• Journal of Industrial Technology
• /
• v.21 no.B
• /
• pp.59-66
• /
• 2001

In this paper, a novel overmodulation strategy for PWM inverters to extend linearity region is presented. The proposed strategy uses the concept of space-vector PWM(SVPWM) based on the zero sequence signal(offset voltage) injection principle. So, by modifying the pole voltage simply, the linear control of inverter output voltage over the whole overmodulation range can be achieved easily. The proposed strategy is so simple that its practical implementation is easy. The validity of the proposed strategy is confirmed by the experimental results.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1994.04a
• /
• pp.53-58
• /
• 1994

Beam-column joints of the skeleton structure can be classified as geometrical D-region, where the assumption of Bernoulli is not applicable. For the detailing of D-region in concrete structure, "Strut-and-Tie' Model is a very powerful tool, which has been widely used by practical engineers. This paper shows how the methodology of Strut-and-Tie Model can be applied for the various cases of beam-column joints. We can find this mechanical model does not give only an appropriate answer to the given problem but also a better insight to the structral behavior of beam-column joints.

• Journal of Advanced Marine Engineering and Technology
• /
• v.10 no.4
• /
• pp.67-77
• /
• 1986

The information on the heat transfer characteristics, flow pattern and pressure drop, are very important for the desing of general heat exchanger, refrigerating system, air conditioning system and energy recovery system. In these systems, water or lubricating oil contained in working fluid affects greatly the flow and heat transfer condition and this phenomena must be considered in the practical design. An experiment has been performed for studying the flow and heat transfer characteristics of the forced convective horizontal flow of R-113 under the range of the liquid single phase state to the boiling flow state. Basic experimental results are obtained in the case that water or lubricating oil does not contaminate in the test fluid. Experimental results are as follows; (1) The local heat transfer coefficients in the nucleate boiling region and transition boiling region are almostly ten times as large as that of liquid single phase flow. (2) The measured heat transfer coefficient in the present experimental range is relatively agreed well with the predicted value from the various experimental results for the boiling flow.

• Journal of Biomedical Engineering Research
• /
• v.2 no.1
• /
• pp.15-20
• /
• 1981

In this study, the scattering of ultrasound by blood is theoretically studied. At first, the Chernow equation which represents acoustic propagation inside the region of inhomogenieties is modified to be fitted for blood. Then, scattering amplitude and scattering Cross-section at the far-field region are obtained from this equation. In this case, hemotocrit is assumed to be less than 26 per cent, and the red blood cell is modeled as independent scatterer. This study also develops a practical approximation for the backscattering of periodic sinewave bursts by a volume of randomly distributed scatterers, i.e., whole red blood cells. This expression for the received backscattering ultrasound pressure after the n-th burst of narrowband transducer is obtained from an ideal continuous wave transducer's response.

• Proceedings of the KIEE Conference
• /
• 2001.07b
• /
• pp.898-900
• /
• 2001

In general, the accuracy of the switching angles is dependent upon the resolution of the encoder and the sampling period of the microprocessor. But the region of high speed, switching angles are fluctuated back and forth from the preset values, which are cause by the sampling period of the microprocessor. Therefore, the low cost linear encoder suitable for the practical and stable SRM drive is proposed and the control algorithm to provide the switching signals using the simple analog type switching logic circuit is also presented in this paper.

• IEIE Transactions on Smart Processing and Computing
• /
• v.5 no.6
• /
• pp.418-429
• /
• 2016

In this paper, we propose a hybrid Wyner-Ziv video coding structure that combines conventional motion predictive video coding and Wyner-Ziv video coding to eliminate the feedback channel, which is a major practical problem in applications using the Wyner-Ziv video coding approach. The proposed method divides a hybrid frame into two regions. One is coded by a motion predictive video coder, and the other by the Wyner-Ziv coding method. The proposed encoder estimates side information with low computational complexity, using the coding information of the motion predictive coded region, and estimates the number of syndrome bits required to decode the region. The decoder generates side information using the same method as the encoder, which also reduces the computational complexity in the decoder. Experimental results show that the proposed method can eliminate the feedback channel without incurring a significant rate-distortion performance loss.

• Progress in Superconductivity and Cryogenics
• /
• v.3 no.2
• /
• pp.1-4
• /
• 2001

For the practical use of a superconducting wire to magnet application, it is important to assess the Young modulus and other mechanical properties of HTS tapes. In order to establish a test method of mechanical properties for oxide composite superconductors. tensile tests of Bi-2223 multi- filamentary tapes were carried out at room temperature, as an activity of the International round robin test proposed by the committee of VAMAS/TWA 16-Subrgroup. The tapes consisting of mutli-filamentary showed a three stage tensile behavior. At the initial stage of the stress-streain curve. The elastic deformation existed in a quite nattrow strain region. But the plastic deformation was observed in a wide strain region due to the platic flow of the Ag alloy matrix. The results of RRT were also reported and discussed.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.743-746
• /
• 2006

We have demonstrated a transflective liquid crystal display (LCD) with a single cell gap in a patterned vertically aligned mode. In our configuration, the different electrode structure in a transmissive and a reflective part was suggested to compensate an optical path difference of each region. As the result, the similar electro-optic characteristic of each region was obtained which results in an enhanced performance of the device. Moreover, suggested technique can be highly effective to realize the practical transflective LCD due to the simple fabrication process.

• Journal of Ecology and Environment
• /
• v.33 no.2
• /
• pp.115-120
• /
• 2010

The Asian cultural landscape is a mirrored ecosystem of great complexity, formed by the interaction of man and nature, coupled with a host of ecological processes. The human dependencies on and environmental adaptation of the bio-organisms and the surrounding landscape constitute the typical cultural landscape. Islands are a good example of a cultural landscape, and each mosaic pattern of marine and coastal ecosystems reflects bio-cultural diversity. Along with land-use patterns, wise use of biological organisms and indigenous knowledge has expanded to islands in the Asia-Pacific region in several ways (sea current and human impact, etc.). Loss in biodiversity and landscape diversity as well as cultural diversity owing to global warming and rapid urbanization are emerging issues for island ecosystems all over the world. In order to sustain the historical coexistence between man and natural systems, we ecologists must continue to search for a holistic solution for academic consilience. In this paper, I present the vision and practical characteristics of island ecology with a view toward the conservation of the traditional landscape and bio-cultural diversities in the seascape.

• 한국전산유체공학회:학술대회논문집
• /
• 2011.05a
• /
• pp.453-457
• /
• 2011

In this study, transonic aeroelastic response analyses haw been conducted for the business jet aircraft configuration considering shockwave and flow separation effects. The developed fluid-structure coupled analysis system is applied for aeroelastic computations combining computational structural dynamics(CSD), finite element method(FEM) and computational fluid dynamics(CFD) in the time domain. It can give very accurate and useful engineering data on the structural dynamic design of advanced flight vehicles. For the nonlinear unsteady aerodynamics in high transonic flow region, Navier-Stokes equations using the structured grid system have been applied to wing-body configurations. In transonic flight region, the characteristics of static and dynamic aeroelastic responses have been investigated for a typical wing-body configuration model. Also, it is typically shown that the current computation approach can yield realistic and practical results for aircraft design and test engineers.