• Applied Chemistry for Engineering
• /
• v.29 no.3
• /
• pp.289-297
• /
• 2018

The vehicle lubricant has captured 35% of the total lubricant market while the engine oil possessed 77% of the vehicle lubricant market in Korea. The suitable quality management of circulating engine oil is thus required for the driver and engine protection. But, KS and synthetic engine oil products (containing over 30% synthetic oil) are exempt to any quality inspections under Petroleum and Alternative Fuel Business Act. In this study, our research group investigated the quality monitoring of 30 kinds of domestic distributing synthetic engine oils. Two kinds of the engine oil showed an off specification from the test results; one engine oil is an imported and the other is a KS synthetic one. Also, the pattern of engine oils were analyzed using SIMDIST (simulated distillation) and the most engine oils had a broad carbon number spectrum, which is a typical of mineral oils except several imported products. Thus, we concluded that relevant laws for the proper quality management of synthetic oils and KS products are needed to be established for preventing consumer's damages.

• The Transactions of the Korea Information Processing Society
• /
• v.7 no.9
• /
• pp.3037-3047
• /
• 2000

This paper describes a method of tracking a close leading vehicle by color image processing using the pairs of tail and brake lights. which emit red light and are housed on the rear of the vehicle in stop-and-go traffic condition. In the color image converted as an HSV color model. candidate regions of rear lights are identified using the color features of a pair of lights. Then. the pair of tailor brake lights are detected by means of the geometrical features and location features for the pattern of the tail and brake lights. The location of the leading vehicle can be estimated by the location of the detected lights and the vehicle can be tracked continuously. It is also possible to detect the braking status of the leading vehicle by measuring the change in HSV color components of the pair of lights detected. In the experiment. this method tracked a leading vehicle successfully from urban road images and was more useful at night than in the daylight. The KAV-Ill (Korea Autonomous Vehicle- Ill) equipped with a color vision system implementing this algorithm was able to follow a leading vehicle autonomously at speeds of up to 15km!h on a paved road at night. This method might be useful for developing an LSA (Low Speed Automation) system that can relieve driver's stress in the stop-and-go traffic conditions encountered on urban roads.

• KIPS Transactions on Software and Data Engineering
• /
• v.8 no.12
• /
• pp.507-516
• /
• 2019

Costs invested in road maintenance and road development are on the rise. However, due to accidents such as portholes and ground subsidence, the risks to the drivers' safety and the material damage caused by accidents are also increasing. Following this trend, we have developed a system that determines road damage, according to the magnitude of vibration generated without directly intervening the driver when driving. In this paper, we implemented the system using a remote control car (RC car) simulator due to the limitation of the environment in which the actual vehicle is not available in the process of developing the system. In addition, we attached a vibration sensor and GPS sensor to the body of the RC car simulator to measure the vibration value and location information generated by the movement of the vehicle in real-time while driving, and transmitting the corresponding data to the server. In this way, we implemented a system that allows external users to check the damage of roads and the maintenance of the repaired roads based on data more easily than the existing systems. By using this system, we can perform early prediction of road breakage and pattern prediction based on the data. Further, for the RC car simulator, commercialization will be possible by combining it with business in other fields that require flatness.

• Spatial Information Research
• /
• v.23 no.4
• /
• pp.47-56
• /
• 2015

Recently, there has been an increase in the number of people who use the smart-phone navigation for using various latest functions such as group driving and location sharing. But smart-phone has a limited storage space for one application, since a lot of applications with different purposes are installed in the smart-phone. For this reason, road network data with a large space of memory used for map matching in the device for navigation cannot be stored in the smart-phone for this reason map matching is impossible. Besides, smart-phone which doesn't use the external GPS device, provides inaccurate GPS information, compared to the device for navigation. This is why the smart-phone navigation is hard to provide accurate location determination. Therefore, this study aims to help map matching that is more accurate than the existing device for navigation, by reducing the capacity of road network data used in the device for navigation through format design of a new road network and conversion and using a database of driver's driving patterns. In conclusion, more accurate map matching was possible in the smart-phone by using a storage space more than 80% less than existing device at the intersection where many roads cross, the building forest that a lot of GPS errors occur, the narrow roads close to the highway. It is considered that more accurate location-based service would be available not only in the navigation but also in various applications using GPS information and map in the future Navigation.

• Journal of Korean Society of Transportation
• /
• v.28 no.1
• /
• pp.39-49
• /
• 2010

Although many studies have been carried out on the pattern of behavior of drivers which result from the provision of traffic information, there have been few detailed studies on the composition of message, method for message expression, timing of provision, point of provision, media for provision, changes by traffic condition, etc. This study was intended to provide an insight into the changes in the characteristics related to the provision of information by analyzing how the patterns of information utilization change depending on the traffic condition and reclassifying such patterns according to the characteristics of media. Unlike the existing studies, this study adopted the traffic condition, using rate of information media, and the correlation coefficient label as the basis for information media classification, and categorized them into passive utilization media, active utilization media, and past experience in order to ensure the statistical reasonability. The categorized using rate of information media and traffic condition was found to have a positive(+) correlation with the travel speed in the case of passive utilization media during both consecutive holidays(Korea's traditional Thanksgiving day) and weekends, but had a negative(-) correlation with the positive utilization media and past experience. The rate of decision to take a detour based on the past experience was high at the condition of congestion or slow during both consecutive holidays and weekends, but the rate of decision to take a detour through passive utilization media was high in a smooth traffic. In other words, if the traffic condition worsens, using rate of passive utilization media would be low while the diversion rate would be high which uses the active utilization media and past experience. Therefore, it should be established to suit the traffic condition and media characteristics for strategies of traffic distribution through drivers' diversion behavior on weekends and consecutive holidays.

• Journal of Veterinary Clinics
• /
• v.32 no.4
• /
• pp.324-329
• /
• 2015

The primary aim of this study was to investigate biosecurity practices in pig farms and to determine the major risk factors associated with PCV2 infection for a sampled swine population in Korea. To this end, we analyzed data from a cross-sectional study of 296 farrow-to-finish farms, which was conducted between March and September 2014 to explore the prevalence of swine disease at farm level. Face-to-face interviews by on-site visit of trained veterinarians were conducted with the farm owners or managers using a standardized questionnaires with information about basic demographical data and management practices. Farms were classified as negative or positive through the use of infection profiles that combined data on serological testing including PCR antigen test result, antibody titer and sero-conversion pattern at each age category taking into account vaccination status. Data were analyzed using multivariate ordinal logistic regression. Results from this study indicated that biosecurity level of the farms was considered not good given low compliance of the biosecurity programs and facilities in the farm: off-site removal of dead stocks (7%), off-site location of storage facility for incoming feeds (12.6%), off-site pick-up location for finishers (19.3%), restrictions on feed supplier vehicles for farm entrance (19.6%), restriction of finisher trucks entering the farm (22.4%), and restriction on manure disposal trucks entering the farm (26.4%). In the final model (n = 255), allowance of finisher truck driver to the pig unit had increased risk of infection (OR = 2.4, 95% CI 1.22-4.67) whereas farms with a sign forbidding the entrance had decreased risk of infection (OR = 0.19, 95% CI 0.10-0.58). Further comprehensive research with larger sample size is required to better understand the multifactorial characteristic that some predisposing risk factors that were not available in this study. To the best knowledge of the authors, this was the first study to use empirical data to report risk factors associated with PCV2 infection in the Korean pig farms. Results from the current study could be used to decide optimal biosecurity measures to reduce the impact of PCV2 infection to farmers and policy makers.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.4
• /
• pp.35-42
• /
• 2019

Nut fasteners that require ultra-precise control are required in the overall manufacturing industry including electronic products that are currently developing with the automobile industry. Important performance factors when tightening nuts include loosening due to insufficient fastening force, breakage due to excessive fastening, Tightening torque and angle are required to maintain and improve the assembling quality and ensure the life of the product. Nut fasteners, which are now marketed under the name Nut Runner, require high torque and precision torque control, precision angle control, and high speed operation for increased production, and are required for sophisticated torque control dedicated to high output BLDC motors and nut fasteners. It is demanded to develop a high-precision torque control driver and a high-speed, low-speed, high-response precision speed control system, but it does not satisfy the high precision, high torque and high speed operation characteristics required by customers. Therefore, in this paper, we propose a control technique of BLDC motor variable speed control and nut runner based on vector control and torque control based on coordinate transformation of d axis and q axis that can realize low vibration and low noise even at accurate tightening torque and high speed rotation. The performance results were analyzed to confirm that the proposed control satisfies the nut runner performance. In addition, it is confirmed that the pattern is programmed by One-Stage operation clamping method and it is tightened to the target torque exactly after 10,000 [rpm] high speed operation. The problem of tightening torque detection by torque ripple is also solved by using disturbance observer Respectively.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.9 no.4
• /
• pp.561-568
• /
• 2021

In this study, in order to observe the change in the amount of Tire and Road Wear Particles and the ratio of tire components in it according to the tire wear resistance performance, carried out the evaluation by varying the vulcanization reaction design of the tire tread rubber. In addition, in order to improve the reliability of the evaluation of Tire and Road Wear Particles, the evaluation was performed indoor laboratory test equipment that simulates the condition on real driving to exclude various environmental influences including minerals, driver's habits, road surface, weather, tire structure and pattern designs. After the evaluation in closed space, it is estimated that the amount of collected Tire and Road Wear Particles is 84% compared to 100% of the tire and road wear loss weight, of which 96.4~97.7% was around the road and 2.3~3.6% was in the air. As a result of analy sis of the collected Tire and Road Wear particles, the tire component existed 63~75% in the Tire and Road Wear Particles depending on the wear resistance performance of the tire.

• Korean Journal of Culture and Social Issue
• /
• v.22 no.1
• /
• pp.19-39
• /
• 2016

Though research has shown that public transportation drivers experience greater burnout than other drivers, the sources of their burnout and possible mediators remain largely unknown. In response, in this study we investigate the relationships among sensation seeking, Type A driving behavior, and meaning of work to elucidate the burnout experienced by bus drivers in Gyeonggi-do, South Korea. To collect data regarding these relationships, 188 bus drivers answered a questionnaire involving the sensation seeking scale, burnout scale, and meaning of work scale. Results showed that Type A driving behavior mediated the relationship between sensation seeking and burnout, while meaning of work moderated the mediated model. These findings demonstrate that sensation-seeking bus drivers tend to experience greater burnout given their tendency to exhibit Type A driving behavior, and this relationship depends on perceived meaning of work. This study therefore contributes meaningful information and outlines significant implications in understanding drivers' burnout.