• Journal of KIISE
• /
• v.42 no.10
• /
• pp.1254-1267
• /
• 2015

Recently, excessive installations of APs have caused WLAN interference, and many techniques have been suggested to solve this problem. The AP aggregation technique serves to reduce active APs by moving station connections to a certain AP. Since this technique forcibly moves station connections, the transmission performance of some stations may deteriorate. The AP transmit power control technique may cause station disconnection or deterioration of transmission performance when power is reduced under a certain level. The combination of these two techniques can reduce interference through AP aggregation and narrow the range of interferences further through detailed power adjustment. However, simply combining these techniques may decrease the probability of power adjustment after aggregation and increase station disconnections upon power control. As a result, improvement in performance may be insignificant. Hence, this study suggests a scheme to combine the AP aggregation and the AP transmit power control techniques in OpenFlow-based WLAN to ameliorate the disadvantages of each technique and to reduce interferences efficiently by performing aggregation for the purpose of increasing the probability of adjusting transmission power. Simulations reveal that the average transmission delay of the suggested scheme is reduced by as much as 12.8% compared to the aggregation scheme and by as much as 18.1% compared to the power control scheme. The packet loss rate due to interference is reduced by as much as 24.9% compared to the aggregation scheme and by as much as 46.7% compared to the power control scheme. In addition, the aggregation scheme and the power control scheme decrease the throughput of several stations as a side effect, but our scheme increases the total data throughput without decreasing the throughput of each station.

• Journal of Korea Multimedia Society
• /
• v.15 no.5
• /
• pp.587-594
• /
• 2012

IEEE 802.15.6 standard technology is proposed for low-power wireless communication in, on and around body, where vital signs such as pulse, blood pressure, ECG, and EEG signals are transmitted as a type of data packet. Especially, these vital signs should be delivered in real time, so that the latency from slave node to hub node can be one of the pivotal performance requirements. However, in the case of IEEE 802.15.6 technology data retransmission caused by transmission failure can be done in the next superframe. In order to overcome this limitation, we propose an adaptive polling algorithm for IEEE 802.15.6 technology. The proposing algorithm makes the hub to look for an appropriate time period in order to make data retransmission within the superframe. Through the performance evaluation, the proposing algorithm achieves a 61% and a 73% latency reduction compared to those of IEEE 802.15.6 technology in the environment of 70% traffic offered load with 10ms and 100ms superframe period. In addition, the proposing algorithm prevents bursty traffic transmission condition caused by mixing retransmission traffic with the traffic reserved for transmission. Through the proposing adaptive polling algorithm, it will be possible to transmit time-sensitive vital signs without severe traffic delay.

• Journal of the Korea Society of Computer and Information
• /
• v.16 no.6
• /
• pp.131-142
• /
• 2011

In this paper, we propose a new multipath routing protocol and compare it with other multipath routing protocols in mobile ad hoc network (MANET) environments. The new multipath routing establishes the main route using a mechanism based on Ad Hoc On-demand Distance Vector(AODV), after which data transmission starts immediately. The backup route search process takes place while data are transmitted, to reduce the transmission delay. The protocol can also operate in a hybrid node-disjoint/link-disjoint mode, where the protocol finds the node-disjoint backup route first; if the node-disjoint does not exist, the protocol discovers the link-disjoint backup route from the main route. When either of the main route or the backup route is broken, data are transmitted continuously through the other route and the broken route is recovered by the route maintenance process. The results of simulations, based on the Qualnet simulator, show that the proposed multipath routing protocol increases the packet transmission success rate and reduces end-to-end delays, when compared with AODV and AOMDV protocols.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.10 no.4
• /
• pp.241-255
• /
• 2015

Recent network environment has been rapidly evolved to cloud computing environment based on the development of the Internet technologies. Furthermore there is an increasing demand on mobile cloud computing due to explosive growth of smart devices and wide deployment of LTE-based cellular networks. Thus mobile Desktop-as-a-Service(DaaS) could be a pervasive service for nomadic users. In addition, video streaming traffic is currently more than two-thirds of mobile traffic and ever increasing. All such trends enable that video streaming in mobile DaaS could be an important concern for mobile cloud computing. It should be noted that the performance of the Transmission Control Protocol(TCP) on cloud host servers greatly affects Quality of Service(QoS) of video streams for mobile users. With widely deployed Linux server platforms for cloud computing, in this paper, we conduct an experimental analysis of the twelve Linux TCP variants in mobile DaaS environments. The results of our experiments show that the TCP Illinois outperforms the other TCP variants in terms of wide range of packet loss rate and propagation delay over LTE-based wireless links between cloud servers and mobile devices, even though TCP CUBIC is usually used in default in the current Linux systems.

• Journal of Convergence Society for SMB
• /
• v.6 no.4
• /
• pp.59-64
• /
• 2016

6LoWPAN (IPv6 over Low Power Wireless Sensor Network) standardized by IETF does not support the mobility of wireless sensor nodes. Since the wireless sensor node, subject to a lot of constraints in the CPU, memory, a battery is not easy to apply to existing protocols such as Mobile IPv6. In this paper, we propose a novel mobility management architecture and methods to work with 6LoWPAN based on the analysis on FPMIPv6 (Fast PMIPv6) the host is not a handover procedure performed in order to support the mobility of such sensor nodes. It was suggested the use of a dispatch code pattern that is not currently used in 6LoWPAN for inter-working, MAG and MAC, MAC in order to reduce packet loss caused as the authentication delay in the handover process to minimize the power consumption of a sensor node that is caused by the re-transmission the new concept of temporary guarantee (temporary guarantee) and trust relationships (trust relationship) between AAA and introduced.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.11
• /
• pp.57-66
• /
• 2004

It is widely accepted that the coverage with high user densities in mobile multimedia environments can only be achieved with small cell such as micro- and pico-cell. The smaller cell size causes frequent handovers between cells and a decrease in the permissible handover processing delay. This may result in the handover failure, in addition to the loss of some packets during the handover. In these cases, re-transmission is needed in order to compensate errors, which triggers a rapid degradation of throughput. In this paper, we propose a new handover scheme in the next generation mobile communication systems, in which the handover setup process is done in advance before a handover request by predicting the handover cell based on mobile terminal's current position and moving direction. Simulation is focused on the handover failure rate and packet loss rate. The simulation results show that our proposed method provides a better performance than the conventional method.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.4 s.346
• /
• pp.22-30
• /
• 2006

In this paper, the goal of our proposed algorithm is to reduce link -failure and route failure caused by dead nodes which consume all of the battery life. I propose an algorithm which provides a ability of changing mutes to neighbor nodes before some of intermediate nodes be shutting don to get the stable route maintenance. To achieve this goal, The proposed routing algerian uses additional new messages to check energy status for monitoring energy of neighbor nodes and to change the path to a neighbor node. From extensive simulations, results show that possibility of cut-offs and time-delay cause of packet-loss have been decreased and also the improvement of transmission effectiveness.

• Journal of Internet Computing and Services
• /
• v.4 no.3
• /
• pp.47-55
• /
• 2003

Multicast protocols ore developed in order to support group communications efficiently, However. there still exist some issues to be solved for deploy multicast protocol in the public internet. This paper refers problem of existing Reliable Multicast Protocols and redesigns component function, and proposes enhanced reliable multicast transport protocol, This paper proposed a improved multicast transport scheme in NACK based reliable multicast. This scheme is much faster than by sender-initiated or receiver-initiated recovery and latency is smaller. Designed components are implemented in UNIX environment using C programming longuage. Then the protocol was evaluated performance through simulation. As the result, proposed protocol is better than existing protocols in both of transmission delay and packet loss. Especially, proposed protocol in this paper con be used in multicast services needed high reliability.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.23 no.3
• /
• pp.196-201
• /
• 2013

In this paper, we propose an asynchronous and adaptive message passing scheme based on S-MAC for handling with the problem on energy efficiency in wireless sensor networks. The proposed scheme consists of a policy that differentiate transmission errors caused by packet collision or radio interference from congestion errors caused by buffer overflow and a method that adaptively controls the size of a fragment according to the variance of traffic loads. Especially, it presents a method that highly reduce the energy consumption by keeping the size of fragment not being excessively smaller than the one that may result in rapid increment of the total transfer time. Finally, with the simulation results we show that network throughput and delay are improved by using the proposed message passing scheme.

• Journal of the Korea Computer Industry Society
• /
• v.2 no.4
• /
• pp.455-470
• /
• 2001

This paper is focused on the traffic characterization for the efficient transmission of the VBR video source in the ATM network. For the traffic characterization, low traffic monitoring technique is applied and the dynamic VBR characterization method is suggested to satisfy the delay requirement. The dynamic VBR method uses the token bucket algorithm buffering though Cumulative Constraint Function. According to the Cumulative Constraint Function, the packet initially started transferring at the peak rate and the token bucket provided proper amount of buffer for traffic after a certain period of monitoring. It also reduced the network resource bandwidth through renewal of the cumulative frame and changed the rate from the previous frame information. It requires only small amount of monitoring and causes little overhead. In addition, it lowered the complexity of Deterministic Constraint Function to 0(n) and mapped the token rate and token depth to the token bucket. This study shows less network resource consumed than the previous method, comparing and analyzing the result of simulations.