• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.2
• /
• pp.321-326
• /
• 2018

This study describes the design and implementation of TRM(Transmit and Receiver Module) for detection for targets of small RCS(Radar Cross Section). Through the pre-simulation analysis of radar system about RF, the main specifications of TRM are verified. After the fabrication of TRM, the main characteristics such as the maximum output, noise figure, spurious were confirmed. In the future, the radar system test will be carried out by assembling TRMs, antenna radiator, and the transceiver that generates and receivers the radar waveform reflected.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.15 no.6
• /
• pp.812-819
• /
• 2012

Interference and jamming are becoming increasing concern to a radar system nowdays. AESA(Active Electronically Steered Array) antennas and adaptive beamforming(ABF), in which antenna beam patterns can be modified to reject the interference, offer a potential solution to overcome the problems encountered. In this paper, we've developed a planar active phased array radar system, in which ABF, target detection and tracking algorithm operate in real-time. For the high output power and the low noise figure of the antenna, we've designed the S-band TRMs based on GaN HEMT. For real-time processing, we've used wavelenth division multiplexing technique on fiber optic communication which enables rapid data communication between the antenna and the signal processor. Also, we've implemented the HW and SW architecture of Real-time Signal Processor(RSP) for adaptive beamforming that uses SMI(Sample Matrix Inversion) technique based on MVDR(Minimum Variance Distortionless Response). The performance of this radar system has been verified by near-field and far-field tests.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.30B no.12
• /
• pp.59-66
• /
• 1993

In this paper we propose an adaptive update rate tracking algorithm for a phased array radar, based on the interacting multiple model(IMM) algorithm. The purpose of the IMM algorithm hers is twofold: 1) to estimate and predict the target states, and 2) to estimate the level of the process noise. Using the estimate of the process noise level adapted to target dynamics, the update interval is determined to maintain a desired prediction accuracy so that the radar system load is minimized. The adaptive update rate tracking algorithm is implemented for a phased array radar and evaluated with Monte Carlo simulations on various trajectories. The evaluation results of the proposed algorithm and a standard Kalman filter without the adaptive update rate control are presented to compare.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.13 no.3
• /
• pp.193-197
• /
• 2013

This paper presents a 5-bit true time delay circuit using a standard 0.18 ${\mu}m$ CMOS process for the broadband phased array antenna without the beam squint. The maximum time delay of ~106 ps with the delay step of ~3.3 ps is achieved at 5-20 GHz. The RMS group delay and amplitude errors are < 1 ps and <2 dB, respectively. The measured insertion loss is <27 dB and the input and output return losses are <12 dB at 5-15 GHz. The current consumption is nearly zero with 1.8 V supply. The chip size is $1.04{\times}0.85\;mm^2$ including pads.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1998.10a
• /
• pp.784-787
• /
• 1998

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.12
• /
• pp.976-985
• /
• 2018

Modern radars such as the phase array radar can handle various tasks by generating a beam from a phased array antenna. Radar can be used for miscellaneous applications such as surveillance, tracking, missile guidance etc. Previous radar systems could handle only one task at a time. As such, multiple radars were required to perform simultaneous tasks. Multi-function radars can perform many tasks using only one radar system. However, the radar's resources are limited in this instance. To efficiently utilize time, it is necessary to properly schedule tasks in the radar's timeline. In this report, we investigate the efficiency of different scheduling tasks.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.1
• /
• pp.29-37
• /
• 2012

In this paper, a stabilizd system operation through a composition of a protective circuit and an improvement of active reflection coefficient(ARC) is studied. Unlike the passive-phased array antenna, the APPA is a combined form of radiating element and transmitter-reciever module. Therefore, a definition of new ARC that differentiates itself from typical passive-phased array antenna must apply. The ARC is a reflection coefficient considering a superposition of a coupling from nearby radiating elements and self reflection. It is an important parameter that predicts and analyzes charateristics of a APPR system. A high level ARC is a direct source inducing a performance degradation of a system. In this paper, as a method for a stabilized operation of APAR, one method for improving a performance and another for degradation prevention are analyzed. An effectiveness of two methods was validated using experiment results of real-fabricated active-phased array antenna.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.9
• /
• pp.1197-1201
• /
• 2018

In this paper, a Doppler radar for a localization of a human motion is demonstrated. In the system, we used a $8{\times}8$ phased array antenna using metamaterial phase shifters for easy and precise control of antenna beam pattern. Scanning area is a circular sector with an inscribed angle of $60^{\circ}$ and a diameter of 45m. This area is divided with 15 designated area and each area is scanned for 0.2 second. When there is a motion in a designated area, we are able to detect a frequency shift due to a Doppler effect. In this way it is possible to detect the location of motion. The experiment shows that 78% of position accuracy. The remaining 22% occurred the surroundings of the designated area.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.7
• /
• pp.46-52
• /
• 1998

This paper presents an experimenal proof for criteria of selecting an optimum adaptive beamforming (ABF) algorithm for a large distorted phased array. A single point target embedded in clutter model is suggested to compare four well-known ABF algorithms. These algorithms are tested to low variance and high variance real data for self-calibrating a large distored phased array. It is shown that these algorithms require at least one dominant scatterer with large radar cross section (RCS) or multiple scatterers with moderate RCS in the field of view. Experimental results are provided to demonstrate the comparisons of the four algorithems in terms of gain loss and image correlaion coefficient, along with corresponding reconstructed cross-range images and range-azimuth images.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.12
• /
• pp.924-934
• /
• 2018

This paper describes the development and measurement results of C-band planar active phase array antenna for detecting and tracking radar(weapon-locating radar). The antenna is designed with 14 sub-arrays(12 main channels and 2 sidelobe blanking channels and approximately 3,000 elements of transmit-receive channel) to generate transmit and digital receive patterns. Using a near-field measurements facility, G/N, transmit patterns, and received patterns are measured. Receive patterns are implemented with digital beamforming by signal processing. The measurement results demonstrate that antenna design specifications were fulfilled.