• The KIPS Transactions:PartC
• /
• v.13C no.7 s.110
• /
• pp.803-812
• /
• 2006

This paper analytically evaluates the FEC(Forward Error Correction) symbol size's effect on the performance and energy consumption of 802.11 protocol with the block FEC algorithm over WSN(Wireless Sensor Network). Since the basic recovery unit of block FEC algorithms is symbols not bits, the FEC symbol size affects the packet correction rate even with the same amount of FEC check bits over a given WSN channel. Precisely, when the same amount of FEC check bits are allocated, the small-size symbols are effective over channels with frequent short bursts of propagation errors while the large ones are good at remedying the long rare bursts. To estimate the effect of the FEC symbol site, the paper at first models the WSN channel with Gilbert model based on real packet traces collected over TIP50CM sensor nodes and measures the energy consumed for encoding and decoding the RS (Reed-Solomon) code with various symbol sizes. Based on the WSN channel model and each RS code's energy expenditure, it analytically calculates the transmission efficiency and power consumption of 802.11 equipped with RS code. The computational analysis combined with real experimental data shows that the RS symbol size makes a difference of up to 4.2% in the transmission efficiency and 35% in energy consumption even with the same amount of FEC check bits.

• Korean Journal of Digital Imaging in Medicine
• /
• v.10 no.1
• /
• pp.45-50
• /
• 2008

Recently, MR Cholangiography used mainly bu controlling of patient's breathing. There is breathing hold techniques to get images within shopt time and gating technique adjusted to respiration cycle for high resolution image. In this study, the aim of this experiment is to know on clinical usefulness compared with PACE and RTG thchniques. This study's period is from 2006 in November to 2007 in January. A total of 21 patients investigated at MAGNETOM Sonata 1.5T (SIEMENS Erlangen) with use of 12ch body coil. MR acquisition protocol used 3D turbo spin echo coronal sequence. Scan parameters applied to potimal setting in use as gating techniques, respectively. Analysis of consuming timing evaluated with rapidness. As analysis of quantity, the common bile duct, gall bladder measured in signal intensities, then these data were calculated by signal to noise ratio and contrast to noise ratio. Qualitative analysis, experienced 2radiologists and 3 RTs were evaluated into 3groups about artifact, accuracy of lesions, sharpness of the common bile duct or gall bladder. As a result of analysis, when compared to PACE, consuming time of the RTG took less than PACE, On both CNRs and SNRs, PACE technique was slightly high values than RTG(p<0.05). Qualitative analysis' results, discrimination of lesions in the common bile duct, gall bladder get a significance level in both RTG and PACE techniques but presence's artifact of breathing and pulsation highly demonstrate in PACE techniques. In conclusion, both PACE and RTG methods at MRCP provided prominently clinical information for the common bile duct, gall bladder. If machines have not limitation with performance, induction of breathing holding also will help getting diagnistic quality.

• Journal of Broadcast Engineering
• /
• v.13 no.1
• /
• pp.6-16
• /
• 2008

An instable wireless channel condition causes more packet losses and retransmissions due to interference, fading, station mobility, and so on. Therefore video streaming service over a wireless networks is a challenging task because of the changes in the wireless channel conditions and time-constraints characteristics of the video streaming services. To provide efficient video streaming over a wireless networks, QoS-enhanced MAC protocol, IEEE 802.11e, is standardized recently. Tn this paper, we propose a new network-adaptive H.264 video streaming mechanism in the IEEE 802.11e wireless networks. To improve the quality of video streaming services, video stream has to adapt to the changes in the wireless channel conditions. The wireless channel conditions are estimated by the packet loss probability and informed to the application layer by the cross-layering. According to the wireless channel information, the video streaming application filters out the low-priority data. This adaptation mechanism efficiently uses system resources because it drops the low-priority data in advance. Therefore, our cross-layer design can provide improved video streaming services to the end-user. Through the implementation and performance evaluation, we prove that the proposed mechanism improves the QoS of the video streaming by providing the smoothed playback.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.11 no.5
• /
• pp.514-520
• /
• 2018

Presence service provides various information about users such as locations, status of on/offline and network access methods, and number of presence resources required by each users increases largely in mobile environment. Therefore an effective method which can reduce load of presence servers is needed. In this paper, a large scale distributed presence service system which can distribute effectively total presence system load of presence servers using message control session has been presented. This large scale distributed presence service system provides various presence information for massive volumes of users. In this study, a new message control session architecture which can dynamically distribute loads of the presence servers to multiple servers has been presented, and a new presence information data architecture for controlling load of the presence servers has been designed. In this architecture, each presence server can exchange current load level in real time to get variance of the total system load change according to user numbers, and can distribute system load to maintain load level of each server evenly. The performance of the proposed large scale distributed presence service system has been analysed by experiments. The results has been showed that average presence resource subscription processing time reduced from 42.6% to 73.6%, and average presence notification processing time reduced from 37.6% to 64.8%.

• 한국정보통신설비학회:학술대회논문집
• /
• 2008.08a
• /
• pp.211-217
• /
• 2008

Recently, there are many efforts to support seamless mobility in 802.11 WLANs using IP Layer mobility protocols. The IP layer mobility protocols are the most efficient mechanism to guarantee the service session continuity when IP subnet is changed during handover. Even if the IP layer mobility protocols are quite efficient, the feature of the protocols that had been designed to consider only L3 layer makes it difficult to improve the performance of hand over more and more. Nowadays, to overcome this limitation of IP mobility protocols, many researchers have worked on the mobility protocols integration of different layers (e.g., L2 layer). In this paper, we propose the enhanced Proxy MIPv4 to minimize the latency of handover using MIH protocol in 802.11 WLANs. The proposed mechanism minimizes the latency of authentication by exchanging security keys between Access Routers during handover. Moreover, it also minimizes packet losses by Inter-AP Tunneling and data forwarding.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.10
• /
• pp.2004-2010
• /
• 2009

The characteristic of the backbond for distribution service in WMNs(Wireless Mesh Networks) is that WMNs has multiple links connected to mesh points and dynamic routing protocol such as AODV to establish routing paths. When the terminal is communicating with the service through new AP, mobile nodes can resume communication by setting only the link between new AP and mobile node in the case of existing WLANs, but WMNs needs path establishment process in multihop networks. Our goal in this paper is to support the seamless communication service by eliminating path establishment delay in WMNs. We present the method that eliminates the handover latency by predicting the location of handover using GPS information and making the paths to their destination in advance. We implement mesh nodes using embedded board that contains proposed handover method and evaluate performance of handover latency. Our experiment shows that handover delay time is decreased from 2.47 to 0.05 seconds and data loss rate is decreased from 20~35% in the existing method to 0~10% level.

• Journal of KIISE:Information Networking
• /
• v.29 no.4
• /
• pp.375-385
• /
• 2002

The IETF has defined the Intserv model and the RSVP signaling protocol to improve QoS capability for a set of newly emerging services including voice and video streams that require high transmission bandwidth and low delay. However, since the current Intserv model requires each router to maintain the states of each service flow, the complexity and the overhead for processing packets in each rioter drastically increase as the size of the network increases, giving rise to the scalability problem. This motivates our work; namely, we investigate and devise new control schemes to enhance the scalability of the Intesev model. To do this, we basically resort to the SCORE network model, extend it to fairly well adapt to the three services presented in the Intserv model, and devise schemes of the QoS scheduling, the admission control, and the edge and core node architectures. We also carry out the computer simulation by using ns-2 simulator to examine the performance of the proposed scheme in respects of the bandwidth allocation capability, the packet delay, and the packet delay variation. The results show that the proposed scheme meets the QoS requirements of the respective three services of Intserv model, thus we conclude that the proposed scheme enhances the scalability, while keeping the efficiency of the current Intserv model.

• The KIPS Transactions:PartC
• /
• v.10C no.4
• /
• pp.433-440
• /
• 2003

According as the real economic activities are carried out in the cyber world and the identity problem of a trade counterpart emerges, digital signature has been diffused. Due to the weakness for real-time validation using the validation method of digital signature, Certificate Revocation List, On-line Certificate Status Protocol was introduced. In this case, every transaction workload requested to verify digital signature is concentrated of a validation server node. Currently this method has been utilized on domestic financial transactions, but sooner or later the limitation will be revealed. In this paper, the validation method will be introduced which not only it can guarantee real-time validation but also the requesting node of certificate validation can maintain real-time certificate status information. This method makes the revocation management node update the certificate status information in real-time to the validation node while revoking certificate. The characteristic of this method is that the revocation management node should memorize the validation nodes which a certificate holder uses. If a certificate holder connects a validation node for the first time, the validation node should request its certificate status information to the above revocation management node and the revocation management node memorizes the validation node at the time. After that, the revocation management node inform the revocation information in real-time to all the validation node registered when a request of revocation happens. The benefits of this method are the fact that we can reduce the validation time because the certificate validation can be completed at the validation node and that we can avoid the concentration of requesting certificate status information to a revocation node.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.1
• /
• pp.185-191
• /
• 2015

This paper suggest the safety class communication board in order to design the safety network of the nuclear safety class controller. The reactor protection system use the digitized networks because from analog system to digital system. The communication board shall be provided to pass the required performance and test of the safety class in the digital network used in the nuclear safety class. Communication protocol is composed of physical layer(PHY), data link layer(MAC: Medium Access Control), the application layer in the OSI 7 layer only. The data link layer data package for the cyber security has changed. CRC32 were used for data quality and the using one way communication, not requests and not responses for receiving data, does not affect the nuclear safety system. It has been designed in accordance with requirements, design, verification and procedure for the approving the nuclear safety class. For hardware verification such as electromagnetic test, aging test, inspection, burn-in test, seismic test and environmental test in was performed. FPGA firmware to verify compliance with the life-cycle of IEEE 1074 was performed by the component testing and integration testing.

• International Journal of Highway Engineering
• /
• v.11 no.4
• /
• pp.133-142
• /
• 2009

This research is performed to estimate quality of trial pavement for construction and analyze effect of fatigue life by using the pay factor. Specially, asphalt content which is difficult to control the pavement quality, is selected by pay adjustment standard factors and pay factor is calculated by asphalt content. This research is also analyzed to present relation of fatigue life according to asphalt content, to evaluate quality of the road pavement by calculating pay factor of sampling trial field mixture 2 times. This research confirms that it is different quality of road pavement according to pay factor changes. To analyze the fatigue life of pavement by using asphalt mixture for trial field. As a result, it is conformed that high pay factor could be high fatigue life of trial field. This means that pay factor using probability theory reflects road pavement fatigue life. Also, this study is included that beam fatigue test manufacturing specimen such as mixing type of plant which purvey asphalt mixture to trial field, compared with fatigue life of trial field. As a result, the fatigue life of specimen that is manufactured by mix type is higher than trial field specimen. This means that performance of road pavement can be reduced by gradation or other effects. Therefore, to exactly evaluate the quality of road pavement, pay factor should be calculated appling various pay adjustment standard factors such as gradation, air-void in U.S. states which is adopted pay adjustment.