling capability than the Weibull ROCOF when the 'failure-time data' is used. Furthermore, the 'failure-time data' is determined to be more appropriate for both ROCOFs compared to the 'failure-number data' in terms of the ROCOF modeling performances for the water mains under study, implying that recording each failure time results in better modeling of the failure rate than recording failure numbers in some time intervals.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.2
• /
• pp.496-503
• /
• 2015

In order to let a wind generator (WG) support the frequency control of a power system, a conventional inertial control algorithm using the rate of change of frequency (ROCOF) and frequency deviation loops was suggested. The ROCOF loop is prevailing at the initial stage of the disturbance, but the contribution becomes smaller as time goes on. Moreover, its contribution becomes negative after the frequency rebound. This paper proposes an inertial control algorithm of a wind power plant (WPP) using the maximum ROCOF and frequency deviation loops. The proposed algorithm replaces the ROCOF loop in the conventional inertial control algorithm with the maximum ROCOF loop to retain the maximum value of the ROCOF and eliminate the negative effect after the frequency rebound. The algorithm releases more kinetic energy both before and after the frequency rebound and increases the frequency nadir more than the conventional ROCOF and frequency loops. The performance of the algorithm was investigated under various wind conditions in a model system, which includes a doubly-fed induction generator-based WPP using an EMTP-RV simulator. The results indicate that the algorithm can improve the frequency drop for a disturbance by releasing more kinetic energy.

• Journal of Korea Water Resources Association
• /
• v.42 no.7
• /
• pp.525-535
• /
• 2009

In this paper a heuristic method for identifying individual pipes in water pipe networks to determine specific sections of the pipes that need to be replaced due to deterioration. An appropriate minimum pipe length is determined by selecting the pipe length that has the greatest variance of the average cumulative break number slopes among the various pipe lengths used. As a result, the minimum pipe length for the case study water network is determined as 4 m and a total of 39 individual pipe IDs are obtained. The economically optimal replacement times of the individual pipe IDs are estimated by using the threshold break rate of an individual pipe ID and the pipe break trends models for which the General Pipe Break Prediction Model(Park and Loganathan, 2002) that can incorporate the linear, exponential, and in-between of the linear and exponetial failure trends and the ROCOFs based on the modified time scale(Park et al., 2007) are used. The maximum log-likelihoods of the log-linear ROCOF and Weibull ROCOF estimated for the break data of a pipe are compared and the ROCOF that has a greater likelihood is selected for the pipe of interest. The effects of the social costs of a pipe break on the optimal replacement time are also discussed.

• Journal of Electrical Engineering and Technology
• /
• v.2 no.1
• /
• pp.19-28
• /
• 2007

The paper discussed various techniques for islanding detection and described in detail the working principles of ROCOF and vector shift relays. A simulator was used to investigate why the stability of both types of relays maybe affected by network and load switching, short-circuit faults and in the case of a ROCOF relay the loss of bulk generation or the tripping of a transmission feeder. Finally, to enhance the reliability of Loss of Mains protection, a new islanding detection technique based on a GPS synchronized phasor measurement system was proposed.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2005.09a
• /
• pp.297-298
• /
• 2005

• Journal of Electrical Engineering and Technology
• /
• v.10 no.3
• /
• pp.1363-1369
• /
• 2015

The frequency of a power system should be maintained within the allowed limits for stable operation. When a disturbance such as generator tripping occurs in a power system, the frequency is recovered to the nominal value through the inertial, primary, and secondary responses of the operating synchronous generators (SGs). However, for a power system with high wind penetration, the system inertia will decrease significantly because wind generators (WGs) are operating decoupled from the power system. This paper proposes a dynamic droop-based inertial control for a WG. The proposed inertial control determines the dynamic droop depending on the rate of change of frequency (ROCOF). At the initial period of a disturbance, where the ROCOF is large, the droop is set to be small to release a large amount of the kinetic energy (KE) and thus the frequency nadir can be increased significantly. However, as times goes on, the ROCOF will decrease and thus the droop is set to be large to prevent over-deceleration of the rotor speed of a WG. The performance of the proposed inertial control was investigated in a model system, which includes a 200 MW wind power plant (WPP) and five SGs using an EMTP-RV simulator. The test results indicate that the proposed scheme improves the frequency nadir significantly by releasing a large amount of the KE during the initial period of a disturbance.

• Journal of Applied Reliability
• /
• v.9 no.2
• /
• pp.121-130
• /
• 2009

The power law process model the Rate of occurrence of failures(ROCOF) with monotonic trend during the operating time. However, the power law process is inappropriate when a non-monotonic trend in the failure data is observed. In this paper we deals with the reliability modeling of the failure process of large and complex repairable system whose rate of occurrence of failures shows the non-monotonic trend. We suggest a sectional model and a change-point test based on the Schwarz information criterion(SIC) to describe the non-monotonic trend. Maximum likelihood is also suggested to estimate parameters of sectional model. The suggested methods are applied to field data from an repairable system.

• New & Renewable Energy
• /
• v.20 no.2
• /
• pp.55-64
• /
• 2024

To ensure the frequency stability of wind power generation, we analyzedd the existing technology and proposedd a method for changing the gain value with respect to to the rotor speed by adding the MPPT reference value and output reference value that reflect the system frequency. The MPPT control and output were compared and calculated for performance verification. Subsequently, the application of the proposed algorithm led to an increased output when compared with that of the existing control method.

• Journal of Electrical Engineering and Technology
• /
• v.8 no.5
• /
• pp.1021-1028
• /
• 2013

The frequency of a power system should be kept within limits to produce high-quality electricity. For a power system with a high penetration of wind generators (WGs), difficulties might arise in maintaining the frequency, because modern variable speed WGs operate based on the maximum power point tracking control scheme. On the other hand, the wind speed that arrives at a downstream WG is decreased after having passed one WG due to the wake effect. The rotor speed of each WG may be different from others. This paper proposes an algorithm for assigning the droop of each WG in a wind power plant (WPP) based on the rotor speed for the virtual inertial control considering the wake effect. It assumes that each WG in the WPP has two auxiliary loops for the virtual inertial control, i.e. the frequency deviation loop and the rate of change of frequency (ROCOF) loop. To release more kinetic energy, the proposed algorithm assigns the droop of each WG, which is the gain of the frequency deviation loop, depending on the rotor speed of each WG, while the gains for the ROCOF loop of all WGs are set to be equal. The performance of the algorithm is investigated for a model system with five synchronous generators and a WPP, which consists of 15 doubly-fed induction generators, by varying the wind direction as well as the wind speed. The results clearly indicate that the algorithm successfully reduces the frequency nadir as a WG with high wind speed releases more kinetic energy for the virtual inertial control. The algorithm might help maximize the contribution of the WPP to the frequency support.

• Convergence Security Journal
• /
• v.6 no.3
• /
• pp.145-153
• /
• 2006

Infinite failure NHPP models for a record value satisfies mode proposed in the literature exhibit either monotonic increasing or monotonic decreasing failure occurrence rates per fault. In this paper, propose comparative study of software reliability model using Erlang distribution, Rayleigh and Gumbel distribution. Equations to estimate the parameters using maximum likelihood estimation of infinite failure NHPP model based on failure data collected in the form of interfailure times are developed. For the sake of proposing distribution, we used to the special pattern. Analysis of failure data set using arithmetic and Laplace trend tests, goodness-of-fit test, bias tests is presented.