• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.1 no.1
• /
• pp.43-51
• /
• 1981

A model of substrate utilization witbin bacterial films has been developed and simulated for a better understanding of fixed film treatment processes. The model consists of two parts, a deep biofilm and a thin biofilm, which are classified based on substrate penetration into the biofilm. Substrate concentration and flux within a biofilm can be computed from the model. Three dimensionless parameters, ${\phi}_1$, ${\phi}_2$ and $\bar{S}_b$ were obtained during model construction, and the substrate concentration and flux can be expressed in terms of these parameters. It has been found that an. increase of ${\phi}_1$ or a decrease of ${\phi}_2$ results in an increase of treatment efficiencies. It has also been found that systems maintaining high efficiencies belong to a deep biofilm. Among the constants involved, the mass transfer coefficient is the only controllable term and it depends Largely on fluid velocity near the biofilm surface. Substrate removal efficiency may be increased with an increase of fluid velocity for a biofilm of fixed depth. However, film depth is decreased due to sloughing with increasing velocity, and the system reaches a new steady state. Because changes in film depth are not well defined quantitatively yet, the efficiency can not be clearly described at a new steady state.

• Journal of Korean Ophthalmic Optics Society
• /
• v.20 no.4
• /
• pp.519-526
• /
• 2015

Purpose: To evaluate the changes of OSI value according to tear-film instability measured serially by OQAS(Optical Quality Analysis System, Visiometrics, Spain) every seconds. The presented study analyzed the relationship of the OQAS parameter with the results of the tear-film break-up time, Schirmer test, and the McMonies score. Methods: 147 eyes of 82 subjects were randomly selected from university students (age: $21.51{\pm}3.97$, male 45, female 37). Subjects were measured tear-film break-up time, Schirmer test, McMonies score and once every second for 15 seconds after blinking by continuous measurements from OQAS system. Results: The normal eye groups presented OSI values of $2.13{\pm}1.16$ while the dry eye groups had OSI values of $3.76{\pm}1.42$. Therefore, a significant difference between the normal eye group and dry eye group was discovered (p<0.05). In addition, the OSI value of all subjects increased over time. The OSI value, which was measured every second after blinking occurred, significantly increased between 6 seconds and 7 seconds after the start of the measurement (p<0.05). OSI cut off of 30% (sec.) showed a greater correlation; TBUT (r = 0.855, p = 0.000), McMonies test (r = -0.351, p = 0.003), Schirmer (r = 0.316, p = 0.012). Conclusions: Continuous measurement of OQAS showed a high correlation with the value of the existing dry eye tests. Therefore, Analysis of OSI values by utilization of OQAS could be useful in objectively evaluation of tear film in patients.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.26 no.5
• /
• pp.423-431
• /
• 2016

In general LPR(License Plate Recognition) in outdoor image is not so simple differently from in the image captured from manmade environment, because of geometric shape distortion and large illumination changes. this paper proposes three techniques for LPR in outdoor images captured from CCTV. At first, a serially connected multi-stage Adaboost LP detector is proposed, in which different complementary features are used. In the proposed detector the performance is increased by the Haar-like Adaboost LP detector consecutively connected to the MB-LBP based one in serial manner. In addition the technique is proposed that makes image processing easy by the prior determination of LP type, after correction of geometric distortion of LP image. The technique is more efficient than the processing the whole LP image without knowledge of LP type in that we can take the appropriate color to gray conversion, accurate location for separation of text/numeric character sub-images, and proper parameter selection for image processing. In the proposed technique we use DBN(Deep Belief Network) to achieve a robust character recognition against stroke loss and geometric distortion like slant due to the incomplete image processing.

• Journal of Advanced Marine Engineering and Technology
• /
• v.40 no.6
• /
• pp.527-534
• /
• 2016

The non-rail mobile rack, which is used for cargo storage, can improve the storage capacities of logistics centers. Furthermore, it has the advantage that it can be used in traditional logistics centers without making any changes or renovation, such as installing rails. However, when the rack is operated by separated drive actuators mounted on the left and the right wheels, precise position control of the wheels is necessary even if the unbalanced cargo weight on the rack would affect the control. Therefore, internal synchronization control for position tracking between the left and right wheels on the non-rail mobile rack is necessary in this study. In addition, external synchronization control for realizing the same straight movements between mobile racks is necessary. For the internal and the external synchronization control, we propose a synchronization control algorithm based on the repetitive control theory. An internal synchronization control algorithm with repetitive control theory requires the application of the robust servo control method owing to parameter variations. In this case, we can set up the gains for the robust servo control system by considering the cargo variations on the mobile rack. Furthermore, for developing the external synchronization control algorithm, we use a double repetitive control system to perform synchronization control between mobile racks. The efficiency of the proposed control algorithm will be verified by simulation and experimental results. The proposed algorithm can be easily applied in the industry.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.1C
• /
• pp.1-10
• /
• 2002

With the explosive growth of the number of Internet users and Internet-related services, the research on construction of broadband Optical Internet by using WDM technologies is actively is actively progressed. In this paper, we design the offset time decision (OTD) algorithm for supporting the QoS in optical networks based on optical burst switching (OBS), which is the new switching paradigm, and evaluate the performance of it. The proposed algorithm determines a reasonable offset time considering traffic load of network and the number of wavelengths to guarantee the burst loss rate (BLR) of high priority Internet traffic as a QoS parameter. In order to design the proposed OTD algorithm, firstly we make the new burst loss formula, which includes the effect of offset time. The decision of offset time corresponding to the requested BLR, however, should use the reverse formula of proposed one, thus we are not able to use it without any changes. In this paper, we define the heuristic loss formula (HLF) that can be changed into reversed formula by using the proposed formula and proportional equation considering its characteristics. Finally we show the OTD algorithm to decide the offset time by using HLF. We show that the requested BLR is guaranteed under various traffic load with the determinded offset time by using the proposed OTD algorithm.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.8
• /
• pp.62-68
• /
• 2016

The feeder cable assembly is an automotive part used for telecommunication. If it malfunctions, the control and safety of the automobile can be put at risk. ALT (Accelerated Life Testing) is a testing process for products in which they are subjected to conditions (stress, strain, temperatures, etc.) in excess of their normal service parameters in an attempt to uncover faults and potential modes of failure in a short amount of time. Failure is caused by defects in the design, process, quality, or application of the part, and these defects are the underlying causes of failure or which initiate a process leading to failure. Thermal shock occurs when a thermal gradient causes different parts of an object to expand by different amounts. Thermal shock testing is performed to determine the ability of parts and components to withstand sudden changes in temperature. In this research, the main causes of failure of the feeder cable assembly were snapping, shorting and electro-pressure resistance failure. Using the Coffin-Manson model for ALT, the normal conditions were from Tmax = $80^{\circ}C$ to Tmin = $-40^{\circ}C$, the accelerated testing conditions were from Tmax = $120^{\circ}C$ to Tmin = $-60^{\circ}C$, the AF (Acceleration Factor) was 2.25 and the testing time was reduced from 1,000 cycles to 444 cycles. Using the Bxlife test, the number of samples was 5, the required life was B0.04%.10years, in the acceleration condition, 747 cycles were obtained. After the thermal shock test under different conditions, the feeder cable assembly was examined by a network analyzer and compared with the Weibull distribution modulus parameter. The results obtained showed good results in acceleration life test mode. For the same reliability rate, the testing time was decreased by a quarter using ALT.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.38 no.2
• /
• pp.249-259
• /
• 2018

More than half of annual rainfall occurs in summer season in Korea due to its climate condition and geographical location. A frequency analysis is mostly adopted for designing hydraulic structure under the such concentrated rainfall condition. Among the various distributions, univariate Gumbel distribution has been routinely used for rainfall frequency analysis in Korea. However, the distributional changes in extreme rainfall have been globally observed including Korea. More specifically, the univariate Gumbel distribution based rainfall frequency analysis is often fail to describe multimodal behaviors which are mainly influenced by distinct climate conditions during the wet season. In this context, we purposed a Gumbel mixture distribution based rainfall frequency analysis with a Bayesian framework, and further the results were compared to that of the univariate. It was found that the proposed model showed better performance in describing underlying distributions, leading to the lower Bayesian information criterion (BIC) values. The mixed Gumbel distribution was more robust for describing the upper tail of the distribution which playes a crucial role in estimating more reliable estimates of design rainfall uncertainty occurred by peak of upper tail than single Gumbel distribution. Therefore, it can be concluded that the mixed Gumbel distribution is more compatible for extreme frequency analysis rainfall data with two or more peaks on its distribution.

• Journal of Distribution Science
• /
• v.11 no.4
• /
• pp.81-88
• /
• 2013

Purpose - This paper analyzes the influence of the RMB internationalization on the KRW/dollar exchange rate using an autoregressive distributed lag model. Comparing the parameter estimators from the sample period before and after the global financial crisis, we found that the RMB/dollar exchange rate has increasingly become more influential on the KRW/dollar exchange rate. Moreover, for the past several years, the Chinese government has actively utilized the financial service FTA negotiation as a measure for the RMB internationalization. This paper simultaneously considers RMB internationalization and financial service negotiations in the Korean-Chinese FTA. The purpose of this paper is to explicitly suggest a direction for the financial service negotiations in the Korean-Chinese FTA considering the effects of RMB internationalization. Research design, data, and methodology - The research plan of this paper has two parts. First, for an empirical study, this paper uses the daily exchange rate of the U.S. dollar against the currencies of the ASEAN5, Taiwan,and Korea. By using an autoregressive distributed lag model, this paper studies the influence of the change in the RMB/dollar exchange rate on changes in the local currency/dollar exchange rate in seven economies neighboring China. Our sample periods are 06/2005 - 07/2008 and 06/2010 -02/2013. During these periods, China was under the multi-currency basket system. We exempted the period of 08/2008 - 05/2010 from the analysis because there was nearly no RMB/dollar exchange rate fluctuation during those months. Second, after analyzing the recent financial service liberalizations and deregulations in China, we recommend a direction for the financial service negotiations in the Korean-Chinese FTA. In the past several years,the main Chinese financial policy agenda has surrounded the RMB internationalization. Therefore, it is crucial to understand this in the search for strategies for the financial service negotiations in the Korean-Chinese FTA. This paper employs an existing literature survey and examines the FTA protocols in its research methodology. Results and Conclusions - After the global financial crisis, the Chinese government wanted to break away from the dollar influence and pursued independent RMB internationalization in order to continue the growth and stability of its economy. Hence, every neighboring economy of China has been strategically impacted by RMB internationalization. Nevertheless, there is little empirical study on the influence of RMB internationalization on the KRW/dollar exchange rate. This paper is one of the few studies to analyze this problem comprehensively. By using a relatively simple estimation model, we can confirm that the coefficient of the RMB/dollar exchange rate has become more significant, except in the case of Indonesia. Although Korea is not under the multi-currency basket system but under the weakly controlled floating exchange rate system, its coefficient appears as large as that of the ASEAN5. This is the basis of the currency cooperation that has grown from the expansion of trade between the two countries. These empirical results suggest that the Korean government should specifically consider the RMB internationalization in the Korean-Chinese FTA negotiations.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.20 no.4
• /
• pp.61-74
• /
• 2012

Industrial complexes in Korea have been vigorously established by economic development plan and development policy of industry in 1960s. Recently, Korean government has promoted Eco Industrial Park (EIP) project to recycle by-products and wastes in industrial park In this study, we analyzed the physical and chemical properties for the sludges discharged from A industrial complex. And we investigated the economic feasibility and environmental impact of sludge to energy facilities. The analysis results indicated that the petrochemical industry were 92% in sludge production, the highest treatment amount was landfill, followed by incineration and recycling and then ocean disposal. Wastewater sludge and process sludge samples are collected and analyzed to use as basic data on economic feasibility and environmental impact. Weighted average heating value of sludge samples was 3,891kcal/kg. Based on this data, installation and operation costs, operation returns of operating the drying facility are estimated, compared with cogeneration facility. And this study examines how the payback period of each simulation(total 8 case) with the important parameter changes. As a result, it was found that what needs the shortest payback period is 3years with connection of drying facility and cogeneration facility based on the government's financial subsidy system.

• Korean Journal of Environmental Biology
• /
• v.38 no.1
• /
• pp.93-100
• /
• 2020

Hybrid grouper (Epinephelus fuscoguttatus ♀×E. lanceolatus ♂) (mean weight 27.3±3.8 g, mean length 11.6±0.7 cm) were exposed to waterborne nitrite at 0, 100, 200, 400, 800, and 1600mg L^-1 for 96 hours. The hematocrit and hemoglobin values were significantly decreased by exposure to 100 mg L^-1 and 400 mg L^-1, respectively. In plasma components, no significant change was observed in magnesium. Glucose was significantly increased by 200 and 400 mg L^-1 nitrite but reduced by 800 mg L^-1. Cholesterol was significantly decreased by 400 mg L^-1 nitrite, but there was no significant change in total protein. GPT(glutamic pyruvate transaminase) was significantly increased by exposure to 200 and 400mg L^-1. ALP(Alkaline phosphatase) was significantly increased by 800 mg L^-1. The results of this study indicate that acute exposure to nitrite changes physiological parameters, such as hematological properties and plasma components.