• Journal of the Korean Society of Visualization
• /
• v.10 no.1
• /
• pp.47-54
• /
• 2012

Single Stage To Orbit (SSTO) missions which require its engines to be operated at varying back pressure conditions, use engines operate at high combustion chamber pressures (more than 100bar) with moderate area ratios (AR 70~80). This ensures that the exhaust jet flows full during most part of the operational regimes by optimal expansion at each altitude. Aero-spike nozzle is a kind of altitude adaptation nozzle where requirement of high combustion chamber pressures can be avoided as the flow is adapted to the outside conditions by the virtue of the nozzle configuration. However, the thrust prediction using the conventional thrust equations remains to be a challenge as the nozzle plume shapes vary with the back pressure conditions. In the present work, the performance evaluation of a new aero-spike nozzle is being carried out. Computational studies are carried out to predict the thrust generated by the aero-spike nozzle in varying back pressure conditions which requires the unsteady pressure boundary conditions in the computational domain. Schlieren pictures are taken to validate the computational results. It is found that the flow in the aero-spike nozzle is mainly affected by the base wall pressure variation. The aerospike nozzle exhibits maximum performance in the properly expanded flow regime due to the open wake formation.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2007.05a
• /
• pp.442-447
• /
• 2007

A very abnormal vibration was occurred at the LP(low pressure) turbine continuously during the pre-operation for a 550MW class USC(ultra super critical) steam turbine. This vibration was initiated at the rotating speed of about 3,450rpm and then the vibration amplitude was highly increased the number by $2{\sim}3$ times with the increase of the rotating speed to the rated speed(3,600rpm). In this paper, this abnormal vibration named spike vibration. This spike vibration was caused by the rubbing between the rotating bucket tip seal and the Lower Half of spill strip. Also, this paper presents the mechanism of the spike vibration and the proper method to eliminate this abnormal vibration problem. This result would be good practice to find the solution of similar high vibration in the USC steam turbines for power plant as well as industrial rotating machineries.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.17 no.12
• /
• pp.1238-1245
• /
• 2007

A very abnormal vibration was occurred at the LP(low pressure) turbine continuously during the pre-operation for a 550MW class USC(ultra super critical) steam turbine. This vibration was initiated at the rotating speed of about 3,450 rpm and then the vibration amplitude was highly increased the number by $2{\sim}3$ times with the increase of the rotating speed to the rated speed (3,600 rpm). In this paper, this abnormal vibration named spike vibration. This spike vibration was caused by the rubbing between the rotating bucket tip seal and the lower half of spill strip. Also, this paper presents the mechanism of the spike vibration and the proper method to eliminate this abnormal vibration problem. This result would be good practice to find the solution of similar high vibration in the USC steam turbines for power plant as well as industrial rotating machineries.

• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 1999.11a
• /
• pp.121-128
• /
• 1999

In this study, a numerical procedure to analyze 3-dimensional unsteady elastohydrodynamic lubrication was developed. The procedure was applied to the actual cam and roller follower of the valve mechanism for a marine diesel engine. The pressure distribution between the cam and roller follower was calculated for the several cam rotating angles. The pressure spike is shown near the roller edge and it is getting higher as the external load is increased. The roller profile for reducing the pressure spike was suggested by the Hertzian contact analysis.

• Journal of Energy Engineering
• /
• v.11 no.2
• /
• pp.122-129
• /
• 2002

The analytical models and algorithm of the SPIKE code, which has been developed by KAERI's KALIMER team to investigate the sodium-water reaction phenomena in the liquid metal reactor, were introduced with its verification calculation results. The sodium water reaction of KALIMER IHTS was evaluated. Early stage of the sodium-water reaction consists of wave and mass transfer regimes. The pressure variations were independent of specific design features in the wave transfer regime. However in the mass transfer regime, the pressure variations were strongly dependent on cover gas volume and rupture disk set pressure. The early stage SWR analysis showed that the KALIMER IHTS with an appropriate cover gas volume and rupture disk set pressure had enough margin to its design pressure.

• Physical Therapy Korea
• /
• v.2 no.2
• /
• pp.66-72
• /
• 1995

The purpose of this study was to determine a more effective method for shoulder pain reduction. Forty-five normal subjects were randomly assigned to one of 3 groups a control group, an acupuncture-like transcutaneous electrical nerve stimulation(ALTENS) group, and a silver spike point(SSP) group. Each person in the ALTENS and SSP groups was measured for pressure pain threshold before and after a 20 minute treatment. The control group was also checked for pressure pain threshold before and after a 20 minute period but no "treatment" was given. The major findings were as follows ; 1)The ALTENS and SSP groups showed significant differences before and after treatment but the control group showed no significant difference. 2)When the three groups were compared, the only significant difference was between the SSP group and the control group. As mentioned above, it may be concluded that both ALTENS and SSP therapy were effective in reducing shoulder pain when measured directly after treatment. However, SSP did not show any superior effect. Further study should be done to determine the effective the maintained pain reduction with post-treatment time lapse.

• Journal of Korean Physical Therapy Science
• /
• v.10 no.2
• /
• pp.199-207
• /
• 2003

The present study examined that in vivo/vitro test is investigated in normotensive sham-operated rats(NSR) and aldosterone-analogue deoxycorticosterone acetate (DOCA)-salt hypertensive rats(ADHR) and that the antiliypertensive effect was induced by silver spike point(SSP) electrical stimulation at meridian points(CV-3, -4, Ki-12, SP-6, LR-3, BL-25, -28, -32, -52), specifically, such as aldosterone in 24 hour urine analysis from normal volunteer. The heart weight, the tickness of vascular wall, collagen fiber and the systolic blood pressure were significantly increased in ADHR than that in NSR. The required time of PSS-induced resting tone and the phosphorylation of stress-activated protein kinase/c-Jun N-terminal protein kinase(SAPK/JNK) were significantly increased in ADHR than that in NSR. However, the Kv currents were significantly decreased in ADHR than that in NSR. The current of 1 Hz continue type of SSP electrical stimulation significantly decreased in excretion of urine aldosterone from normal volunteer. These results suggest that the development of aldosterone analogue-induced hypertension is associated with changed heart weight, content of collagen fiber, tickness of vascular wall, blood pressure, resting tone, voltage-dependent K+ current(Kv) and phosphorylation of SAPK/JNK, which directly affects blood pressure. Therefore the hypertension is a risk factor on cerebrovascular disease. Moreover, These results suggest that the SSP electrical stimulation, especially current of 1 Hz continue type, significantly regulates excretion of urine aldosterone from volunteer.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2004.03a
• /
• pp.634-643
• /
• 2004

In this paper are presented a concept of a new supersonic air inlet, which is designated a Multi-Row Disk (MRD) inlet, aiming at performance improvement under off-design conditions, and results of wind tunnel tests examined performance characteristics of the MRD inlet. The MRD inlet is frequently called ‘a skeleton inlet’ because of its appearance. The performance of a conventional axisymmetric inlet with a solid center body (spike) deteriorates under off-design Mach number conditions. It is due to the fact that total pressure recovery (TPR) governed by the throat area of inlet and mass capture ratio (MCR) governed by an incidence position of an oblique shock from the spike tip into the cowl can not be controlled independently in such air inlet. The MRD inlet has the spike that is composed of a tip cone and several disks arranged downstream of it, based on the experimental fact that several deep cavities on a conical surface have little negative effect on the boundary layer growth. The overall spike length of the MRD inlet is adjustable to the given flight speed by changing space between disks so that a spillage flow can be controlled independently from controlling the throat area. It could be made clear from the result of wind tunnel tests that the MRD inlet improves TPR by 10% compared with a conventional inlet with a solid spike under off-design conditions.

• Tribology and Lubricants
• /
• v.25 no.5
• /
• pp.335-341
• /
• 2009

Elastohydrodynamic lubrication (EHL) analysis shows that film thickness is very flat in the contact area and pressure distribution is somehow similar to that of Hertzian contact pressure except the outlet region with pressure spike. These typical patterns of EHL film thickness and pressure are the cases under the steady contact conditions of applied loads and speeds. However, many engineering contacts are rather under the conditions of varying loads and contact speeds, and therefore the predictions for endurance life and performance of machine elements with steady EHL analysis are not suitable in many occasions. This study shows the differences in film thickness formation and pressure distribution between steady and transient contact conditions in several contact cases.

• Proceedings of the KOSOMBE Conference
• /
• v.1996 no.05
• /
• pp.3-5
• /
• 1996

Electrogastrography(EGG) is the technique by which gastric myoelectrical activity is recorded noninvasively, from electrodes on the abdominal skin. This gastric myoelectrical activity consists of two type signals : 1) slow wave, which is gastric basal rhyemic activity and is not closely related to gastric contraction 2) spike wave, which is generated only during contraction of the stomach. Despite many attempts made over the decades, analysis of surface EGG has not led to identification of the spike wave (gastric contraction) that would help the clinician to diagnose functional or organic diseases of the stomach. In this paper, we propose a feasible methods to detect gastric contraction by frequency-domain signal analysis of surface ECG signal. Synchronous measurement of gastric pressure by the antropyloric manometry with surface EGG established feasibility of this method.