• Food Science and Preservation
• /
• v.23 no.7
• /
• pp.1004-1011
• /
• 2016

Flavonoids, non-nutrient secondary metabolites of plants, are widely distributed in commonly consumed agro-food resources. Flavonoids include aglycones, and their glycosides are reported to have potential health-promoting compounds. The aim of this study was to investigate flavonoid glycosides in the fruit and leaves of Zizyphus jujuba var. inermis (Bunge) Rehder (jujube). A total of six flavonoids (five flavonols and one chalcone) were identified in jujube fruit and leaves by using ultra-performance liquid chromatography-diode array detector-quadrupole time of flight mass spectrometry along with chemical library and an internal standard. In positive ion mode, six flavonoids were linked to the C- and O-glycosides which were conjugated with sugar moieties based on kaempferol, quercetin, and phloretin aglycones. Total flavonoid contents of leaves (8,356.5 mg/100 g dry weight (DW)) was approximately 900-fold higher than that of fruit (fresh fruit, 13.6 mg/100 g dry DW; sun-dried fruits, 9.2 mg/100 g dry DW). Quercetin 3-O-rutinoside (rutin) and quercetin 3-O-robinobioside were the predominant flavonols in fruit and leaves of jujube. In particular, rutin had the highest content (6,735.2 mg/100 g DW) in leaves, and rutin is a widely reported bioactive compound. Phloretin 3',5'-di-C-glucoside (chalcone type) was detected only in leaves. The leaves of jujube contain a high content of flavonoids and the results of this study indicate that jujube leaves may be a source of bioactive flavonoids.

• Journal of the Korean GEO-environmental Society
• /
• v.11 no.12
• /
• pp.47-56
• /
• 2010

The construction of new roads and the consistent extension of already-existing roads or the line-shape revision of those roads are increased with the governmental investment to SOC facilities currently. Accordingly, the road cut slopes are in the trend of rapidly increasing. As the road slope has increased, a lot of human and property damages has entailed consequently and in the local case, numerous studies have carried out aiming at minimizing this damages caused by the rockfall and landslide. In general, standard falling rock prevention facility has employed for most of the local road slope based on "Guide for Installation and Management of Road Safety Facilities" published by MLTM(the Ministry of Land, Transport, and Maritime Affairs) but profound doubt has raised as to whether this rockfall prevention facility would function properly enough to prevent rockfall efficiently without any damages in case of actual occurrence of rockfall. In addition, it is a reality that in most cases, such work is relied on overseas technology as a whole as the local technical level is low and in case of rockfall prevention net, it is judged that a study on rockfall prevention net that is able to endure more powerful rockfall energy is required as the problem including net bursting is taken place as a result of enough bearing force being failed to be demonstrated due to its partial weak point(not uniformly made). Under this background, in this study, three kinds of model depending on mesh size of expanded metal that is considered to have an adoptability as rockfall prevention net, as target are selected and characteristics depending on mesh size of expanded metal is intended to be researched through a pull-out test performance by using pull-out test equipment rockfall prevention net.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.7
• /
• pp.2497-2507
• /
• 2010

The objectives of this study were to identify recognition, intention and practice to premarital examination of women and to define the predictors of intention and compliance to examination. The subjects for this study were 257 women at a university, college, a bank worker and health clinic visitor in Busan city. The date for this study was collected from August 25th to September 24th 2006 by structured questionaries, and were analyzed mean, standard deviations(SD), $x^2$-test, t-test and multiple Logistic regression using SPSS/WIN 12.0. The mean performance of the premarital examination was 28.4%. Thirty-five point five percent of unmarried women and 71.6 percent of married women had experience of heard premarital examination. The score of attitude toward premarital examination were that single women was 23.04 and married women was 22.55, respectively. The scores of behavioral control cognition between unmarried women and married women were statistically significant different. The predictor of premarital examination intention was necessity of premarital examination, and the predictors of examination compliance were experience of hearing examination and behavioral control cognition. Based on the results of this study, promoting recognition and behavioral control cognition by community healthcare organization and health professionals for empowering the premarital examination of women were needed.

• Korean Journal of Applied Biomechanics
• /
• v.26 no.4
• /
• pp.343-351
• /
• 2016

Objective: The purpose of this study was to help improve game performance and provide preliminary data to enhance the efficiency of the kick and stability of the support foot by comparing the kinematic characteristics of the repeated side kick (geodeupyeopchagi) in poomsaeKoryo between expert and non-expert groups. Method: The subjects were divided into 2 groups according to proficiency in Taekwondo, an expert group and a non-expert group (n = 7 in each group), to observe the repeated side-kick technique. Four video cameras were set at a speed of 60 frames/sec and exposure time of 1/500 sec to measure the kinematic factors of the 2 groups. The Kwon3D XPprogramas used to collect and analyze three-dimensional spatial coordinates. Ground reaction force data were obtained through a force plate with a 1.200-Hz frequency. An independent samplesttest was performed, and statistical significance was defined as .05. The SPSS 18.0 software was used to calculate the mean and standard deviation of the kinematic factors and to identify the difference between the experts and non-experts. Results: The angular displacement of the hip joint in both the expert and non-expert groups showed statistical significance on E1 and E4 of the left support foot and E5 of the right foot (p<.05). The angle displacement of the knee joint in both groups showed statistical significance on E4 of the left support foot, and E1 and E2 of the right foot (p<.05). The angular velocity of the lower leg in both groups showed no statistical significance on the left support foot but showed statistical significance on E2 and E6 of the right foot (p<.05). The angular velocity of the foot in both groups showed no statistical significance on the left support foot but showed statistical significance on E2 of the right foot (p<.05). The vertical ground reaction force in both groups showed statistical significance on E2 (p<.05). The center of pressure in all directions in both groups showed statistical significance (p<.5). Conclusion: While performing the repeated side kick (geodeupyeopchagi), the experts maintainedconsistency and stability of the angle of the support leg while the kick foot moved high and fast. On the other hand, the angle of the support foot of non-experts appeared inconsistent, and the kick foot was raised, relying on the support leg, resulting in unstable and inaccurate movement.

• Journal of Food Hygiene and Safety
• /
• v.32 no.2
• /
• pp.83-88
• /
• 2017

We introduced disposable amperometric immunosensors for the detection of Sildenafil and Vardenafil (SDF/VDF) based on screen printed carbon electrodes. The developed immunosensors were used as a non-competitive sandwich-type enzyme immunoassay with a horseradish peroxidase label. The sensors were constructed on screen printed carbon electrodes by the simple electrochemical deposition of a reduced graphene oxide and chitosan (ErGO-CS) composite. To evaluate the sensing chemistry and optimize the sensor characteristics, a series of electrochemical experiments were carried out including electrochemical impedance spectroscopy, cyclic voltammetry and amperometry. The sensors showed a linear response to SDF/VDF concentrations in a range from 100 pg/mL to 300 ng/mL. The lower detection limit was calculated to be 55 pg/mL, the sensitivity was calculated to be $1.02{\mu}Ang/mL/cm^2$, and the sensor performance exhibited good reproducibility with a relative standard deviation (RSD) of 7.1%. The proposed sensing chemistry strategy and the sensor format can be used as a simple, cost-effective, and feasible method for the in-field analysis of SDF/VDF in functional or health supplement food samples.

• Journal of KIISE:Computing Practices and Letters
• /
• v.7 no.4
• /
• pp.372-381
• /
• 2001

In this paper SEED, the Korea Standard 128-bit block cipher algorithm is implemented with VHDL and mapped into one FPGA. SEED consists of round key generation block, F function block, G function block, round processing block, control block and I/O block. The designed SEED is realized in an FPGA but we design it technology-independently so that ASIC or core-based implementation is possible. SEED requires many hardware resources which may be impossible to realize in one FPGA. So it is necessary to minimize hardware resources. In this paper only one G function is implemented and is used for both the F function block and the round key block. That is, by using one G function sequentially, we can realize all the SEED components in one FPGA. The used cell rate after synthesis is 80% in Altem FLEXI0KlOO. The resulted design has 28Mhz clock speed and 14.9Mbps performance. The SEED hardware is technology-independent and no other external component is needed. Thus, it can be applied to other SEED implementations and cipher systems which use SEED.

• Journal of agriculture & life science
• /
• v.45 no.4
• /
• pp.65-72
• /
• 2011

The objective of this research is to develop biomass allometric equation for Pinus densiflora in central region and Quercus variabilis. To develop the biomass allometric equation by species and tree component, data for Pinus densiflora in central region is collected to 30 plots (70 trees) and for Quercus variabilis is collected to 15 plots (32 trees). This study is used two independent values; (1) one based on diameter beast height, (2) the other, diameter beast height and height. And the equation forms were divided into exponential, logarithmic, and quadratic functions. The validation of biomass allometric equations were fitness index, standard error of estimate, and bias. From these methods, the most appropriate equations in estimating total tree biomass for each species are as follows: $W=aD^b$, $W=aD^bH^c$; fitness index were 0.937, 0.943 for Pinus densiflora in central region stands, and $W=a+bD+cD^2$, $W=aD^bH^c$; fitness index were 0.865, 0.874 for Quercus variabilis stands. in addition, the best performance of biomass allometric equation for Pinus densiflora in central region is $W=aD^b$, and Quercus variabilis is $W=a+bD+cD^2$. The results of this study could be useful to overcome the disadvantage of existing the biomass allometric equation and calculate reliable carbon stocks for Pinus densiflora in central region and Quercus variabilis in Korea.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.14 no.5
• /
• pp.349-361
• /
• 2021

With the development of technology and the advancement of weather forecasting models and prediction methods, higher performance weather forecasting software has been developed, and more precise and accurate weather forecasting is possible by performing software using supercomputers. In this paper, the weather forecast model used by six major countries is investigated and its characteristics are analyzed, and the Korea Meteorological Administration currently uses it in collaboration with the UK Meteorological Administration since 2012 and explains the GloSea However, the existing GloSea was conducted only on the Meteorological Administration supercomputer, making it difficult for various researchers to perform detailed research by specialized field. Therefore, this paper aims to establish a standard experimental environment in which the low-resolution version based on GloSea6 currently used in Korea can be used in local systems and test it to present the localization of low-resolution GloSea6 that can be performed in the laboratory environment. In other words, in this paper, the local portability of low-resolution Globe6 is verified by establishing a basic architecture consisting of a user terminal-calculation server-repository server and performing execution tests of the software.

• Smart Media Journal
• /
• v.10 no.3
• /
• pp.31-38
• /
• 2021

It is hard to predict when and where a fall accident will happen. Also, if rapid follow-up measures on it are not performed, a fall accident leads to a threat of life, so studies that can automatically detect a fall accident have become necessary. Among automatic fall-accident detection techniques, a fall detection scheme using an IMU (inertial measurement unit) sensor attached to a wrist is difficult to detect a fall accident due to its movement, but it is recognized as a technique that is easy to wear and has excellent accessibility. To overcome the difficulty in obtaining fall data, this study proposes an algorithm that efficiently learns less data through machine learning such as KNN (k-nearest neighbors) and SVM (support vector machine). In addition, to improve the performance of these mathematical classifiers, this study utilized feature data aquired in the frequency space. The proposed algorithm analyzed the effect by diversifying the parameters of the model and the parameters of the frequency feature extractor through experiments using standard datasets. The proposed algorithm could adequately cope with a realistic problem that fall data are difficult to obtain. Because it is lighter than other classifiers, this algorithm was also easy to implement in small embedded systems where SIMD (single instruction multiple data) processing devices were difficult to mount.

• Journal of Korean Society of Disaster and Security
• /
• v.14 no.3
• /
• pp.29-38
• /
• 2021

Riverfront facilities are river space facilities used by citizens for the rest and convenience. Recently, although the importance of efficient maintenance of riverfront facilities is increasing, damaging facilities cases are increasing due to frequent floods. Currently, the inspections and diagnosis of river space facilities are limited to the main flood control facilities. And the standards for the maintenance and management of the riverfront facilities are insufficient. Utilization survey, which is the standard for managing river space facilities, is also inefficient in terms of manpower consumption and economic feasibility. This study uses mobile big data to classify river usage and conducts a survey for usability of river facilities to derive economic evaluation for usage performance. In the future, if economical method system that considers safety, usability, and durability is conducted and demanding analysis for each convenience facility is evaluated, it is expected that the efficient maintenance of riverfront facilities is perfomed better and the use of rivers by citizens will further increase.