• 한국의류학회지
• /
• 제3권2호
• /
• pp.37-41
• /
• 1979

In order to obtain tasic information for solvent dyeing, polyethylene terephthalate (PET) films was pretreated with water, tetrachloroethylene (TCE) and water/TCE emulsion for three hours at $140^{\circ}C$ for stabilizing the substrate. By film roll cyliderical method, Disperse Red 60, Disperse Yellow 42, and Disperse Blue 27 were diffused in the films and examined dyeing properties. The results are summarized as follows; 1) Diffusion coefficient increases in the order, waterTCE>water/TCE 2) A linear relationship between diffusion coefficient and shrinkage was Observed 3) The temperature dependence of the diffusion coefficient can't be expressed by WLF equation.

• 한국염색가공학회지
• /
• 제11권1호
• /
• pp.25-33
• /
• 1999

PET fabric was grafted with $CF_4$ or $C_2F_6$ plasmas generated by glow discharge. The water repellency of plasma-treated fabrics were evaluated with contact angle meter. The change in surface morphologies was observed by SEM, and the change of surface chemical characteristics were analyzed by FT-IR, ESCA and microchemical analysis technique. The results obtained are as follows : 1) The contact angle of plasma-treated fabric was over $150^\circ{C}$. 2) It was observed by SEM that the surface of treated substrate was over coated with thin film formed by the fluorocarbon plasma treatment. 3) According to ESCA analysis, there were prevailing -CHF-, $-CF_2$- and a little $-CF_3$ components on fluorocarbon plasma treated substrate. -CHF- and $-CF_2$- components were reduced by washing, and $-CF_2$- component was recovered by heat treatment. 4) In consideration of quantitative analysis of fluorine and F/C ratio by ESCA, we found that fluorination reached to the inner of substrate.

• 반도체디스플레이기술학회지
• /
• 제15권4호
• /
• pp.36-40
• /
• 2016

The 2 wt.% Al-doped ZnO(AZO) thin films were fabricated on PET substrates with various RF power 20, 35, 50, 65, and 80W by using RF magnetron sputtering in order to investigate the structure, electrical and optical properties of AZO thin films in this study. The XRD measurements showed that AZO films exhibit c-axis orientation. At a RF power of 80W, the AZO films showed the highest (002) diffraction peak with a FWHM of 0.42. At a RF power of 65W, the lowest electrical resistivity was about $1.64{\times}[10]$ ^(-4) ${\Omega}-cm$ and the average transmittance of all films including substrates was over 80% in visible range. Good transparence and conducting properties were obtained due to RF power control. The obtained results indicate that it is acceptable for applications as transparent conductive electrodes.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2009년도 9th International Meeting on Information Display
• /
• pp.1535-1537
• /
• 2009

High performance resistive type touch panel was fabricated on flexible polyethylene terephthalate (PET) substrates coated with Al- and Ga-codoped ZnO (AGZO) films. The AGZO films were deposited by roll-to-roll direct current magnetron sputter at room temperature. The AGZO thin films on PET substrates showed high transparency (> 85 % at 550 nm) and low sheet resistance (450 ${\Omega}$/sq.). These values were similar to those of commercial ITO films used for resistive type touch panel.

• 한국표면공학회지
• /
• 제50권5호
• /
• pp.373-379
• /
• 2017

Dry processes like evaporation and sputtering in vacuum chamber are difficult to make a uniform, large area and high quality film on thin PET substrate because of PET degradation and bad adhesion. On the other hand, wet processes like electro or electroless plating have complex processes and require high environmental cost. In this study, we successfully prepared $2{\mu}m$ Zn/Cu/Ni multilayers coated on $12{\mu}m$ polyethylene terephthalate (PET) substrate by using dry-wet mixing processes. Their surface electric resistances were evaluated around $0.2{\Omega}$ by using 4 probe measurements. Furthermore, their corrosion resistance also evaluated by natural potential test and compared with other wet, dry and mixing process samples.

• 한국염색가공학회지
• /
• 제2권3호
• /
• pp.26-35
• /
• 1990

This study was carried out with the view of fundamental investigating to improve the tactile and the hygroscopicity of Poly(ethylene Terephthalate) (PET)fibers. Mono-sodium ethylene glycolate in ethylene glycol (MSEG-EG) solution was prepared and PET films were treated with it. The following conclusions were obtained. When PET films were decomposed in MSEG-EG solution, decomposition rate constant showed an exponential relationship with treating temperature; activition energy was 23.30 Kcal/mol, activation enthalpy was 22.52~22.60 Kcal/mol and activation entropy was -29.20~ -29.41 e.u. On the basis of the results obtained above and structure identification of decomposition products, it was found that the decomposition reaction proceeded through ester interchange reaction.

• Journal of Microbiology and Biotechnology
• /
• 제18권3호
• /
• pp.568-572
• /
• 2008

This study was conducted to investigate the effect of modified atmosphere packaging (MAP) in combination with BN/PE film on the shelf life and quality of fresh-cut iceberg lettuce during cold storage. The total mesophilic population in the sample packed in BN/PE film under MAP conditions was dramatically reduced in comparison with that of PE film, PE film under MAP conditions, and BN/PE film. The $O_2$ concentration in the BN/PE film under MAP conditions decreased slightly as the storage period progressed. The coloration of the iceberg lettuce progressed the slowest when it was packaged in BN/PE film under MAP conditions, followed by BN/PE film, PE film, and PE film under MAP conditions. The shelf life of fresh-cut iceberg lettuce packaged in the BN/PE film under MAP conditions was extended by more than 2 days at $10^{\circ}C$ as compared with that of the BN/PE film in which the extension effect was more than 2 days longer than that of PE, PET, and OPP films.

• 한국염색가공학회지
• /
• 제30권3호
• /
• pp.190-198
• /
• 2018

We fabricated high transmission and high scattering poly(ethylene-co-vinyl acetate)(EVA) films embedding $SiO_2$ nanoparticles to improve outcoupling efficiency in organic display. The 800nm diameter $SiO_2$ nanoparticles aggregated and formed $1.56{\mu}m$ (with ${\pm}0.853{\mu}m$ standard deviation) diameter microparticles in EVA. The total transmission of scattering film was 83.3% on Polyethylene terephthalate(PET), which was higher than reference 82.8% PET substrate. The diffuse transmission and haze of the $SiO_2$ embedded EVA film were 76.1% and 91.4%, respectively. The optimized condition was 1:1 weight ratio of $SiO_2$ nanoparticles to EVA in Tetrahydrofuran(THF) solution. When the ratio of $SiO_2$ was larger than 1, the total transmission decreased by the increase in backscattering of light due to high scattering. With the optimized condition, we could succeed to fabricate a large scale film(35m in length) with a roll-to-roll process.

• 센서학회지
• /
• 제30권4호
• /
• pp.255-260
• /
• 2021

We studied electrochemical sensors using printed carbon nanotube (CNT) film on a polyethylene terephthalate (PET) substrate. Multiwalled CNT films were printed on a PET substrate to study its feasibility as hazardous and noxious substances (HNS) detection sensor. The printed CNT film (PCF) with a 50 ㎛ thickness exhibited a specific resistance of 230 ohm. To determine the optimum sensor structure, a resistance-type PCF sensor (R-type PCF sensor) and a conductive-type PCF sensor (C-type PCF sensor) were fabricated and compared using diluted NH₃ droplets with various concentrations. The response magnitude, response time, sensitivity, linearity, and limit of detection (LOD) were compared, and it was concluded that the C-type PCF sensor exhibited superior performance. By applying a C-Type PCF sensor, we confirmed the detection performance of 12 types of floating HNS and the response of the sensor with selectivity according to the degree of polarity.

• 한국포장학회지
• /
• 제23권1호
• /
• pp.9-15
• /
• 2017

수증기 및 산소에 대한 차단성이 개선된 PVA-BA 코팅 조성액의 포장소재로의 적용가능성을 확인하기 위하여 콤마 코팅과 라미네이션 공정을 이용하여 PET/PVA-BA/OPP 다층필름을 제조하였다. PCT 전 후의 PET/PVA-BA/OPP 다층필름의 기체, 수증기 차단특성 및 인장강도를 확인하였고 이를 PA/PA/EVOH/PP 다층필름의 물성과 비교하였다. PVA내 BA 함량이 증가함에 따라 물성이 증가하는 것을 확인할 수 있었지만, PCT 후 PET/PVA-BA/OPP 다층필름의 산소, 수증기 차단특성 및 인장강도는 감소하는 경향을 보였다. 이는 PVA-BA층 내 증가한 가교밀도와 관련이 있는 것으로 판단된다. 또한, 조미김을 이용한 저장특성분석에서, PET/PVA-BA/OPP다층필름은 PP/Al-metallized PP 다층필름에 비해 조미김의 지방산화를 야기시키는 요인을 효과적으로 억제하는 것으로 판단된다. 하지만, PP/Al-metallized PP 다층필름에 비해 PET/PVA-BA/OPP 다층필름의 상대적으로 높은 수분투과특성 때문에 Aw에 큰 장점을 확인하지 못하였다. 따라서, 물성 극대화 및 포장소재로 적용을 위해서는 PET/PVA-BA/OPP 다층필름 내 수분 차단성 향상에 대한 추가적인 연구가 필요하다는 것을 확인하였다.