• Journal of the Korean Institute of Gas
• /
• v.1 no.1
• /
• pp.113-119
• /
• 1997

The detection capability of UV flame detector in dust environment would be impaired. In this study, an experiment was conducted, in an effort to further understand the behavior of UV flame detector and to evaluate its detection capability in industry dust environment. Detergent powder, coal powder and dry extinguishing agent were selected as dust sources. Flaming sources include propane and gasoline flame. Experiment results indicate that dust can cause remarkable attenuation of UV flame radiation. The concentration of dust and the length of air layer where dust dispersed determine the reduction of radiation intensity. On the other hand, the attenuation of UV radiation also depends on the chemical and Physical properties of dust.

• Journal of the Korean Society of Combustion
• /
• v.7 no.3
• /
• pp.9-15
• /
• 2002

Soot generation by combustion process has been investigated with objective of understanding of chemical reaction responsible for its formation in a coaxial laminar propane jet diffusion flame. For the direct photos, as the coflowing air flow rate is reduced, the area of soot luminous zone increases at first, then becomes smaller and smaller, and even disappears. The aspects of soot deposition can be acquired by using nine $15{\mu}m$ thin SiC fibers are positioned horizontally across the flame. Deposited soots on SiC fibers show the soot inception point and growth and soot oxidation zone in a typical propane diffusion. Soot is not generated anymore in a oxidizer deficient conditions of near-extinction and flame is fully occupied by transparent blue flame. It suggests that nonsooting pyroligneous blue reaction is being dominant in a oxidizer deficient ambience. In comparison with luminosities of SiC fibers and flame itself, indirect evidence is found that the process of soot nucleation and growth is endothermic reaction. It is remarkable that there exists two adjacent regions to have antithesis characteristics; one is exothermic reaction of blue flame and another endothermic reaction zone of soot formation.

• 한국연소학회:학술대회논문집
• /
• 2000.05a
• /
• pp.9-15
• /
• 2000

Characteristics of lifted flames for highly diluted propane and methane with nitrogen in coflowing air is experimentally investigated. In case of propane, for various fuel mole fractions and jet velocities, three distinctive types of flames are observed; nozzle attached flames, stationary lifted flames, and oscillating lifted flames. When fuel jet velocity is much smaller than coflow velocity, the base of nozzle attached flame has a tribrachial structure unlike usual coflow difusion flames. Based on the balance mechanism of the propagation speed of tribrachial flame with flow velocity, jet velocity is scaled with stoichiometric laminar burning velocity. Results show that there exists two distinctive lifted flame stabilization; stabilization in the developing region and in the developed region of jets depending on initial fuel mole fraction. It has been found that lifted flame can be stabilized for fuel velocity even smaller than stoichiometric laminar burning velocity. This can be attributed to the buoyancy effect and flow visualization supports it. Lifted flames are also observed for methane diluted with nitrogen. The lifted flames only exist in the developing region of jet.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2009.05a
• /
• pp.247-250
• /
• 2009

The catalytic combustor has the advantage of stable combustion under very lean conditions with low emissions of $NO_x$, CO and unburned hydrocarbon(UHC). Notwithstanding these advantages, the commercial application of the catalytic combustion has been delayed due to the complicated reaction process. For the stable operation of catalytic combustor, study on the combustion characteristics of the catalytic combustor is needed. So, in this study, numerical study on the propane combustion characteristics of the catalytic combustor with Pd-based catalyst is performed.

• Journal of the Korean Society of Combustion
• /
• v.20 no.1
• /
• pp.43-51
• /
• 2015

A study on laminar jet flames in coflow air diluted with helium has been conducted to investigate self-excitations for various propane mole fractions and nozzle exit velocities. The stability map was represented as a function of nozzle exit velocity and fuel mole fraction for propane. The results show that two types of self-excitation were observed : (1) buoyancy-driven self-excitation (hereafter called BDSE) and (2) Lewis-number induced-self-excitation coupled with (1) (hereafter called LCB) near extinction limit for 9.4 mm nozzle diameter. It was shown that with 0.95 mm nozzle diameter, Lewis-number-induced self-excitation (hereafter LISE) and BDSE could be separated. The differences between the two self-excitations were shown and discussed.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.7 no.2
• /
• pp.249-265
• /
• 1995

The performance of a refrigerant mixture of propane(R290)/isobutane(R600a) as a substitute for CFC12 was investigated in a domestic refrigerator with single evaporator. A thermodynamic cycle simulation indicated an increase in COP of a 1.7 to 2.4% with R-290/600a in the composition range of 0.2 to 0.6 mass fraction of R290 compared to CFC12. For the tests, two units($299{\ell}$, $465{\ell}$) were used. All refrigeration components remained the same throughout the tests, except that the length of capillary tube and amount of charge were changed for the mixture. The refrigerators were fully instrumented with more than 20 thermocouples, 2 pressure transducers, and watt/watt-hour meter for each refrigerator. 'Energy consumption test' and 'no load pulldown test' were performed under the same condition. The experimental results obtained with the same compressor indicated that R-290/600a mixture at 0.6 mass fraction of R290 showed a 3 to 5% increase in energy efficiency and a faster cooling speed compared to CFC12. The R-290/600a mixture showed a shorter compressor on-time and a lower compressor dome temperature than CFC12. In conclusion, the proposed hydrocarbon mixture seems to be an appropriate candidate to replace CFC12 without causing more environmental problems.

• 한국연소학회:학술대회논문집
• /
• 2001.11a
• /
• pp.104-110
• /
• 2001

Characteristics of lifted flame for highly diluted propane with nitrogen in high temperature coflowing air have been experimentally investigated, and the stabilization mechanism of lifted flame in high temperature air coflow have been proposed. As the coflow temperature increases, the liftoff height of flame decreased due to the increase of stoichiometry laminar burning velocity. At same coflow temperature, the difference of liftoff height between the fuel mole fractions has been disappeared by scaling the liftoff velocity with stoichiometry laminar burning velocity. It has been found that lifted flame can be stabilized for even smaller fuel velocity than stoichiometry laminar burning velocity. This can be attributed to buoyancy effect and the liftoff velocity characteristics for coflow temperature support it.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.10 no.6
• /
• pp.683-694
• /
• 1998

The application of hydrocarbon refrigerants in a hermetic reciprocating compressor for refrigerator is investigated. The selected refrigerants are isobutane(R600a), propane(R290), R12, binary mixture of R600a/R290, and OS-21CII. Both theoretical and experimental investigations have been performed for the selected refrigerants. The test results of hydrocarbon refrigerants have been compared to the traditional refrigerant(R12). The results show that hydrocarbon refrigerants(HC-Blend, OS-21C II) are very good alternatives in the refrigeration system for R12.

• Carbon letters
• /
• v.1 no.3_4
• /
• pp.143-147
• /
• 2001

Under the irradiation of radiofrequency wave, the dipole materials vibrate as microwave phase changes. This causes friction between adjacent molecules and enables an unique characteristics of interior heating of the materials. Using this principle, when harmful material pass through anthracite- bed which play a role as a absorber of radiofrequency wave, the material can be easily decomposed by the microwave energy. To remove benzene vapour and other solvents in the process of industry, we examined decomposition of benzene in this manner. It was found that benzene was decomposed to the methane, ethane, propane and butane, etc. during passing through the carbon-bed under the microwave impingement and distribution of methane in the products reached about 85 vol.%. The decomposition rate of benzene was high within 5 minutes from start of reaction. For a lower concentration of benzene gas, general cases in the field of industry, almost complete decomposition of benzene is believed possible and this method is surely expected to be useful for the prevention of air pollution and improvement of ambient condition.

• Journal of Korean Society for Atmospheric Environment
• /
• v.10 no.E
• /
• pp.303-310
• /
• 1994

The effects of NOx reduction by new staged fuelling system in a small scale combustor (6.6 ㎾$_{T}$) have been investigated using propane gas flames laden with ammonia as fuel-nitrogen. The variables which had the greatest influence on NOx reduction were temperature, reducing stoichiometry( related to main combustion zone stoichiometry, air fraction and returning fuel fraction ) and residence time. The best NOx reduction was observed at the reburning zone stoichiometry of 0.85. In terms of residence time of the reburning zone, NOx reduction was effective when burnout air was injected at the Point where the reburning zone has been already established.d.