• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 춘계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.278-280
• /
• 2006

In this paper, a novel type of auxiliary active snubbingcircuit assisted quasi-resonant soft-switching pulse width modulation inverter is proposed for consumer induction heating equipments. The operation principle of this high frequency inverter is described using switching modes and equivalent circuits. This newly developed series resonant high frequency inverter can regulate its high frequency output AC power under a principle of constant frequency active edge resonant soft- switching commutation by asymmetrical PWM control system. The high frequency power regulation and actual power conversion efficiency characteristics of consumer induction heating (IH) products using the proposed soft-switching pulse width modulation (PWM) series load resonant high frequency inverter evaluated. The practical effectiveness and operating performance of high frequency inverter are discussion on the basis of simulation and experimental results as compared with the conventional soft-switching high frequency inverter.

• 한국정보통신학회논문지
• /
• 제13권6호
• /
• pp.1117-1122
• /
• 2009

본 논문에서는 온도 센서 및 온도 측정을 위한 제어회로를 설계하였다. 설계된 회로는 기존의 방법들과는 달리 일반적인 CMOS(Complementary Metal Oxide Semiconductor) 공정에서 추가 공정없이 제작 가능하도록 설계하였으며, 온도는 디지털 값으로 출력 되도록 구성하였다. 설계되어진 회로는 5volts 공급전압을 사용하였으며, 0.5${\mu}m$ CMOS 공정을 사용하였다. 온도 측정을 위한 회로는 PWM(Pulse Width Modulation) 제어회로, VCO(Voltage controlled oscillator), 카운터 그리고 레지스터로 구성되어 있다. PWM 제어회로의 동작 주파수는 23kHz 이며, VCO의 동작 주파수는 416kHz, 1MHz, 2MHz를 사용하였다. 회로의 동작은 SPICE(Simulation Program with Integrated Circuit Emphasis)를 사용하여 확인 하였다.

• 전력전자학회논문지
• /
• 제26권2호
• /
• pp.120-126
• /
• 2021

DC-link capacitors are one of the main components in two-level three-phase voltage source inverters (VSIs); they provide the pulsating input current and stabilize the vacillating DC-link voltage. Ideally, the larger the capacitance of DC-link capacitors, the better the DC-link voltage stabilizes. However, high capacitance increases the cost and decreases the power density of VSI systems. Therefore, the capacitance should be chosen carefully on the basis of the DC-link voltage ripple requirement. However, the DC-link voltage ripple is dependent on the pulse-width modulation (PWM) strategy. This study especially presents a DC-link voltage ripple analysis when the minimum loss discontinuous PWM strategy is applied. Furthermore, an equation for the selection of the minimum capacitance of DC-link capacitors is proposed. Experimental results with R-L loads are also provided to verify the effectiveness of the presented analysis.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 1995년도 춘계학술대회 논문집
• /
• pp.283-288
• /
• 1995

Dynamic model of 3-way PWM high speed solenoid valve was derived considering reluctance and inductance of electromagnet through valve spool by Bondgraph modeling method. Computer simulations of hydraulic system with 3-wayhigh speed solenoid valve were performed and the results were compared to te experimental results in order to validate the PWM valve dynamic model obtained.

• Journal of Power Electronics
• /
• 제16권4호
• /
• pp.1407-1414
• /
• 2016

Unlike existing pulse-width modulation (PWM) techniques, such as sinusoidal PWM and random PWM, the wavelet PWM (WPWM) technique based on a Harr wavelet function can achieve a high fundamental component for the output voltage, low total harmonic distortion, and simple digital implementation. However, the original WPWM method lacks output voltage control. Thus, the practical application of the WPWM technique is limited. This study proposes an improved WPWM technique that can regulate output voltage amplitude with the addition of a parameter. The relationship between the additional parameter and the output voltage amplitude is analyzed in detail. Experimental results verify that the improved WPWM exhibits output voltage control in addition to all the merits of the WPWM technique.

• Journal of international Conference on Electrical Machines and Systems
• /
• 제1권2호
• /
• pp.64-69
• /
• 2012

This paper presents a hybrid pulse width modulation (PWM) method under low switching frequency conditions based on space vector PWM (SVPWM) and selective harmonic eliminated PWM (SHEPWM), which use asynchronous carrier modulation SVPWM at low frequency, and SHEPWM at high frequency, a square wave after rated conditions. A transitive strategy is proposed to realize a smooth transition of individual modes including SVPWM, SHEPWM and square waves. Experimental results confirm this hybrid modulation method and their transition are reasonable and proper.

• 한국컴퓨터정보학회논문지
• /
• 제14권2호
• /
• pp.157-168
• /
• 2009

본 논문에서는 태양광 발전시스템을 이용한 승압 초퍼와 전압형 PWM(Pulse Width Modulation) 인버터인 전력변환기로 구성하였고, 안정된 변조를 위해서 동기신호와 제어신호를 원칩 마이크로프로세서에 의해서 처리하였다. 전력비교에 따라 시간 비율을 변화시키지만 태양전지는 전형적인 수하특성을 갖고 있어, 일사량과 온도변화에 관계없이 항상 최대 출력점을 추적하도록 승압초퍼를 제어하였다. 또한 PWM 전압형 인버터는 태양전지가 연속 발전할 수 없는 단점을 보완하기 위해 일반 상용전원과 연계함으로써 약 $10{\sim}20[%]$ 전력절감효과를 얻을 수 있는 에너지절약 전원 복합형 전력변환장치로 구성하였다. 그리고 태양광 발전의 효율을 높이기 위하여 센서와 마이크로프로세서를 이용한 태양광위치추적 장치를 설계하여 고정방식의 태양광 발전에 대하여 비교해 보았다. 그 결과, 태양광 위치추적장치는 고정방식의 태양광 발전에 비해 5% 정도 개선됨을 알 수 있었다. 또한, PWM 전압형 인버터와 위상동기를 위해서 계통전압을 검출하여 계통전압과 인버터 출력을 동상 운전하므로 잉여전력을 계통과 연계할 수 있게 하였다. 그리고 고역율과 저고조파 출력을 유지함으로서 부하와 계통에 전력이 안정하게 공급될 수 있도록 제어하였다.

• ETRI Journal
• /
• 제33권5호
• /
• pp.679-688
• /
• 2011

A new discrete-amplitude pulse width modulation (DAPWM) scheme for a high-efficiency linear power amplifier is proposed. A radio frequency (RF) input signal is divided into an envelope and a phase modulated carrier. The low-frequency envelope is modulated so that it can be represented by a pulse whose area is proportional to its amplitude. The modulated pulse has at least two different pulse amplitude levels in order that the duty ratios of the pulse are kept large for small input. Then, an RF pulse train is generated by mixing the modulated envelope with the phase modulated carrier. The RF pulse train is amplified by a switching-mode power amplifier, and the original RF input signal is restored by a band pass filter. Because duty ratios of the RF pulse train are kept large in spite of a small input envelope, the DAPWM technique can reduce loss from harmonic components. Furthermore, it reduces filtering efforts required to suppress harmonic components. Simulations show that the overall efficiency of the pulsed power amplifier with DAPWM is about 60.3% for a mobile WiMax signal. This is approximately a 73% increase compared to a pulsed power amplifier with PWM.

• Journal of Power Electronics
• /
• 제9권5호
• /
• pp.667-678
• /
• 2009

The PWM (Pulse Width Modulation) control signals have a drawback in that their power spectrum tends to be concentrated around the switching frequency and the resulting harmonic spikes cause an EMI (Electromagnetic Interference) and switching losses in semiconductors, etc. The SDM (Sigma-Delta Modulation) is a type of switching modulation used to reduce these harmonic spikes, and several SDM schemes are investigated in this paper. In the DSDM (Dithered SDM), the SDSDM (Space-Dithered SDM) and TDSDM (Time-Dithered SDM), the signals are classified by the location of their random dither additions. In these schemes, the switching frequency is spread by a random dither generator placed on the input or the output parts. Experimental results are presented where the advantages of the new proposed CDSDM (Combined Dithered SDM) are confirmed by applying to a buck converter.

• Journal of Electrical Engineering and Technology
• /
• 제12권2호
• /
• pp.738-750
• /
• 2017

In this paper, carrier-based pulse width modulation (CBPWM), space vector PWM (SVPWM) and reduced switching losses PWM (RSLPWM) for the three-level neutral point clamped (NPC) inverter are introduced. In the case of the neutral point (NP) potential (NPP) offset, an asymmetric disposition PWM (ASPDPWM) strategy is proposed, which can output PWM sequences correctly and suppress the lower order harmonics of the inverter effectively. An NPP balance strategy based on carrier based PWM (CBPWM) is analyzed. A hybrid modulation strategy combining RSLPWM and the NPP balance based on CBPWM is proposed, and hysteresis control is adopted to switch between the two modulation strategies. An experimental prototype of the three-level NPC inverter is built. The effectiveness of the hybrid modulation is verified with a resistance-inductance load and a permanent magnetic synchronous motor (PMSM) load, respectively. The experimental results show that reduced switching losses and an acceptable NPP can be effectively achieved in the hybrid modulation strategy.