• 한국세라믹학회지
• /
• 제43권3호
• /
• pp.156-161
• /
• 2006

Impedance spectroscopy was applied to the initial hydration of calcium phosphate bone cements in order to investigate the electrical/dielectric properties. Hydration or equivalently setting was monitored as a function of the amount of water and initial powder characteristics. Higher amounts of water produced more open microstructures, leading to higher conductivity and enhanced dielectric constant. The effects of the initial characteristics in the powder were investigated using bone cement powder prepared with and without granulation. Granulated powder exhibited a significant change in resistance and produced a higher dielectric constant than those of conventional powder. Through a simplified modeling, the effects of thickness in reaction products and pore sizes were estimated by the frequency-dependent impedance measurements. Furthermore, impedance spectroscopy was proven to be a highly reliable tool for evaluating the continuous change in pore structure occurring in calcium phosphate bone cements.

• 대한기계학회논문집
• /
• 제18권4호
• /
• pp.903-911
• /
• 1994

This study addresses the phenomena of bubbling, icing, eruption, component varieties of the evaporated natural gas, and volumetric heat transfer coefficients obtained during the operation of a proposed LNG evaporator between LNG and water in direct contact. In the present investigation, the explosive and eruption phenomena within the water column were not observed during the entire operation of the heat exchanger. Compared with the natural gas produced by conventional LNG evaporator, the analysis of the gas produced by the direct contact LNG evaporator shows that nitrogen, methane, and ethane components were reduced by 0.002~0.007mol%(4~14%), 1.6~1.92mol%(1.9~2.3%) and 0.17~1.28mol%(1.1~8.4%) respectively, while the moisture content was rather increased by 0.51~0.76mol%. The maximum volumetric heat transfer coefficient of the direct contact heat exchanger was found to be $21, 800kW/m^3\cdotK$.

• 생약학회지
• /
• 제8권2호
• /
• pp.55-60
• /
• 1977

In this study the effect of water extract of Viticis rotundifoliae Fructus(VRE) on the blood pressure of the rabbit was investigated. The results of the experiment are as follows. 1. VRE produced a fall of blood pressure, exhibiting dose-action curve in the rabbit. 2. The depressor effect of VRE was inhibited by atropine and chlorisondamine, potentiated by physostigmine, and then potentiated slightly by bethanidine. 3. Effect of VRE was not influenced by propranolol and cyproheptadin. The above results indicate that hypotension of VRE is produced by stimulation of parasympathetic nervous system induced centrally.

• 대한기계학회논문집A
• /
• 제29권7호
• /
• pp.970-975
• /
• 2005

This paper presents a novel microgenerator of $CO_2$ (carbon dioxide) gas. $NaHCO_3$ (sodium bicarbonate) in a chamber is decomposed by the underlaid microheater. Alternatively, water droplet is caged by paraffin layer and released by heating. The released water dissolve HOC(COOH)$(CH_2COOH)_2$ (citric acid) powder and then, $NaHCO_3$ reacts with the solubilized HOC(COOH)$(CH_2COOH)_2$ and $CO_2$ is produced. Micropumps actuated by $CO_2$ generation were fabricated. A portable micro cell incubator of which pH is controlled by the produced $CO_2$ is also presented as one of the further applications.

• 한국식생활문화학회지
• /
• 제10권2호
• /
• pp.83-88
• /
• 1995

This study was conducted to examine the effects of additives and drying methods in Yukwa's manufacture. Additives had significant effects on hardness, and bean water and bean powder added group rated better than the baking powder and boiled bean added group. Sensory evaluation test showed that bean water and bean powder added group produced higher desirability. Drying methods had significant effects on all attribute of sensory evaluation, natural drying and incubative plate drying produced higher uniformity, denseness and overall desirability.

• 설비공학논문집
• /
• 제13권6호
• /
• pp.505-513
• /
• 2001

A revised VX cycle using ammonia/water as the working fluid is a cycle which is suitable to produce cooling utilizing low temperature hat sources. The cycle was analyzed numerically to investigate the effects of the design and operating conditions on the performance. It was shown that both COP and cooling capacity were significantly influenced by the performance of he rectifier. Insufficient UA of the rectifier reduced both ammonia mass fraction and mass flow rate of the vapor entering the condenser, which produced cooling effect in the evaporator. As the temperature and the mass flow rate of the heat source increased, both COP and exergetic efficiency decreased due to the irreversibilities produced in heat exchangers, but cooling capacity did not vary much. Cooling capacity increased significantly as the coolant temperature decreased, although COP and exergetic efficiency remained nearly constant.

• 한국분말야금학회:학술대회논문집
• /
• 한국분말야금학회 2006년도 Extended Abstracts of 2006 POWDER METALLURGY World Congress Part2
• /
• pp.784-785
• /
• 2006

Co-based amorphous powder was produced by a new atomization process "Spinning Water Atomization Process (SWAP)", having rapid super-cooling rate. The composition of the alloys was ($(Co_{0.95}Fe_{0.05})_{1-x}Cr_x$)$_{75}Si_{15}B_{10}$ (x=0, 0.025, 0.05, 0.075). The powders became the amorphous state even if particle size was up to about $500{\mu}m$. The coercive force of powders was about 0.35 - 0.7 Oe. Furthermore, Co-based amorphous powder cores with glass binders were made by cold-pressing and sintering methods. The initial permeability of the core in the frequency range up to 100 kHz was about 110, and the core loss at 100 kHz for Bm = 0.1 T was $350kW/m^3$.

• 한국세라믹학회지
• /
• 제28권12호
• /
• pp.943-952
• /
• 1991

Lead zirconate titanate(PZT) powders and thin films were prepared from an alkoxide-based solution by sol-gel method. Gelation of synthesized complex solutions, pyrolysis and crystallization behaviors of the dried powder were studied in accordance with a water content and a catalyst. PZT thin films were formed by spin-casting method on silicon and platinum substrates, and characterized. Ester produced from the reactions was completely removed when drying of the gel was finished. Pyrolysis property of the dried PZT gels were changed in order water content, class of catalyst, and quantity of catalyst. Crystalline Pb phase was transiently formed near 250$^{\circ}C$. Basic catalyst is good additive for a formation of perovskite phase in the films, and acidic catalyst for a densified film structure. By the analysis of RBS, Pb element in the PZT films were diffused into silicon substrate, and the pores, may be produced due to local densification around some grains in the films, make an origin of fault in microstructure when holding time goes to be longer at 700$^{\circ}C$.

• Biotechnology and Bioprocess Engineering:BBE
• /
• 제8권3호
• /
• pp.179-182
• /
• 2003

Anaerobic fermentation was attempted to produce methane from the wood chip (Eucalyptus globulus). By the pretreatment of the wood chip using hot water with high temperature, NaOH, and steam explosion, the production of methane gas was enhanced. The pretreatment using Steam explosion resulted in more amount of methane gas produced than the treatment using either hot water or 1% (w/w) NaOH with high temperature, and the steam explosion at a steam pressure of 25 atm and a steaming time of 3 min was the most effective for the methane production. The amount of methane gas produced depended on the ratio of weight of Klason lignin, a high molecular weight lignin, in the treated wood chip.

• 한국세라믹학회지
• /
• 제26권3호
• /
• pp.445-451
• /
• 1989

Hydrolysis of aluminum isopropoxide with excess water in the presence of excess isopropyl alcohol resulted in the formation of boehmite in independence of temperature of hydrolysis and aging. Stoichiometric and substoichiometric amount of water hydrolyzed aluminum isopropoxide to pseudo-boehmite and amorphous one, respectively. $\alpha$-Al2O3 with 0.3${\mu}{\textrm}{m}$ in median size was produced by calcination of boehmite, bseudo-boehmite and amorphous boehmite at 125$0^{\circ}C$, 120$0^{\circ}C$, and 115$0^{\circ}C$ for one hour, respectively. Singnificant reduction in particle size was found during transition from $\theta$-Al2O3 to $\alpha$-Al2O3. $\alpha$-Al2O3 produced in this study was relatively uniform spherical and its purity was found to be over 99.9%.