• Journal of Environmental Science International
• /
• v.13 no.9
• /
• pp.759-765
• /
• 2004

HEC-RAS model is used for estimation of rating-curve of Musung in Wi stream. Discharge is computed from stage estimated by HEC-RAS model, is compared with the discharge of water surface slope method. The relative deviation of observed and computed discharge is 5.37%, and shows as a good results. A rating-curve by HEC-RAS model shows better results than by water surface slope method.

• BMB Reports
• /
• v.29 no.5
• /
• pp.442-447
• /
• 1996

Mutations in codon 12, 13 and 61 of one of the three ras genes, H-ras, K-ras and N-ras, convert these genes into active oncogenes. The presence of H-ras gene mutations have important prognostic implications in various cancers. In this study, the H-ras gene mutations were investigated by two-step PCRRFLP in patients with bladder and stomach cancer. For the control experiments, T24 and SK2 cell lines were used. In a total of 36 bladder cancer patient cases, five (13.9%) mutations were found by this method. Of these, point 12 mutations were two (5.6%) cases and point 61 mutations were three (8.3%) cases. On the other hand, H-ras mutation was not found in 29 cases of stomach cancer. The results of the mutated H-ras gene confirmed by direct sequencing analysis were correlated well with PCR analysis. From the sensitivity test, the H-ras mutation was found to have about 0.2% of mutated DNA mingled in normal DNA. In conclusion, the H-ras mutation has a higher clinical Significance in bladder cancer than stomach cancer. Moreover the two-step PCR-RFLP method is sensitive, rapid and relatively simple for clinical work in detecting H-ras point mutations.

• International Journal of Aeronautical and Space Sciences
• /
• v.17 no.1
• /
• pp.20-28
• /
• 2016

In this study, an efficient method of designing laminate composite radar absorbing structures (RAS) is proposed with consideration given to the structural shape so as to improve aircraft stealth performance. The calculation of the radar cross section (RCS) should be decreased to enhance the efficiency of the stochastic optimization when designing an RAS. In the proposed method, RAS are optimized to match up the input impedance of the minimal RCS, which is obtained by using physical optics and the transmission line theory. Single and double layer dielectric RAS for aircraft wings are employed as numerical examples and designed using the proposed method, RCS minimization and reflection coefficient minimization. The availability of the proposed method is assessed by comparing the similarity of the results and computation time with other design methods. According to the results, the proposed method produces the same results as the stochastic optimization, which adopts the RCS as the objective function, and can improve RAS design efficiency by reducing the number of RCS analyses.

• Advances in aircraft and spacecraft science
• /
• v.9 no.5
• /
• pp.463-477
• /
• 2022

This study compares various ways of calculating flows for the problems with the presence of shock waves by first-order schemes and higher-order DG method on the tests from the Quirk list, namely: Quirk's problem and its modifications, shock wave diffraction at a 90 degree corner, the problem of double Mach reflection. It is shown that the use of HLLC and Godunov's numerical schemes flows in calculations can lead to instability, the Rusanov-Lax-Friedrichs scheme flow can lead to high dissipation of the solution. The most universal in heavy production calculations are hybrid schemes flows, which allow the suppression of the development of instability and conserve the accuracy of the method.

• Smart Structures and Systems
• /
• v.20 no.3
• /
• pp.343-350
• /
• 2017

An experimental study is presented of the application of fiber Bragg grating (FBG) interrogation method based on optical time-domain reflectometery (OTDR) to monitoring strain in bent reinforced concrete beams. The results obtained with the OTDR-based method are shown to agree well with the direct spectral measurements. Strain sensitivity, resolution and measurement range amounted to $0.0028dB/{\mu}strain$; $30{\mu}strain$; $4000{\mu}strain$, correspondingly. Significant differences are observed in surface and inner deformations of the test beams which can be attributed to different mechanical properties of concrete and steel reinforcement. The prospects of using OTDR-based FBG interrogation technique in real-life applications are discussed.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.43 no.2
• /
• pp.118-124
• /
• 2015

The design of radar absorbing structures(RAS) is a discrete optimization problem and is usually processed by stochastic optimization methods. The calculation of radar cross section(RCS) should be decreased to improve the efficiency of designing RAS. In this paper, an efficient method using impedance matching is studied to design RAS for minimizing RCS. Input impedance of the minimal RCS for the specified wave incident conditions is obtained by interlocking physical optics(PO) and optimizations. Complex permittivity and thickness of RAS are designed to satisfy the calculated input impedance by a discrete optimization. The results reveal that the studied method attains the same results as stochastic optimization which have to conduct numerous RCS analysis. The efficiency of designing RAS can be enhanced by reducing the calculation of RCS.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.4
• /
• pp.437-440
• /
• 1999

New method of control based upon a physical model of the Stepanov growth technique has been developed. The controller keeps the system stable and completely denies operator's interference into the process. The system demonstrates very reliable results under commercial production of shaped sapphire crystals.

• Journal of Powder Materials
• /
• v.27 no.6
• /
• pp.464-467
• /
• 2020

Nickel nanopowders are obtained by the spark discharge method, which is based on the evaporation of the electrode surface under the action of the discharge current, followed by vapor condensation and the formation of nanoparticles. Nickel electrodes with a purity of 99.99% are used to synthesize the nickel nanoparticles in the setup. Nitrogen is used as the carrier gas with a purity of 99.998%. XRD, TEM, and EDX analyses of the nanopowders are performed. Moreover, HRTEM images with measured interplanar spacings are obtained. In the nickel nanopowder samples, a phase of approximately 90 wt% with an expanded crystal lattice of 6.5% on average is found. The results indicate an unusual process of nickel nanoparticle formation when the spark discharge method is employed.

• Journal of Plant Biotechnology
• /
• v.45 no.3
• /
• pp.273-278
• /
• 2018

We performed an analysis of the effect of postharvest treatment of rhizomes of Aconitum septentrionale Koelle with the biological preparation of Bacispecin based on a cytokinin producing strain of Paenibacillus ehimensis IB-739 on the content of alkaloid lappaconitine in rhizomes. The total alkaloid content was assayed based on exhaustive extraction method. The lappaconitine content was measured by HPLC. The efficiency of the preparation was dependant on either the concentration or intensity of the growth processes in rhizomes. Both parameters varied depending on the stage of development of plants and the amount of precipitation. In the years with normal precipitation, concentrations of Bacispecin ranging from 5 to 10 g/l were found to be most effective for increasing lappaconitine content in rhizomes of A. septentrionale. Whereas, under local drought conditions, the concentration of preparation should be less than 2 g/l.

• Nuclear Engineering and Technology
• /
• v.53 no.1
• /
• pp.253-257
• /
• 2021

This work demonstrates the use of baromembrane method based on reverse osmosis (RO) process. The method is realized on mobile complex, which allows to concentrate and determine ultra-low activity of radionuclides in water cooling ponds of Russian nuclear fuel cycle enterprises. The existence level of radionuclide background creates difficult conditions for identification the contribution of liquid discharges enterprise, as standard monitoring methods have a very high detection level for radionuclides. Traditional methods for determining the background radionuclides concentrations require the selection of at least 500 liters (l) of water, followed by their evaporation to form a dry residue. This procedure with RO membranes requires at least 5 days. It is possible to reduce the time and energy spent on evaporation of hundreds of water liters by pre-concentrating radionuclides in a smaller sample volume with baromembrane method. This approach allows preliminary concentration of water samples from 500 l volume till 20 l volume during several hours. This approach is universal for the concentration of dissolved salts of any heavy metals, other organic compounds and allows the preparation of water countable samples in much shorter time compared to the traditional evaporation method.