• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.4 no.2
• /
• pp.139-147
• /
• 1994

Orthophosphate crystals were grown by the hydrothermal method and the properties of grown crystals were investigated by means of X-ray diffraction. Vickers hardness tester, etc. The starting powders of $AIPO_4 and GaPO_4 $were prepared as a single phase by the solid state reaction of stoichiometric mixture of $AI_2O_3 or Ga_2O_3$ and $NH_4H_2PO_4$ and the subsequently by the hydrothermal treatment. The hydrothermal conditions for high growth rates of the orthophosphate crystals are as follows: $AlPO_4$ crystal; temperature ranges, between $170$~$200^{\circ}C$; temperatures difference, $15$~$20^{\circ}C;$, hydrothermal solvent, 4m HCl, $GaPO_4 crystal; temperature ranges, between $210 and 240^{\circ}C;$; temperature difference, $25$~$30^{\circ}C; $, hydrothermal solvent, 4m HCl. Morphologies of grown crystals tended to be bounded by (1010), (1011) and (0111) faces at low temperatures, and grew with well developed (0001) faces by increasing the growth temperature. On the other hand, the properties of orthophosphate crystals $(AlPO_4/GaPO_4)$ were as follows: lattice parameters (nm); a=0.494, c=1.094/a=0.490, c=1.105, density (gcm-3); 2.62/3.56, Vickers hardness (Nm^2); $1.02{\times}10^1^0/7.06{\times}10^9$, refractive indices; $ne=1.529{\pm}0.003, no=1.519{\pm}0.003/ne=1.611{\pm}0.006, no=1.599{\pm}0.006, birefringence; {\pm}0.01/{\pm}0.012$, dielectric constant (Fm-1); 6/7.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.05a
• /
• pp.66-70
• /
• 2001

The partial discharge testing is widely used in diagnostic measuring technology because it gives low stress to power equipment which is undertaken tests. Therefore it is very useful method compare to previous destructive methods and effective diagnosis method in power system that requires on-line/on-site diagnosis. But partial discharges have very complex characteristics of discharge pattern, so it is required continuous research to development of precise analysis method. In recent, the study of partial discharge is carrying out discover of initial defect of power equipment through condition diagnosis and system development of degradation diagnosis using HFPD(High Frequency Partial Discharge) detection. In this study, simulated system is manufactured and HFPD occurred from those simulator is measured with broad-band antenna in real time, the degradation grade of system is analyzed through produced patterns in simulated target according to the AI/statistics processing.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.05b
• /
• pp.75-78
• /
• 2001

Recently, the HFPD measurement testing is widely used in partial discharge measurement of HV machines because HFPD measurement testing receives less influence of external noise and has a merit of good sensitivity. Also HFPD testing is able to offer the judgement standard of degradation level of HV machine and can detect discharge signals in live-line. Therefore it is very useful method compare to previous conventional PD testing method and effective diagnosis method in power transformer that requires live-line diagnosis. But partial discharges have very complex characteristics of discharge pattern so it is required continuous research to development of precise analysis method. In recent, the study of partial discharge is carrying out discover of initial defect of power equipment through condition diagnosis and system development of degradation diagnosis using HFPD(High Frequency Partial Discharge) detection. In this study, simulated transformer is manufactured and HFPD occurred from transformer is measured with broad band antenna in real time, the degradation grade of transformer is analyzed through produced patterns in simulated transformer according to applied voltages.

• Journal of the Korean Chemical Society
• /
• v.31 no.3
• /
• pp.225-230
• /
• 1987

Electrical conductivity of $CdO-La_2O_3$ system containing 0.8mol% of CdO was measured from 500 to $900^{\circ}C$ at oxygen partial pressures of $10^{-7}\;to\;10^{-1}$ atm. Plots of log ${\sigma}$ vs. 1/T at constant $PO_2$ are found to be linear and the activation energy appears to be 0.97eV. The log ${\sigma}$vs. log $PO_2$ is found to be linear at oxygen pressures of $10^{-7}\;to\;10^{-1}$ atm and $500{\sim}900^{\circ}C$. The conductivity dependence on $PO_2$ at the above temperature range is given by ${\sigma}\;{\alpha}\;PO_2^{1/4}$. The defect structure in this system is believed to be complex, i.e., ${V_{La}}^{'''}$ and $V\"{o}$. The interpretations of conductivity dependences on temperature and $PO_2$ are presented and conduction mechanism is proposed to explain the data.

• Korean Journal of Veterinary Service
• /
• v.35 no.2
• /
• pp.83-90
• /
• 2012

Porcine rotaviruses are the most common causes of viral gastroenteritis in piglets around the world. The major G genotypes of porcine rotaviruses causing diarrhea were G4, G5 and G11 genotypes. Recently, G9 genotype rotaviruses were problemed at swine farms and frequently recognized from diarrheic piglets. In this study, a porcine rotavirus (PoRV-1) was isolated from piglet showing diarrhea using MA104 cells and confirmed as rotavirus by electron microscopy, genomic RNA electropherotyping and indirect immunofluorescence antibody tests. The nucleotide sequence of the VP7 gene of PoRV-1 was determined and compared with those of other genotype rotavirus strains from other parts of the world. Also, the nucleotide sequences of VP4, VP6 and NSP4 genes of PoRV-1 were determined and compared with those of other rotavirus strains from other countries. The results showed that the PoRV-1 isolate belonged to the G9 genotype and the P, I and E genotypes of PoRV-1 were P[23], I5 and E1, respectively. The Korean G9 PoRV-1 isolate and its nucleotide sequence data would be usefully used for the development of porcine rotavirus vaccines in near future.

• Journal of the Korean Chemical Society
• /
• v.65 no.3
• /
• pp.197-202
• /
• 2021

In this study, activated clay treated with H₂SO₄ (20% by weight) and heat at 90 ℃ for 8 h for acid white soil was used as an adsorbent for the removal of PO₄^3--P in water. Prior to the adsorption experiment, the characteristics of activated clay was examined by X-ray Fluorescence Spectrometry (XRF) and BET surface area analyser. The adsorption of PO₄^3--P on activated clay was steeply increased within 0.25 h and reached equilibrium at 4 h. At 5 mg/L of low PO₄^3--P concentration, roughly 98% of adsorption efficiency was accomplished by activated clay. The adsorption data of PO₄^3--P were introduced to the adsorption isotherm and kinetic models. It was seen that both Freundlich and Langmuir isotherms were applied well to describe the adsorption behavior of PO₄^3--P on activated clay. For adsorption PO₄^3--P on activated clay, the Freundlich and Langmuir isotherm coefficients, K_F and Q, were found to be 8.3 and 20.0 mg/g, respectively. The pseudo-second-order kinetics model was more suitable for adsorption of PO₄^3--P in water/activated clay system owing to the higher correlation coefficient R² and the more proximity value of the experimental value q_e,exp and the calculated value q_e,cal than the pseudo-first-order kinetics model. The results of study indicate that activated clay could be used as an efficient adsorbent for the removal of PO₄³-P from water.

• Proceedings of the CALSEC Conference
• /
• 2001.08a
• /
• pp.25-33
• /
• 2001

eProcurement System io for the improvement of costs and productivity, and consists of eCatalog, eSourcing supporting the supplier selection, and ePurchase system supporting purchase request, approval, and PO.(omitted)

• Journal of Nutrition and Health
• /
• v.25 no.5
• /
• pp.351-359
• /
• 1992

This study was conducted to compare the effects of perilla oil or corn oil on lipid peroxidation and eicosanoid productions which are associated with the promotion of carcinogenesis. in liver or blood in rats. Male Sprague-Dawley8 weaning rats were fed on semisynthetic diets containing 15%(w/w) beef fat(BF). corn oil(CO) or perilla oil(PO) Three weeks after the half of rats in each diet group were injected with a single dose of 50mg 2-acetylaminofluorene (AAF)/Kg BW hepatocarcinogen intraperitoneally 3 times at 2-day interval and all of the rats were sacrificed after 8 weeks from the first injection. The rats fed on different dietary fats without 2-AAF treatment had not different MDA produc-tion and conjugated diene content in liver microsome. CO+AAf group had significantly higher conjugated diene content than BF+AAF and PO+AAF groups. and lower glucose-6-phospha-tase activity than BF+AAF group But PO+AAF had similar conjugated diene content to BF+AAF group and significantly lower MDA production than BF+AAF and CO+AAF groups. The hepatic mocrosomal lipid peroxidation was slightly greater in CO group than in PO group though perilla oil(P/S=9.67) has much more polyunsaturated fatty acids than corn oil(P/S=2.92) PG E2 level in liver and TX B2 level in plasma were significantly higher in CO group than in BF and PO groups. TX B2 level was lowered in CO and BF groups by 2-AAF treatment. These results reach to the contclousion than the type of dietary fatty acid as well as the P/S ratio has effect on hepatic microsomal lipid peroxidation and eicosanoid production and perilla oil or linolenic acid(n3) might be less effective on lipid peroxidation or PG E2 and TX B2 mediated tumor promotion than corn oil or linoleic acid(n6).

• Journal of the Korean Electrochemical Society
• /
• v.15 no.1
• /
• pp.27-34
• /
• 2012

$Li_3V_2(PO_4)_3$/carbon composite materials are synthesized from a sucrose-containing precursor. Amorphous $Li_3V_2(PO_4)_3/C$ (a-LVP/C) and crystalline $Li_3V_2(PO_4)_3/C$ (c-LVP/C) are obtained by calcining at $600^{\circ}C$ and $800^{\circ}C$, respectrively, and electrochemical performance as the negative electrode for lithium secondary batteries is compared for two samples. The a-LVP electrode shows much larger reversible capacity than c-LVP, which is ascribed to the spatial $Li^+$ channels and flexible structure of amorphous material. In addition, this electrode shows an excellent rate capability, which can be accounted for by the facilitated $Li^+$ diffusion through the defect sites. The sloping voltage profile is another advantageous feature for easy SOC (state of charge) estimation.

• Journal of the Korean Chemical Society
• /
• v.25 no.4
• /
• pp.236-245
• /
• 1981

The electrical conductivities of oxidized pure and Ni-doped $SrTiO_3$ single crystals were measured as a function of the oxygen partial pressure($Po_2$) at temperature from 700 to $1200^{\circ}C$ and $Po_2$ of $10^{-8}$ to $10^{-1}$ atm. Plots of log ${\sigma}$ vs. 1/T at constant $Po_2$ were found to be linear, and the activation energies obtained from the slopes of these plots have an average value of 1.34 eV for oxidized pure and 1.06 eV for oxidized Ni-doped $SrTiO_3$ single crystals at $Po_2$'s between $10^{-8}$ to $10^{-1}$ atm. The log ${\sigma}$ vs. log $Po_2$ curves at constant temperature were found to be linear with an average slope of ${\frac{-1}{5.6}}\;{\sim}\;{\frac{-1}{6.2}}$ in the $Po_2$ ranges. From the agreement between experimental and theoretically predicted values for the electrical conductivity dependences on $Po_2$, an oxygen vacancy defect model was found applicable to oxidized pure and Ni-doped $SrTiO_3$ single crystals over the temperature range, 700~$1200^{\circ}C$. Conduction mechanisms were proposed to explain the dependences of electrical conductivity on temperature and $Po_2$.