• International Journal of Naval Architecture and Ocean Engineering
• /
• 제8권4호
• /
• pp.312-319
• /
• 2016

Measured wave data covering two years simultaneously at 3 locations along the eastern Arabian Sea reveals the presence of long-period (peak wave period > 18 s) low-amplitude waves (significant wave height < 1 m) and the characteristics of these waves are described in this article. In a year, 1.4-3.6% of the time, the low-amplitude long-period swells were observed, and these waves were mainly during the nonmonsoon period. The wave spectra during these long-period swells were multi-peaked with peak wave period around 18.2 s, the secondary peak period around 13.3 s and the wind-sea peak period at 5 s. The ratio of the spectral energy of the wind-sea peak and the primary peak (swell) was slightly higher at the northern location (0.2) than that at the southern location (0.15) due to the higher wind speed present at the northern location.

• International Journal of Ocean Engineering and Technology Speciallssue:Selected Papers
• /
• 제3권1호
• /
• pp.29-34
• /
• 2000

This paper proposes a long-term prediction of offshore structures in ocean waves. All short-term statistics is generated by the simulation for all the combinations of significant wave heights and spectral peak periods. The simulation has been tested first on linear system, whose analytic solution is known, to verify if the simulation works accurately. Then the scheme was applied to the nonlinear system. This paper demonstrated that the proposed scheme could be an efficient tool in estimating the response of offshore structures.

• 한국해안·해양공학회논문집
• /
• 제25권6호
• /
• pp.394-404
• /
• 2013

본 연구에서는 너울성파랑을 정의하기 위한 첫 단계로 확률모의실험을 통해 파랑스펙트럼 첨두모수 $Q_p$, 주파수폭대역 모수 ${\varepsilon}$, 파랑스펙트럼 폭 모수 ${\nu}$의 특성들을 분석하였다. 이를 위해 유의파고 및 첨두주기의 결합확률 밀도함수를 새롭게 유도한 후, MCMC(Markov Chain Monte Carlo)기법을 이 함수에 적용하여 가상의 유의파고 및 첨두주기를 생성하였다. 그리고, 이 때 생성된 파랑자료들을 파랑스펙트럼모형에 적용하여 각각에 대한 파랑스펙트럼 형상모수들을 산정한 다음, 각각의 파랑자료들과 파랑스펙트럼 형상모수들의 상관관계 계수를 산정하는 방법으로 각 파랑스펙트럼 형상모수의 특성들을 조사하였다. 본 연구의 결과에 의하면, 파랑스펙트럼 형상모수 중 파랑스펙트럼 첨두모수가 유의파고 및 첨두주기에 관계없이 파랑스펙트럼의 뾰족한 정도를 잘 나타내고 있었는데, 이러한 특성은 후포 및 울릉도 파랑관측자료에서도 동일하게 나타나고 있는 것으로 확인되었다. 너울성파랑 정의를 위한 대표적인 파랑스펙트럼 형상모수로 파랑스펙트럼 첨두모수를 사용하는 것이 가장 적절한 것으로 보인다.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2011년도 추계학술대회 초록집
• /
• pp.38.1-38.1
• /
• 2011

This study investigates the effects of Pierson-Moskowitz, Jonswap spectrum that are typical irregular wave spectrums for wind turbine system with jacket support structure. Also various offshore environmental parameters based on korean local condition were used in our study. The loads acting on the system was considered by referring to the Design Load Case from IEC guide line. And improved von Karman model was used as a turbulence model. As a result, various significant wave height and peak spectral period cause noticeable difference of extreme and fatigue loads prediction.

• Nuclear Engineering and Technology
• /
• 제53권12호
• /
• pp.4179-4188
• /
• 2021

This study identifies efficient earthquake intensity measures (IMs) for seismic performances and fragility evaluations of the reactor containment building (RCB) in the advanced power reactor 1400 (APR1400) nuclear power plant (NPP). The computational model of RCB is constructed using the beam-truss model (BTM) for nonlinear analyses. A total of 90 ground motion records and 20 different IMs are employed for numerical analyses. A series of nonlinear time-history analyses are performed to monitor maximum floor displacements and accelerations of RCB. Then, probabilistic seismic demand models of RCB are developed for each IM. Statistical parameters including coefficient of determination (R²), dispersion (i.e. standard deviation), practicality, and proficiency are calculated to recognize strongly correlated IMs with the seismic performance of the NPP structure. The numerical results show that the optimal IMs are spectral acceleration, spectral velocity, spectral displacement at the fundamental period, acceleration spectrum intensity, effective peak acceleration, peak ground acceleration, A95, and sustained maximum acceleration. Moreover, weakly related IMs to the seismic performance of RCB are peak ground displacement, root-mean-square of displacement, specific energy density, root-mean-square of velocity, peak ground velocity, Housner intensity, velocity spectrum intensity, and sustained maximum velocity. Finally, a set of fragility curves of RCB are developed for optimal IMs.

• 대한전기학회논문지:시스템및제어부문D
• /
• 제52권9호
• /
• pp.547-553
• /
• 2003

In this paper, we designed the PC-based analyzer of the power spectral density that could estimate the heart rate variability from time series data of R-R interval. The power spectral density estimated that it applied the autoregressive model to the measured electrocardiogram during a short period. Also, the characteristics of the designed analyzer are that it could process of the signal filtering, the generation and recomposition of time series and the feature extraction at the same time. Especially the analyzer reconstructed which applied the lowpass filter of the time series composed by the linear interpolation so as to enhance the signal-to-noise feature. We could estimate the power spectral density that confirmed a variety of power peak with low frequency range and high frequency rang of autonomic nerve by the heart rate variability.

• Structural Engineering and Mechanics
• /
• 제41권4호
• /
• pp.479-494
• /
• 2012

This study explores a coefficient-based seismic capacity assessment method with a special emphasis on low-rise masonry in-filled (MI) reinforced concrete (RC) buildings subjected to earthquake motion. The coefficient-based method without requiring any complicated finite element analysis is a simplified procedure to assess the maximum spectral acceleration capacity of buildings. This paper first compares the fundamental periods of MI RC structures obtained, respectively, from experimental period data and empirical period-height formulas. The coefficient-based method for low-rise masonry buildings is then calibrated by the published experimental results obtained from shaking table tests. The comparison of the experimental and estimated results indicates that the simplified coefficient-based method can provide good approximations of the maximum spectral accelerations at peak loads of the low-rise masonry reinforced concrete buildings if a proper set of drift factors and initial fundamental vibration periods of structures are used.

• Structural Engineering and Mechanics
• /
• 제42권1호
• /
• pp.121-129
• /
• 2012

All contemporary seismic Codes have adopted smooth design acceleration response spectra, which have derived by statistical analysis of many elastic response spectra of natural accelerograms. The above smooth design spectra are characterized by two main branches, an horizontal branch that is 2.5 times higher than the peak ground acceleration, and a declining parabolic branch. According to Eurocode EN/1998, the period range of the horizontal, flat branch is extended from 0.1 s, for rock soils, up to 0.8 s for softer ones. However, from many natural recorded accelerograms of important earthquakes, the real spectral amplification factor appears to be much higher than 2.5 and this means that the spectrum leads to an unsafe seismic design of the structures. This point is an issue open to question and it is the object of the present study. In the present paper, the spectral amplification factor of the smooth design acceleration spectra is re-calculated on the grounds of a known "reliability index" for a desired probability of exceedance. As a pilot scheme, the seismic area of Greece is chosen, as it is the most seismically hazardous area in Europe. The accelerograms of the 82 most important earthquakes, which have occurred in Greece during the last 38 years, are used. The soil categories are taken into account according to EN/1998. The results that have been concluded from these data are compared with the results obtained from other strong earthquakes reported in the World literature.

• Earthquakes and Structures
• /
• 제23권2호
• /
• pp.115-128
• /
• 2022

One common method to select input ground motions to predict dynamic behavior of structures subjected to seismic excitation requires spectral acceleration (S_a) match target mean response spectrum. However, dispersion of ground motions, which explicitly affects the structural response, is rarely discussed in this method. Generally, selecting ground motions matching target mean and variance has been utilized as an appropriate method to predict reliable seismic response. The goal of this paper is to investigate the impact of target spectra variance of ground motions on structural seismic response. Two sets of ground motions with different target variances (zero variance and minimum variance larger than inherent variance of the target spectrum) are selected as input to two different structures. Structural responses at different heights are compared, in terms of peak, mean and dispersion. Results show that increase of target spectra variance tends to increase peak floor acceleration, peak deformation and dispersions of response of interest remarkably. To short-period structures, dispersion increase ratios of seismic response are close to that of S_a of input ground motions at the first period. To long-period structures, dispersions of floor acceleration and floor response spectra increase more significantly at the bottom, while dispersion increase ratios of IDR and deformation are close to that of S_a of input ground motions at the first period. This study could further provide useful information on selecting appropriate ground motion to predict seismic behavior of different types of structures.

• 한국해양공학회지
• /
• 제34권1호
• /
• pp.26-36
• /
• 2020

An extreme value analysis of metocean data which include wave, wind, and current data is a prerequisite for the operation and survival of offshore structures. The purpose of this study was to provide information about the return wave, wind, and current values for the Barents Sea using extreme value analysis. Hindcast datasets of the Global Reanalysis of Ocean Waves 2012 (GROW2012) for a waves, winds and currents were obtained from the Oceanweather Inc. The Gumbel distribution, 2 and 3 parameters Weibull distributions and log-normal distribution were used for the extreme value analysis. The least square method was used to estimate the parameters for the extreme value distribution. The return values, including the significant wave height, spectral peak wave period, wind speed and current speed at surface, were calculated and it will be utilized to design offshore structures to be operated in the Barents Sea.