• Proceedings of the KIPE Conference
• /
• 2011.07a
• /
• pp.573-574
• /
• 2011

본 논문에서는 DC-DC 컨버터의 설계 및 해석 방법을 PSpice와 Simulink를 이용한 Co-Simulation방법으로 제안하였다. 일반적인 회로 및 제어기 설계방식은 회로와 제어기를 각각 설계하여 시제품으로 측정하는 방법과 이상적인 모델을 이용하여 시뮬레이션 하는 방법을 사용한다. 본 논문에서는 상용 소자모델로 구성된 컨버터를 PSpice로 설계하였고, Simulink에서 PSpice Solver를 이용하여 시뮬레이션 함으로써 일반적인 설계 방식보다 높은 신뢰성을 가진 시뮬레이션 방법을 제안한다.

• Proceedings of the KIPE Conference
• /
• 2011.07a
• /
• pp.408-409
• /
• 2011

본 논문에서는 전력전자 시스템 해석 시 PSpice와 Simulink를 이용한 Co-Simulation방법으로 회로 레벨(Circuit level)을 포함한 시스템 레벨(System level)에서의 시뮬레이션 해석 방법을 제안한다. 일반적인 전력전자 시스템의 설계 방법은 회로 레벨과 시스템 레벨에서 별도로 시뮬레이션하거나 이상적인 모델을 이용하여 시스템을 해석하여 왔으나, 이러한 시스템 설계 방법은 별도의 시제품을 제작하여 측정함으로써 시간과 금전적 손실이 있었다. 이러한 점을 보완하기 위해서 PSpice와 Simulink를 이용한 Co-Simulation방법을 제안한다.

• Journal of Advanced Marine Engineering and Technology
• /
• v.23 no.2
• /
• pp.150-158
• /
• 1999

The process of designing protective circuits against damage by transient overvoltages requires much work and expensive equipment. However computer simulation using PSpice can overcome these problems. In this paper a gas tube and a ZnO varistor Pspice-model considering the steepness of the wave-front were presented. The effects of various waveforms on the transient behaviors and firing volt-ages of a gas tube were modeled by controlled voltage source E controlled current source G and TABLE function of PSpice. And the nonlinear characteristics of a ZnO varistor were modeled by controlled voltage source E and H. To estimate the characteristics of the models proposed various waveforms specified in IEC Std. 1000310-4-5 were used in the simulation and the actual tests. The simulation results were compared with test results and showed good agreement.

• Journal of information and communication convergence engineering
• /
• v.9 no.1
• /
• pp.74-77
• /
• 2011

PSPICE modeling of a commercial LED driver IC (TOP245P) and PC817A optocoupler is proposed for the switch-mode power supply (SMPS) (applicable to LED driver) design and simulation. An analog behavioral model of the TOP245P IC including the shunt regulator, under-voltage(UV) detection, over-voltage(OV) shut-down and SR flip-flop is developed by using PSPICE. The empirical equation of PC817A current transfer ratio (CTR) is fitted from the datasheet of PC817A. Two types of SMPSs are simulated with the averaged-model and switching-model. The simulation results by the proposed PSPICE models are in good agreement with those in the data sheet and an experimental data.

• Proceedings of the KIEE Conference
• /
• 2009.04a
• /
• pp.163-165
• /
• 2009

Many photovoltaic (PV) systems are being developed and installed. For a PV developer, simulations are required before the experimental testing. However, most simulation tools do not offer data libraries for PV systems, so that some Institutes who try to use such software will be in difficulty. In this paper, simulations of performance and stability have been carried out using the software PSPICE. In this paper, the modelling of solar cell arrays, photovoltaic modules, PV generators, batteries and drive systems is carried out based on mathematical equivalence circuits and available data, and the models are converted into a data library for PSPICE that is user friendly. System variations can be modeled by simple parameter variation. To verify the accuracy of the simulation library, various models were run and compared to known systems.

• Proceedings of the KIPE Conference
• /
• 2016.11a
• /
• pp.192-193
• /
• 2016

본 논문은 계통 전원 정전 시 계통 전원을 대신하여 전력을 엘리베이터 구동 시스템에 공급함으로써 정전으로 기동이 정지된 엘리베이터 내부에 고립된 승객에 대한 비상구출 운전을 실시하는 자동 비상 구출 운전 시스템의 축전지 충전 회로에 관한 Simulink 및 PSpice 연동 해석 모델 개발을 실시한다.

• Proceedings of the KIPE Conference
• /
• 1998.07a
• /
• pp.444-446
• /
• 1998

Pspice을 사용하여 IGBT의 게이트 드라이브의 동작과 시스템의 단락에 의한 Fault 발생시 IGBT를 보호하기 위해서 밀러 효과에 의한 전류를 게이트 저항을 통하지 않고 이미터로 흐르게 하여 게이트 전압의 상승을 줄여주는 방법을 제안하고 게이트 전압을 낮게 클램핑하는 방법과 비교하였다.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.8 no.2
• /
• pp.180-191
• /
• 2003

In this paper, the modelings of PSPICE of the piezoelectric transformer and CCFL drive circuit using an electrical equivalent circuit is proposed. In the CCFL drive circuit modeling the model parameters of the CCFL were derived using the method of least squares because push-pull inverter and loads such as CCFL were also modeled using PSPICE. It is considered that the simulation techniques can be used in the piezoelectric devices such as piezoelectric transformer.

• Proceedings of the KIEE Conference
• /
• 1998.07e
• /
• pp.1675-1677
• /
• 1998

It is currently increasing to use surge protection devices in the protection of various electronic circuits from the transient overvoltages such as lightning strikes and switching surges. For this reason, the simulation methods, which can easily predict the protection performance of the devices, are strongly required in order to design the adequate surge protection circuits in lightning surge cut-off performance and economic aspects. This paper deals with ZnO varistor modeling method for designing a surge protection circuit and suggests the Pspice simulation model which takes the characteristic of varying clamping voltage into consideration during the time-to-crest, in range of $8{\sim}30{\mu}s$, of surge current applied to a ZnO varistor. The ZnO varistor Pspice simulation data introduced in this paper has produced almost same values as the measured results experimentally.

• Proceedings of the KIEE Conference
• /
• 1991.07a
• /
• pp.37-42
• /
• 1991

In this paper, the authors describe the equivalent circuit for a DC motor in consideration of both magnetic saturation and armature reaction phenomena. To develop DC motor model in PSPICE is to eliminate the gap between drive electronics and models of driven machine. On the basis of these results the dynamic characteristics of a MOSFET chopper controlled DC series motor are investigated by PSPICE simulation and experiment.