• Journal of Advanced Navigation Technology
• /
• v.26 no.4
• /
• pp.185-194
• /
• 2022

Avionics equipment requires various environmental conditions and performance during development, and as a countermeasure against such development risk, the worst-case circuit analysis(WCCA) is applied to predict perform preliminary performance analysis. WCCA calculates the maximum and minimum values by combining the parameter values of the relevant circuit after deriving the parameter values in consideration of the aging of the temperature and operating period at the component level. In this paper, the necessary matters for WCCA application are described. Chapter 2 describes the differences and characteristics of the WCCA techniques EVA, RSS, and Monte Carlo.Chapter 3 introduces the analysis process through the example circuit to introduce the actual analysis procedure. Chapter 4 describes the method of selecting an analysis technique for each condition of the analysis target. As a result of applying the procedures and analysis methods introduced in this paper when open, it was confirmed that preliminary performance analysis and part optimization design verification are possible.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.03a
• /
• pp.825-831
• /
• 2010

In this study is stress behavior of steel support structure is to identify basic research. Steel stress due to load step to determine the behavior of steel using strain gauge steel loading test was performed. Numerical analysis and steel loading test using strain gauge on the actual steel stress behavior was analyzed. First, when tensile loading 3.5tonf load side of the plastic behavior appeared. Elastic model, using numerical analysis and comparison of results, the actual value is saved and you can see some difference. This repeated loading tests on steel can be seen from the results of the stress behavior of the steel rather than the elastic behavior of elastic-plastic behavior is because you can see. In addition, the upper and lower steel stress in compression and tension behavior represents the behavior was similar, but different. Steel loading test results, Y-axis get a compression if X-axis is tension. The future based on this study, the stress sensitivity curve of magnetic anisotropy sensor for non-destructive stress measurement technique for the study will be performed. And the behavior of plastic zone and residual stress to determine the numerical analysis using non-elastic model is needed.