• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제55권8호
• /
• pp.389-395
• /
• 2006

In the single-phase switched reluctance motor (SRM) drive, the required DC source is generally supplied by the circuit consisting of bridge rectifier with diodes and many filter capacitances connected with AC source. Although the peak torque ripple of SRM is small because of large capacity of the capacitance, the charge and discharge time swhich the AC source acts on the capacitance are small and the peak current will pass on the side of source, so power factor and system efficiency decrease. Therefore a novel SRM drive system is presented in this paper, which includes drive circuit realizing reduction of torque ripple and improvement of power factor and switching topology. The proposed drive circuit consists of one switching part and diodes which can separate the output of AC/DC rectifier from the large capacitance and supply power to SRM alternately in order to realize reduction of torque ripple and improvement of power factor through the turn on and turn off of switching part. In addition, the validity of method is tested by simulation and experiment.

• 한국수자원학회논문집
• /
• 제43권7호
• /
• pp.635-643
• /
• 2010

작은 규모 유역의 홍수 유출량을 산출하기 위해서 유역을 대표하는 하나의 단위유량도를 많이 적용해 왔다. 이 때 단위유량도의 첨두유량과 첨두 발생시간은 단위유량도를 결정하는 특성치로 취급된다. 본 연구에서는 국내에서 $8.5\;km^2$ 정도의 소규모 유역에서도 강우 사상별로 단위유량도의 첨두유량과 발생시간은 상당히 변동되는 것을 보이고 분석하였다. 그리고 동일 소유역에서 단위유량도 변동의 주요인으로 강우 사상별 평균 강우강도라고 보고 강우 사상별 강우강도와 단위유량도의 첨두유량 및 발생시간의 관계를 각각 지수함수식으로 제시하였다. 결과적으로 사용 자료상의 제약 등으로 단위유량도 첨두치에상당한 분산을 동반하는 한계는있지만 연구된 대로 단위유량도의첨두유량 및 첨두 발생시간과 강우의 평균적인 회귀 관계는 단위유량도 이론의 보완적 측면에서 수문학적 가치를 갖는다.

• Macromolecular Research
• /
• 제12권1호
• /
• pp.141-143
• /
• 2004

We have investigated the dynamic mechanical behavior of ultra-high molecular weight polyethylene (UHMWPE) irradiated with varying doses of gamma rays. A relaxation peak in the loss factor curve, which has not been reported previously in the literature, is observed at a temperature above the crystal melting temperature. The peak is unique to UHMWPE and appears to be related to the high degree of entanglement. Because the temperature and intensity of the peak are reduced by irradiation-induced chain scission and crosslinking, respectively, we believe that the peak is associated with disentanglement relaxation. The behavior of the storage modulus in the melt state agrees with the classical theory of rubber elasticity.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1993년도 하계학술대회 논문집 B
• /
• pp.1088-1090
• /
• 1993

This paper shows efficient peak demand control method in office buildings. With a rapid growth of national economics and living standard, electrical energy consumption markedly increased. Expecially, it is increased electrical energy comsumption in the office buildings and thus an energy conservation through efficient use of electricity became more important. From the data of electric equipment capacity and electric power consumption for 96 buildings, current levels of demand factor and a growth trend of peak loads by office buildings were surveyed and analyzed. In addition the efficient peak demand control method in office buildings were studied.

• 전기학회논문지
• /
• 제58권6호
• /
• pp.1078-1086
• /
• 2009

This paper presents a Fourier based algorithm for estimating the parameters of the low frequency oscillating modes. The proposed methods estimates various parameters(frequency, damping factor, mode magnitude, phase) by fitting Fourier spectrum and phase with a damped exponential cosine function. Dominant frequency is selected by taking frequency corresponding to the peak spectrum, and damping factor is estimated using the left/right spectra of Fourier spectrum. In addition, mode magnitude is calculated by the normalized peak spectrum, and phase is estimated from spectrum phase. Also, we introduce an accuracy index in order to determine the accuracy of the estimated parameters, and the index is calculated using the deviations of the peak spectrum and the left/right spectra. The parameter estimation methods proposed in this paper include very simple arithmetical processes, so the algorithms are simple and the calculation speed is very fast. The proposed methods are applied to test functions with two dominant modes. The results show that the proposed methods are highly applicable to low frequency parameter estimation.

• 한국해양공학회지
• /
• 제29권5호
• /
• pp.342-350
• /
• 2015

A seismic reliability analysis of the jacket-type support structure for an offshore wind turbine was performed. When defining the limit state function using the dynamic response of the support structure, numerous dynamic calculations should be performedin an approach like the FORM (first-order reliability method). This causes a substantial increase in the analysis cost. Therefore, in this paper, a new reliability analysis approach using the static response is used. The dynamic effect of the response is considered by introducing a new parameter called the peak response factor (PRF). The probability distribution of the PRF could be estimated using the peak value of the dynamic response. The probability distribution of the PRF was obtained for a set of ground motions. A numerical example is considered to compare the proposed approach with the conventional static-response-based approach.

• Journal of Welding and Joining
• /
• 제17권3호
• /
• pp.55-65
• /
• 1999

Metallurgical factors influencing toughness of the Intercritically Reheated Coarse-Grained Heat Affected Zone (ICCG HAZ) of multiple welded SA508-cl.3 Reactor Pressure Vessel Steel were evaluated. The recrystallized austenite formed along the prior austenite grain boundaries and late interfaced on heating to the intercritical range was transformed to bainite and/or martensite during cooling. The newly formed martensite always included some retained austenite(M-A constituents). The characteristics(amount, hardness, density, and size) of M-A constituents were found to be strongly associated with both peak temperature and cooling time(△t8/5(2)) of last pass. Toughness in the ICCG HAZ was deteriorated with increasing amount of M-A constituents which was increased with increasing the last peak temperature within the intercritical temperature range. Meanwhile, for the same intercritical peak temperature, toughness was decreased with increasing cooling time. When cooling time was short, the dominant factor influencing toughness of the ICCG HAZ was amount of M-A constituents. However, when cooling time was lengthened, the hardness difference between M-A constituents and softened matrix(tempered martensite) was found to be the dominant factor.

• 한국해양공학회지
• /
• 제7권1호
• /
• pp.124-132
• /
• 1993

In order to examine the effect of anisotropy and stress ratio on fatigue crack propagation rate and opening-closing behavior and also arrest behavior by single tension peak overload, the fatigue tests of constant amplitude atress and single tension peak overload adding to cycle of constant amplitude were carried out in stress ratio of -0.4, -0.2, and 0.4 with materials of T-L and L-T directions in 2024-T3 aluminum alloy plate. Crack opening-closing begavior were measured by the compliance method using COD gage and strain gage. In case of the crack opening-closing behavior was measured by strain gage, the effect of stress ratio is unchangeable. But in the case of COD gage, that is remarkably decreased. Fictitious effective stress intensity factor(U sub(f)) and effective stress intensity factor ratio(U) in L-T direction was higher than those in T-L direction and also threshold arrest overload ratio incrased as stress ratio decreased and that of T-L direction was higher than that in L-T direction.

• 대한전기학회논문지
• /
• 제45권3호
• /
• pp.358-364
• /
• 1996

Recently, much power demand from domestic power consumer is weakening the allowable power reserve margin in summer, especially at midday for one day due to a steep increase of air cooling loads such as air conditioner. Therefore solar airconditioning system can'be considered as one of the best remedies to meet the increase of peak power. Generally in solar air conditioning system, the diode rectifier is used to build up DC link voltage from AC source. The diode rectifier is simple and cheap but it brings out the problems of low power factor and plentiful harmonics at the AC source. Also It can derate the utilization rate of solar energy because the reverse of power flow cannot be made. Hence, in this paper to overcome the peak power problem in summer and to endure good AC input characteristics, solar air conditioning system using the PWM converter is proposed. As results, obtained are the characteristics of the PWM converter such as low distorted current waveform, high power factor and bidirectional power control. And also the stability of proposed system is verified by examining the dynamics of step load change and power reversal testing. (author). refs., figs., tabs.

• 도시과학
• /
• 제6권2호
• /
• pp.49-57
• /
• 2017

A new Fiber Bragg Grating (FBG) wavelength demodulation scheme is studied in the paper, which consists of an improved de-noising method and Gaussian fitting peak searching algorithm. The improved translational invariant wavelet without threshold adjust factor is proposed to get a better de-noising performance for FBG sensor signal and overcome the drawbacks of soft or hard threshold wavelets. In order to get a high wavelength demodulation precision of FBG sensor signal, this de-noising method is designed to combine with Gaussian fitting peak searching algorithm. The simulation results show that the wavelength maximum measurement error is lower than 1pm, and can get a much higher accuracy.