• Proceedings of the KIEE Conference
• /
• 1998.07d
• /
• pp.1398-1400
• /
• 1998

The physical properties of the LB films with merocyanine dyes have been published and attract attention due to the possibility of molecular structure control. The evaluation of the thin films was focused for the purpose of molecular structure control. The molecular structure in the case of the thin films with dyes can be examine by optical absorption spectra measurements. In the case of optical absorption spectra of the LB films by the heat treatment at $70^{\circ}C$ in the air, both of the shifted absorption bands decay and a monomer absorption peak of about 530 nm appears instead. And, the formation and dissociation of J-aggregates, anisotropic behavior was no longer observed in the heat treated merocyanine dyes LB films. In the results, study of the merocyanine dyes LB films using optical absorption spectra would an interesting problem of absorption peak shifts and mixed components.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1997.11a
• /
• pp.132-135
• /
• 1997

The absorption coefficient of contrast media was meassured region of diagnostic radiology. Relative values of absorption coefficient was fecund the largest peak in the range of 60 ∼ 70kVp for sodium sulfate and 60kVp for iodine. Increasing the thickness of contrast media and patient the values of absorption coefficient was rising.

• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.895-898
• /
• 1999

We calculated Al-Absorption, Al-reflection, and Si-etching probabilities as a function of incident angle and energy using classical molecular dynamics (MD) simulation. Variations of the cases of Al-absorption rate and Al-reflection rate are less than that of Si-etching rate. In contrast with general prediction, our simulation results showed that channeling of the <110> direction occurred the most in the case of incident angle between 30degree and 40degree. We investigated that channeling of the <110> directions quite affect Al-absorption rate in silicon. Since Si-etching rate is high and Al-absorption rate by <110> channeling is high, we found that Al ionized physical vapor deposition (PVD) on Si(001) has a different characteristics with Al ionized PVD on A1(111).

• Asian-Australasian Journal of Animal Sciences
• /
• v.15 no.9
• /
• pp.1354-1358
• /
• 2002

Two hundred and ten post-larvae (PL) of Macrobrachium rosenbergii (14.5-14.9 mg) were equally distributed in two experimental groups and fed with either steam cooked or extruded pellet for a period of 60 days. Physical evaluation and growth promoting effect of both the pellets were assessed. Significantly higher (p<0.05) water stability, absorption and protein efficiency ratio (PER) were recorded in extruded pellet than the steam cooked pellet. Nutrient loss was minimum in the extruded pellet for which lower feed conversion ratio (FCR) (p<0.05) was recorded in this group. However, weight gain, relative growth and specific growth rate (SGR) in both the groups were not significantly different (p>0.05). Although insignificant (p>0.05) but higher amylase activity was recorded in steam pellet fed group. Survival was not affected by feeding either of the diets.

• The Journal of Korean Physical Therapy
• /
• v.14 no.4
• /
• pp.412-422
• /
• 2002

The use of biochemical markers of bone turnover may be particular interest in the investigation of bone disorders with osteoporosis. Serum osteocalcin(OC), total alkaline phosphatase and procollagen C, reflecting bone formation, and urinary pyridinium cross-links excretion, reflecting bone reabsorption have been measured in hyperthyroidism, postmenopause women, after testosterone supplementation, androgen, testosterone and estrogen deficiency, bone mineral density degree, age duration. Bone marks which is reflect to metabolic bone disorders are biochemical indices method to measure enzyme activity about bone formation, bone absorption and bone components in blood or urine. Bone metabolism biochemical marks are correlated with osteophorotic agents and also represent significantly different between bone mineral density and bone biochemical marks. Therefore if we develope and use bone metabolism marks which have higher sensitivity and specificity in bone formation and bone absorption, I think that these bone biochemical marks can have utility in the clinical application to predict osteoporosis risk group, bone loss, bone fracture and response degree to treatment of osteoporosis risk groups.

• Advances in concrete construction
• /
• v.12 no.6
• /
• pp.461-467
• /
• 2021

Polyethylene-terephthalate (PET) from bottle waste and linear low-density polyethylene (LLDPE) from barrels and tanks waste are widely available and need to be recycled. Recycling them in concrete and mortar is an alternative solution for their disposal. In this study various quantities of sand (5%, 10%, 15% and 20%) were substituted by powder from LLDPE waste. In addition, PET waste fibers (corrugated, straight) were added to the mortar with different percentages (0.5%, 1%, 1.5% and 2%) of cement mass. This paper evaluate the mechanical and physical properties of the composites in fresh (workability, air content and density) and hardened state (compressive and flexural strength, water absorption and total shrinkage). From the experimental results, it can be concluded that the strengthening in tensile of the mortar with plastic waste corrugated fibers is improved. Other important results are that the water absorption and the density rate are less than that of the ordinary mortar.

• 보존과학연구
• /
• s.31
• /
• pp.43-57
• /
• 2010

This study intends to provide quantitative data about the extraction characteristics of major elements of earthenware by executing soaking test of cleaning agents. It aims at providing basic data for the stability assessment when applying the cleaning agents for conserving earthenware. The data will be extracted from the analysis of co-relationship between the physical characteristics and the ion extraction characteristics. XRD analysis displayed that AT-1, AT-2 and AT-3 which did not generate mullite were fired at lower than 1,000 whereas AT-3 and AT-5 that included mullite were higher than 1,000. The degree of absorption was AT-4 > AT-2 > AT-1 > AT-3 > AT-5 in order and the correlation between the degree of absorption and firing temperature of earthenware displayed a positive correlation. Extraction amount of oxalic acid which was used for the removing iron oxide was AT-1 > AT-2 AT-4 > AT-3 > AT-5 in order. and the ion extraction data displayed that there is a positive correlation with absorption level. However AT-1 and AT-2 which were fired at lower temperature showed that there was no correlation between the ion extraction characteristics and absorption level. Ion extraction of citric acid produced little amount compared with the one of oxalic acid, yet it caused less damage to earthenware than oxalic acid when it applied. The result of ion extraction level in the absorption test displayed that Fe had higher level than in Si, Al from the test for both oxalic acid and citric acid. Based on the regression analysis of the data from the previous studies, the physical characteristics of the earthenware and ion extraction level, further studies will be conducted on the predicting technique on the extraction characteristics of major elements of earthenware samples for the conservation in future.

• Fashion & Textile Research Journal
• /
• v.20 no.4
• /
• pp.457-463
• /
• 2018

This study examined the water absorption and drying properties of the thirteen types of the knitted fabrics for sports wear. These physical properties were analysed with relation to the constituent fiber cross-sectional shape and structure parameters of the knitted fabrics by regression analysis. Absorption and drying properties of the knitted fabric specimens were increased with increasing the porosity of the constituent yarns, which was attributed to the capillary channels in the yarns. The water absorption and drying properties were increased and decreased with increasing tightness factor and stitch density of the knitted fabric. The absorption property of the knitted fabric for perspiration absorption and fast dry sport-wear clothing was mostly influenced mostly by fiber cross-sectional shape and its characteristics, whereas, drying property was dependent on the structural parameters of the knitted fabric such as tightness factor and stitch density. Therefore, superior perspiration absorption and fast drying knitted fabric could be obtained in the fabric structure with optimum tightness factor and stitch density, and constituent yarn structure with non-circular fiber crosssection and high porosity. GATS method and MMT method are used to measure sweating fast drying properties and it is necessary to carry out studies using these measurement methods in order to compare with the results of this study.

• Journal of Radiation Protection and Research
• /
• v.25 no.2
• /
• pp.109-114
• /
• 2000

The SI unit of specific absorption rate (SAR) in W/kg in the electromagnetic (EM) field as non-ionizing radiation is exactly same as the SI unit of absorbed dose rate in Gy/s in the ionizing radiation field. The SI unit of both physical quantities can be expressed in $[m^{\cdot}s^{-3}]$. Where, the unit of absorbed dose, Gy stands for Gray. In EM biological interactions, the SAR equations are derived and the characteristics of EM field energy absorption in terms of the SAR are discussed and described on the mathematical basis.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.360-360
• /
• 2012

Graphene shows diverse novel physical properties arising from its peculiar electronic states, so called Dirac electrons. Especially, effect of magnetic field is very unique, exhibiting exotic Landau level (LL) splitting. LLs are substantially modified by spins of Dirac electrons and pseudo-spins. The degeneracy of LLs is lifted to show splitting by electron-electron interaction and by the Zeeman effect. We investigated the magneto-optical absorption of graphene subjected to ultra-high magnetic field. Samples were prepared by the CVD method deposited on GaAs and Quart substrate. We have confirmed existence of graphene on each substrate by the micro-Raman spectroscopy. Next, we conducted magneto-absorption measurements in magnetic field up to 120 T by the single-turn coil (STC) method. We could observe absorption peak at 65 T and 100 T, respectively, probably arising from the LL inter-band transitions.