• 한국가시화정보학회:학술대회논문집
• /
• 2001.12a
• /
• pp.14-22
• /
• 2001

The frequency responses on the sub-pixel evaluation technique were investigated using the Monte-calro Simulation technique. The frequency response by the FFT based cross-correlation gives very good results, however, the gain loss does exist for the small displacement, (less than 0.5 pixel). While, the no gain loss is observed in the Direct Cross-correlation, however, the sub-pixel accuracy was limited to be about 0.1 pixel, i.e., it could not detect the small displacement. To detect the higher accurate sub-pixel displacement, the gradient based technique is the best. For the small interrogation area (e.g., 4x4), only the gradient technique can detect the small displacement correctly.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.10B
• /
• pp.1813-1820
• /
• 2000

In this paper we proposed an efficient multiresolution motion estimation(MRME) algorithm using half-pixel accuracy motion estimation (HPAME) and characteristics of motion vectors in the baseband. Conventional MRME method needs exact motion vectors in the baseband because those are used as initial motion vectors in higher frequency subbands. Therefore the proposed method uses HPAME to estimate the motion vectors exactly in the baseband. Based on the characteristics of these motion vectors the motion vectors in the higher frequency subbands are selectively estimatied. That is motion vectors in the higher frequency subbands are estimated only for the blocks which have the half-pixel accuracy motion vectors in the baseband. In the proposed method by using HPAME in the baseband and selective motion estimation in the higher frequency subbands we can obtain reconstructed image with the similar quality with the conventional method though we reduce the computational complexity and the bit rate considerably.

• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 2017.04a
• /
• pp.157-157
• /
• 2017

To minimize the damage by wild birds and acquire the benefits such as protection against weeds and maintenance of water content in soil, the mulching black color vinyl after seeding should be carried out. Non-contact and non-destructive methods that can continuously determine the locations are necessary. In this study, a crop position detection method was studied that uses infrared thermal image sensor to determine the cotyledon position under vinyl mulch. The moving system for acquiring image arrays has been developed for continuously detecting crop locations under plastic mulching on the field. A sliding mechanical device was developed to move the sensor, which were arranged in the form of a linear array, perpendicular to the array using a micro-controller integrated with a stepping motor. The experiments were conducted while moving 4.00 cm/s speed of the IR sensor by the rotational speed of the stepping motor based on a digital pulse width modulation signal from the micro-controller. The acquired images were calibrated with the spatial image correlation. The collected data were processed using moving averaging on interpolation to determine the frame where the variance was the smallest in resolution units of 1.02 cm. Non-linear integral interpolation was one of method for analyzing the frequency using the normalization image and then arbitrarily increasing the limited data value of $16{\times}4pixels$ in one frame. It was a method to relatively reduce the size of overlapping pixels by arbitrarily increasing the limited data value. The splitted frames into 0.1 units instead of 1 pixel can propose more than 10 times more accurate and original method than the existing correction method. The non-integral calibration method was conducted by applying the subdivision method to the pixels to find the optimal correction resolution based on the first reversed frequency. In order to find a correct resolution, the expected location of the first crop was indicated on near pixel 4 in the inversion frequency. For the most optimized resolution, the pixel was divided by 0.4 pixel instead of one pixel to find out where the lowest frequency exists.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.10
• /
• pp.2514-2526
• /
• 2013

This paper presents a detection method for least significant bit matching revisited (LSBMR) steganography. Previous research shows that the adjacent pixels of natural images are highly correlated and the value 0 appears most frequently in pixel difference. Considering that the message embedding process of LSBMR steganography has a weighted-smoothing effect on the distribution of pixel difference, the frequency of the occurrence of value 0 in pixel difference changes most significantly whereas other values approximately remain unchanged during message embedding. By analyzing the effect of LSBMR steganography on pixel difference distribution, an equation is deduced to estimate the frequency of difference value 0 using the frequencies of difference values 1 and 2. The sum of the ratio of the estimated value to the actual value as well as the ratio of the frequency of difference value 1 to difference value 0 is used as the steganalytic detector. Experimental results show that the proposed method can effectively detect LSBMR steganography and can outperform previous proposed methods.

• Proceedings of the KSRS Conference
• /
• 2005.10a
• /
• pp.604-607
• /
• 2005

All CCD pixels do not react uniformly even if the light of same radiance enters into the camera. This comes from the different camera optical characteristics, the read-out characteristics, the pixel own characteristics and so on. Usually, the image data of satellite camera can be corrected by the various image-processing methods in the ground. However, sometimes, the in-orbit correction is needed to get the higher quality image. Especially high frequency pixel correction in the middle of in-orbit mission is needed because the in-orbit data compression with the high frequency loss is essential to transmit many data in real time due to the limited RF bandwidth. In this case, this high frequency correction can prevent have to have any unnecessary high frequency loss. This in-orbit correction can be done by the specific correction table, which consists of the gain and the offset correction value for each pixel. So, it is very important to get more accurate correction table for good correction results. This paper shows the new algorithm to get accurate pixel correction table. This algorithm shall be verified theoretically and also verified with the various simulation and the test results.

• Current Optics and Photonics
• /
• v.5 no.4
• /
• pp.409-420
• /
• 2021

We propose a method to synthesize a color non-hogel-based computer-generated-hologram (CGH) from light field data of a three-dimensional scene with a hologram pixel pitch shared for all color channels. The non-hogel-based CGH technique generates a continuous wavefront with arbitrary carrier wave from given light field data by interpreting the ray angle in the light field to the spatial frequency of the plane wavefront. The relation between ray angle and spatial frequency is, however, dependent on the wavelength, which leads to different spatial frequency sampling grid in the light field data, resulting in color aberrations in the hologram reconstruction. The proposed method sets a hologram pixel pitch common to all color channels such that the smallest blue diffraction angle covers the field of view of the light field. Then a spatial frequency sampling grid common to all color channels is established by interpolating the light field with the spatial frequency range of the blue wavelength and the sampling interval of the red wavelength. The common hologram pixel pitch and light field spatial frequency sampling grid ensure the synthesis of a color hologram without any color aberrations in the hologram reconstructions, or any loss of information contained in the light field. The proposed method is successfully verified using color light field data of various test or natural 3D scenes.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.05a
• /
• pp.364-367
• /
• 2013

In this paper, we propose a method about reducing facial blemishes using Morphological Operation. First, we detect skin region using pixel data of RGB's each channel image. we create histogram of skin region R, G, B channel and save 3 pixel values that are high frequency pixel value in each channel. After than, we find facial blemishes using Black-hat operation. The pixel value of facial blemishes changes average of its pixel value, 8-neighborhood pixel value and high frequency pixel values. And the facial blemishes pixel is blurred with median filter. The result of this test with facial pictures that have facial blemishes, we prove that this system that correct the face skin using reduction facial Blemishes is more efficient method than correct the face skin just using lighting up.

• Journal of Korea Multimedia Society
• /
• v.16 no.4
• /
• pp.411-417
• /
• 2013

In this paper, we proposed a fast detection method of copy-move forgery image based on low frequency coefficients of the DCT coefficients. We proposed a new matching criterion of copy-moved forgery image detection (MCD) using discrete cosine transform. For each $8{\times}8$ pixel block, the DCT transform is calculated. Our algorithm uses low frequency four (DC, 3 AC coefficient) and six coefficients (DC, 5 AC coefficients) of DCT per $8{\times}8$ pixel block. Our algorithm worked block matching for DCT coefficients of the $8{\times}8$ pixel block is slid by one pixel along the image from the upper left corner to the lower right corner. Our algorithm can reduce computational complexity more than conventional copy moved forgery detection algorithms.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.41 no.5
• /
• pp.135-141
• /
• 2004

Image interpolation is an image enlargement method that calculates an empty pixel value using the information of given pixel values. Since a natural image is composed of various spatial frequency components, it is difficult for one method to interpolate pixels with various spatial frequencies. In this paper, we propose an image interpolation method using multiple neural networks with spatial frequency characteristic. Input image is segmented according to spatial frequency by local variance, and each segmented image is interpolated using neural network established for spatial frequency band. The proposed method is applied to line doubling that becomes an important part in image interpolation because of deinterlacing. In simulation the proposed algorithm shows the improved PSNR result compared with conventional algorithms and method using single neural network.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.4
• /
• pp.261-269
• /
• 2019

This study investigates a method of designing pixel-type frequency selective surfaces(FSS) with flexibility while considering factors, such as polarization and incident angle. Among the various methods used to solve the discrete space problem when designing a pixel-type FSS, the binary particle swarm optimization(BPSO) algorithm is one of the most applicable techniques to determine the periodic structure pattern of an FSS. Therefore, a method of efficiently designing FSS with roll-off band pass characteristics using an improved BPSO algorithm is proposed. To solve the convergence problem in the fitness function design to induce particles in the desired solution, FSS with desired roll-off wave characteristics can be easily obtained by applying a fitness function using "slope" as an input parameter.