• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.54 no.2
• /
• pp.81-86
• /
• 2005

In this paper we consider an optimal configuration problem for redundant inertial sensors which have uncertainty such as misalignment, scale factor error. The optimal configuration problem is treated from the viewpoint of navigation accuracy. We propose a necessary and sufficient condition for the optimal configuration of redundant sensors with no uncertainty, and a sufficient condition for the optimal configuration of redundant sensors with uncertainty. Finally we propose a condition for the optimal configuration based both navigation performance and FDI(fault detection and isolation).

• Proceedings of the Optical Society of Korea Conference
• /
• 2003.02a
• /
• pp.334-335
• /
• 2003

현재 기지국과 중계기 사이의 광선로에 사용되고 있는 1310 nm와 1550 nm 파장이외에 OADM (optical add-drop multiplexer)을 사용하여 새로운 2개 파장을 광선로에 추가로 연결함으로써 광선로 임차사용의 효율을 증대시키는 4파장 광중계기의 구현시 drop신호는 삽입손실 ­3 dB 이하의 저손실특성이 요구되며 isolation 신호는 통상 ­40 dB 이상의 고품질이 요구된다. 그러나 이와같은 성능의 광모듈을 실제로 구현하기 어렵다. 따라서 많은 광결합 부품의 조합을 통해서도 drop또는 isolation 특성은 4파장 광중계기를 실용화하기 어려울 만큼 저하된다. (중략)

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2003.05a
• /
• pp.142-147
• /
• 2003

This paper is concerned with the experiment of vibration isolation device whit can cope with heave, pitch and roll type vibrations. This new device consists of S-shaped piezoceramic actuators supporting each corner of the plate. Small piezoceramic sensors are located at the middle of each side. This paper also presents the development and the movement of the system. The active control technique was also developed to cope with base excitation. Experimental results show that vibrations can be reduced by the new device in the case of base excitation of harmonic type.

• Journal of electromagnetic engineering and science
• /
• v.13 no.4
• /
• pp.263-266
• /
• 2013

A novel compact and low-loss VHF bandpass filter is presented with enhanced stopband performance using metamaterial zeroth order resonator (ZOR) characteristics. An in-line ZOR filter is initially suggested and changed to have transmission zeros (TZs) due to source-load coupling for effective improvement of the isolation from UHF wireless channels. The proposed filter is smaller than 1/10 of the conventional filters in terms of size and has relatively very low insertion loss (< 1 dB for the electromagnetic (EM) simulation and < 3 dB for the measurement) and return loss (<-20 dB) in the passband due to the approximately 80% size reduction and the higher isolation in the stopband due to the TZs. The circuit and EM simulation are in good agreement with the measurements.

• Journal of Power Electronics
• /
• v.14 no.5
• /
• pp.874-881
• /
• 2014

This study presents a single-phase power factor correction AC-DC converter that operates in discontinuous conduction mode. This converter uses the pulse-width modulation technique to achieve almost unity power factor and low total harmonic distortion of input current for universal input voltage $90V_{rms}$ to $264V_{rms}$) applications. The converter has a simple structure and electrical isolation. The magnetizing-inductor energy of the transformer can be recycled to the output without an additional third winding. The steady-state analysis of voltage gain and boundary operating conditions are discussed in detail. Finally, experimental results are shown to verify the performance of the proposed converter.

• ETRI Journal
• /
• v.33 no.4
• /
• pp.580-588
• /
• 2011

This paper proposes reversible data hiding using minimum/maximum preserved overflow/underflow avoidance (MMPOUA). The proposed MMPOUA algorithm consists of three main steps. These steps include the minimum (or maximum) pixel fixing, pixel squeezing, and pixel isolation. The aims of pixel fixing are to keep the minimum (or maximum) pixel of a host block unchanged and prevent the occurrence of overflow/underflow. Both the pixel squeezing and pixel isolation supply hiding storage while keeping the amount of distortion low. The proposed method can avoid (or significantly reduce) the overhead bits used to overcome overflow/underflow issues. At an embedding rate of 0.15 bpp, the proposed algorithm can achieve a PSNR value of 48.52 dB, which outperforms several existing reversible data hiding schemes. Furthermore, the algorithm performed well in a variety of images, including those in which other algorithms had difficulty obtaining good hiding storage with high perceived quality.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.3
• /
• pp.109-114
• /
• 2004

This paper proposes an advanced circuit for the fingerprint sensor signal processing. We increased the voltage between ridge and valley by modifying the parasitic capacitance eliminating circuit of sensor plate. The analog comparator was designed for comparing the sensor signal voltage with the reference signal voltage. We also propose an effective isolation strategy for removing noise and signal coupling of each sensor pixel. The fingerprint sensor circuit was designed and simulated, and the layout was performed.

• Korean Journal of Food Science and Technology
• /
• v.19 no.5
• /
• pp.392-396
• /
• 1987

A method for isolation of some phenolic acids from Korean ginseng(Panax ginseng C.A.Meyer)was studied using silicic acid column chromatography. preparative thin layer chromatography and high performance liquid chromatography. Two phenolic compounds were isolated and identified as ferulic acid, mp $156-157^{\circ}C$ and vanillic acid. mp $154-156^{\circ}C$ by spectral data of Mass and NMR spectroscopy.

• Proceedings of the KIEE Conference
• /
• 2002.06a
• /
• pp.142-145
• /
• 2002

This paper presents the electromagnetic field water treater system with the high performance for a good quality of water. The electromagnetic field water treater consists of a solion, a solion body. and a high voltage converter. The high voltage converter is controlled by PWM current controller. The high voltage converter of 13W is designed for an isolation operation ramp. an isolation current detector, and an over current protector. Using the high voltage PWM converter, the system with the proposed electromagnetic field water treater can be controlled easily. Simulation and experimental results show the effectiveness of the system strategy proposed for the scale rejection.

• International Journal of Automotive Technology
• /
• v.8 no.2
• /
• pp.233-241
• /
• 2007

A lumped parameter model is proposed for the analysis of dynamic behaviour of a Passive Hydraulic Engine Mount (PHEM), incorporating inertia track and throttle, which is characterized by effective and efficient vibration isolation behaviour in the range of both low and high frequencies. Most of the model parameters, including volume compliance of the throttle chamber, effective piston area, fluid inertia and resistance of inertia track and throttle are identified by an experimental approach. Numerical predictions are obtained through a finite element method for responses of dynamic stiffness of the rubber spring. The experiments are made for the purpose of PHEM validation. Comparison of numerical results with experimental observations has shown that the present PHEM achieves good performance for vibration isolation.