• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.58 no.11
• /
• pp.2242-2246
• /
• 2009

In this paper, a homogeneous dual composite right/left-handed (D-CRLH) transmission line (TL) is proposed by using a defected ground structure (DGS) on the ground plane. In order to satisfy a homogeneity condition of metamaterial, a subwavelength unit cell is designed by way of a spiral DGS and a meander stub. From a dispersion diagram, it is expected that the frequency bands for the left-handed (LH) property is 3.5 - 4.4 GHz. At 3.8 GHz in the LH band, backward propagating phenomenon is observed from full-wave analysis. The experimental results show that the proposed TL has a stop-band in 1.75 - 3.6 GHz.

• Journal of KSNVE
• /
• v.9 no.2
• /
• pp.340-347
• /
• 1999

The acoustic performance of reactive type single expansion chamber can be calculated theoretically by plane wave theory. But higher order model should be considered to widen the frequency range. Mode matching method has been developed to consider higher order modes, but very complicated algebra should be used. Munjal suggested a numerical collocation method, which can overcome the shortcomings of mode matching method, using the compatibility conditions for acoustic pressure and particle velocity at the junctions of area discontinuities. But the restriction of Munjal's method is that the ratio between the area of inlet(or outlet) pipe and that of chamber must be natural number. In this paper, the new method was suggested to overcome the shortcomings of Munjal's method. The predictions by this method was also compared with those by the finite element method and Munjal's method in order to demonstrate the accuracy of the modified method presented here.

• Journal of the Optical Society of Korea
• /
• v.7 no.1
• /
• pp.38-41
• /
• 2003

We present an analysis of highly-dispersive guided modes of two-dimensional photonic crystal waveguides. By the plane ave expansion method, band structures and mode profiles of two-dimensional photonic crystal waveguides are obtained. It is found that guided modes have very small group velocities and very large group velocity dispersions in the region near the f-point and in the region near the Brillouin zone edge. Especially, the group velocity dispersions are found to be millions of times larger than that of a conventional optical fiber. The contributions of the transverse resonance formed by two photonic band gap reflectors and the standing wave mode formed by periodic structures are discussed. We conclude that the highly-dispersive characteristics originate from the resonator-like aspect of the photonic crystal waveguide.

• Journal of the Korean earth science society
• /
• v.32 no.2
• /
• pp.161-169
• /
• 2011

Focal mechanism solutions in the central and western areas of the Korean Peninsula (36-37.8$^{\circ}N$, 126-128$^{\circ}E$) were obtained from the analysis of the recent seventeen earthquakes (M${\geq}$2.2) which occurred from January, 2005 to May, 2010. The spatial differences between the epicenters recalculated by this study and those announced by the Korea Meteorological Administration are less than $0.03^{\circ}$, indicating a small deviation. Focal mechanism solutions were obtained from the analysis of P wave polarities, SH wave polarities and SH/P amplitude ratios. The focal mechanism solutions show dominant strike-slip faulting or oblique slip faulting with strike-slip components. The P-axes trends are mainly ENE-WSW or E-W directions. The direction of fault plane and auxillary fault plane with NNE-SSW and WNW-ESE are almost parallel to the general trends of lineaments in the study area. The results also show that focal mechanism solutions and the main axis of stress field in the Kyonggi massif and Okchon belt are almost same.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2008.11a
• /
• pp.71-81
• /
• 2008

This paper proposes a spectral element which can represent dynamic responses in high frequency domain such as Lamb waves on a thin plate. A two layer beam model under 2-D plane strain condition is introduced to simulate high-frequency dynamic responses induced by piezoelectric layer (PZT layer) bonded on a base plate. In the two layer beam model, a PZT layer is assumed to be rigidly bonded on a base beam. Mindlin-Herrmann and Timoshenko beam theories are employed to represent the first symmetric and anti-symmetric Lamb wave modes on a base plate, respectively. The Bernoulli beam theory and 1-D linear piezoelectricity are used to model the electro-mechanical behavior of a PZT layer. The equations of motions of a two layer beam model are derived through Hamilton's principle. The necessary boundary conditions associated with electro mechanical properties of a PZT layer are formulated in the context of dual functions of a PZT layer as an actuator and a sensor. General spectral shape functions of response field and the associated boundary conditions are formulated through equations of motions converted into frequency domain. A detailed spectrum element formulation for composing the dynamic stiffness matrix of a two layer beam model is presented as well. The validity of the proposed spectral element is demonstrated through comparison results with the conventional 2-D FEM and the previously developed spectral elements.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.17 no.3
• /
• pp.209-214
• /
• 2017

A plane-wave incident upon asymmetric multi-layered dielectric grating as well as symmetric grating structure generates space harmonics. Selected space harmonics among those harmonics can undergo strong resonance scattering variations known as GMR(guided-mode resonance). In this paper, to clarify these effects, the field propagation and dispersion curve inside the grating region are analyzed by using a rigorous equivalent transmission-line theory(RETT) based on eigenvalue problem. The results show that, at the peak of a scattering resonance, the reflected mode is almost identical to a leaky wave that can be supported by the grating structure. Thus, it confirms to be occurred GMR effect associated with the free-resonant character of leaky waves at asymmetric multi-layered dielectric gratings. Quantitative simulation results illustrating the behavior of typical gratings are given, and the special case of normal incidence is discussed for TE and TM modes.

• Journal of Korean Ophthalmic Optics Society
• /
• v.10 no.1
• /
• pp.9-15
• /
• 2005

The polariscope to measure the microscopic stress in CR lens consists of light source polarizer, model, polarizer, CCD, computer, chrome conversion orderly and the principal-stressed difference, (${\sigma}_1-{\sigma}_2$) and the fringe order n were measured by analyzing two components of light wave $E_1$ and $E_2$ following each polarizer's steps. The two-dimensional model could be determined from the fact that the optical axes of sample concide with the principal-stress directions. The bi-refringence acted to a light wave and the phase retardation were in proportion to the principal-stressed difference(${\sigma}_1-{\sigma}_2$) and the intensity of final light wave was proportioned to $sin2({\Delta}/2)$ and when ${\Delta}/2=n{\pi}$ (n=0, 1, 2, ${\ldots}$) the extinction occurs. Photoelastic's image by microscopic stress could analyzed using chrome conversion, and the image showed clearly.

• The Journal of the Acoustical Society of Korea
• /
• v.27 no.3
• /
• pp.140-148
• /
• 2008

In this study, a numerical method for a time-domain acoustic wave backscattering analysis is established based on a physical optics and a Fourier transform. The frequency responses of underwater targets are calculated based on physical optics derived from the Kirchhoff-Helmholtz integral equation by applying Kirchhoff approximation and the time-domain signals are simulated taking inverse fast Fourier transform to the obtained frequency responses. Particularly, the adaptive triangular beam method is introduced to calculate the areas impinged directly by acoustic incident wave and the virtual surface concept is adopted to consider the multiple reflection effect. The numerical analysis result for an acoustic plane wave field incident normally upon a square flat plate is coincident with the result by the analytic time-domain physical optics derived theoretically from a conventional physical optics. The numerical simulation result for a hemi-spherical end-capped cylinder model is compared with the measurement result, so that it is recognized that the presented method is valid when the specular reflection effect is predominant, but, for small targets, gives errors due to higher order scattering components. The numerical analysis of an idealized submarine shows that the established method is effectively applicable to large and complex-shaped underwater targets.

• Journal of the Korean earth science society
• /
• v.34 no.1
• /
• pp.59-68
• /
• 2013

Focal mechanism solutions in the southwestern region of the Korean Peninsula ($34^{\circ}N-36^{\circ}N$, $126^{\circ}E-128^{\circ}E$) were obtained from the analysis of the recent 22 earthquakes ($M{\geq}2.0$) occurred from January, 2005 to March, 2011. The spatial differences between the epicenters recalculated by this study and those by KMA (Korea Meteorological Administration) and KIGAM (Korea Institute of Geoscience and Mineral Resources) are less than $0.05^{\circ}$, indicating a small deviation. However, they become a little bit larger in the coastal area due to a biased arrangement of seismic stations. Redetermined depths of hypocenters show a difference less than 12.7 km by comparison with the depth data announced by KIGAM. Most epicenters in inland area are located closely to the lineaments. Fault plane solutions were obtained from the analysis of P and SH wave polarities, and SH/P amplitude ratios. They show strike-slip faulting or strike-slip faulting with reverse components dominantly. The P-axes trends are mainly ENE-WSW or E-W directions. The direction of fault plane and auxiliary plane with 'NNE-SSW and WNW-ESE' or 'NE-SW and NW-SE' are dominant and almost parallel to the general trends of lineaments in the study area.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.3 no.4
• /
• pp.235-243
• /
• 1991

This paper is concerned with developing infinite elements which are applicable to wave diffraction and radiation problems in the vertical plane. The near need region surrounding the solid body is modeled using conventional finite elements. but the far fold region is represented using the infinite elements developed in this study. The shape functions for the infinite elements are derived from the analytical eigenseries solution of the scattered waves in the far field region. The system matrices of the elements are constructed by performing the integration in the infinite direction analytically to achieve computational efficiency. Numerical analysis is carried out for two floating bodies with different cross-sectional shapes to prove the efficiency and validity of the elements. Numerical experiments are also performed to determine the suitable location of the infinite elements which directly affect accuracy and efficiency of the solution.