• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 2004년도 유체기계 연구개발 발표회 논문집
• /
• pp.614-625
• /
• 2004

The main purpose of this study is to get flowrate coefficient 'q' and to study characteristics of flowrate of screw pump. This study is based on Muskin's formula and depends on the computer simulation. The results of study are as follows. 1. Flowrate coefficient will reduce according to increase of inclination. The larger the pitch ratio is and the smaller the diameter ratio is, the more coefficient reduces. 2. As a rule, the coefficient increases according to reduction of the diameter ratio, but the coefficient tends to reduce when the ratio is less than 0.45. So, in actual application, it is recommended that the ratio should be above 0.45. 3. If the pitch ratio increases, the coefficient increases in case of small inclination and decreases in case of large inclination. 4. The coefficient increases according to number of windings. Especially, singles winding is not used in actual application because it has too small coefficient. 5. The coefficient decreases when the influent water level falls. Flowrate is almost zero when the water level is below $40\%$ of Filling Points.

• 한국세라믹학회지
• /
• 제28권11호
• /
• pp.908-916
• /
• 1991

The characteristics of the carbonized and calcined products made from coal tar pitch coke and coal tar pitch, were investigated in the aspect of the manufacture of isotropic graphite with high density. The mesophase from the pitch was rapidly formed at higher heat-treatment temperature between 410$^{\circ}C$ and 450$^{\circ}C$, where the insolubes in the pitch accelerated the rate of nucleation and growth of the mesophase. The benzene insolubles and the quinoline insolubes were increased as the heat treatment temperature and the heat-treatment time increased. The ratio of benzene insolubles and quinoline solubles (BI/QS) was decreased as the heat-treatment temperature was higher and maintained to be nearly constant regardless of heat-treatment time at fixed heat treatment temperature. The bulk density of the calcined carbon was linearly proportional to the ratio of quinoline solubes to volatile matter in the green coke. Anisotropic ratio of electrical resistance was measured to be between 0.98 and 1.10.

• Carbon letters
• /
• 제28권
• /
• pp.24-30
• /
• 2018

Coke aggregates and carbon artifacts were produced to investigate the interactions of coke and pitch during the kneading process. In addition, the kneading ratio of the coke and binder pitch for the coke aggregates was controlled to identify the formation of voids and pores during carbonization at $900^{\circ}C$. Experiments and thermogravimetric analysis revealed that carbon yields were improved over the theoretical yield calculated by the weight loss of the coke and binder pitch; the improvement was due to the binding interactions between the coke particles and binder pitch by the kneading process. The true, apparent, and bulk densities fluctuated according to the kneading ratio. This study confirmed that an excessive or insufficient kneading ratio decreases the density with degradation of the packing characteristics. The porosity analysis indicated that formation of voids and pores by the binder pitch increased the porosity after carbonization. Image analysis confirmed that the kneading ratio affected the formation of the coke domains and the voids and pores, which revealed the relations among the carbon yields, density, and porosity.

• 한국인터넷방송통신학회논문지
• /
• 제20권6호
• /
• pp.21-26
• /
• 2020

본 논문에서는 자수된 SF-MPAA 구현을 위해 방사체를 자수로 구현할 경우 방사체 구조에 따른 SF-MPAA의 특성을 조사 하였다. 자수된 방사체의 길이방향의 그리드 수와 폭 방향의 그리드 수를 줄여서 피치를 늘렸을 때 안테나 이득과 공진주파수는 추세적으로 감소하였다. 그러나 안테나 특성은 폭 방향의 피치에는 크게 영향을 받으나 길이 방향의 피치에는 상대적으로 영향을 적게 받았다. 따라서 도체비율을 줄이기 위해 길이 방향의 그리드 수를 줄이는 것이 유리함을 알 수 있었다. SLL은 피치보다는 길이와 폭 방향 피치의 조합에 영향을 받았다. 자수된 방사체의 도체비율은 자수실 굵기에 대한 피치의 비율로 결정이 되었다. 이 비율이 5이하에서는 도체비율이 급격히 감소했고 5이상에서는 포화되어 서서히 감소했다.

• 사상체질의학회지
• /
• 제15권1호
• /
• pp.50-59
• /
• 2003

Purpose Five animals sounds which are come under five sounds(Gong, Sang, jiao, zhi, yu) which are compared with the musical scale. It is looking for similarity between five animals' sounds and the musical scale. Methods 녹음 record 1 ig machine 1. Five animals (cattle, horse, pheasant, pig, sheep) sounds has been recording on tape. 2. That was transfer to CSL(computerized speech lab) 3. That was analysed to pitch, formant 1,2,3. energy pitch 4. That analysed result (Pitch, formant 1,2,3. energy ratio) of five animals are calculated and compared with the five musical scale(five sounds) Result The ratio of five animals sounds is not consistent with the musical scale in any five item (pitch, formant 1,2,3. energy). Conclusion 1.The five musical scale has no similarity with the five animals sounds 2.The five sound is supposed to oriented form theoretical back ground of five-going not have no relative with the five animals sounds

• Wind and Structures
• /
• 제38권5호
• /
• pp.341-354
• /
• 2024

This paper presents a theoretical method to deal with the aerodynamic performance and pitch optimization of the horizontal axis wind turbine blades at low wind speeds. By considering a blade element, the functional relationship among the angle of attack, pitch angle, rotational speed of the blade, and wind speed is derived in consideration of a quasi-steady aerodynamic model, and aerodynamic loads on the blade element are then obtained. The torque and torque coefficient of the blade are derived by using integration. A polynomial approximation is applied to functions of the lift and drag coefficients for the symmetric and asymmetric airfoils respectively, where specific expressions of aerodynamic loads as functions of the angle of attack (which is a function of pitch angle) are obtained. The pitch optimization problem is investigated by considering the maximum value problem of the instantaneous torque of a blade as a function of pitch angle. Dynamic pitch laws for HAWT blades with either symmetric or asymmetric airfoils are derived. Influences of parameters including inflow ratio, rotational speed, azimuth, and wind speed on torque coefficient and optimal pith angle are discussed.

• 한국전산유체공학회지
• /
• 제13권1호
• /
• pp.21-27
• /
• 2008

A numerical study for laminar flow in the entrance region of helical tubes for uniform inlet velocity conditions is carried out by means of the finite volume method to investigate the effects of Reynolds number, pitch and curvature ratio on the flow development. This results cover a curvature ratio range of 1/10$\sim$1/320, a pitch range of 0.0$\sim$3.2, and a Reynolds number range of 125$\sim$2000. It has been found that the curvature ratio does significantly effect on the angle of flow development, but the pitch and Reynolds number do not. The characteristic angle $\phi_c(=\phi/\sqrt{\delta})$, or the non-dimensional length $\overline{l}(=l\sqrt{\delta}cos(atan\lambda)/d)$ can be used to represent the flow development for uniform inlet velocity conditions. In uniform inlet velocity conditions, the growth of boundary layer delays the flow development attributed to centrifugal force, and in which conditions the amplitude of flow oscillations is smaller than that in parabolic inlet velocity conditions. If the pitch increases or if the curvature ratio or Reynolds number decreases, the minimum friction factor and the fully developed average friction factor normalized with the friction factor of a straight tube and the flow oscillations decrease.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2009년도 하계학술발표대회 논문집
• /
• pp.266-271
• /
• 2009

The present study numerically investigated the effect of the geometry of the flattened tube on the thermal performance of a high temperature generator (HTG) of a double effect LiBr-water absorption system. The heat transfer tubes of the HTG were arranged behind a metal fiber burner. The heat transfer of the tubes of HTG were consisted with a set of circular and flattened tubes in series. FLUENT, as a commercial code, was applied for estimating the thermal performance of the HTG. Key parameters were the tube arrangement in the HTG. Temperature and velocity profiles in the HTG were calculated to estimate the thermal performance of the HTG. The heat transfer rate of a HTG tube was increased, and the gas temperature around the flattened tube was decreased as the pitch ratio was increased. The heat transfer rate for the circular tube bundle with the pitch ratio of 2.48 were larger by 10% respectively than that of 2.10 and the heat transfer rate for the flattened tube bundle with the pitch ratio of 1.88 were larger by 36% respectively than that of 1.63.

• 반도체디스플레이기술학회지
• /
• 제21권4호
• /
• pp.45-49
• /
• 2022

Through Silicon Via (TSV) is a technology that interconnects chips through silicon vias. TSV technology can achieve shorter distance compared to wire bonding technology with excellent electrical characteristics. Due to this characteristic, it is currently being used in many fields that needs faster communication speed such as memory field. However, there is performance degradation issue on TSV technology due to the parasitic capacitance. To deal with this problem, in this study, the parasitic capacitance with TSV design factors is analyzed using commercial tool. TSV design factors were set in three categories: size, aspect ratio, pitch. Each factor was set by dividing the range with TSV used for memory and package. Ansys electronics desktop 2021 R2.2 Q3D was used for the simulation to acquire parasitic capacitance data. DOE analysis was performed based on the reaction surface method. As a result of the simulation, the most affected factors by the parasitic capacitance appeared in the order of size, pitch and aspect ratio. In the case of memory, each element interacted, and in the case of package, it was confirmed that size * pitch and size * aspect ratio interact, but pitch * aspect ratio does not interact.

• 한국항공우주학회지
• /
• 제39권2호
• /
• pp.137-143
• /
• 2011

중력구배 인공위성의 pitch 운동이 관성 모멘트 비와 편심율에 따라 혼돈계가 될 수 있다. 혼돈계의 경우 운동의 정확한 예측을 위하여 비혼돈계로 전환하는 혼돈계 제어가 필요하다. 혼돈계 제어에는 feedback control system을 사용할 수 있다. 중력구배 인공위성의 pitch 운동의 혼돈계 제어를 위하여, 비선형 pitch 운동 방정식을 선형화를 하여 linear nonautonomous system을 구하고, 이를 근거로 pitch 운동의 혼돈계 제어와 안정화(stabilization)를 위한 제어법칙을 설계하고 원래의 비선형 혼돈계 pitch 운동에 적용하였다. 설계된 pitch 운동 제어계는 두 개의 parameter를 가지는데, 혼돈계 제어와 안정화에 만족할 만한 결과를 보여주었다.