• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.7 no.1
• /
• pp.16-20
• /
• 2001

In order to optimize designing process of corrugated fiberboard boxes for agricultural products, first of all, compression strength of each liner were experimentally evaluated on the various conditions of relative humidity and analyzed by liner regression analysis. At the 66 percents of relative humidity, IK(imported kraft liner) liner board lost little of its compression strength compared to others. At the relative humidity 93 percents, KA liner board lost its compression strength only 40 percents while SK liner board lost up to 56 percents. From the result of prediction modeling of ring crush strength in various humidity conditions, R square values were ranged from 0.59 to 0.97. At 56 percents of RH or below, R square values were relatively low, but at 66 percents of RH or higher, the values were 0.85 or higher. The significance values were lower than 0.001 at every RH condition. Level of significance of experimented values was about 80 percents of predicted values and R square values were between 0.89 to 0.95.

• Bulletin of the Korean Chemical Society
• /
• v.18 no.2
• /
• pp.193-197
• /
• 1997

Theoretical studies on the base-catalyzed deprotonation of 4-phenacylpyridinium cations, R1-CO-CH2-C5H4N-R2, I (R1=YC6H4 -and R2=CH3), and II (R1=C6H5 and R2=CH2C6H4Y) have been carried out with bases, NH3 and XC6H4NH2 using AM1 MO method. The Brψnsted α values are 0.20 and 0.22 and the βB values are 0.62 and 0.61, respectively for cations I and II. The negative Ⅰ (=α-βB) values obtained are in accord with the experimental results in aqueous solution, although the theoretical gas-phase α values for I are somewhat smaller than the experimental values in water due to neglect of solvation effect. It has been stressed that the Brψnsted α is distorted not only by the lag in the resonance and solvation development in the carbanion, but also by the difference in the distance between the anionic center and substituents in the TS and in the product anion.

• Bulletin of the Korean Chemical Society
• /
• v.18 no.4
• /
• pp.424-427
• /
• 1997

To study the NMR chemical shift arising from the 5f-electron orbital angular momentum and the 5f-electron spin dipolar-nuclear spin angular momentum interactions, the evaluation of the hyperfine integrals has been extended to any pairs of SCF type 5f orbitals adopting a general method which is applicable to a general vector R, pointing in any direction in space. From the electronic wavefunctions for 5f orbitals expressed in common coordinate system, the radial part of the hyperfine interaction integrals are derived by translating the exponential part, r2 exp(-2βr), in terms of R, rN and the modified Bessel functions. The radial integals for 5f orbitals are tabulated in analytical forms. When two of the hyperfine integrals along the (100), (010), (001), (110), and (111) axes are calculated using the derived radial integrals, the calculated values for the 5f system change sign for R-values larger than R　0.35 nm. But the calculated values for the 4f systems change sign for R-values larger than R　0.20 nm.

• Earthquakes and Structures
• /
• v.20 no.4
• /
• pp.389-403
• /
• 2021

Skewed bridges, being irregular structures with complicated dynamic behavior, are more susceptible to earthquake damage. Reliable seismic-resistant design of skewed bridges can be achieved by accurate determination of nonlinear seismic demands. However, the effect of geometric characteristics on the response modification factor (R-factor) is not accounted for in bridge design practices. This study attempts to investigate the effects of changes in the number of spans, skew angle and bearing stiffness on R-factor values and to assess the seismic fragility of skewed bridges. Results indicated that changes in the skew angle had no significant effect on R-factor values which were in consonance with code-prescribed R values. Also, unlike the increase in the number of spans that resulted in a decrease in the R-factor, the increase in bearing stiffness led to higher R-factor values. Findings of the fragility analysis implied that although the increase in the number of spans, as well as the increase in the skew angle, led to a higher failure probability, greater values of bearing stiffness reduced the collapse probability. For practicing design engineers, it is recommended that maximum demands on substructure elements to be calculated when the excitation angle is applied along the principal axes of skewed bridges.

• Journal of Animal Environmental Science
• /
• v.7 no.2
• /
• pp.103-110
• /
• 2001

This study conducted to monitor decomposition process of the charomatophore pollution solution of an animal slurry by using a CCD camera. After the solution was put into test tube, the images(R, G, B, H, L, S) values of the solution were measured by the imgae processing system, and those of it\`s optical density were measured for three hours to be decomposed by microscopic organism. The values of measured for three hours to be decomposed by microscopic organism. The values of measured images(R, G, B, H, L, S) were analysed and compared with those of the optical density. Some of the results are as follows. 1. High correlation coefficients, which analyzed by using data on linear equations, were 0.9557 and 0.9672. They were decreased regularly in this R-value experiment of RGB level. The microscopic organism in this experiment was effective for decomposition of the red charomatophore pollution solution. 2. The values of all correlation coefficients from relationship between RGB-value and optical density were more than 0.95 except H-values. RGB-values, which were average values of summed R, G, B values, had correlation coefficients of 0.9863, 0.9937. These results showed so good relationship that decomposition process of charomatophore pollution solution could be monitored by a image processing system.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.49 no.1
• /
• pp.41-45
• /
• 2004

We have developed and tested a new method for nondestructive estimation of chlorophyll- and nitrogen-contents in rye leaf. It was found that the relation-ships among nitrogen, chlorophyll content and fresh weight were significantly positive correlated. Nitrogen and chlorophyll content were positively correlated whereas correlation coefficients among R, G, R-B and G-B on the basis of photo-numerical values were negative. We have found that R/(R-B) obtained from data of digital camera is the best criterion to estimate the chlorophyll content of leaves. The regression curves of the relation between R/(R-B) and chlorophyll content were also calculated from the data collected on cloudy days. The coefficients of determination ($\textrm{r}^2$) were ranged from 0.33 to 0.99. In this study, the accuracy in estimating chlorophyll content from the color data of digital camera image could be improved by correcting with R, G, and B values. It is suggested that, for practical purposes, the image values estimated with sufficient accuracy using a portable digital camera can be applied for determining chlorophyll content and nitrogen status in plant leaves.

• The Korean Journal of Physiology
• /
• v.1 no.1
• /
• pp.73-76
• /
• 1967

A nomogram of gas exchange ratio (R) in air breathing subjects ,was porposed which enables a simple and rapid determination of R value using the fractional concentrations of nitrogen and carbon dioxide in the expired or alveolar gas. The readable limit of R value seems less than 1/100 of R unit and the average difference between the values from the nomogram and the actually calculated values is less than 0.005 of R unit. The usefulness of this nomogram for rapid and frequent determinations of the oxygen uptake is also suggested.

• Biomolecules & Therapeutics
• /
• v.15 no.3
• /
• pp.187-191
• /
• 2007

This study was conducted to compare the bioavailability of two brands of atenolol (50 mg) tablets, which are a generic product of $Ditent^{\circledR}$ (Daewon Pharmaceutical Co., Ltd., Korea) and an innovator product $Tenormin^{\circledR}$ (Hyundai Pharm. Ind. Co., Ltd., Korea), in 20 healthy Korean male volunteers. The volunteers received a single 50 mg dose of each atenolol formulation according to a randomized, two-way cross-over design. The washout period between treatments was 1 week. Plasma samples were obtained over a 24-hour interval, and atenolol concentrations were determined by HPLC with a fluorescence detector. From the plasma atenolol concentration vs. time curves, the following parameters were compared: area under the plasma concentration-time curve ($AUC_{0-24}$), peak plasma concentration ($C_{max}$), time to reach peak plasma concentration ($T_{max}$), and terminal first order elimination half-life ($t_{1/2}$). No statistically significant difference was obtained between the $T_{max}$ values, and the logarithmic transformed $AUC_{0-24}$ and $C_{max}$ values of the two products. The 90% confidence interval for the ratio of the logarithmically transformed AUC and $C_{max}$ values of $Ditent^{\circledR}$ over those of $Tenormin^{\circledR}$ were calculated to be between 0.85 and 1.04, and 0.89 and 1.07, respectively; both were within the bioequivalence limit of 0.80-1.25. The mean of $T_{max}$ in $Tenormin^{\circledR}$ group was 3.1 hour, and that in Ditent$^{\circledR}$ group was 3.2 hour. The values of $t_{1/2}$ between the two products were found comparable, and the mean values were 5.2 hour in the both products. Based on these results, it was concluded that $Ditent^{\circledR}$ was comparable to $Tenormin^{\circledR}$ in both the rate and extent of absorption, indicating that $Ditent^{\circledR}$ was bioequivalent to the reference product, $Tenormin^{\circledR}$.

• Fibers and Polymers
• /
• v.7 no.4
• /
• pp.398-403
• /
• 2006

Dimensional constants (k values) of single jersey fabrics made from $LincLITE^{(R)}$ and conventional yams are calculated under dry, steam, full relaxation treatments. Fabrics were made under different tightness factors such as high, medium and low with different twist factors, twist directions and feeder blending. $LincLITE^{(R)}$ yarns made to get soft and bulkier effects with yam count of 39 tex and conventional yams made into 39 tex and 48 tex yam counts. Various effects on K values are analysed using correlation coefficients. K-values are increased with relaxation progression and have shown some differences between in $LincLITE^{(R)}$ and conventional fabrics, and feeder blended fabrics. Loop shape factor is highly affected by tightness factor, relaxation and feeder blending in $LincLITE^{(R)}$ fabrics, whereas twist factor not significantly effects on loop shape factor in conventional fabrics. Stitch density significantly increases with relaxation in conventional fabrics and no significant effect shows with $LincLITE^{(R)}$ fabrics.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2009.10a
• /
• pp.277-280
• /
• 2009

This paper deals with the performance evaluation of Barlat's and BBC yield criteria by the directional variation prediction of the yield stresses and the R-values. for the evaluation of yield criteria, three kinds of Aluminum alloys and two kinds of steels were selected and their material properties are from Stoughton and Yoon's work. The experimental data required for the parameter evaluation included the uniaxial yield stresses and R-values (width-to-thickness strain ratio in uniaxial tension) measured in rolling direction, diaganol direction and the transverse direction, the equibiaxial yield stress and the R-value of equibiaxial tension. The optimization method, the Downhill Simplex method, was selected for the coefficient identification of Barlat91, Barlat97 and Barlat2000 yield criteria. Yield surface shapes, yield stress and R-value directionalities of Barlat's and BBC yield criteria were investigated and compared with the experimental data. Barlat2000 and BBC yield criteria were extremely qualified for the shape of the yield surface and the directionality of the yield stresses and the R-values.