• 수산해양교육연구
• /
• 제26권4호
• /
• pp.894-901
• /
• 2014

This study concerns the performance of condensation heat transfer in two-phase loop thermosyphons. In the present work, R134a has been used as the working fluid. Liquid fill charge ratio defined by the ratio of working fluid volume to total internal volume of thermosyphon, heat flux and wind speed of condensation have been used as the experimental parameters. The results show that the filling rate of working fluid and heat flux are very important factors for the operation of two-phase loop thermosyphons. The optimum liquid fill charge ratio for the best condensation heat transfer rate was 80%.

• 대한기계학회논문집
• /
• 제13권3호
• /
• pp.528-537
• /
• 1989

The objective of this paper is to investigate effects of the specific heat and the diameter of suspending particles on the heat transfer coefficient of two phase turbulent flow with suspension of solid particles in a circular tube with constant heat flux. Heat transfer coefficients of two phase turbulent flow in pipe with suspension of graphite powder were measured with variations of particle sizes and solid-gas loading ratio. Measured data were compared with predictions by numerical analysis in which the turbulece models are closed on the first order level. Results show that heat transfer coefficient increases with increasing the solid-gas loading ratio and the specific heat of suspending material, however, it decreases as the average diameter of particles decreases below $24{\mu}m$.

• 설비공학논문집
• /
• 제14권3호
• /
• pp.231-239
• /
• 2002

Experiments on the single phase cooling heat transfer and pressure drop with microfin tubes were performed using water as a test fluid. Experimental data were obtained in the range of Reynolds number 3000 ~40000 and Prandtl number 4-6. The data of microfin tubes presented the characteristics of rough surface tube in pressure drop and heat transfer Experimental data were compared with the heat transfer and friction factor correlations of smooth tubes. Heat transfer enhancements of microfin tubes were lower than pressure drop penalty factors. The helix angle is more significant parameter in both of the pressure drop and heat transfer than the relative roughness. The correlations of Nusselt number and friction factor were suggested for the tested microfin tubes. Maximum deviations between correlations and experimental data were within $\pm15$% for Nusselt number and $\pm10$% for friction factor.

• 동력기계공학회지
• /
• 제17권4호
• /
• pp.45-50
• /
• 2013

This paper presents the comparison of heat transfer and pressure drop of various secondary refrigerants (single-phase and two-phase) in the indirect refrigeration system. The main results were summarized as follows: In case of heat transfer, it is useful to use secondary refrigerants in low evaporating temperature region and the heat transfer coefficient of single-phase is larger than two-phase secondary refrigerants. In case of pressure drop, it is useful to use secondary refrigerants in high evaporating temperature region and the pressure drop of two-phase is smaller than single-phase secondary refrigerant. Also, $CO_2$ is the best useful because pressure drop of $CO_2$ among the secondary refrigerants is the smallest.

• 설비공학논문집
• /
• 제25권9호
• /
• pp.477-483
• /
• 2013

A numerical analysis of solid-liquid phase change was performed on a heat transfer module which consisted of circulating water path (BRINE), heat transfer plate (HTP) and phase change material (PCM) layers, such as high temperature PCM (HPCM, $78{\sim}79^{\circ}C$) and low temperature PCM (LPCM, $28{\sim}29^{\circ}C$). There were five arrangements, consisting of BRINE, HTP, LPCM and HPCM layers in the heat transfer module. The time and heat transfer rate for melting/solidification was compared to their arrangements, against each other. As results, the numerical time without convection was longer than the experimental one for melting/solidification. Moreover, the melting/solidification with the BRINE I-LPCM-BRINE II-HPCM arrangement was faster(10 hours) than the others; HPCM-BRINE-LPCM, BRINE I-HPCM-LPCM-BRINE II one.

• 대한전자공학회논문지SD
• /
• 제45권4호
• /
• pp.146-153
• /
• 2008

High speed serial link에 적합한 clock multiphase generator용 integrated phase-locked loop (PLL)을 설계하였다. 설계된 PLL은 programmable current mirror를 사용하여 동작 범위 안에서 동일한 loop bandwidth와 damping factor를 가진다. 또한 설계한 PLL 회로 netlists를 가지고 HSPICE 시뮬레이션을 통해 close-loop transfer function과 VCO의 phase noise transfer function을 구하였다. Board 위 칩의 자체 임피던스는 decoupling capacitor의 크기와 위치에 따라 계산된다. 세부적으로, close-loop transfer function에서 gain의 최대값과 VCO noise transfer function에서 gain의 최대값 사이의 주파수범위에서 decoupling capacitor의 크기와 위치에 따른 보드 위 칩의 자체 임피던스를 구하였다. 이를 바탕으로 보드에서의 decoupling capacitor의 크기와 위치가 PLL의 jitter에 어떠한 영향을 미치는지 분석하였다. 설계된 PLL은 1.8V의 동작 전압에서 400MHz에서 2GH의 wide operation range를 가지며 $0.18-{\mu}m$ EMOS공정으로 설계하였다. Reference clock은 100MHz이며 전체 PLL power consumption은 1.2GHz에서 17.28 mW이다.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2000년도 추계학술대회논문집B
• /
• pp.297-303
• /
• 2000

Natural convection heat transfer have been paid attention because it can be applied to various areas such as cooling of nuclear reactor, heat storing system and so on. Among such applications, the melting process of phase change material(PCM) has been actively studied. However most researches have focused on phase change heat transfer in natural melting. Therefore, In this paper, ultrasonic vibration was adopted to increase the melting rate. In addition, general relationship and corelationship between melting with ultrasonic vibration and melting without ultrasonic vibration have been established during the melting of PCM.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2000년도 춘계학술대회논문집B
• /
• pp.71-76
• /
• 2000

This experimental study was conducted to figure out the drag reduction and convective heat transfer in vertical downward two-phase flow with polymer additives. The drag reduction effect were analyzed by using the difference of the pressure drop between the flow with polymer additives and without it. Experimental results show that the pressure drop with polymer additives is less than the pressure drop without polymer in vertical downward two-phase flow. And the convective heat transfer has decreased with increasing the polymer concentration in vertical downward two-phase flow.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2002년도 International Meeting on Information Display
• /
• pp.724-727
• /
• 2002

2,7-dibromo-9, 9-dialkyl-substituted-fluorene derivatives were prepared by the alkylation of 2,7-dibromofluorene with various alkyl groups under two-phase phase transfer catalysis (PTC) conditions, as monomers for synthesizing poly(dialkylfluorene)s. Tetra-nbutylammonium hydrogen sulfate (TBAHS) was used as a phase transfer catalyst to enhance nucleophilic substitution. In addition, NaOH in water (25M) was used as a base to generate anions. Compared to conventional alkylation using butyllithium(BuLi), the reaction using the PTC technique attained high selectivity and substantial conversion of reactants, due to the enhanced reaction rate, while the reaction was carried out under moderate conditions. An approximately 90% yield was obtained from the reaction and the reaction time was remarkably reduced. 2,7-dibromo-9,9-dihexyl-fluorene, 2,7-dibromo-9,9-dioctyl-fluorene, and 2,7-dibromo-9,9-di(2-ethylhexyl)-fluorene were effectively synthesized by phase transfer catalytic reaction.

• The Journal of the Acoustical Society of Korea
• /
• 제18권2E호
• /
• pp.31-38
• /
• 1999

This paper focuses on extracting formants from transfer function, derived from linear prediction analysis of speech signal. The second derivative of the log magnitude spectrum of the transfer function, the first and third derivatives of the phase spectrum of the transfer function in the z-plane are discussed. Their resolutions of detecting formants are analyzed and some comparisons are given. Theoretical analyses and experimental results show that the third derivative of the phase spectrum decays more rapidly around the formant locations than the first derivative of the phase spectrum and the second derivative of the log magnitude spectrum. Compared with the second derivative of the log spectrum and the first derivative of the phase spectrum, the third derivative of the phase spectrum has higher resolution in frequency domain and provides more accurate formant extraction.