• 한국정밀공학회지
• /
• 제31권9호
• /
• pp.805-811
• /
• 2014

In this investigation, we constructed and demonstrated a simple Yb-doped fiber laser, of which longitudinal modes are mode-locked without any additional devices to compensate the dispersion caused by optical components. Non-linear polarization rotation (NPR) was adopted for the mode-locking mechanism and a polarization controller (PC) was used for a kind of spectral filters to restrict the bandwidth for mode-locking. As the result, the laser was successfully operated as mode-locked with the repetition rate of 42.2 MHz and the spectrum was broadened up to approximately 16 nm at 1033 nm center wavelength when the laser was mode-locked. In this paper, the operation of the developed Yb-doped mode-locked laser is explained with the concept of Lyot filter realized by a PC, which enables mode-locking under normal dispersion. In the industrial applications, this laser can be used as a seed laser of the high power lasers for optical manufacturing.

• 한국전자파학회논문지
• /
• 제11권4호
• /
• pp.599-609
• /
• 2000

In this paper, sub-harmonically pumped single balanced resistive mixers are presented . Frequency bandwidth is selected for a Ku-band, which is 11.75-12.25GHz for RF, 5.375∼5.625 GHz for LO, and 1 GHz for IF signals. A rat-race hybrid is designed for the accomplishment of single balanced type. A low pass filter (LPF) with photonic band gap(PBG) structure is used for good conversion loss and unwanted harmonics suppression. Two types of mixers are suggested, which are one with no gate bias for no DC power consumption and the other with the IF amplifier for conversion gain. When a LO signal with the power of 6 dBm at 5.5 GHz is injected, a conversion loss of 12.17dB and a conversion gain of 7.83 dB are obtained for each mixer. For the both mixers , LO to RF isolation of 20 dB and LO to IF isolation of 60dB are obtained. With the RF power of -30dBm to -3dBm, the mixer shows linear characteristics region of IF. this mixer can be applied for Ku-band and other microwave communication systems.

• Current Optics and Photonics
• /
• 제4권4호
• /
• pp.361-367
• /
• 2020

An approach based on an integrated photonic Ti:LiNbO₃ Y branch has been proposed, designed, and analyzed for the microwave instantaneous frequency measurement (IFM). By designing the Y branch with length L = 6545 ㎛ and refractive index N_TE - N_TM = 0.0764, a complementary optical filter with free spectral range (FSR) of 600 GHz is constituted, which results in a maximum measureable frequency of 300 GHz being obtained. Theoretical analysis on the temperature stability of the Ti:LiNbO₃ Y branch shows that the FSR variation of the complementary filter is 0.3% for the temperature change of 100 K, which indicates that the IFM approach will have a better stability. All these results demonstrate that the proposed IFM approach has potential capability to be used for the increasingly higher microwave IFM with better stability.

• Journal of electromagnetic engineering and science
• /
• 제5권4호
• /
• pp.208-212
• /
• 2005

In this paper, we introduced a band-pass filter employed the PBG structure and the aperture on the ground together. The harmonics of band pass filter have been suppressed by employing the PBG structure and the bandwidth of it has been broadened by using the aperture on the ground. The designed PBG cells have three different sizes. The largest cells, the middle cells, and the smallest cells have suppressed the multiple of second harmonics, the multiple of third harmonics, and the multiple of fifth harmonics, respectively. The center frequency has been 2.18 GHz. The bandwidth has been increased from 230 MHz up to 310 MHz(80 MHz, about $35\%$) by the aperture and the ripple characteristics in passband have been improved and the harmonic frequencies have been suppressed about 30 dB by the PBG.

• Journal of the Optical Society of Korea
• /
• 제20권1호
• /
• pp.180-187
• /
• 2016

The independent operation of a color filter for incident polarization is demonstrated using a guided-mode resonance (GMR) filter employing a metal-insulator-metal (MIM) waveguide. To achieve independent operation, a rectangular MIM grating is proposed as a wave-guide resonator. The design considerations are discussed and include how to determine the grating period and slit width. Power flow distribution is observed with slit width variation. Blue-green, green-red, and blue-red filters for corresponding x- and y-polarizations are demonstrated as application examples with numerical simulation with rectangle-shaped MIM grating. As a practical application, feasibility as a chromatic polarizer is discussed.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제55권5호
• /
• pp.267-271
• /
• 2006

A polymeric waveguide-type wavelength filter based on a Bragg grating has been proposed and fabricated using the simple nanoimpring technique, for the first time to our knowledge. An ultraviolet transparent stamp with the single-mode waveguide pattern incorporating a surface-relief-type Bragg grating was specially designed selective dry-etching process. Using this stamp, the device fabrication was substantially involving just a single-step process of imprint followed by polymer spin-coating. The achieved maximum reflection was higher than 25 dB at the center wavelength of 1569 nm. And the 3-dB bandwidth was 0.8 nm for the device length of 1.5 cm.

• Journal of electromagnetic engineering and science
• /
• 제10권4호
• /
• pp.282-289
• /
• 2010

A simplified, practical vector network analyzer (VNA) that uses mature radio-over-fiber technology has been designed and demonstrated. The measurement concept allows the full S-parameters of a microwave device (or antenna) to be obtained while minimizing the detrimental effects of electrical cables, which are replaced with a photonic link. A variety of high-frequency light modulation schemes with frequency sweeping capabilities are presented to realize a one-path (single, forward), frequency-multiplied optical link for VNA applications. Using the photonic one-path link, full two-port S-parameters have been extracted based on five-term error modeling, which has half the error terms compared with the standard duplex configuration. The S-parameters of a microwave filter and antenna measured using frequency-multiplied optical links are found to be in good agreement with those obtained using a conventional VNA.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2001년도 종합학술발표회 논문집 Vol.11 No.1
• /
• pp.337-340
• /
• 2001

We show that the microstrip ring with a narrow gap exhibits a photonic band gap (PBG) that is generally believed to be created by a periodic array. The discontinuity of impedance at the narrow gap induces the multiple reflections with fixed phase correlation necessary to make the PBG. We have also discussed the tuning of the PBG frequency by applying an external voltage on a varactor mounted on the gap and the applications of this PBG ring as a tunable bandstop filter and a microwave switch.

• Journal of the Optical Society of Korea
• /
• 제11권3호
• /
• pp.130-132
• /
• 2007

The characteristics of $S\breve{o}lc$ filters in $X^{(2)}$ nonlinear photonic crystals, periodically poled lithium niobate ($LiNbO_3$), were investigated by the Jones matrix method. The transmittance increases and the full width half maximum of the filter becomes narrow as the duty ratio increases. However, the filtering wavelength does not change. The transmittance at the filtering wavelength is over 95% when the duty ratio is larger than 0.35.

• Current Optics and Photonics
• /
• 제5권4호
• /
• pp.466-476
• /
• 2021

Frequency-multiplication technology based on microwave photonic principles can be used to generate microwave and millimeter wave signals with a wide frequency tuning range. However, the existing cascaded external modulation frequency-tupling scheme needs to ensure the phase coherence of the modulated Radio Frequency (RF) signal, while the phase modulation directly limits the frequency tuning range of the external modulation frequency multiplication. In this paper, a novel approach for generating an incoherent frequency 12-tupling signal with cascade modulation is proposed. The structure of cascaded dual-parallel Mach-Zehnder modulators can generate a frequency 12-tupling signal. The proposed structure uses no filter or phase control of the RF driving signal. Microwave photonic frequency-tupling was realized under incoherent conditions. Software simulations and experiments validated the proposed structure and proved that it can generate frequency 12-tupling microwave signals under incoherent conditions. Both the frequency range and reliability of the frequency-tupling system has been improved by the proposed structure.