• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.9
• /
• pp.1364-1372
• /
• 2017

In this paper, a problem of event-triggered model predictive control is investigated for continuous-time Takagi-Sugeno (T-S) fuzzy systems with input quantization. To efficiently utilize network resources, event-trigger is employed, which transmits limited signals satisfying the condition that the measurement of errors is over the ratio of a certain level. Considering sampling and quantization, continuous Takagi-Sugeno (T-S) fuzzy systems are regarded as a sector bounded continuous-time T-S fuzzy systems with input delay. Then, a model predictive controller (MPC) based on parallel distributed compensation (PDC) is designed to optimally stabilize the closed loop systems. The proposed MPC optimize the objective function over infinite horizon, which can be easily calculated and implemented solving linear matrix inequalities (LMIs) for every event-triggered time. The validity and effectiveness are shown that the event triggered MPC can stabilize well the systems with even smaller average sampling rate and limited actuator signal guaranteeing optimal performances through the numerical example.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.11a
• /
• pp.57-60
• /
• 2004

This paper presents multibit Sigma-Delta ADC using Leslie-Singh Structure to Improve nonlinearity of feedback loop. 4-bit flash ADC for multibit Quantization in Sigma Delta modulator offers the following advantages such as lower quantization noise, more accurate white-noise level and more stability over single quantization. For the feedback paths consisting of DAC, the DAC element should have a high matching requirement in order to maintain the linearity performance which can be obtained by the modulator with a multibit quantizer. Thus a Sigma-Delta ADC usually adds the dynamic element matching digital circuit within feedback loop. It occurs complexity of Sigma-Delta Circuit and increase of power dissipation. In this paper using the Leslie-Singh Structure for improving nonliearity of ADC. This structure operate at low oversampling ratio but is difficult to achieve high resolution. So in this paper propose improving loop filter for single-bit feedback multi-bit quantization Sigma-Delta ADC. It obtained 94.3dB signal to noise ratio over 615kHz bandwidth, and 62mW power dissipation at a sampling frequency of 19.6MHz. This Sigma Delta ADC is fabricated in 0.25um CMOS technology with 2.5V supply voltage.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.5
• /
• pp.822-832
• /
• 1994

DSC-HDTV image compression algorithm removes spatial, temporal, and amplitude redundancies of an image by using transform coding, motion-compensated predictive coding, and adaptive quantization, respectively. In this paper, leak processing method which is used to recover image quality quickly from scene change and transmission error and adaptive quantization using perceptual weighting factor obtained by HVS are proposed. Perceptual weighting factor is calculated by contrast sensitivity, spatio-temporal masking and frequency sensitivity. Adaptive quantization uses the perceptual weighting factor and global distortion level from buffer history state. Redundant bits according to adaptation of HVS are used for the next image coding. In the case of scene change, DFD using motion compensated predictive coding has high value, large bit rate and unstabilized buffer states since reconstructed image has large quantization noise. Thus, leak factor is set to 0 for scene change frame and leak factor to 15/16 for next frame, and global distortion level is calculated by using standard deviation. Experimental results show that image quality of the proposed method is recovered after several frames and then buffer status is stabilized.

• Investigative Magnetic Resonance Imaging
• /
• v.8 no.1
• /
• pp.42-49
• /
• 2004

Purpose : The quantization noise in magnetic resonance imaging (MRI) systems is analyzed. The signal-to-quantization noise ratio (SQNR) in the reconstructed image is derived from the level of quantization in the signal in spatial frequency domain. Based on the derived formula, the SQNRs in various main magnetic fields with different receiver systems are evaluated. From the evaluation, the quantization noise could be a major noise source determining overall system signal-to-noise ratio (SNR) in high field MRI system. A few methods to reduce the quantization noise are suggested. Materials and methods : In Fourier imaging methods, spin density distribution is encoded by phase and frequency encoding gradients in such a way that it becomes a distribution in the spatial frequency domain. Thus the quantization noise in the spatial frequency domain is expressed in terms of the SQNR in the reconstructed image. The validity of the derived formula is confirmed by experiments and computer simulation. Results : Using the derived formula, the SQNRs in various main magnetic fields with various receiver systems are evaluated. Since the quantization noise is proportional to the signal amplitude, yet it cannot be reduced by simple signal averaging, it could be a serious problem in high field imaging. In many receiver systems employing analog-to-digital converters (ADC) of 16 bits/sample, the quantization noise could be a major noise source limiting overall system SNR, especially in a high field imaging. Conclusion : The field strength of MRI system keeps going higher for functional imaging and spectroscopy. In high field MRI system, signal amplitude becomes larger with more susceptibility effect and wider spectral separation. Since the quantization noise is proportional to the signal amplitude, if the conversion bits of the ADCs in the receiver system are not large enough, the increase of signal amplitude may not be fully utilized for the SNR enhancement due to the increase of the quantization noise. Evaluation of the SQNR for various systems using the formula shows that the quantization noise could be a major noise source limiting overall system SNR, especially in three dimensional imaging in a high field imaging. Oversampling and off-center sampling would be an alternative solution to reduce the quantization noise without replacement of the receiver system.

• Proceedings of the IEEK Conference
• /
• 2003.11a
• /
• pp.461-464
• /
• 2003

This paper proposes the multi-level vector error diffusion for smear artifact reduction in the boundary regions. Smear artifact mainly results from a large accumulation of quantization error. Accordingly, to reduce these artifacts, the proposed method excludes the large quantization error in the error diffusion process by comparing the magnitude of the error vector with predetermined first threshold. In addition, if the vector norm of the difference between the error adjusted input vector and the primary co]or that has minimum vector norm for the error adjusted input vector is larger than second threshold, the error is excluded. As a result, the proposed method reduce smear artifact in the boundary region and produces visually pleasing halftone pattern.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.31B no.9
• /
• pp.124-132
• /
• 1994

An image data compression method for a digital VCR must satisfy special requirements such as high speed playback. various edting capabilities and error concealment to provide immunity to tape dropouts. Taking these requirements requirements into consideration, this paper proposes a new interframe subband coding algorithm for a digital VCR. In the proposed method, continuous input images are fist partitioned into four frequency bands. The lowest frequency subband is coded with 3-D block adaptive quantization that removes the level redundancy within each level. The other higher frequency subbands are coded by an intraframe coding method using the property of the human visual system. To keep reasonable image quality in high speed palyback, a segment forming method in the frequency domaing is also proposed Computer simulation results demonstrate that the proposed algorithm has the potential of achieving virtually lossless compression in normal play and produces an image with less mosaic errors in high speed play.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.16 no.5 s.110
• /
• pp.495-502
• /
• 2006

A fault diagnosis method is developed in this study using automaton through quantization of vibration signals for normal and faulty conditions, respectively. Automaton is a kind of qualitative model which describes the system behaviour at the level of abstraction. The system behavior was extracted from the probability of the output sequence of vibration signals. The sequence was made as vibration levels by reconstructing the originally measured vibration signals. As an example, a fault diagnosis for the bearing of ATM machine was done, which detected the bearing fault with confident level compared to any other existing methods of kurtosis or spectrum analysis.

• 한국초전도학회:학술대회논문집
• /
• 2009.07a
• /
• pp.57-57
• /
• 2009

• Journal of Korea Multimedia Society
• /
• v.7 no.9
• /
• pp.1246-1254
• /
• 2004

This paper presents a image coding method that is well adaptive to close-range video transmission because of its low titrate and simple coding procedure. At first, it reduces temporal redundancies by performing image DPCM between previous frame and current frame, and makes wavelet transformed image of this difference image. Then, the coefficients are quantized selectively by using the coefficient values of base level and mid-frequency level because inter-level redundancies are widely exists in multi-resolution images. Finally quantized coefficients are made iron the function that implies the target bitrate, the average coefficient energy, and the value of the level. The proposed method shows the effective Performance in the experiments using the continuous motion images and transition images.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.9
• /
• pp.63-69
• /
• 1998

In this paper, we propose a new Bit-Rate control algorithm based on bit usage matching to substitute encoded GOP(s) for new GOP(s) in MPEG-2 bitstream. It iteratively encodes current picture according to quantization value of previous picture and records bit-usage of each slice until nearly target bits are used. With target bits falling in two output bits, quantization value of slice should be changed to alleviate output bit error. We use recorded bit-usage information to decide which slices should be encoded with one quantization value and others with another. As every macroblock has different activity, we change macroblock quantization value using slice quantization value and activity value. The simulation results demonstrate that the fluctuation of the output bits can be kept within few-several tens of bits while maintaining the quality of the reconstructed pictures at a relatively stable level.