• Journal of Korean Society of Steel Construction
• /
• v.19 no.6
• /
• pp.611-620
• /
• 2007

The beam-column connection is the critical design section of general steel frame structures owing to the behavioral characteristics of the structural system. As most members of a frame structure are composed of rolled section beams, the cross-section of the beam members is governed by the negative bending moment near beam-column connections. Such a design concept leaves a redundant load-carrying capacity at the positive bending regions of the beam members leading to design inefficiency. Therefore, it is of utmost importance to redistribute the beam end moments and reduce the stresses at the beam-column connections for a more efficient design of steel frame structures. In this study, reaction-moment prestressing method (RMPM) was proposed for the innovative design and construction of steel frame structures. The RMPM is a prestressing method utilizing the elastic bending deformation of a beam member induced by temporary prestressing for the distribution of a relatively large bending moment to other sections for the efficient use of the beam section. By the application of the RMPM, the negative bending moment at the beam-column connections can be significantly reduced, ultimately leading to possible use of smaller beam sections. Through a series of model tests and numerical analyses of steel frame structures, the moment distributing effect and feasibility of the RMPM was verified.

• The Korea Journal of Herbology
• /
• v.22 no.2
• /
• pp.97-102
• /
• 2007

Objectives : This study presents a high performance liquid chromatography - electrospray ionization-mass spectrometer (HPLC-MS/MS) methods for the quantitative and qualitative analysis of various active components in Samul-tang, which is composed of four crude herbs. Methods : HPLC-ESI-MS/MS for the determinations of paeoniflorin and 5-HMF (5-hydroxymethyl 2-furaldehyde) in the Samul-tang, the separation method was performed on an COSMOS1L 5C18-AR-Il (2.0 X 150 mm I.D.) column by gradient elution with 0.1% acetic acid and 5% CH3CN in water (A)-0.1% acetic acid and 5% H20 in CH3CN (B) as the mobile phase at a flow-rate of 300 ${\mu}L/min$ with detection at quadrupole mass spectrometer. The all marker substances were always detected as the base peaks in the positive ion mode. Results : The paeoniflorin of Paeoniae Radix in Samul-tang showed a strong base peak [M+H2O]+ in the positive detection mode to give the following as; paeoniflorin (498.109 [M+H2O]+, 479.8 [M]+, 301 [M-glucose]+, 179.3 [glucose]+). Based on the HPLC retnetion time and MS of standard compounds confirmed the identity of active compounds in Rehmanniae Radix Preparata as follows; 5-HMF (127.0[M+H]+, 109.3 [M-OH]+) in the positive ion mode. Conclusion : According to the above results, HPLC-ESI-MS method permits assignment of tentative structures such as paeoniflorin and 5-HMF in the Samul-tang.

• KSBB Journal
• /
• v.29 no.3
• /
• pp.131-138
• /
• 2014

In this study, we isolated two novel chitinase producing bacterial strains from yellow loess samples collected from Jullanamdo province. The chitinase producing bacteria were isolated based on the zone size of clearance in the chitin agar plates. Both of them were gram positive, rod ($2{\sim}3{\times}0.3{\sim}0.4{\mu}m$), spore-forming, and motility positive. They were facultative anaerobic, catalase positive and hydrolyzed starch, gelatin, and casein. From the 16s rRNA gene sequence analysis, the isolates were labeled as Bacillus licheniformis KYLS-CU01 and B. licheniformis KYLS-CU02. The isolates showed higher extracellular chitinase activities than B. licheniformis ATCC 14580 as a control. The optimum temperature and pH for chitinase production were $40^{\circ}C$ and pH 7.0, respectively. Response Surface Methodology (RSM) was used to optimize the culture medium for efficient production of the chitinase. Under this optimal condition, 1.5 times higher chitinase activity of B. licheniformis KYLS-CU02 was obtained. Extracellular chitinases of the two isolates were purified through ammonium sulfate precipitation and anion-exchange DEAE-cellulose column chromatography. The specific activities of purified chitinase from B. licheniformis KYLS-CU01 and B. licheniformis KYLS-CU02 were 7.65 and 5.21 U/mg protein, respectively. The molecular weights of the two purified chitinases were 59 kDa. Further, the purified chitinase of B. licheniformis KYLS-CU01 showed high antifungal activity against Fusarium sp.. In conclusion, these two bacterial isolates can be used as a biopesticide to control pathogenic fungi.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.79-79
• /
• 2017

Grain Sorghum varieties grown in Korea have low productivity and are constrained by the fact that farmers' choice of improved varieties is limited. Hybrid cultivars have been demonstrated to be more productive and food security than pure line varieties. However, There's no available hybrid cultivars and never planted before in Korea. This study was, therefore, conducted to determine combining ability of Korean landrace varieties and cultivar, the level of heterosis of experimental hybrids depending on environments. Two cytoplasmic male-sterile lines were crossed with six male-fertile lines in accordance with North Carolina II mating scheme to generate 12 experimental hybrids. The hybrids were evaluated in replicated row-column alpha designs at two sites in Texas and South Korea under on-season production conditions. For each trait, general combining ability (GCA) and specific combining ability (SCA) effects were estimated using the line-tester method of analysis. Results indicated significant differences among genotypes for both grain yield potential and secondary traits. Hybrids were predominant for grain yield, and displayed up to 127% heterosis of A03017 ${\times}$ Sodamchal in Korea. Positive GCA for yield was observed for Donganme, Hwanggeumchal and Jungmo4002 in Korea. Among them Jungmo4002 and Donganme had highly positive for yield (227.90 and 84.90 kg ha-1), while it showed negative GCA for yield in College station (-40.90, -189.60 kg ha-1). ATx630 ${\times}$ Sodamchal had the greatest SCA for yield (468.10 kg/ha) in College station but at South Korea its SCA effect was -302.40 kg/ha. A similar trend was observed, followed by A03017 ${\times}$ Donganme (SCA effect = 215 kg ha-1 at College station vs. -44.20 kg ha-1 at South Korea). At South Korea the greatest positive SCA effect for grain was observed in ATx630 ${\times}$ Jungmo4002 as 322.20 kg/ha. Both GCA and SCA effects significantly interacted with site effects demonstrating the need for region adaptation of potential cultivars and test for developing Korea suitable cultivar.

• Journal of Korean Society on Water Environment
• /
• v.18 no.3
• /
• pp.253-260
• /
• 2002

The purpose of this research was to describe the mechanisms and prevention of initial degradation in turbidity of the sand filter effluent. The method used was by adding a coagulant (PAC) to the sand filter after backwashing as a means of reducing turbidity. It was found that adding 80 mg/L of PAC solution to the sand filter was very effective in improving the initial effluent turbidity. A turbidity removal efficiency of 99 % was observed in the initial term period as compared to a 70% efficiency without PAC addition. The PAC solution added to the sand filter resulted in high aluminum concentration at the upper layer as compared with the bottom layer of the sand filter column. A change in the zeta potential to a strong positive-ions at upper layer was observed at this time but only a small change was obtained at the bottom. This result showed that the zeta potential of the sand was changed to positive with PAC coating. The effect of pH on zeta potential with PAC addition was also investigated. Zeta potential was greatly changed to positive-ion at pH 4~6. A series of experiments was then conducted in this study to optimize the pH of the PAC solution to be added to the sand filter after backwashing. The removal efficiency of turbidity was found to be highest at pH 5. This result suggested that hydrolyzed aluminium species attached to the surface of the sand enhanced the removal of turbidity of the effluent.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 1996.11a
• /
• pp.53-56
• /
• 1996

In this paper, the pulsed mode operated gas discharge tube is composed with mixed gas of Hg-Ne (10 Torr), in the tube of 15.0 mm outer diameter and has variable color from red to blue with changing frequency high voltage. As increasing frequency in the gas discharge tube, the phenomena, that the electron temperature in the positive column increases and the radiation from atoms of higher upper state energy levels increases, exist The color have the locus from red (0.4972, 0.3128) to blue (0.2736, 0.2619) in CIE chromacity diagram with increasing frequency. The method of changing frequency has been shown to be suitable for the luminous color control.

• Microbiology and Biotechnology Letters
• /
• v.24 no.3
• /
• pp.321-326
• /
• 1996

In the course of screening for new bioactive compounds from oligotrophs in soil, a microorganism, designated as SA-246 and now identified as Micromonospora sp., has been shown to produce a strong antibacterial compound. The active compound was purified from broth filtrate by ethylacetate extraction, silica gel column chromatography, preparative TLC and HPLC, and was identified as crisamicin A based on mass and NMR spectral data. The compound SA- 246 exhibited not only strong antibacterial activity against Gram-positive bacteria but also cytotoxicity against cancer cell lines such as A549 (lung), SK-OV-3 (ovarian), SK-MEL-2 (melanoma), XF498 (central nervous system) and HCT15 (colon).

• Microbiology and Biotechnology Letters
• /
• v.22 no.2
• /
• pp.169-174
• /
• 1994

Antitumor antibiotic HS-1 was purified from the culture broth of a streptomyces floridae SHS-1372 which had been isolated from soil, by solvent extraction, silica gel column chromatography and gel filtration. It was confirmed that HS-1 was active against gram positive bacteria and cancer cells(K562, P388, MCF-7, HT-29). Through the analysis of UV spectrum, melting point, IR spectrum, FAB-MS, $_{1}$H-NMR, $_{13}$C-NMR, 2D-NMR spectra, HS-1 could be identified sa the actinomycin X$_{2}$ antibiotics containing actinocine chromophore and peptides consisted of threonine, proline, methylvaline, sarcosine, D-valine and 4-ketoproline.

• Journal of Life Science
• /
• v.9 no.6
• /
• pp.653-658
• /
• 1999

A novel marine microorganism, Vibrio sp. YE-101, was isolated from pufferfish and investigated for its ability to synthesize tetrodotoxin (TTX). Various strains isolated from the intestine of pufferfish were grown on TCBS agar plate, and then cultured on Ocean Research Institute (ORI) medium supplemented with 3% NaCl at 23$^{\circ}C$ for 3days. The cells were harvested, disrupted, fractionated by Bio-Gel P-2 column chromatography and then TTX-producing strain, Vibrio sp. YE-101, was identified using mouse bioassay. The isolated TTX from Vibrio sp. YE-101 was also analyzed and identified by HPLC and gas chromatography-mass spectrometer (GC-MS). The mass fragmentation of trimethylsilyl derivatives of C9-base of TTX from Vibrio sp. YE-101 was interpreted and the pattern of fragmentation was same with that of authentic standard. The purfied TTX was also positive to the mouse bioassay, which clearly represents that Vibrio sp. YE-101 can synthesize TTX.

• Steel and Composite Structures
• /
• v.1 no.3
• /
• pp.341-354
• /
• 2001

This paper provides a state-of-the-art review on advanced analysis models for investigating the load-displacement and ultimate load behaviour of steel and composite frames subjected to static gravity and lateral loads. Various inelastic analysis models for steel and composite members are reviewed. Composite beams under positive and negative moments are analysed using a moment-curvature relationship which captures the effects of concrete cracking and steel yielding along the members length. Beam-to-column connections are modeled using rotational spring. Building core walls are modeled using thin-walled element. Finally, the nonlinear behaviour of a complete multi-storey building frame consisting of a centre core-wall and the perimeter frames for lateral-load resistance is investigated. The performance of the total building system is evaluated in term of its serviceability and ultimate limit states.