• Nuclear Engineering and Technology
• /
• 제15권2호
• /
• pp.149-153
• /
• 1983

흡착 기포 분리에 의하여 수용액으로부터 아연(II)을 회수하는 방법에 관하여 연구하였다. 그리고 흡착 기포 분리에서 용매부선 과정과 거품 분별 과정에 채용되었고 이들 분리 과정에서 카프르산을 아연의 회수 물질로 사용하였다. 이온 강도 및 수소이온의 농도가 분리 과정의 효율에 어떤 영향을 미치는지를 기술하였으며, 추출제로 벤젠에 녹은 카프르산을 이용한 용매 추출과정과도 상호 비교하였다.

• 전기화학회지
• /
• 제14권3호
• /
• pp.152-156
• /
• 2011

A room temperature ionic liquid (RTIL) based on trihexyl (tetradecyl)phosphonium bis(trifluoromethanesulfonyl) imide ([$(C_6H_{13})_3P(C_{14}H_{29)}$] [TFSI];P66614TFSI) was synthesized and analyzed to determine their characteristics and properties. The bis(trifluoromethanesulfonyl)imide (TFSI) anion is widely studied as an ionic liquid (IL) forming anion which imparts many useful properties, notably electrochemical stability. Especially its electrochemical and physical characteristics for solvent of lithium ion battery were investigated in detail. $P_{66614}$ TFSI exhibits fairly low conductivity (0.89 mS $cm^{-1}$) and higher viscosity (298 K: 277 cP; 343 K: 39 cP) than other ionic liquids, but it exhibits a high thermal stability (over $400^{\circ}C$). Especially corrosion behavior on Al current collector was tested at room temperature and further it was confirmed that thermal resistivity for Al corrosion was highly increased in 1.0M LiTFSI/$P_{66614}$-TFSI electrolyte comparing with other RTILs by linear sweep thermometry.

• 한국세라믹학회지
• /
• 제35권10호
• /
• pp.1070-1077
• /
• 1998

Effect of current collecting layer on the cathode was characterized by AC impedance spectroscopy at 800$^{\circ}C$ under flowing air. LSM-YSZ composite cathode showed lower polarization resistance due to the in-crease of triple phase (LSM/YSZ/Pore) boundary length by incorporation of YSZ. Ohmic resistance {{{{ {R }_{1 } }} of LSM-YSZ was higher than that of pure LSM however because in-plane resistance of the cathode was fair-ly high due to its high specific resistivity. To reduce the in-plane resistance of LSM-YSZ cathode cathode side current collecting layer was required. Ohmic resistance {{{{ {R }_{1 } }} was reduced after forming LSM current col-lecting layer on the LSM-YSZ cathode. In case of pure LSM cathode the formation of Pt, or LSCO current collecting layer reduced polarization resistance {{{{ {R }_{p } }} but ohmic resistance {{{{ {R }_{1 } }} was relatively constant. After annealing of LSM cathode with Pt current collector at higher temperature polarization resistance {{{{ {R }_{p } }} was in-creased but ohmic resistance {{{{ {R }_{1 } }} was constant. These phenomena indicate that Pt or LSCo current col-lecting layers act as a catalytic layer for oxygen reduction of pure LSM cathode. LSCO current collector was effective in reducing the ohmic and polarization resistance of LSM-YSZ cathode.

• 한국습지학회지
• /
• 제19권2호
• /
• pp.252-258
• /
• 2017

계류에서 보가 저서성 대형무척추동물 군집에 미치는 효과를 확인하기 위해 도림천 상류에서 계단식 구간(100m 당 3.02개의 보)과 비계단식 구간(100m 당 0.96개의 보)을 나누어 저서성 대형무척추동물을 정성, 정량 조사하였다. 평균 유속은 계단식 구간(0.043m/s) 보다 비계단식 구간(0.149m/s)에서 더 빨랐다. 정수역을 선호하는 파리목(Diptera)는 비계단식 구간(32%)보다 계단식 구간(78.3%)에서 더 많이 출현하였다(p<.05). 유수역을 선호하는 하루살이목(Ephemeroptera)는 계단식 구간(4.5%)보다 비계단식 구간(14.1%)에서 더 풍부하게 출현하였다(p=.203). 날도래목(Trichoptera)는 종에 따라 출현하는 빈도가 다르게 나타났다. 주워먹는 무리(gathering-collector)비계단식 구간보다 계단식 구간에서 1.8배나 많이 출현하였다(p<.05). 반면 걸러 먹는 무리(filtering-collector)는 계단식 구간에서 약 4.4배 더 많이 출현하였다(p=.124). 균등도 지수(J')는 계단식 구간과 비계단식 구간에서 각각 0.41과 0.77로 나타났다. 수환경을 평가하는 데 이용되는 한국오수생물지수 KSI는 계단식 구간과 비계단식 구간에서 각각 4.0과 2.4이었다. 군집의 균형성을 나타내는 EPT/C 지수는 계단식 구간과 비계단식 구간에서 각각 0.1과 0.7으로 나타났다. 본 연구는 저서성 대형무척추동물의 다양성을 유지하기 위해서는 소형보를 계류에 설치할 것을 제안한다.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 하계종합학술대회 논문집(2)
• /
• pp.77-80
• /
• 2002

In this paper, InP-based HBTs have been optimally designed by numerical simulation and fabricated by the self-aligned process. The structure of HBT was designed in terms of the current gain*f$_{max}$ for the base and f$_{T}$*f$_{max}$ for the collector. The designed structure produced the current gain of about 50 and the cutoff frequency and the maximum oscillation frequency of 87GHz and 2940Hz respectively. In addition, we present a study of the vertical and lateral etching of InP with the mask sides parallel to the principal crystallographic axes, [0101 and (001). This etching characteristics arc used to fabricate self-aligned HBT structures with reduced parasitic effects.s.s.s.

• 자원리싸이클링
• /
• 제25권6호
• /
• pp.98-104
• /
• 2016

본 연구의 목적은 호주산 저품위 동광을 부유선별하여 정광으로 회수하고자 할 때, 최적의 부유선별 조건을 얻고자 하는데 있다. 본 연구에서는 저품위 동광의 파분쇄 및 분급에 의해 선별에 적절한 입자크기의 시료를 얻은 다음, 이를 대상으로 부유선별 시 포수제, 활성제, 억제제의 첨가량 및 광액의 pH 변화가 부선효율에 미치는 영향을 조사함으로써 품위가 향상된 정광을 얻고자 하였다. 본 연구실험결과 얻은 최적의 부유선별 조건은 광액산도 pH9.0, 활성제 500 g/t $CuSO_4{\cdot}5H_2O$, 포수제 500 g/t K.E.X, 억제제 1500 g/t $Na_2SO_3$, 광액농도는 25 wt.% 이었다. 최적조건하에서 얻은 정광중의 동 품위 및 회수율은 각각 4 wt.%와 65 wt.% 정도이었고 대부분 철 성분을 함유한 광물 이었다.

• 태양에너지
• /
• 제4권2호
• /
• pp.29-36
• /
• 1984

This paper reviews the current status of R&D work on selective absorber materials. For the efficient utilization of solar energy, various types of selective absorber materials are being used for solar hot water heaters. Many selective absorbers which have been proposed and designed up to data are classified according to the absorption mechanisms. Temperature-time cycle method is often recommended for the measurement of solar absorptance. In addition, conversion efficiency of the solar collector with selective surface is compared with one with black paint surface.

• 산업기술연구
• /
• 제1권
• /
• pp.35-38
• /
• 1981

The conclutions arrived at as a result of experimental work are as follow; 1. The use of kerosene as a collector was found essential to produce a good recovery of chalcopyrite, galena and zincblende under the condition of high pH(below 2). 2. Temperature doesn't seemingly effect the flotation of chalcopyrite, galena and zincblende. 3. The minimum concentration of kerosene as a collecter was 26mg kerosene per liter of solution.

• 태양에너지
• /
• 제7권1호
• /
• pp.14-22
• /
• 1987

This paper presents an experimental study of a solar drying system designed and installed by KIER. Experiments have been performed using the KIER system for the drying of marine products, such as squid. Presented in detail are the experimental observations of collector air temperature, solar intensity, absorber plate temperature, drying chamber temperature, humidity and other measures of drying chamber performance with variation of air mass flow rate. As a result, average temperature attained in the drying chamber during autumn weather has been adequated for drying of squids.

• Journal of Biosystems Engineering
• /
• 제3권2호
• /
• pp.100-113
• /
• 1978

Drying grain with conventional artificial drying methods requires great quantities of petroleum fuels. Depletion of fossil fuel increases the need of the utilization of solar energy as an alternative to petroluem fuels for drying grain , an energy intensive agricultural operation. Many techniques for the utilization of solar energy in grain drying have been developed, however, there are many problems in adopting solar energy as an energy sources for drying grain. Futhermore, very little research has been done on solar grain drying in Korea. This study was conducted to evaluate the availability of solar energy for drying of rough rice in Chuncheon, Suweon, and Jinju areas based on 50year meteorological data, and to analyze experimentally the performance of a solar air collector for dying grain, and to find the effects of solar heated air compared to unheated air on the rate of drying and energy consumption required for drying of rough rice. The results of this study was may be summarized as follows ; 1. Monthly average daily total radiation on a horizontal surface in October was 260.6 ly/day for Chuncheon, 240.3 ly/day for Suweon , and 253.4 ly/day for Jinju area, respectively. 2. the ratio of monthly average daily diffuse radiation to daily total radiation on a horizontal surface was approximately 0.41 for Chuncheon, 0.45 for Suweon, and 0.44 for Jinju area, respectively. 3. Although the statistical distribution curves of daily total radiation for the three locations were not identical , the differences among them were not large and may be neglected for many practical purposes. 4. I was estimated that the optimum tilting angle of the collector in October was approximately 46 degrees for Chuncheon and Suweon and 45 degrees for Jinju. 5. The ratio of the total radiation on a optimum tilting plane to that on a horizontal plane was estimated to be 1.36 for Chuncheon, 1.31 for Suweon, and 1.27 for Jinju , respectively. 6. The collection efficiency of the solar air collector ranged from 47. 8 to 51. 5 percent at the air flow rates of 251. 1-372.96 $m^3$/hr. High efficiency remained nearly , constant during the best sunshine hours, 10 a.m. to 2 p.m. and decreased during other hours. More energy was collected as the air flow rate incresed. 7. The average temperature rise in the drying air from the solar collector for the test period varied from $6.5^\circC$ to $21.8^\circC$ above the ambient air temperature. 8. Solar-dried rough rice averaged 13.7 percent moisture (w.b.) after 130 hours of drying with the air flow rate of 1. 64 ccm/$m^3$, and rough rice dried with natural air averaged 15.1 percent moisture (w.b.) after 325 hours of drying with the same air flow rate. 9. Energy saving of 2.4 kwh per $m^3$ percentage point of moisture removed was obtained from solar heated air drYing. The solar bin used 53.3 percent less energy per percentage point of moisture removed than the natural air bin.