• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.5B
• /
• pp.508-519
• /
• 2004

This paper proposed two multi-path constraint-based routing algorithms for Internet traffic engineering using MPLS. In normal constraint-based shortest path first (CSPF) routing algorithm, there is a high probability that it cannot find the required path through networks for a large bandwidth constraint that is one of the most important constraints for traffic engineering, The proposed algorithms can divide the bandwidth constraint into two or more sub-constraints and find a constrained path for each sub-constraint, if there is no single path satisfying the whole constraint. Extensive simulations show that they enhance the success probability of path setup and the utilization of network resources.

• Proceedings of the KIEE Conference
• /
• 2004.11c
• /
• pp.225-227
• /
• 2004

A sensor networkis composed of a large number of sensor nodes, which are densely deployed either inside the phenomenon or very close to it. One of the most important constraints on sensor nodes is the low power consumption requirement. Sensor nodes carry limited, generally irreplaceable, power sources. Therefore, while traditional networks aim to achieve high quality of service (QoS) provisions, sensor network protocols must focus primarily on power conservation. This paper presents the characteristics of energy consuming, average delay in 802.11 MAC, S-MAC that is specifically designed for wireless sensor networks. We analyze the energy consuming state in the 802.11 MAC in the simulation topology nodes, and measure average delay in 802.11 and S-MAC. Energy efficiency is the primary goal in this protocol design. 802.11 MAC is more efficient than S-MAC in the average delay, throughput. However S-MAC is an energy efficient protocol, a tradeoff between energy efficiency and delay.

• Proceedings of the Korean Society of Computer Information Conference
• /
• 2018.07a
• /
• pp.123-126
• /
• 2018

자율 주행 자동차는 다수의 센서와 ECU 등으로 구성된 분산 시스템이다. 이 시스템은 다양한 시간적 제약사항들을 갖는 자율주행 응용들을 구동하며 각 응용들에 대한 시간적 제약사항 위반을 탐지해야한다. 이러한 분산 시스템에서 응용들 간의 통신을 위해 사용되는 미들웨어들 중 대표적인 것은 DDS이다. DDS는 높은 확장성을 지원하는 발행-구독 통신 모델을 기반으로 하며, 실시간성을 고려한 다양한 QoS 정책들을 제공한다. 하지만 DDS는 자율주행 응용이 요구하는 시간적 제약사항들 중 deadline과 correlation 제약 사항에 대한 위반 여부를 탐지하지 못한다. 본 논문은 DDS 기반 시스템에서 deadline과 correlation 제약 사항 위반 여부를 런타임에서 탐지하는 기법을 제안한다. 본 연구진은 제안된 기법을 DDS의 구현들 중 하나인 Vortex 사의 OpenSplice 기반 시스템에 구현하였다. 실험을 통해 검증한 결과, deadline과 correlation 제약 사항에 대한 위반 여부를 적은 오버헤드와 함께 성공적으로 탐지하였다.

• Annual Conference of KIPS
• /
• 2012.11a
• /
• pp.42-45
• /
• 2012

A network processor (NP) is an application-specific instruction-set processor for fast and efficient packet processing. There are many issues in compiler's code generation and optimization due to NP's hardware constraints and special hardware support. In this paper, we describe in detail how to resolve the issues. Our compiler was developed on LLVM 3.0 and the NP target was our in-house network processor which consists of 32 64-bit RISC processors and supports multi-context with special hardware structures. Our compiler incurs only 9.36% code size overhead over hand-written code while satisfying QoS, and the generated code was tested on a real packet processing hardware, called S20 for code verification and performance evaluation.

• Proceedings of the IEEK Conference
• /
• 2000.07a
• /
• pp.27-30
• /
• 2000

In this paper, we propose a new dynamic bandwidth allocation and call admission control method for the VBR video sources with QoS constraints to provide user's quality of service requirements and at the same time to achieve an efficient resource management in networks. The proposed mechanism dynamically adjusts the necessary bandwidth by the networks based on the provided quality of service satisfaction degree of each connection in respect to the user's requirements in terms of loss ratio and average delay Simulation results show that our proposed dynamic method is able to provide the desired level of quality of service and high utilization.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.6 no.10
• /
• pp.2455-2472
• /
• 2012

Although underlay spectrum sharing has been shown as a promising technique to promote the spectrum utilization in cognitive radio networks (CRNs), it may suffer bad secondary performance due to the strict power constraints imposed at secondary systems and the interference from primary systems. In this paper, we propose a two-phase based cooperative transmission protocol with the interference cancellation (IC) and best-relay selection to improve the secondary performance in underlay models under stringent power constraints while ensuring the primary quality-of-service (QoS). In the proposed protocol, IC is employed at both the secondary relays and the secondary destination, where the IC-based best-relay selection and cooperative relaying schemes are well developed to reduce the interference from primary systems. The closed-form expression of secondary outage probability is derived for the proposed protocol over Rayleigh fading channels. Simulation results show that, with a guaranteed primary outage probability, the proposed protocol can achieve not only lower secondary outage probability but also higher secondary diversity order than the traditional underlay case.

• Journal of Satellite, Information and Communications
• /
• v.12 no.2
• /
• pp.51-55
• /
• 2017

This paper aims to maximize the energy harvesting rate and channel capacity in RF-energy harvesting networks (RF-EHNs) under the constraints of maximum transmit power and minimum quality of service (QoS) in terms of rate capacity for each user. We study a multi-user RF-EHN with frequency division multiple access (FDMA) in a Rayleigh channel. An access point (AP) simultaneously transmitting wireless information and power in the RF-EHN serves a subset of active users which have a power-splitting antenna. To gauge the network performance, we define energy efficiency (EE) and propose an optimization solution for maximizing EE with Lagrangian dual decomposition theory. In simulation results, we confirm that the EE is effectively maximized by the proposed solution with satisfying the given constraints.

• Journal of information and communication convergence engineering
• /
• v.17 no.2
• /
• pp.105-116
• /
• 2019

Recently, there has been an increase in research on wireless sensor networks (WSNs) because they are easy to deploy in applications such as internet-of-things (IoT) and body area networks. However, WSNs have constraints in terms of power, quality-of-service (QoS), computation, and others. To overcome the power constraint issues, wireless energy harvesting has been introduced into WSNs, the application of which has been the focus of many studies. Additionally, to improve system performance in terms of achievable rate, cooperative networks are also being explored in WSNs. We present a review on current research in the area of energy harvesting in WSNs, specifically on the application of simultaneous wireless information and power transfer (SWIPT) in a cooperative sensor network. In addition, we discuss possible future extensions of SWIPT and cooperative networks in WSNs.

• Journal of KIISE:Software and Applications
• /
• v.37 no.5
• /
• pp.341-353
• /
• 2010

Mobile Internet Device (MID) allows users to flexibly use various forms of wireless internet such as Wi-Fi, GSM, CDMA, and 3G. Using such Internet, MID users can utilize application services. MID usage is expected to grow due to the benefits of portability, Internet accessibility, and other convenience. However, it has resource constraints such as limited CPU power, small memory size, limited battery life, and small screen size. Consequently, MIDs are not capable to hold large-sized complex applications and to process a large amount of data in memory. An effective solution to remedy these limitations is to develop cloud services for the required application functionality, to deploy them on the server side, and to let MID users access the services through internet. A major concern on running cloud services for MIDs is the potential problems with low Quality of Service (QoS) due to the characteristics of MIDs. Even measuring the QoS of such services is more technically challenging than conventional quality measurements. In this paper, we first identify the characteristics of MIDs and cloud services for MIDs. Based on these observations, we derive a number of quality attributes and their metrics for measuring QoS of mobile services. A case study of applying the proposed quality model is presented to show its effectiveness and applicability.

• The Journal of the Korea Contents Association
• /
• v.8 no.9
• /
• pp.42-54
• /
• 2008

In recent years, embedded systems have been expanding their application domains from traditional embedded systems such as military weapons, robots, satellites and digital convergence systems such as celluar phones, PMP(Portable Multimedia Player), PDAs(Personal Digital Assistants) to Next Generation Personal Computers(NGPCs) such as eating PCs, wearable computers. The NGPCs are network-based, human-centric digital information devices diverged from the traditional PCs used mainly for document writing, internet searching and database management. Wearable computers with battery capacity and memory size limitations have to use real-time operating systems with small footprints and low power management techniques to provide user's QoS in spite of hardware constraints. In this paper, we have designed and implemented a low-power RTOS (called eRTOS) for wearable computers. The implemented eRTOS has 18KB footprints and the dynamic power management and the device power management schemes are adapted in it. Experimental results with wearable computer applications show that the low power techniques could save energy up to 47 %.