• Journal of Internet of Things and Convergence
• /
• v.6 no.2
• /
• pp.25-29
• /
• 2020

The elliptic curve crypto-algorithm is widely used in authentication for IoT environment, since it has small key size and low communication overhead compare to the RSA public key algorithm. If the scalar multiplication, a core operation of the elliptic curve crypto-algorithm, is not implemented securely, attackers can find the secret key to use simple power analysis or differential power analysis. In this paper, an elliptic curve scalar multiplication algorithm using a randomized scalar and an elliptic curve point blinding is suggested. It is resistant to power analysis but does not significantly reduce efficiency. Given a random r and an elliptic curve random point R, the elliptic scalar multiplication kP = u(P+R)-vR is calculated by using the regular variant Shamir's double ladder algorithm, where l+20-bit u≡rn+k(modn) and v≡rn-k(modn) using 2^lP=∓cP for the case of the order n=2^l±c.

• Magazine of the Korea Concrete Institute
• /
• v.19 no.4
• /
• pp.52-58
• /
• 2007

• Economic and Environmental Geology
• /
• v.5 no.2
• /
• pp.77-86
• /
• 1972

The system NaAlSiO_4-KAlSiO_4-SiO_2-H_2O, Bowen's "Petrogeny's Residua System" of course is extremely important in understanding the phase relationships of igneous and metamorphic rock in the continental crust. The phase relationships in this system, however, have not been completely established in the P-T range above the Mohorovicic discontinuity. They need to be established. In this study, the most probable sequence of P-T curves around a quaternary invariant point(~5Kb/${\sim}635^{\circ}C$) in the system using Schreinemakers' rule, is deduced, essentially on the basis of Morse's(1969a and b) experimental data. Possible modifications of the sequence of the P-T curves considering likely changes of the invariant chemogram are also considered. It is concluded that the sequence of P-T curves around the invariant point (~5Kb/${\sim}635^{\circ}C$) is (L), (Anl), (Or), (V), (Ne) and (Ab) on the P-T projection, where the P-T curve (L) is extended towards lower P-T regions, and the (Anl) curve is extended towards a region of higher temperature and lower pressure from the invariant point respectively.

• Journal of the Korean Geotechnical Society
• /
• v.32 no.3
• /
• pp.39-47
• /
• 2016

In this study, dynamic centrifuge tests in dry sand were conducted in order to evaluate the effect of pile installation on the dynamic p-y curve. According to the result of the pile installation effect on the dynamic p-y backbone curves, the subgrade resistance of a jacked pile in 40 g was found to be greater than that of a jacked pile in 1 g and a preinstalled pile in 1 g. It was also found that differences of the subgrade resistance decrease with the depth of the pile. Applicability of dynamic p-y backbone curve for the bored pile proposed by preceded researcher was evaluated by comparing with the result of centrifuge tests. In addition, dynamic p-y backbone curve for jacking/driven pile was developed by modifying that for the bored pile.

• Journal of agriculture & life science
• /
• v.50 no.5
• /
• pp.173-182
• /
• 2016

This study was aimed to identify the phenotypic relationships between calving interval and lactation curve parameters in Korean Holstein cow. The data of 36,505 lactation records was obtained from the Dairy Herd Improvement program run by Dairy Cattle Improvemnet Center of National Agricultural Federation of Korea. All lactation records were collectied from the multiparous cows calving between 2011 to 2013. The estimated lactation curves were drawn using Wood model based on actual milk yield records, and NLIN Procedure of SAS program (ver. 9.2). General linear multivariate models for calving interval, 305-d milk yield, lactation parameters(A, b, c), persistency, peak day, and peak yield included fixed effects of calving year-season (spring, summer, fall and winter) and parity(2, 3 and 4). For calving interval, 305-d milk yield, lactation parameters(A, b, c), persistency, peak day and peak yield, all two fixed effect(calving year-season, parity) were significant(p<0.05). The estimated lactation functions using Wood model for 2, 3, and 4 parity were yt=24.66t0.175e-0.00302t, yt=24.69t0.192e-0.00334t, and yt=24.22t0.200e-0.00341t, respectively. Phenotypic correlation (partial residual correlation) between calving interval and 305-d milk yield, A, b, c, persistency, peak day, and peak yield were 0.093, -0.014, 0.028, -0.046, 0.099, 0.085, and 0.052, respectively. To conclude, if calving interval increase then ascent to peak, persistency, peak day and peak yield are increase, and descent after peak is decrease. So, total 305-d milk yield is increase.

• The Korean Journal of Rheology
• /
• v.7 no.1
• /
• pp.28-34
• /
• 1995

고체가 아닌 계인 마요네즈에 대해 Couette형 점도계를 사용하여 일정한 전단속도에 서 시간과 더불어 전단응력이 감소하는 응력완화 곡선을 온도 2$0^{\circ}C$, $25^{\circ}C$, 3$0^{\circ}C$, 34$^{\circ}C$, 4$0^{\circ}C$ 에서 얻었다 이현상을 설명하기 위하여 구조가 형성되는 flow unit 2와 구조가파괴되는 flow unit 3에 대한 fraction (X2, X3)사이의 평형을 생각하고 X2 와 X3 에 해당하는 항에 실 험적 조건인 s=p(t0+t)의 관계를 적용하여 다음과 같은 응력완화에 관한 식을 구하고 이식을 실험결과에 적용하여 유동파라메타를 구하였으며 그 파라메타중의 평형상수 k와 실험 온도 를 이용하여 열역학 파라메타를 구하였다.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.27 no.5
• /
• pp.750-757
• /
• 2003

In order to determine creep stress intensity limit of high-temperature components, the usefulness of the creep work and time equation, defined as W$\_$c/t$\^$p/ = B(where W$\_$c/ = $\sigma$$\varepsilon$ is the total creep work done during creep, and p and B are constants), was investigated using the experimental data. For this Purpose, the creep tests for generating 1.0% strain for commercial type i16 stainless steel were conducted with different stresses; 160 MPa, 150 MPa, 145 MPa, 140 MPa and 135 MPa at 593$^{\circ}C$. The plots of log W$\_$c/ - log t showed a good linear relation up to 10$\^$5/ hr, and the results of the creep work-time relation for p, B and stress intensity values showed good agreement to those of isochronous stress-strain curves (ISSC) presented in ASME BPV NH. The relation can be simply obtained with only several short-term 1% strain data without ISSC which can be obtained by long-term creep data. Particularly, this relation is useful in estimating stress intensity limit for new and emerging class of high-temperature creeping materials.

• Transactions of the Korean hydrogen and new energy society
• /
• v.13 no.2
• /
• pp.151-158
• /
• 2002

The hydorgen storage alloys were produced by melting in arc melting furnace and then solution heat treated at $1,100^{\circ}C$ followed by pulverization. The chemical analysis on the samples showed that the major elements of misch metal(Mm) were La, Ce, Pr and Nd with impurity less than 1wt.%. X-ray diffraction indicated that the structure for these samples were a single phase of hexagonal with $CaCu_5$ type. Compared to the initial particle size $100{\sim}110{\mu}m$, the many fine cracks were found and particle size decreased to $14{\mu}m$ for $MmNi_{4.5}Mn_{0.5}$ after hydriding/dehydring test run. To activate the sample the vessel filled with hydrogen storage alloys was first evacuated for for at $70^{\circ}C$ and then treated for 10.5hr under hydrogen pressure of 20atm for $MmNi_{4.5}Mn_{0.5}$ alloy. The experimental data showed that the hydrogen storage alloy of $MmNi_{4.5}Mn_{0.5}$ had superior adsorption and description properties within a temperature rang of $40^{\circ}C{\sim}80^{\circ}C$ and also they had a good P-C-T curve.

• Korean Journal of Clinical Pharmacy
• /
• v.21 no.2
• /
• pp.115-121
• /
• 2011

에토포시드와 아피제닌의 약동학적 상호작용 연구를 위하여 아피제닌 (0.4, 2.0 또는 8 mg/kg)과 에토포시드의 경구(6 mg/kg) 및 정맥 (2 mg/kg) 투여 하여 본 연구를 실시하였다. 아피제닌이 cytochrome P450 (CYP) 3A4 활성과 P-glycoprotein (P-gp)의 활성에 미치는 영향도 평가하였다. 아피제닌의 CYP3A4의 50% 효소활성억제는 $1.8{\mu}M$ 이었다. 아피제닌은 MCF-7/ADR 세포의 로다마인-123 세포 축적을 증가 시키므로 P-gp를 억제시켰다. 아피제닌은 에토포시드의 혈장곡선하면적과 최고혈장농도 (AUC and $C_{max}$)를 유의성 있게 증가시켰으나, 에토포시드의 최고혈장농도 도달시간 ($T_{max}$)과 생물학적 반감기 ($t_{1/2}$)에는 영향을 미치지 않았다. 따라서, 아피제닌 존재하에 에토포시드의 절대적생체이용률 (AB)은 대조군과 비교하여 유의성있게 증가되었다. 경구투여시와는 대조적으로, 아피제닌은 정맥 내로 투여된 에토포시드에서는 약동학적 파라미터에 어떤 영향도 미치지 않았다. 따라서 아피제닌이 에토포시드의 생체이용률을 증가시킨 것은 아피제닌이 소장과 간장에서 CYP3A4을 억제 및 소장에서 P-gp를 억제 시켰기 때문으로 사료된다.

• Journal of the Korean Vacuum Society
• /
• v.1 no.1
• /
• pp.176-182
• /
• 1992

t-Stress and junction leakage current characteristics of CVD-tungsten have been investigated. Stressversus continuous annealing temperature plot. shows hysteresis curve where the stress level of the cooling curveis higher than that of the heating curve. It is found that the thermal and intrinsic stress of tungsten film depositedby SiH4 reduction is higher than that by Hz reduction.The tungsten film deposited by SiHl reduction is in the tensile stress state below 700"Cnd the stress ofthe film decreses with increasing annealing temperature. The stress state changes into compressive stress atabout 700"Cnd the compressive stress increases rapidly with increasing temperature.Leakage current of the n+/p diode increases rapidly especially in the range of 400-450$^{\circ}$C with increasingdeposition temperature of the CVD-W by SiH4 reduction, which is due to the Si consumption by W encroachment.On the other hand leakage current of the n+/p diode slightly increases with increasing SiH4/WF6 ratio.h increasing SiH4/WF6 ratio.