• The Transactions of the Korean Institute of Power Electronics
• /
• v.5 no.2
• /
• pp.163-169
• /
• 2000

From the viewpoint of the cost effective design of power conversion systems, it is very important to fully u utilize the CillTent capacity of power devices over all circumstances. Therefore this paper deals with the l practical design of digital CillTent controller to meet the requirements of fast and overshoot free control r response over the varying control voltage bOlmds, the accompanied computational delay, and the system U W1certainties. The proposed controller consists of high gain PI control schemes using both the conditional i integrator and the modified delay compensator. The simulation and experimental results show the validity of t the proposed controller.

• Journal of Power Electronics
• /
• v.8 no.2
• /
• pp.141-147
• /
• 2008

This paper deals with a new and improved control technique for shunt active filters (AF) used for compensating unwanted harmonic currents injected in the mains due to nonlinear varying loads. This work is motivated by the need to find a permanent solution to the rigorous hit and trial method for evaluating system parameters in an indirect control of AF. A fuzzy pre-compensated PI (Proportional-Integral) controller is used to fuzzify the reference DC voltage of AF to the controller input so that the overshoots and undershoots in its DC link voltage are minimized and the settling time is improved. A three-phase diode rectifier with R-L (Resistive-Inductive) load is used as a non-linear load to study the effectiveness of the proposed controller of the AF. Robustness to filter parameter variations, insensitivity to controller parameter variations, and transient response has been taken as performance evaluation parameters. The results are shown through simulations in Matlab using power system block sets to demonstrate the capability of the proposed controller of the AF.

• Journal of Power Electronics
• /
• v.11 no.1
• /
• pp.45-50
• /
• 2011

This paper proposes a method for comparing and evaluating anti-windup proportional-integral (PI) control strategies. The so-called PI plane is used and its coordinate is composed of the error and the integral state. In addition, an anti-windup PI controller with integral state prediction is proposed. The anti-windup scheme can be easily analyzed and evaluated on the PI plane in detail. Representative anti-windup methods are experimentally applied to the speed control of a vector-controlled induction motor driven by a pulse width modulated (PWM) voltage-source inverter (VSI). The experimental results compare the anti-windup PI controllers. It is empathized that the initial value of the integral state at the beginning of the linear range dominates the control performance in terms of overshoot and settling time.

• Journal of international Conference on Electrical Machines and Systems
• /
• v.1 no.3
• /
• pp.391-396
• /
• 2012

The Voltage Bus Conditioner(VBC) is a bidirectional DC-DC converter for damping the instability and any transients of the bus voltage in a DC Distributed Power System(DPS). In this paper, a PI controller for the VBC has been designed for the frequency domain. The proposed PI controller not only dampens the bus transients, but also keeps the storage voltage level. Simulation by Matlab/Simulink and experimental results are presented for the validity of the proposed control technique.

• Proceedings of the KIPE Conference
• /
• 2019.11a
• /
• pp.144-145
• /
• 2019

This paper proposes a design and analysis for a PI-IP hybrid voltage controller with a combination of PI and IP voltage controller for stable voltage control of DC bus voltage, Transient characteristic of DC bus voltage is improved by designed setting variable value and control method in the variable load and power generation conditions.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.51 no.8
• /
• pp.391-397
• /
• 2002

This paper presents a modeling and simulation of a PI controller for maximum power extraction of a grid-connected wind energy conversion system with a link of a rectifier and an inverter. It discusses the maximum power control algorithm fnr a wind turbine and proposes, in a graphical form, the relationships of wind turbine output, rotor speed, power coefficient, tip-speed ratio with wind speed when the wind turbine is operated under the maximum power control. The control objective is to always extract maximum power from wind and transfer the power to the utility by controlling both the Pitch angle of the wind turbine blades and the inverter firing angle. Pitch control method is mechanically complicated, but the control performance is better than that of the stall regulation method. The simulation results performed on MATLAB will show the variation of generator's rotor angle and rotor speed, pitch angle, and generator output.

• Proceedings of the KIPE Conference
• /
• 2000.07a
• /
• pp.211-214
• /
• 2000

The conventional PI controller has been widely used in industrial application due to the simple control algorithm. But it is very difficult to find the optimal PI control gain. Therefore in this paper to obtain optimal performance fuzzy proportional-plus-integral controller for the vector control system of an induction machine is presented. The simulation model is created in MATLAB/SIMULINK. The simulation results demonstrate the good performance of this system.

• Transactions on Electrical and Electronic Materials
• /
• v.18 no.3
• /
• pp.129-135
• /
• 2017

This paper introduces a design and a simulation of a hybrid active power filter (HAPF) for harmonics reduction given an ideal supply source. The synchronous reference frame method has been used here to identify the reference currents. The proposed HAPF uses a new artificial- intelligence technique called Particle Swarm Optimization (PSO) for tuning the parameters of a proportional and integral controller called PI-PSO. The PI-PSO controller is used to archive optimality for the DC-link voltage of the HAPF-inverter. The hysteresis non-linear current control method is used in this approach to compare the extracted reference and the actual currents in order to generate the pulse gate required for the HAPF. Results obtained by simulations with Matlab/Simuling show that the proposed approach is very flexible and effective for eliminating harmonic currents generated by the non-linear load with the HAPF based PSO tuning.

• Proceedings of the KIEE Conference
• /
• 2002.07b
• /
• pp.1155-1157
• /
• 2002

This paper presents the use of a simple genetic algorithm for the tuning of a proportional-integral speed controller for an induction motor drive. The influence of population size, generation number and rate of mutation on the convergence of the genetic algorithm is investigated. On Matlab/Simulink environment, this paper proposes an optimal GA-PI controller of indirect vector control for induction motor drive system. The simulation results verify that the system has a more robust to the parameter variation than classical PI controller.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.3
• /
• pp.522-532
• /
• 2017

In this paper, a new method of SVPWM implementation for 3-Phase 3-Leg 3-Level AC/DC converter known as the Vienna converter is proposed. Also the performances of PI and PR controller used in AC input current controller are compared. To verify the proposed method, PSIM, a power electronics simulation program, is utilized. The performances of the proposed new method and the two existing methods are compared through simulation and experiment. Also PI and PR controller in AC input current controller are compared through 10[kW] Vienna converter system.