• Journal of Embryo Transfer
• /
• v.31 no.1
• /
• pp.53-59
• /
• 2016

This study was to investigate effect of progesterone ($P_4$) on prostaglandin (PG) synthases and plasminogen activators (PAs) system in bovine endometrium during estrous cycle. Endometrium tissues were collected from bovine uterus on follicular and luteal phase and were incubated with culture medium containing 0 (Control), 0.2, 2, 20 and 200 ng/ml $P_4$ for 24 h. The $PGF_{2{\alpha}}$ synthase (PGFS), $PGE_2$ synthase (PGES), cyclooxygenase-2 (COX-2), urokinase PA (uPA), and PA inhibitors 1 (PAI-1) mRNA in bovine endometrium were analyzed using reverse transcription PCR and PA activity was measured using spectrophotometry. In results, COX-2 was higher at 2 ng/ml $P_4$ group than control group in luteal phase (p<0.05), but, it did not change in follicular phase. Contrastively, PGES was significantly increased in 2 ng/ml $P_4$ group compared to control group in follicular phase, but there were no significant differ among the treatments in luteal phase. uPA was no significant difference between $P_4$ treatment groups and control group in both of different phase. PAI-1 was decreased in 20 ng/ml $P_4$ group compared to control group in follicular phase (p<0.05). PA activity was decreased in 2 ng/ml $P_4$ group compared to other groups in follicular and luteal phase (p<0.05). In conclusion, we suggest that $P_4$ may influence to translation and post-translation process of PG production and PA activation in bovine endometrium.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.53 no.3
• /
• pp.206-211
• /
• 2004

In phase controlled rectifier, it's been known that a fast response is achieved by predictive current control without any overshoot. The frequent sampling period is essential to improve the firing accuracy in conventional predict current control. However, improving the firing accuracy if difficult to reduce the period of sampling efficiently because current sampling and predictive current control is carried out in every period and the ON-OFF current control is performed by comparing two different one. To improve the firing accuracy at the predictive current control, the calculated firing angle is loaded into the high-accuracy hardware timer. So the calculation of exact crossing point between the predictive and actual current is the most important. In this paper, the flow chart for proposed firing angle calculation algorithm is obtained for the fastest current control performance in transient state. The performance of proposed algorithm is verified through simulations and experiments.

• Proceedings of the KIPE Conference
• /
• 1998.10a
• /
• pp.658-662
• /
• 1998

A pulse frequency modulation control method for single-switch three-phase buck rectifiers is comprehensively studied in this paper. The proposed pulse frequency control method leads the three-phase buck rectifier to high performance system that can draw the nearly sinusoidal imput-line currents. The simulated and experimental results demonstrate that the system provides low total harmonic distortion of the input-line currents, high-power factor, and good output voltage regulation.

• Proceedings of the KIEE Conference
• /
• 2000.11a
• /
• pp.139-141
• /
• 2000

High voltage direct current(HVDC) transmission system uses the phase controlled rectifier triggered by means of IPC(individual phase control) or EPC(equidistant pulse control). Most HVDC system has adopted EPC method that can solve the harmonic instability problem of IPC method in weak power system. But EPC has inherent indirect synchronizing problem requiring the closed loop control. This paper presents the new gate pulse generating method for 12-pulse HVDC converter, which combines IPC with EPC. Simulation and test results are presented. The basic concept is that it generates the gating pulse for 12-pulse converter by synthesizing the internal phase reference using the frequency and phase information of a sin91e phase voltage. To ensure the reliability of the external phase input, Potential transformer that detects the phase voltage has redundancy. Using fault detecting algorithm the healthy input is always guaranteed. And the frequency compensation function was reinforced.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.2
• /
• pp.654-664
• /
• 2017

This paper proposed an unified dual-phase-shift (UDPS) control for dual active bridge (DAB) converters in order to improve efficiency for a wide output power range. Different operating modes of UDPS are characterized with respect to the reactive current distribution. The proposed UDPS has the same output power capability with conventional phase-shift (CPS) method. Furthermore, its implementation is simple since only the change of the leading phase-shift direction is required for different operating power range. The proposed UDPS control can minimize both the inductor rms current and the circulating reactive current for various voltage conversion ratios and load conditions. The optimal phase-shift pairs for two bridges of DAB converter are derived with respect to the comprehensive reactive power loss model, including the reactive components delivered from the load and back to the source. Simulation and experimental results are illustrated and explained with details. The effectiveness of the proposed method is verified in terms of reactive power losses minimization and efficiency improvement.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.8
• /
• pp.44-53
• /
• 2007

In this paper, the Sliding Mode Controller is applied to reduce the starting current of the single phase induction motor. The input voltage to the single phase induction motor is controlled so that the starting current of the motor may be maintained within the rating value and the velocity is also controlled, by adjusting the switching function of the Sliding Mode Controller. The switching of sliding control made appropriately with regard to velocity error signal and acceleration signal. It is shown that the starting characteristics of the single phase induction motor(SPIM) can be greatly enhanced through the sliding control of single phase induction motor.

• ETRI Journal
• /
• v.38 no.3
• /
• pp.417-424
• /
• 2016

In this paper, an accurate characterization of a fabricated X-band transmit/receive module is described with the process of generating control data to correct amplitude and phase deviations in an active electronically scanned array antenna unit. In the characterization, quantization errors (from both a digitally controlled attenuator and a phase shifter) are considered using not theoretical values (due to discrete sets of amplitude and phase states) but measured values (of which implementation errors are a part). By using the presented procedure for the characterization, each initial control bit of both the attenuator and the phase shifter is closest to the required value for each array element position. In addition, each compensated control bit for the parasitic cross effect between amplitude and phase control is decided using the same procedure. Reduction of the peak sidelobe level of an array antenna is presented as an example to validate the proposed procedure.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.17 no.1
• /
• pp.1-7
• /
• 2012

This paper describes the performance comparison results for current controller of a single-phase PFC converter with 1-switch voltage doubler strategy for single-phase double-conversion UPS(Uninterruptible Power Supply). A single-phase PFC converter with 1-switch voltage doubler strategy needs a diode bridge and one bidirectional active switch. Thus it is possible to reduce the material cost. However, the study results of current controller design and comparison of current control method has not been known after the converter circuit was proposed. For the performance comparison of current control, single-phase 3 kVA double-conversion UPS was tested. The performance of PI and PR current controller is experimentally confirmed with followings - input current reference tracking, input power factor correction and input current THD suppression.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.8
• /
• pp.1376-1385
• /
• 2000

The phase characteristic of delay line in feedfarward linearizer has been changed due to variation of operating temperature. In this paper, design method of fixed phase control circuit of group delay line using adaptive vector control is derived. To maintain transfer characteristics of nominal operating temperature, the error correlated signals, which are changed adaptively due to changing of temperature, are added to main signals. The proposed method maintains transfer characteristics under 0.06dB of insertion loss and 0.36$^{\circ}$ of phase variation in case of 1-tone(880 MHz) and under 0.07 dB of insertion loss and 0.35$^{\circ}$ of phase variation in case of 2-tones(877 MHz, 882 MHz) for 10dB input power dynamic range and +/-10$^{\circ}$ phase variation respectively.

• Journal of Microbiology and Biotechnology
• /
• v.18 no.5
• /
• pp.918-925
• /
• 2008

Controlling the light energy and major nutrients is important for high cell density culture of cyanobacterial cells. The growth phase of Anabaena variabilis can be divided into an exponential growth phase and a deceleration phase. In this study, the cell growth in the deceleration phase showed a linear growth pattern. Both the period of the exponential growth phase and the average cell growth rate in the deceleration phase increased by controlling the light intensity. To control the light intensity, the specific irradiation rate was maintained above $10\;{\mu}mol/s/g$ dry cell by increasing the incident light intensity stepwise. The final cell density increased by controlling the nutrient supply. For the control of the nutrient supply, nitrate, phosphate, and sulfate were intermittently added based on the growth yield, along with the combined control of light intensity and nutrient concentration. Under these control conditions, both final cell concentration and cell productivity increased, to 8.2 g/l and 1.9 g/l/day, respectively.