• Environmental Engineering Research
• /
• v.14 no.4
• /
• pp.220-225
• /
• 2009

The water quality in eutrophic lakes is affected by serious problems, such as abnormal increasing of Cyanobacteria. The purpose of this study was to investigate the possibility of a modified flotation system using a hybrid technique formed by chemical compounds and an electrostatic bridge. Therefore, experiments using the hybrid technique were performed to measure the zeta potential value on the phytoplankton surface and the removal efficiencies of phytoplankton, ammonia nitrogen, nitrate nitrogen and phosphoric acid. The results were as follows: Firstly, the zeta potential of M.aeruginosa was observed to approach charge neutralization due to adhesion of magnesium hydroxide precipitate on the phytoplankton surface in the pH range 10.5 to 11. Secondly, the concentration of chlorophyll-a decreased from about 150 to 20${\mu}g$g/L, with a maximum removal efficiency of 84% due to coagulation with pH values higher than 10. Thirdly, the N$H_4$-N concentration was observed to decrease from 0.62 to 0.54mg-N/L (13%), and the P$O_4$-P concentration, which is a limiting factor to the formation of algae blooms, decreased from 0.27 to 0.02mg-P/L (92%). These findings suggest that the modified flotation system can be applied for the purification of the raw water of numerous lakes containing high phytoplankton populations and elevated pH.

• Journal of the Korean Chemical Society
• /
• v.38 no.9
• /
• pp.667-675
• /
• 1994

The precipitate flotation using $La(OH)_3$ as a coprecipitant was studied for the simultaneous determination of trace three elements in a sea water. Several experimental conditions such as pH, coprecipitant and surfactant were investigated with an artificial sea water. To remove the influence of Cr(VI) the Cr(VI) was reduced to Cr(III) using $NaBH_4$ prior to the flotation. Trace amounts of Cu(II), Co(II) and total Cr in 1.0 l sea water was coprecipitated together with the precipitation of $La(OH)_3$ in the solution of pH 9.8 adjusted with 3.OM NaOH solution. The precipitate was floated by using a mixed surfactant (1 to 8 of each 0.5% ethanolic sodium oleate and sodium dodecylsulfate solution) by bubbling a nitrogen gas. The floats was separated and filtrated from the mother liquor by suction. The precipitate was dissolved in 7.0 M $HNO_3$ solution and then marked to 25.0 ml with a deionized water. These elements were determined by graphite fumace atomic absorption spectrophotometry. This method was applied to determine the elements in the sea water of the Eastern and Western coasts. And the recoveries were over 90.0% in the samples into which given amounts of the analyte elements were spiked.

• Bulletin of the Korean Chemical Society
• /
• v.16 no.7
• /
• pp.582-588
• /
• 1995

The preconcentration and determination of trace Cd(Ⅱ), Cu(Ⅱ), Pb(Ⅱ), Mn(Ⅱ) and Zn(Ⅱ) in water samples were studied by the precipitate flotation using La(OH)3 as a coprecipitant. The analytes were quantitatively coprecipitated by adding 3.0 mL of 0.1 M La(Ⅲ) solution in a 1,000 mL water sample and adjusting the pH to 9.5 with NaOH solution. After the addition of the 1:8 mixed surfactant solution of each 0.1% sodium oleate and sodium lauryl sulfate, the solution was stirred with a magnetic stirrer for 10 minutes. The precipitates were floated to the surface by bubbling with nitrogen gas and collected in a small sampling bottle. The precipitates were dissolved in nitric acid and then the solutions were diluted to 25.00 mL with a deionized water. The analytes were determined by flame atomic absorption spectrometry. This procedure was applied to the waste water analysis. This technique was simple, convenient and especially rapid for the analysis of a large volume of sample. And also, from the recoveries of better than 92% which were obtained from real samples, this method could be judged to be applicable to the preconcentration and quantitative determination of trace elements in water samples.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 1999.11b
• /
• pp.164-171
• /
• 1999

A new technique for recycling process water was developed in order to reduce the calcium hardness of the closed OCC recycling system. Calcium ions present in the white water were precipitated as calcium carbonate by a reaction with sodium carbonate and the CaCO$_3$precipitates were easily removed from the system by a dissolved air flotation(DAF) method. After the DAF stage, CO$_2$-gas was purged into the water because the pH of Na$_2$CO$_3$-treated white water was reduced to neutral by CO$_2$gas. Since CaCO$_3$precipitate tends to stick onto the fine fiber surface and then is selectively removed from the water, a proper amount of suspended solid in the process water acts as an important factor in deciding the removal efficiency. By the application of Na$_2$CO$_3$addition - DAF - CO$_2$purging to the short circulated white water the calcium hardness was significantly reduced by 92% and more. The removal of calcium ions with fine fibers led to drainage improvement, reduction of fresh water consumption, and enhanced efficiency of wet-end chemicals.

• Journal of the Korean Chemical Society
• /
• v.37 no.3
• /
• pp.327-333
• /
• 1993

A method was developed for the determination of trace elements in seawater by precipitate flotation preconcentration and subsequent flame atomic absorption detection. In order to quantitatively coprecipitate trace ions such as Cd(II), CuI(II), Fe(III), Mn(II), Pb(II) and Pd(II), 2.0 ml of 1.0M cerium(III) solution was added to 1.0l of seawater and the pH was adjusted to 9.5 with 5.0 M sodium hydroxide solution while stirring with a magnetic stirrer. The precipitate was floated with the aid of surfactant solution (1.0 ml of 0.3% sodium oleate) by bubbling nitrogen gas through a porous (No. 4) fritted glass disk. The floats was collected in a small Erlenmeyer flask by suction. The washed precipitate was dissolved in 8.0 M nitric acid and marked with deionized water in the volumetric flask of 10.0 ml. The analyte was determined by measuring the atomic absorbances in 100-fold concentrated solution. Above all analytes in Kangnung (East Sea) and Kanghwado (West Sea) sea waters were found to be under the detection limit of this method. The recoveries of over 92% for all analytes spiked into seawater samples showed that this method was applicable to the analysis of real seawater.

• Journal of the Korean Chemical Society
• /
• v.35 no.4
• /
• pp.355-361
• /
• 1991

The separative preconcentration of trace mercury[Hg(II)] in a water sample was studied by a coprecipitation flotation technique. The trace Hg(II) was precipitated together with Ce(OH)$_3$ by adding 3.0 ml of 0.1M Ce$^{3+}$ solution to 1,000 ml of water sample and adjusting pH to 11.0 with 1.0M NaOH solution. The hydrophobic precipitate[Ce(OH)$_3$-Hg(OH)$_2$], which was formed by adding 2.0 ml of 0.1${\%}$ ethanolic sodium oleate solution, were floated on the surface with an aid of tiny nitrogen gas bubbles. The floated materials were quatitatively collected in a suction flask and dissolved with 5.0 ml of 2.0M HNO$_3$. The solution was marked to 25.00 ml with a deionized water. The content of Hg(II) was determined by cold vapor atomic absorption spectrophotometry. Any interferences of concomitants such as Ag$^+$, Br$^-$, I$^- $, etc. were not observed on the whole procedure. The analytical result showed that Hg(II) found in the wastewater of Seochang Campus, Korea University was 1.98 ng/ml with the relative standard deviation of 3.6${\%}$. And recoveries of Hg(II) in the wastewater into which 1.0 ng/ml and 2.0 ng/ml were added were 95${\%}$ and 91${\%}$, respectively. From such results, this procedure could be concluded to be tolerably accurate and reproducible for the determination of trace mercury in a water sample.

• Resources Recycling
• /
• v.29 no.6
• /
• pp.98-103
• /
• 2020

In this study, the depression behavior of zinc sulfate on the sphalerite with the addition of potassium butyl xanthate was investigated to clear the relationship between zinc sulfate and xanthate in depression of sphalerite. As a result of the experiment, it was confirmed that the depress effect of zinc sulfate on the sphalerite declined with the increase of its addition amount. From the results of SEM-EDS and FT-IR analysis, it was found out that the amorphous precipitate of metal xanthate (Zn-BX) was formed in sphalerite concentrate, when the solubility product of [Zn+]·[BX] in the pulp solution exceeded 3.71×10-11, which is the solubility of Zn-butyl xanthate. It is considered that the Zn-butyl xanthate had a negative effect on the depression of sphalerite.