• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.45 no.5
• /
• pp.409-416
• /
• 2017

In order that multiple wideband RF transmitters which have mission to deliver essential information to aircraft operate at the same time, RF transmitter has a variable sub-carrier frequency to modulate the signal. In case of exposure to weak environment, Wide-band RF transmitter is designed to check component of transmitter that includes antenna BIT to increase system reliability. Normally, Antenna BIT measure the reflection RF power of antenna to check system condition. However, Antenna BIT has a difference that depends on testing frequency to use the long RF cable which is located between the power amp and the antenna. The periodic phenomenon of the reflected antenna power are theoretically explained about dependence on the RF cable length. Based on presented result, suggested measurement methods is effectively able to be applied to diagnosis system condition.

• ETRI Journal
• /
• v.37 no.4
• /
• pp.647-656
• /
• 2015

This paper proposes a single-RF MIMO receiver that adopts a beam-switching antenna (BSA) instead of a conventional array antenna. The beauty of the proposed single-RF MIMO receiver with BSA is that it can be deployed in a very small physical space while achieving a full spatial multiplexing gain. Our analysis has revealed that the use of a BSA inevitably results in the spectrum spreading effect at the RF output, which in turn causes an SNR decrease and adjacent channel interference (ACI). Two novel receiver techniques are proposed to mitigate the issues of redundant sub-band suppression and ACI avoidance. Numerical analysis results verify the performance improvement from the proposed receiver techniques.

• Journal of Space Technology and Applications
• /
• v.1 no.3
• /
• pp.364-374
• /
• 2021

This research discusses the change in radio frequency (RF) characteristics according to the number of Gores on the deployable mesh antennas for potential micro-satellite applications. The deployable type of lightweight mesh antenna can be used for various space missions such as communication/SAR/ SIGINT. In order to implement an ideal curvature of antenna surface, sufficient number of antenna rib structures are required. However, the increase in antenna ribs affects various design factors of the antenna system, especially total system mass, complexity of deployable mechanism and reliability. In this paper, the proper number of ribs for the mesh antenna were derived by comparison of electro-magnetic (EM) simulation results of example of antenna model in accordance with the various number of ribs.

• Proceedings of the KIEE Conference
• /
• 2003.11b
• /
• pp.27-30
• /
• 2003

Wireless power transmission system is one of the very interesting field not only in a technical and economical point of view but also that people are still trying to realize lossless power transmission. This paper has a purpose on the efficient power transmission at the passive type ICcard by using wireless power transmission system. The most difficult but important part of the passive type RF-ID system is building the system that supplies power from Reader-antenna to IDcard-antenna. To check what is the most efficient way to deliver power depending on what kind of specifications of the power-amp in reader, antenna and antenna in IDcard is for operating IDcard circuit efficiently receiving the power from reader-antenna. For this, we used 125kHz sinewave for RF signal as a basic specification, power-amp : OP-Amp for amplifying signal and AB Class push-pull power-amp for amplifying power, loop type antenna.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.10
• /
• pp.579-584
• /
• 2014

In this paper, we propose beamsapce MIMO(mulitple input multiple output) system using patch ESPAR(Electronically Steerable Parasitic Array Radiator) antenna. When using conventional monopole ESPAR antenna, we have advantages cost of hardware and power consumption of RF cirsuit because of single RF chian. But it is difficult to apply to small portable mobile device. Therefore we design patch ESPAR antenna in order to reducing volume and analyze performance of BS MIMO system that is able to MIMO communication with single RF chain. In This paper, we confirm beam pattern of designed patch ESPAR antenna is steered as ${\pm}15^{\circ}$ elevation angle. Furthermore, we design BS MIMO system using this ESPAR antenna and confirm BER performance of this system.

• Journal of Sensor Science and Technology
• /
• v.25 no.1
• /
• pp.46-50
• /
• 2016

During KSTAR plasma experiments, torsional $Alfv\acute{e}n$ waves in the frequency of few GHz or below were detected. To understand this plasma waves during the crash of MHD instabilities, an RF spectrometer has been developed for detection of the radiated RF signals in the KSTAR Tokamak. It has the capability of broadband RF spectral measurement (50 ~ 400 MHz). To detect the broadband RF signals which are radiated from the KSTAR systems, a broadband antenna is the key feature of the RF spectrometer. In this paper, a broadband bowtie antenna for detection of $Alfv\acute{e}n$-waves in the KSTAR Tokamak is presented. Planar-type bowtie antenna is designed and fabricated on an FR4 substrate with thickness of 1.6 mm. The antenna consists of bowtie shaped balanced radiators and broadband planar balun. The antenna is designed to have an input impedance of 50 Ohm, and a taper-shaped balun is adopted for field and impedance matching between 50 Ohm transmission line to 110 Ohm feeding network of balanced radiators. The implemented antenna provides around -3 to 3 dBi of gain for the whole frequency band. The VSWR of the bowtie antenna is less than 12:1 over the frequency bandwidth of 50 to 2000 MHz.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.13 no.5
• /
• pp.21-26
• /
• 2014

This paper proposes a frequency reconfigurable antenna which operates at not only LTE but also other currently serviced bands. The high band(1,710-2,170 MHz) performance was satisfied through PIFA structure, and the low band performance through the additional RF Switch by changing the state between SW1 and SW2. When the RF switch is SW1 state, the operation bandwidth is 782-907 MHz (GSM), and 738-861 MHz (LTE) at OFF state. The proposed antenna has a omni-directional radiation pattern and measured peak gains were 0.04-4.68 dBi at the SW1 state and 0.92-1.53 dBi at the SW2 state, respectively. Judging from the results, proposed reconfigurable antenna is expected to be applied to LTE-Advanced mobile terminals since the antenna shows an outstanding performance.

• Aerospace Engineering and Technology
• /
• v.6 no.2
• /
• pp.52-59
• /
• 2007

Telecommunication satellite consists of a bus system and an RF payload system with high efficiency and high gain reflector antennas. Antenna measurement and also RF system performance (antenna under test, payload and satellite level) have to be evaluated enough before launching in the far-field range or equivalent test range. Basically far-field range is required in a range from two hundred meters to several kilo meters, and it is highly constrained to the externa1 environment, like the RF and the whether environment So the compact antenna test range is developed and used efficiently without external environments as in-door facility. This paper describes the configuration of the compact antenna test range, the range error, and the physical concept of the plane wave illumination Also, it provides a overall design of the anechoic chamber and range parameter values to accommodate the precision measurements in antenna test range.

• Journal of the Semiconductor & Display Technology
• /
• v.20 no.4
• /
• pp.102-107
• /
• 2021

In this paper, the measurements of received power was shown and compared in two developed 5.8GHz 25W wireless charging systems. One is the system using commercial transmission antenna, and the other is the system using transmission antenna combined with metamaterial. The system combined with metamaterial shows higher received power due to negative reflective index of metamaterial. In addition, a comparative analysis of the systems shows that the transmission efficiency in the systems can decrease the real gain of transmission antenna due to higher side robe of beam pattern. The side robe beams of transmitting antenna interferes transmitted beam with the reflected beams from the bottom region due to the side robes. The failure problems of the RF wireless charging systems are discussed and proposed in order to charge mobile devices through the RF wireless charging system.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.26 no.10
• /
• pp.1567-1570
• /
• 2022

This paper, we presents a RF protection technique of antenna switch by improving the power handling capability in worst case environment mode for mobile phone applications without critical payment of circuit performances such as insertion loss, isolation and ACBV (AC breakdown voltage). By applying a additional capacitive path located in front of the antenna in cell-phone, it performs the effective reduction of input power in high voltage standing wave ratio (VSWR) condition. Under the all-path off condition which causes a high VSWR, it achieved 37.7dBm power handling level as high as 5.7dB compared to that of conventional one at 2GHz. In addition, insertion loss and isolation performances were 0.31dB and 42.72dB at 2 GHz, respectively which were almost similar to that of the conventional circuit. The proposed antenna switch was fabricated in 130nm CMOS SOI technology.