• Korean Chemical Engineering Research
• /
• v.48 no.4
• /
• pp.515-518
• /
• 2010

D,L-tryptophans were separated by using $Chirobiotic^{(R)}$ T HPLC column. Mobile phases were the mixture of methanol and water(70:30, 80:20, 90:10, v/v). Experimental temperatures were adjusted as 25, 40 and $55^{\circ}C$ in order to compare retention times. Difference in D,L-tryptophan retention times was studied in terms of the interaction between stationary phase and tryptophans. Selectivity, resolution and efficiency of column were utilized to find an optimum separation condition. Retention times were shortened by increasing the amount of methanol in mobile phase and the temperature of column. The best selectivity and resolution was obtained with the temperature($25^{\circ}C$) and the ratio of mobilephase(70/30 v/v%).

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.2
• /
• pp.46-52
• /
• 2009

In this paper, the timing estimator based on the principle of the best linear unbiased estimator (BLUE) is proposed in OFDMA uplink systems. The proposed timing estimator exploits the phase information of the differential correlation between adjacent subcarriers. The differential correlation can extract the information about timing offset and mitigate the distortion of the signal caused by the frequency selectivity of channel. Compared with conventional methods, the proposed estimator shows more accurate capability in estimation. In addition, the estimator is hardly affected by the distortion caused by the frequency selectivity of channel. Simulation results confirm that the proposed estimator shows a small error mean and a relatively small error variance. In addition, the performance of the estimator is evaluated by means of SNR loss. It is shown by simulations that the SNR loss of the proposed estimator by estimation errors is less than 0.4 dB for the SNR values between 0 and 20 dB. This might indicate that the proposed estimator is suitable for the timing synchronization of multiple users in OFDMA uplink systems.

• Membrane Journal
• /
• v.29 no.1
• /
• pp.1-10
• /
• 2019

Poly(ether block amide) (PEBA) is one of the commercially important class of block copolymer very much suitable specifically for $CO_2$ separation. Gas separation membrane need to have good mechanical strength as well as high gas permeability. The crystalline polyamide (PA) block provides the mechanical strength while the rubbery polyether (PE) group being $CO_2$-philic facilitate $CO_2$ permeation though the membrane. Composition of thermoplastic and rubbery phase in the polymer are changed to fit into suitable gas separation application. Although PEBA has good permeability, the selectivity of the membrane can be enhanced by incorporating molecular sieve without affection much the gas permeability. Mixed matrix membrane (MMM), a class of composite membrane combine the advantage of polymer matrix with the inorganic fillers. However, there are some disadvantages based on the compatibility of the inorganic fillers and polymeric phase. This review covers both the advantage and limitations of PEBA block copolymer based composite membrane.

• Macromolecular Research
• /
• v.13 no.2
• /
• pp.141-146
• /
• 2005

Calix[4]crown-6-2,4-bis(4-aminobutyl ether), which has a crown-6 moiety at the 1,3-position and amino function at the 2,4-position, was prepared as an intermediate for the subsequent synthesis of calix[4]crown-6-containing polyamide and polyimide using adipoyl chloride and 1,2,4,5-benzenetetracarboxylic dianhydride. The chemical structures were characterized by IR, $^{1}H NMR$ spectroscopy and elemental analysis, and some of their physical properties, including their thermal behavior, were examined. The ion binding characteristics of the monomer and polymers for alkali metal and alkali earth metal ions were measured by liquid-liquid extraction from the aqueous phase into the organic phase. It has been observed that polyamide has a high binding ability towards various metal cations as compared to polyimide, which showed cesium ion selectivity.

• Applied Chemistry for Engineering
• /
• v.5 no.1
• /
• pp.121-126
• /
• 1994

To elucidate the effect on the reactive extraction of acetic acid, various carriers and modifiers were investigated. Carriers used were secondary and tertiary amines and solvation extractant. Diluent was n-butylacetate. Modifiers were 4-nonylphenol, TBP(Tti-n-butyl phospate) and isodecanol. Besides the effect of temperature and pH in aqueous phase were studied. The mixture of 50% tri-n-octyl/n-decylamine tertiary amine, gave higher degree of extraction and selectivity than other extractants in the extraction of acetic acid. It was found that 4-nonylphenol as modifier fairly good. The degree of extraction was higher with decreasing the pH in aquous phase and the temperature of extraction system.

• Macromolecular Research
• /
• v.12 no.4
• /
• pp.427-430
• /
• 2004

Calix[4]crown-6-2,4-bis(2-hydroxyethyl ether) (2), which has crown-6 moieties at the 1- and 3-positions and hydroxyethyl functions at the 2- and 4-positions, was prepared for the syntheses of polyester 3 and polyurethane 4 by reactions with adipoyl chloride and hexamethylene diisocyanate, respectively. The ion binding characteristics of monomer 2 and polymers 3 and 4 toward alkali and alkali earth metal ions were measured by liquid-liquid extraction from the aqueous phase into the organic phase. We observed that the polyurethane 4 has a higher binding affinity toward various metal cations when compared to polyester 3, which exhibits cesium ion selectivity.

• Bulletin of the Korean Chemical Society
• /
• v.26 no.6
• /
• pp.930-934
• /
• 2005

A chloroform membrane system containing a given mixture of benzylaza-12-crown-4 and oleic acid is introduced for the selective and efficient transport of $Pb^{2+}$ ion. The transport was capable of moving metal ions ‘up-hill’. In the presence of ${S_2O_3}^{2-}$ion as a suitable metal ion acceptor in the receiving phase, the amount of lead ion transport across the liquid membrane after 150 minutes is (95.0 ${\pm}$ 1.7)%. The selectivity and efficiency of lead transport from aqueous solution containing $Tl^+,\;Ag^+,\;Mg^{2+},\;Ca^{2+},\;Co^{2+},$ $Ni^{2+},\;Cu^{2+},\;Zn^{2+},\;Hg^{2+}$ and $Cd^{2+}$were investigated. In the presence of thiosulfate as a suitable masking agent in the source phase, the interfering effects of $Ag^+\;and\;Cu^{2+}$ were diminished drastically.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.3
• /
• pp.683-686
• /
• 2009

Slurry phase reaction of elemental silicon with methanol has been studied in the presence of copper using a small amount of cuprous chloride as an activator in DBT (dibenzyltoluene) at various temperatures from 200 ${^{\circ}C}$ to 320 ${^{\circ}C}$. Trimethoxysilane (1a) with a Si-H unit was obtained as the major product and tetramethoxysilane (1b) as the minor product. The reaction worked well using a 0.5 wt % CuCl as an activator. The optimum temperature for this direct synthesis of 1a was 240 ${^{\circ}C}$. Methoxysilanes were obtained in 95% yield with 81% selectivity to 1a from 85% conversion of elemental silicon.

• KSBB Journal
• /
• v.18 no.1
• /
• pp.65-69
• /
• 2003

Two molecular imprinted polymers (MIPs) were prepared by using pentoxifylline and a mixture of caffeine-theophylline (2:1, mole ratio) as the templates, MAA as the monomer, and EDMA as the crosslinker The obtained polymer particles (particle size 25-35 $\mu\textrm{m}$) were packed into a HPLC column (150$\times$3.9mm). The selectivity and chromatographic characterization of the imprinted polymers were studied using pentoxifylline, caffeine, theophylline, theobromine as samples and acetonitrile as the mobile phase, Both imprinted polymers showed increased affinity for structural analogues. By using a mixture of caffeine-theophylline templates MIPs, good separations of caffeine, theobromine and theophylline were obtained, and pentoxifylline and caffeine were partly separated.

• Bulletin of the Korean Chemical Society
• /
• v.22 no.7
• /
• pp.699-702
• /
• 2001

A series of cleft-type ionophores having two convergent hydroxamic acid functions are prepared and their selective ionophoric properties toward heavy metal and transition metal ions have been investigated. Hydroxamic acids 3 exhibited a prominent selectivity toward heavy metal ions of Hg2+ and Pb2+, and transition metal ions of Cu2+ over other transition metal and alkaline earth metal ions from slightly acidic source phase (pH 6) to an acidic receiving phase (pH 1). Selective ionophoric properties toward Pb2+ and Cu2+ ions over other surveyed metal ions are also confirmed by the FAB-MS measurements.