• Applied Chemistry for Engineering
• /
• v.20 no.3
• /
• pp.241-250
• /
• 2009

During the past few years, titanium salts were investigated as alternative coagulants for the removal of organic matter of different molecular sizes in contaminated water. The flocculation efficiency of Ti-salt was comparable to those of $FeCl_3$ and $Al_2(SO_4)_3$ salts, commonly used coagulants. Incinerated sludge-$TiO_2$ showed higher surface area and photocatalytic activity than commercially available $TiO_2$. Metal-doped forms were produced by adding coagulant aids such as iron (Fe-), aluminium (Al-) and (Ca-) calcium salts during Ti-salt flocculation to increase pH. Ca- and Al- doped $TiO_2$ showed very high photocatalytic activity compared to Fe-doped $TiO_2$. When tested in a pilot scale plant for treatment of dye wastewater to check practical feasibility of the novel process, the removal ratio of the chemical oxygen demand was comparable to those of commonly used coagulants but the settling of sludge was faster. The $TiO_2$ generated after sludge incineration showed a high photocatalytic activity for degradation of volatile organic compounds and increased the rate of hydrogen production by water photosplitting. $TiCl_4$ coagulant and $TiO_2$ produced from different water sources with different concentrations had low acute toxicity compared to heavy metals and commercial $TiO_2$ when examined based on D. Magna mortality. This paper presents the production, characterisation and the photoactivity of $TiO_2$ produced from Ti-salt flocculated sludge. Different case studies are discussed to highlighted recent advances in this field.

• Korean Journal of Environmental Agriculture
• /
• v.22 no.1
• /
• pp.26-35
• /
• 2003

An investigation was carried out to evaluate the effects of pebble size on the small-scale sewage treatment apparatus by natural purification method that consisted of aerobic and anaerobic plot. pH and EC in both plots varied minimally regardless of pebble size. DO in aerobic plot increased as the pebble size decreased. That in the anaerobic plot was slightly less in comparison with that of the aerobic plot but varied minimally, $2.4{\sim}5.1\;mg/L$ regardless of pebble size. Under all experimental conditions, removals of BOD, COD and turbidity in anaerobic plot were more than 98, 91 and 98, 98% respectively. Removals of T-N and T-P increased as pebble size decreased. Under all experimental conditions, removals of T-N and T-P in anaerobic plot were about $45{\sim}59$ and $480{\sim}96%$, respectively. Judging from the above results, it should be considered that the optimum pebble size and pebble permeability in both plot was $2{\sim}4$ and $0.1{\sim}4\;mm$, respectively.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.10 no.6 s.52
• /
• pp.137-145
• /
• 2006

Recently, the interests in structural monitoring of civil infrastructures are increased. Especially, as the civil infrastructures such as bridges, tunnels and buildings become large-scale, it is necessary to monitor and maintain the safety state of the structures, which requires smart systems that can supply long-term monitoring during the service time of the structures. In this paper, we investigated the possibilities of fiber optic sensor application to the various structures. We investigate the possibility of using fiber optic Bragg grating sensors to joint structure. The sensors show good response to the structural behavior of the joint while electric gauges lack of sensitivity, durability and long term stability for continuous monitoring. We also apply fiber optic structural monitoring to the composite repaired concrete beam structure. Peel-out effects is detected with optical fiber Bragg grating sensors and the strain difference between main structure and repaired carbon sheets is observed when they separate each other. The real field test was performed to verify the behaviors of fiber Bragg grating sensors attached to the containment structure in Uljin nuclear power plant in Korea as a part of structural integrity test which demonstrates that the structural response of the non-prototype primary containment structures. The optical fiber Bragg grating sensor smart system which is the probable means for long term assessments can be applicable to monitoring of structural members in various civil infrastructures.

• Preventive Nutrition and Food Science
• /
• v.14 no.2
• /
• pp.142-147
• /
• 2009

In this study, the selenium (Se) accumulations of soybean sprouts and mungbean sprouts treated with various concentrations of Se-solutions were evaluated, as part of a broader effort to produce Se-enriched variants of the plants. Four levels of sodium selenate ($Na_{2}SeO_{4}$)-dissolved solutions (i.e. 0, T0; 6, T1; 60, T2; and $600{\mu}g/mL$, T3) were prepared and sprayed onto the plants during cultivation. The effect of different spraying periods on Se accumulation was also assessed by watering plant groups once a day for periods of one, two, or three days. Se solution remaining on the surfaces of the plants was washed out by spraying with distilled water on the final day of cultivation. However, the increase of Se accumulation in the plants was found to depend on both Se-concentration and watering period, and the soybean sprouts were determined to accumulate Se more effectively than the mungbean sprouts. Additionally, with regard to Se accumulation in the plants, the period of application of Se solution was determined to be more important than the concentration of the Se solution applied. The averaged total levels of Se-enrichment in whole soybean sprouts at T0, T1, T2, and T3 were 0.26, 65.86, 179.62, and $525.12{\mu}g/dry$ matter (DM) g, respectively, and the relative equations relating Se enrichment in soybean sprouts (Y) against watering days (X) were Y=32.505X-36.17 (T1), Y=88.46X-92.04 (T2), and Y=251.11X-254.9(T3). The averaged total levels of Se-enrichment in the whole mungbean sprouts at T1, T2, and T3 group were 0.05, 3.64, and $101.43{\mu}g/DM$ g, respectively, and the relative equations relating Se enrichment (Y) to watering days (X) for mungbean sprouts were Y=1.67X-1.3467 at T1 and Y=48.035X-46.907 at T2. The results of this study suggest that soybean sprouts and mungbean sprouts enriched with bioavailable Se can be produced on a large scale by Se supplementation, allowing for the development of healthy functional foods such as Se-enriched mungbean sprout soups and salads, Se-enriched functional drink and food additives, and selenium tablets to promote health.

• The Journal of the Acoustical Society of Korea
• /
• v.35 no.3
• /
• pp.223-233
• /
• 2016

Design of a vegetation type sound barrier was presented as a noise barrier on the boundary of neighborhood facilities including schools, and apartments. The suggested noise barrier is made of unit blocks that are to be formed by stacking over the wall structure containing the plant and soils in the blocks. The advantage of the vegetation noise barrier is to acquire not only sound absorptive effects of plants and soils, but also sound diffusive effect caused by the irregular surface of the barrier which could eventually mitigate the noise. First, the optimum size of the units to obtain the highest noise reduction was investigated using 1/10 scaled model experiment, and sound attenuation experiments were carried out using a 1/2 mock-up model which is 2 m high and 5 m long. Total 1,137 unit blocks were made of synthetic woods with the size of $10{\times}10{\times}9cm$. These unit blocks were installed on the both side of the 1/2 mock-up steel framed noise barrier. As a result, it was revealed that the block typed vegetation noise barrier has 7 dB higher insertion loss in comparison with the general plane noise barrier. Also, it was found that the appropriate size of unit blocks is $20{\times}20cm$ which has large effect of sound insertion loss.

• Journal of the Korean GEO-environmental Society
• /
• v.11 no.9
• /
• pp.39-45
• /
• 2010

Controlled low strength material(CLSM) is produced by mixing portland cement, fine aggregates, water and chemical admixtures. Sand is the most commonly used as the fine aggregates in the conventional CLSM. It is getting more and more difficult to obtain sand in Korea so it is required that the alternative materials be developed as the replacement of sand. Since the engineering characteristics of coal ash are similar to the sand, it becomes necessary to examine the application of the coal ash as the alternative material for CLSM and as the environment-friendly material. When the results meet the optimum pH level that plants can live, it can be expanded the scale of application of the study on the plant as the important field. This study was subjected to present the method to reduce the pH range of CLSM to a suitable condition that plants can survive. To verify this method, the care of neutralization was conducted by immersing the specimen to Ammonium monohydrogen phosphate. Before curing and neutralization, the maximum pH of developmental CLSM is approximately 11. However, the pH value of developmental CLSM has under 9.5 after peaceful curing and neutralization management.

• Journal of Energy Engineering
• /
• v.20 no.1
• /
• pp.13-20
• /
• 2011

The high fuel flexibility of Micro Gas Turbine(MGT) has boosted their use in a wide variety of applications. Recently, the demand for biogas generated from the digestion of organic wastes and landfill as a fuel for gas turbines has increased. We researched the influence of firing landfill gas(LFG) on the performance and operating characteristics of a micro gas turbine combined heat and power system. $CH_4$ and $CO_2$ simultaneous recovery process has been developed for field plant scale to provide an isothermal, low operating cost method for carrying out the contaminants removal in Land Fill Gas(LFG) by liquid phase catalyst for introduce into the green house for the purpose of $CO_2$ rich cultivation of the plants. Methane purification and carbon dioxide stripping by muti panel autocirculation bubble lift column reactor utilizing Fe-EDTA was conducted for evaluate optimum conditions for land fill gas. Based on inflow rate of LFG as 0.207 $m^3$/min, 5.5 kg/$cm^2$, we designed reactor system for 70% $CH_4$ and 27% $CO_2$ gas introduce into MGT system with $H_2S$ 99% removal efficiency. A green house designed for four different carbon dioxide concentration from ambient air to 1500 ppm by utilizing the exhaust gas and hot water from MGT system.

• Horticultural Science & Technology
• /
• v.30 no.1
• /
• pp.34-41
• /
• 2012

The study was conducted in a glasshouse to examine the possibility of producing paprika plug seedlings in a newly developed inert phenolic foam growing medium. Plug seedlings of 'Fascinato' paprika were grown in five media, Grodan rockwool (Grodan Co. Ltd., Denmark), UR rockwool (UR Co. Ltd., Korea), phenolic foam LC (Smithers Oasis Korea Co. Ltd., Korea), phenolic foam RC, and phenolic foam 3813-4 all in a pellet type. Seeds were germinated in a growth chamber ($25^{\circ}C$, 90% RH, dark) for 4-5 days and then seedlings were grown in a glasshouse with nutrient solution supplied by an overhead irrigation system. Seedling growths were measured 20 days after sowing. The medium pH was the highest in the Grodan rockwool, and medium EC was the highest in phenolic foam 3813-4, although no nutritional excess disorders were observed. Germination rates of paprika were higher than 90% in all the media. Plant height, stem diameter, T/R ratio, leaf area, and chlorophyll showed a similar to those in the rockwool medium. Number of leaves, length of the longest root and dry weights of shoot were not significantly different among treatments. Overall, phenolic foam LC and RC produced seedlings with a similar growth as the rockwool medium. The results obtained suggest that rockwool can be replaced with a new material such as phenolic foam in the commercial scale production of plug seedlings of 'Fascinato' paprika.

• Analytical Science and Technology
• /
• v.26 no.6
• /
• pp.387-394
• /
• 2013

We aim to unveil dietary history recorded in Neolithic human bone from Janghang site at Gadeok Island, Busan. Excavation of Janghang site at Gadeok Island from 2010 to 2011 is an outstanding discovery in Korean Neolithic archaeology. A large number of human bones (48 individuals) were found at Janghang site, which is the largest-scale Neolithic cemetery in Korea. We extracted human bone collagen from 10 individuals and stable carbon and nitrogen isotope analysis were carried out using carbon and nitrogen analyzer connected to a continuous-flow isotope-ratio-monitoring mass-spectrometer. Although bone histological analysis shows poor preservation state, stable isotope results correspond well with bone collagen quality indicator, which implies that bone collagen reflects lifetime signature. Stable carbon and nitrogen isotope result indicates highly marinebased diet(${\delta}^{13}$C=$-14.5{\pm}1.3$‰, ${\delta}^{15}$N=$-17.4{\pm}1.7$‰, n=10), however the possible input of terrestrial animal and wild plant cannot be excluded. Our isotopic findings provide an invaluable information on Neolithic subsistence economy in this coastal area. In addition, Janghang site shows specific features in burial methods and burial goods. Two different burial methods of arranging bodies are found with extended burial type and particularly high ratio of flexed burial type. There are also burial goods such as pottery. However, there are no significant isotopic differences according to burial methods and burial goods. Although this is a preliminary study on this site, our research will provide important clues in understanding isotopic dietary history of Korean Neolithic people.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.8 no.3
• /
• pp.81-88
• /
• 2000

Composting of N-rich wastes such as food waste and wastewater sludges can be associated loss of with substantial gaseous N, which means loss of an essential plant nutrient but may also lead to environmental pollution. We investigated the behavior of nitrogenous materials during the first high-rate phase in composting of food waste. Air dried food waste was mixed with shredded waste paper or wood chip and reacted in a bench scale composting reactor. Samples were analyzed for pH, ammonia, oxidized nitrogen and organic nitrogen. The volatilized ammonia nitrogen was also analyzed using sulfuric acid as an absorbent solution. Initial progress of composting reaction greatly influenced the ammonification of organic nitrogen. A well-balanced composting reaction with an addition of active compost as an inoculum resulted in the promoted mineralization of organic nitrogen and volatilization of ammonia. The prolongation of initial low pH period delayed the production of ammonia. It was also found that nitrogen loss was highly dependent on the air flow supplied. With an increase in input air flow, the loss of nitrogen as an ammonia also increased, resulted in substantial reduction of ammonia content in compost. The conversion ratio of initial nitrogen into ammonia was in the range of 28 to 38% and about 77~94% of the ammonia produced was escaped as a gas. Material balance on the nitrogenous materials was demonstrated to provide an information of importance on the behavior of nitrogen in composting reaction.