• Electrical & Electronic Materials
• /
• v.8 no.1
• /
• pp.21-26
• /
• 1995

Highly sensitive and mechanically stable gas sensors have been fabricated using the microfabrication and micromaching techniques. The sensing material used to detect the offensive trimethylarnine ((CH$_{3}$)$_{3}$N) gas is 6 wt% $Al_{2}$O$_{3}$-doped, 1000.angs.-thick ZnO deposited by r. f. magnetron sputtering. The optimum operating temperature of the sensor is 350.deg.C and the corresponding heater power is about 85mW. Excellent thermal insulation is achieved by the use of a double-layer structure of 0.2.mu.m -thick silicon nitride and 1.4.mu.m-thick phosphosilicate glass(PSG) prepared by low pressure chemical vapor deposition(LPCVD) and atmospheric pressure chemical vapor deposition(APCVD), respectively. The sensors are mechanically stable enough to endure at least 43, 200 heat cycles between room temperature and 350.deg. C.

• Applied Science and Convergence Technology
• /
• v.25 no.2
• /
• pp.32-35
• /
• 2016

Using conventional deposition techniques, we demonstrate a method to fabricate ultra-smooth 10 nm silver films without using a wetting layer or co-depositing another material. The argon working pressure plays a crucial role in achieving an excellent surface flatness for silver films deposited by DC magnetron sputtering on an InP substrate. The formation of ultra-smooth silver thin films is very sensitive to the argon pressure. At the optimum deposition condition, a uniform silver film with an rms surface roughness of 0.81 nm has been achieved.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.05a
• /
• pp.243-246
• /
• 1999

The displacement current measuring system used for detecting the dynamic behavior of monolayers at the air-water interface is described. It basically consists of a film balance, a pair of electrodes connected to each other through a sensitive ammeter. Here, one electrode is suspended in air and the other electrode is the water, With Maxwll-displacement-current-measuring method, the phase transitions of Poly(λ-benzyl- L-glutamate)(PBLG) on a water surface were detected, Displacement currents generated during the compression of monolayers of PBLG on the surface of water were investigated. As results, the displacement pick was generated when the area per molecule was about 15 $\AA$$^{2}$ in low pressure, and tit was generarted when the area per molecule about 27$\AA$$^{2}$ in high pressure.

• Transactions on Electrical and Electronic Materials
• /
• v.14 no.1
• /
• pp.20-23
• /
• 2013

When applying superconducting wire to power machines, an investigation needs to be carried out on the characteristics of wire phase changes in connection with the insulating layer. This study examined trends in the increase of the wire's resistance and the characteristics of its recovery from quenching by a current-applied cycle at temperatures of 90 K, 180 K, and 250 K. The procedure was conducted based on the thickness and presence (or absence) of the insulating wire layers. To achieve this, YBCO thin-film wires with the same critical temperatures were prepared with copper and stainless steel stabilizing layers. At levels (-one, three, and five-), with superior performance, polyimide pressure-sensitive adhesive tape was attached to the wires at a very low temperature. The eight prepared test samples were wound around the linear frames. The wire's voltage and current created from the phase change characteristics were measured at the wire's prescribed temperature, using the four-point probe method. The wire's resistance and recovery characteristics were examined for each cycle at temperatures of 90 K, 180 K, and 250 K.

• Journal of the Korean Vacuum Society
• /
• v.6 no.4
• /
• pp.354-358
• /
• 1997

Crystal properties of wurtzite GaN films grown on $Al_2O_3$(0001) substrates under various nitrogen pressure and plasma power by electron cyclotron resonance molecular beam epitaxy were investigated by full width at half maximum of X-ray diffraction peak and scanning electron microscope. It was found that the nitrogen pressure has a large effect on the FWHM value of XRD, and the GaN film grown under the optimum nitrogen pressure contains high density of dislocations. These results suggest that the crystal quality is sensitive to the plasma source conditions and that the relaxation of stress depends of V/III ratio. However, substrate-surface nitridation has little effect on the relaxation of misfit stress.

• Journal of Oral Medicine and Pain
• /
• v.31 no.3
• /
• pp.265-274
• /
• 2006

Temporomandibular joint (TMJ) internal derangement, especially disc displacement with reduction (DDwR) is the most common TMJ arthropathy and has been thought to do some effects on masticatory performance. Measuring of maximal bite force has been widely used as objective and quantitative method of evaluating masticatory performance, but previous studies showed various results due to various characteristics of subjects and different measuring devices and techniques. In a few studies about the correlation of bite force and temporomandibular disorders (TMD), some authors reported that bite force and masticatory performance would be reduced in patients with TMD because of pain. But the correlation of changes in structure of articular disc and masticatory performance has not been well investigated yet. In this study, to investigate the influences of non-painful disc change on the masticatory performance, we measured the value of maximal bite force, occlusal contact area and occlusal pressure of 39 patients with non-painful DDwR of the TMJ using pressure sensitive film, and compared it with that of 59 controls. The results are summarized as follows: 1. The maximal bite force (P<0.01) and the occlusal contact area (P < 0.05) of the DDwR patients were greater than the controls. 2. There was no significant difference in occlusal pressure between the DDwR patients and the controls (P > 0.05). 3. The maximal bite force of the male group was greater than that of the female group (P < 0.05). However, the occlusal contact area and the occlusal pressure between the male and the female group didn't show significant difference (P > 0.05). From the results above, we can suggest that DDwR could be a factor of changing bite force, but more controlled, large scaled and EMG related further study is needed.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.4
• /
• pp.73-80
• /
• 1989

The image sensitive PbO photoconductive films were fabricated ar several deposition conditions such as $O_2$ gas pressure, deposition rate, and substrate temperature. And the effects of these deposition condition on the structural and electrical properties of them were investigated with the aid of scanning electron photomicrographs. X-ray diffraction patterns, and current-valtage chatacteristics. The results show that when PbO film has red tetragonal structure and its dominant orientations are <110> and <010> direction, photocurrent-darkcurrent ratio and light transfer ratio are increase.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.05b
• /
• pp.47-50
• /
• 2002

The displacemant current measuring system used for detecting the dynamic behavior of monolayers at the air-water interface is described. It basically consists of a film balance, a pair of electrodes connected to each other through a sensitive ammeter. Here, one electrode is suspended in air and the other electrode is placed in the water. With Maxwell-displacement-current-measuring method, the phase transitons of $Poly-{\gamma}-benzyl_{L}$ -glutamate (PBLG) and $Poly-{\gamma}-benzyl_{D}$-glutamate(PBDG) on a water surface were detected. Measured surface pressure, displacement current and dipole moment of monolayers of PBLG and PBDG on the water surface. Also, we measured that compression velocity (30, 40, 50[mm/min]) when the sample spread volume was about 370[ul]-400[ul] and displacement current that occur when differed temperature. From the result, it is known that current is generated in the range of high surface pressures as compression velocity become faster and increase of temperature.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.1047-1049
• /
• 2001

The displacemant current measuring system used for detecting the dynamic behavior of monolayers at the air-water interface is described. It basically consists of a film balance, a pair of electrodes connected to each other through a sensitive ammeter. Here, one electrode is suspended in air and the other electrode is placed in the water. With Maxwell-displacement-current-measuring method, the phase transitions of Poly-${\gamma}$ -benzyl D-glutamate(PBDG) on a water surface were detected. Measured surface pressure, displacement current and dipole moment of monolayers of PBDG on the water surface. We measured analyzed displacement current that occur when differed temperature. Could know that displacement current is proportional in increase of temperature and great as experiment result.

• Proceedings of the KIEE Conference
• /
• 2001.07c
• /
• pp.1530-1532
• /
• 2001

The displacement current measuring system used for detecting the dynamic behavior of monolayers at the air-water interface is described. It basically consists of a film balance, a pair of electrodes connected to each other through a sensitive ammeter. Here, one electrode is suspended in air and the other electrode is placed in the water. With Maxwell-displacement-current-measuring method, the phase transitons of Poly-$\gamma$-benzyl p-glutamate (PBDG) on a water surface were detected. Measured surface pressure, displacement current and dipole moment of monolayers of PBDG on the water surface. Also, we measured that compression velocity(30, 40, 50[mm/min]) when the sample spread volume was about 400[ul]. From the result, it is known that current is generated in the range of high surface pressures as compression velocity become faster.