• 제어로봇시스템학회:학술대회논문집
• /
• 2004.08a
• /
• pp.772-776
• /
• 2004

This paper proposes an interference avoidance approach for Constraint-Based Routing (CBR) algorithm in the Multi-Protocol Label Switching (MPLS) network. The MPLS network itself has a capability of integrating among any layer-3 protocols and any layer-2 protocols of the OSI model. It is based on the label switching technology, which is fast and flexible switching technique using pre-defined Label Switching Paths (LSPs). The MPLS network is a solution for the Traffic Engineering(TE), Quality of Service (QoS), Virtual Private Network (VPN), and Constraint-Based Routing (CBR) issues. According to the MPLS CBR, routing performance requirements are capability for on-line routing, high network throughput, high network utilization, high network scalability, fast rerouting performance, low percentage of call-setup request blocking, and low calculation complexity. There are many previously proposed algorithms such as minimum hop (MH) algorithm, widest shortest path (WSP) algorithm, and minimum interference routing algorithm (MIRA). The MIRA algorithm is currently seemed to be the best solution for the MPLS routing problem in case of selecting a path with minimum interference level. It achieves lower call-setup request blocking, lower interference level, higher network utilization and higher network throughput. However, it suffers from routing calculation complexity which makes it difficult to real task implementation. In this paper, there are three objectives for routing algorithm design, which are minimizing interference levels with other source-destination node pairs, minimizing resource usage by selecting a minimum hop path first, and reducing calculation complexity. The proposed CBR algorithm is based on power factor calculation of total amount of possible path per link and the residual bandwidth in the network. A path with high power factor should be considered as minimum interference path and should be selected for path setup. With the proposed algorithm, all of the three objectives are attained and the approach of selection of a high power factor path could minimize interference level among all source-destination node pairs. The approach of selection of a shortest path from many equal power factor paths approach could minimize the usage of network resource. Then the network has higher resource reservation for future call-setup request. Moreover, the calculation of possible path per link (or interference level indicator) is run only whenever the network topology has been changed. Hence, this approach could reduce routing calculation complexity. The simulation results show that the proposed algorithm has good performance over high network utilization, low call-setup blocking percentage and low routing computation complexity.

• Journal of the Korean Society for Railway
• /
• v.20 no.1
• /
• pp.20-30
• /
• 2017

Due to the evolution of wireless communications technology, Long Term Evolution (LTE), which is a $4^{th}$ generation mobile communications system, has been adopted as a railway communications system. This LTE Railway (LTE-R) system is composed of various elemental functions, which are largely categorized into public safety and wireless communications for train control. Research on the public safety functions of railway communications have their roots in TRS based national public safety communication systems, and research on wireless communications functions for train control have their roots GSM-R, which is utilized by the ETCS in Europe. Based on these circumstances, this paper first analyzes the requirements for developing public safety technology in LTE-R, and compares those requirements with the functions of public safety LTE (PS-LTE), which is being deployed for the first time in the world by the South Korean government. Based on an analysis of the common and specific functions of LTE-R and PS-LTE, we conclude that there is little problem in integrating LTE-R and PS-LTE from the perspective of functionality. Second, this paper provides a comparison of the LTE-R requirements for the Quality of Service (QoS) with those of GSM-R utilized by the ETCS. This offers a guideline to allow LTE-R to be applied to a 500km/h train control system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.1
• /
• pp.68-78
• /
• 2013

In this paper, we propose an early spectrum sensing(ESS) as an advance preparation for radio-access trial, which enables multi-mode terminals to access the most appropriate radio-access system in a cloud-conceptual base station system where multiple radio access technologies(RATs) coexist. Prior to a random access to one of RATs, a multi-mode terminal conducts a spectrum sensing over entire frequency bands of whole RATs, then select the RAT with the lowest sensing power, that is likely to have the most available spectrum. Thus, an access failure caused by that the selected RAT has no available radio spectrum could be avoidable in advance. In computer simulation, we consider as various RATs as possible. First, circuit and packet systems are taken into consideration. In addition, the packet systems are classified according to the feasibility of carrier aggregation(CA). In case of terminal, three modes are considered with circuit-only, packet-only, and multi-mode. Subsequently, packet traffic is classified into real-time and non-real-time traffic with three different tolerable delay levels. The simulation includes a call process starting with a call generation and ending up with a resource allocation reflecting individual user's QoS requirements and evaluates the proposed scheme in terms of the successful access probability, system access time, system balancing factor and packet loss probability.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.1
• /
• pp.12-22
• /
• 2000

This paper presents the window-based permit distribution scheme for efficient medium access control to support multiclass traffic in APON(ATM over passive optical network). The proposed MAC protocol considers the characteristics of QoS(Quality of Service) for various traffic classes. A periodic RAU(request access unit) in upstream direction, includes dedicative request fields for each traffic category within the request slot. The transmission of upstream cell is permitted by the proposed window-based spacing scheme which distributes the requested traffic into several segments in the unit of one spacing window. The delay sensitive traffic source such as CBR or VBR with the stringent requirements on CDV and delay, is allocated prior to any other class. In order to reduce the CDV, so that the permit arrival rate close to the cell arrival rate, Running-Window algorithm is applied to permit distribution processing for these classes. The ABR traffic, which has not-strict CDV or delay criteria, is allocated flexibly to the residual bandwidth in FIFO manner. UBR traffic is allocated with the lowest priority for the remaining capacity. The performance of proposed protocol is evaluated in terms of transfer delay and 1-point CDV according to various offered load. The simulation results show that our protocol has the prominent improvement on CDV and delay performance with compared to the previous protocol.

• The KIPS Transactions:PartC
• /
• v.9C no.1
• /
• pp.73-78
• /
• 2002

In WATM networks, in order to perform dynamic slot allocation required slots of mobile terminals are estimated based on DP (Dynamic Parameter) reflecting characteristics of traffic. In VBR (Variable Bit Rate) traffic, slot allocation is done at MT considering both time-dependent characteristics and QoS (Quality of Service) requirements. In this paper, DPs-buffer state information and buffer state change-are transmitted through in-band signaling. BS (Base Station) performs dynamic slot allocation considering traffic characteristics of each MT (Mobile Terminal), in other words, buffer state information informs the potentiality of 'buffer full state'to BS if MT buffer is over the specific threshold value and buffer state change notifies change in buffer state of incoming cells to MT. If buffer state information is equal to 'low (more than threshold)' and 'abrupt increase' it generates 'buffer full' state cell transmission delay or cell loss might occur. At this time BS should assign additional slots to MT, and then MT consumes cells in its buffer. In simulation, the proposed scheme shows better performance in cell delay and loss than EPSA (Estimation-Prorated Slot Assignment) in-band scheme.

• Journal of Internet Computing and Services
• /
• v.10 no.1
• /
• pp.123-134
• /
• 2009

The CRM(Customer Relationship Management) is a business strategy model which can reap higher profits and can provide a competitive edge to an enterprise in today's new business environments. Early next year (2009), the Capital Market Consolidation Act will be in effect in South Korea. This is required for a qualitative growth to provide QoS (Quality of Service) and ensure growth in finance, IT industry & service. Accordingly, the securities and insurance companies, banks and other financial institutions make efforts to improve their derivative financial product and also enhance their services. In this paper we design and implement a Channel Server model for a Scalable Service Channel Server to efficiently manage the high volumes of inbound customer interactions based on the requirements of a CRM center. The proposed Scalable Service Channel Server supports integration with other third party service and standardization of multiple inbound service channels. The proposed model can be efficiently used in an inbound CRM center of any banking, finance, securities and insurance establishments.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.10
• /
• pp.83-98
• /
• 2007

The handover between different radio access networks, especially where their coverage overlaps, suffers various complications since the different access networks provide different service characteristics. One way to reduce service interruptions and QoS (i.e., bandwidth, throughput, delay) degradations during the inter-technology handover is to reserve the required resource in advance. The resource reservation algorithm should minimize the handover latency and maximize the resource utilization based on the accurate estimation on mobile's location, velocity, movement pattern and service requirements. In this paper, we propose a resource reservation algorithm based on the mobile terminal velocity and the cell selection probability, which maximizes resource utilization ana reduces network overhead. We compare the proposed algorithm with PMS(Predictive Mobility Support) and VCDS(Velocity and Call Duration Support scheme) based on 3-layer network model under various scenarios.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.8B
• /
• pp.613-619
• /
• 2012

The Long Term Evolution (LTE) system is already able to provide a background of variety services for mobile users with multimedia services such as audio, video, and data. In fact, the High Speed Packet Access plus (HSPA+) solution can greatly enhance bit rates on down-link. However, the supporting for multimedia applications with different QoS (Quality of Service) requirements is not devised yet. Hence, in this paper we propose an effective packet scheduling algorithm based on Proportional Fairness (PF) scheduling algorithms for the LTE. In this proposed packet scheduling scheme, we optimized instantaneous user data rates and the traffic class weight which prioritize user's packets. Finally, we evaluated and showed the performance of the proposed scheduling algorithm through simulations of multimedia traffics being transmitted to users over LTE links in a multi-cell environment.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2008.11a
• /
• pp.1332-1335
• /
• 2008

In order to various service types of real time and non-real time traffic with varying requirements are transmitted over the IEEE 802.16 standard is expected to provide quality of service(QoS) researchers have explored to provide a queue management scheme with differentiated loss guarantees for the future Internet. The sides of a packet drop rate, an each class to differential drop probability on achieving a low delay and high traffic intensity. Improved a queue management scheme to be enhanced to offer a drop probability is desired necessarily. This paper considers multiple random early detection with differential drop probability which is a slightly modified version of the Multiple-RED(Random Early Detection) model, to get the performance of the best suited, we analyzes its main control parameters (max_th, min_th, max_p) for achieving the proportional loss differentiation (PLD) model, and gives their setting guidance from the analytic approach. we propose Dynamic-multiple queue management scheme based on differential drop probability, called Dynamic-VQSDDP(Variable Queue State Differential Drop Probability)T, is proposed to overcome M-RED's shortcoming as well as supports static max_p parameter setting values for relative and each class proportional loss differentiation. M-RED is static according to the situation of the network traffic, Network environment is very dynamic situation. Therefore max_p parameter values needs to modify too to the constantly and dynamic. The verification of the guidance is shown with figuring out loss probability using a proposed algorithm under dynamic offered load and is also selection problem of optimal values of parameters for high traffic intensity and show that Dynamic-VQSDDP has the better performance in terms of packet drop rate. We also demonstrated using an ns-2 network simulation.

• The KIPS Transactions:PartA
• /
• v.9A no.2
• /
• pp.181-190
• /
• 2002

IEEE1394 is a de facto standard for the home network interfaces of digital multimedia home devices including digital A/V systems, digital camcorders, and PCs. Recently, it has been used in applications to guarantee the real-time characteristics such as home automation system and IICP (Instrument and Industrial Control Protocol). In order to guarantee real-time requirements in these IEEE1394-based real-time applications, this thesis proposes the software architecture of an IEEE1394 based home network that supports the guarantee for service's react-time characteristics. The proposed architecture has a real-time IEEE1394 device driver and event service architecture for guarantee real-time characteristics. The real-time device driver supports priority-based queueing of packets and mechanism to reduce the interrupt latency time in ISR. The event service architecture supports a real-time events delivery based on home network service using real-time event channel. This architecture can accommodate the real-time requirements of various applications and services such as digital multimedia services with QoS guarantees. home automation system required real-tine characteristics.