• Journal of Life Science
• /
• v.19 no.5
• /
• pp.566-572
• /
• 2009

A recombinant plasmid, pDH3, was obtained from the genomic library of Serattia marcescens KCTC 2172, and several recombinant subclones constructed from pDH3. The nucleotide sequence of a 5,137 bp segment, pPH4, was determined and three open reading frames were detected. The three ORFs encoded the phosphate specific transport (pst) operon, which was pstC, pstA, and pstB, with the same direction of transcription. Comparison of the pst operon of S. marcescens with that of other organisms revealed that the genes for pstS and phoU were missing. A potential CRP bonding site and pho box sequence was found in the upstream of the putative promoter at the regulatory region. Analysis of the nucleotide sequence showed that homology in amino acid sequences between the PstC protein and Yersinia sp., Vibrio sp., and Pseudomonas sp. were 49, 37 and 33%, respectively. The PstA protein and Yersinia sp., Vibrio sp., and Pseudomonas sp. showed homologies of 64, 51, and 47%, respectively. PstB protein and Methanocaldococcus sp., E. coli, and Mycoplasma sp. showed homologies of 60, 50, and 48%, respectively. The pst genes could be expressed in vivo and positively regulated by cAMP-CRP. The E. coli strain harboring plasmid pPH7, with pst genes, increased with the transport of phosphate.

• Proceedings of the KIEE Conference
• /
• 2006.10a
• /
• pp.115-116
• /
• 2006

Dielectric PST (20/80) / PST (80/20) heterolayered thin films structures were created by a consequent deposition of the PST (20/80) and PST (80/20) thin films on the $Pt/Ti/SiO_2/Si$ substrate using alkoxide-based sol-gel method. Both structural and dielectric properties of heterolayered PST thin films were investigated for the tunable microwave device applications. As the number of coating increases, the lattice distortion decreased. It can be assumed that the lower PST layer affects a nucleation site or a seeding layer for the formation of the upper PST layer. The dielectric constant, dielectric loss and tunability of the PST-6 heterolayered structure measured at 100 kHz were 399, 0.022 and 57.9%, respectively. All these parameters showed an increase with increasing number of coatings due to the decrease in lattice distortion.

• Journal of Veterinary Clinics
• /
• v.9 no.1
• /
• pp.333-366
• /
• 1992

Safety of recombinant porcine somatotropin administration on pig was studied using 32 Landrace x Yorkshire crossbred pigs. The starting body weight ranged from 55.5kg to 65.3kg. Eight pigs were allotted to each low dose group of sustained releasing rPST(SL), high dose group of sustained releasing rPST(SH), daily injection group of rPST(DI), and control group(C). Pigs in SL group and SH group were injected subcutaneously twice in 3 week-interval with 1000$\mu\textrm{g}$ and 2000$\mu\textrm{g}$ of sustained releasing rPST per kg body weight, respectively. Pigs in DI group were injected intramuscularly with 100$\mu\textrm{g}$ of rPST everyday for 6 weeks. Blood was collected from anterior vena cava just before the first treatment, and at four weeks and six weeks of experiment. Hematological parameters and blood chemical parameters indicating liver function, kidney function, electrolyte metabolism, mineral metabolism and lipid metabolism were determined. Necropsy and urinalysis were performed after final blood collection. The results were summarized as follows, and it is concluded that rPST administration does not affect pig health negatively. 1. rPST administration did not affect kidney function as manisfested by BUN, creatinine and urinalysis. 2. rPST administration did not affect liver function as manisfested by total protein, albumin, serum AST activity serum ALT activity serum ALP activity, serum LDH activity, serum GGT activity and serum SDH activity. 3. rPST administration did not affect skeletal muscle, cardiac muscle and brain as manifasted by serum AST activity and serum LDH activity. 4. rPST administration increased blood glucose level within normal range. 5. rPST administration did not affect lipid metabolism as manisfested by triglyceride, cholesterol, and phospholipid concentrati on. 6. rPst administration dia not affect mineral metabolism as manisfested by calcium, phosphorus, magnesium and iron concentration. 7. rPST administration did not affect electrolyte metabolism as manisfested by Na, K, chloride concentration. 8. rPST administration did not affect erythrocyte count, leukocyte count, thrombocyte count, and plasma fibrinogen level.

• Polymer(Korea)
• /
• v.30 no.3
• /
• pp.224-229
• /
• 2006

Quaternary ammonium salt terminated silane was prepared from aminopropyldimethylethoxysilane with methyliodide and ionized 7,7,8,8-tetracyanoquinodimethane $(Li^+TCNQ^-)$ was prepared from TCNQ with methyliodide and lithium iodide. Quaternary ammonium salt silane-TCNQ adduct (ST) was prepared by reacting quaternary ammonium salt terminated silane with $Li^+TCNQ^-$ solution. Poly (dimethylsiloxane)-ST adduct (PST) was prepared by condensation of $\alpha,\omega-hydroxyl$ group terminated poly (dimethylsiloxane) (PDMS) with ST. Maleated polyethylene modified with PDMS (PST-g-MPE) was prepared by melt polymerization of maleated PE and PST in internal mixer and PST-g-MPE/carbon black (CB) and MPE/CB composites were prepared by compounding PST with MPE and PST-g-MPE, respectively. The thermal and mechanical properties of the composites were measured and dispersion characteristics of CB in matrix rosins show that the dispersion of CB in PST-g-MPE/CB was better than that of MPE/CB composite.

• The Journal of the Korea Contents Association
• /
• v.22 no.8
• /
• pp.619-627
• /
• 2022

This study aims to examine significant changes in participants experiences by analyzing cases of PST applied with TCI, and to suggest that TCI and PST can be used to promote their psychology. To this end, an in-depth interview was conducted for a total of eight PST sessions for three months for one B-boying player competing in the national team selection and the world competition, and the time required for one session was about 60 minutes. The pre-post measurement results were analyzed by applying the case study A-B method. As a result of conducting PST, focusing on grasping the characteristics and psychological strengths and weaknesses of the player using the TCI results, it was found to improve the player's psychological skills and happiness, proving the effectiveness of PST. This is the first report that PST can be applied to the breaking field, and it is meaningful that TCI was applied to psychological technology.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.11a
• /
• pp.288-291
• /
• 2002

An alkoxide-based sol-gel method was used to fabricate $(Pb_{x},Sr_{1-x})$TiO3 (PST) thin films on a Pt/Ti/SiO2/Si substrate, and the dielectric properties of the PST thin films were investigated as a function of the Pb/Sr composition for use in tunable microwave device applications. The dielectric properties of the PST films were strongly dependent on the Pb/Sr ratio. The dielectric constant and dielectric loss of the PST films increased with increasing Pb content, and the figure of merit (FOM) reached a maximum value of 27.5 at a Pb/Sr ratio of 4:6. The tunability increased with increasing Pb content. The dielectric constant, loss factor, and tunability of PST (50/50) thin films were 404, 0.023, and 51.73%, respectively. From the result, the PST films with good dielectric properties are useful candidates for tunable microwave device.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.648-651
• /
• 2004

Pb0.5Sr0.5TiO3(PST) thin films were deposited on the LaNiO3 (LNO(100))/Si and Pt/Ti/SiO2/Si substrates by the alkoxide-based sol-gel method. Structural and dielectric properties of PST thin films for the tunable microwave device applications were investigated. The PST films, which were directly grown on the Pt/Ti/SiO2/Si substrates showed the random orientation. For the LNO/Si substrates, the PST thin films exhibited highly (100) orientation. Compared with randomly oriented films, the highly (100)-oriented PST thin films showed better dielectric constant, tunability, and figure of merit (FOM). The dielectric constant, tunability, and FOM of the highly (100)-oriented PST thin film increased with increasing annealing temperature due to the decrease in lattice distortion. The differences in dielectric properties may be attributed to the change in the film stress and the in-plane oriented Polar axis depending on the substrate was used. The dielectric constants, dielectric loss and tunability of the PST thin films deposited on the LNO/Si substrates measured at 1 MHz were 483, 0.002, and 60.1%, respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.582-585
• /
• 2004

Pb0.5Sr0.5TiO3 (PST) thin films were fabricated by the alkoxide-based sol-gel process using spin-coating method on Pt/Ti/SiO2/Si substrate. The PST films annealed from 500C to 650C for 1h show a perovskite phase and dense microstructure with a smooth surface. The grain size and dielectric constant of PST films increases with the increase in annealing temperature, which reduces the SiO2 equivalent thickness of the PST film. The crystallinity or internal strain in the PST thin films analyzed from the diffraction-peak widths correlate well with the decrease in the dielectric losses. The dielectric constants and dielectric loss (%) of the PST films annealed at 650c (teq : 0.89 nm) were 549 and 0.21%, respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.726-729
• /
• 2004

Etching characteristics of (Pb,Sr)$TiO_3$(PST) thin films were investigated using inductively coupled chlorine based plasma system as functions of gas mixing ratio, RF power and DC bias voltage. It was found that increasing of hi content in gas mixture lead to sufficient increasing of etch rate and selectivity of PST to Pt. The maximum etch rate of PST film is $562{\AA}/min$ and the selectivity of PST film to Pt is 0.8 at $Cl_2/(Cl_2+Ar)$ of 20 %. It was Proposed that sputter etching is dominant etching mechanism while the contribution of chemical reaction is relatively low due to low volatility of etching products.

• Research in Plant Disease
• /
• v.8 no.2
• /
• pp.92-100
• /
• 2002

For the survey of viruses infected in peanut cultivated in Korea, peanut seeds and leaves showing viral symptoms were collected from their growing areas. Typical symptoms on virus infected peanut leaves including mosaic, mottle with necrosis, yellowing, stripe or vein banding and stunts were observed. Two viruses isolated from the naturally infected peanuts were identified as Bean common mosaic virus(BCMV-PSt) and Peanut mottle virus(PeMoV) by their host range, immunosorbent elcetron microscopy(ISEM), direct immuno staining assay(DISA), RT-PCR, and intracellural symptoms. Direct negative staining method by electron microscope showed filamentous particles of about 780 m in length as well as inclusion bodies. In ultrathin sections of BCMV-PSt and PeMoV infected tissues, cytoplasmic cylindrical inclusions as well as filamentous virus particles were observed in the cytoplasm of parenchyma cells. ISEM revealed filamentous particles strongly decorated with antiserums of BCMV-PSt and PeMoV Peanut seeds were stained with BCMV-PSt and PeMoV antisera indicating the possibility of seed transmission far these viruses. Seedlings germinated from peanut seeds which reacted with antiserums of BCMV-PSt by DISA showed mild mottle or stripe symptoms while mosaic and necrotic mottle symptoms were observed for PeMoV-positive seedlings. Filamentous particles were strongly decorated with each antiserum under ISEM observation. BCMV-PSt coat protein gene of about 1.2 Kbp was amplified by RT-PCR. Altogether these results indicate that BCMV-PSt is the most prevalent virus infecting peanut in Korea.