• Journal of environmental and Sanitary engineering
• /
• v.15 no.3
• /
• pp.70-74
• /
• 2000

The technology of malodorous substances treatment was classified physical separation and chemical destruction. This study was carried out to investigate the characteristics of malodorous substances treatment with the change of operating conditions from the ozone generator. The major results of this study were as follows : Removal efficiency by additive ozone rate was measured $NH_3$:95%(ozone additive rate : 2), $H_2S$ : 97%(ozone additive rate:4), $CH_3SH$ : 96%(ozone additive rate : 3), $(CH_3)_2S_2$ : 97%(ozone additive rate:5), $(CH_3)_3N$ : 95%(ozone additive rate : 1), $CH_3CHO$ : 95%(ozone additive rate : 2), $C_6H_5CHCH_2$ : 95%(ozone additive rate : 2).

• Elastomers and Composites
• /
• v.34 no.2
• /
• pp.177-182
• /
• 1999

SBS thermoplastic elastomers offer an inexpensive alternative to vulcanised rubbers for many undemanding applications. They are, however, particularly susceptible to attack from atmospheric ozone leading to cracking as soon as any strain is applied. In most rubber applications some strain is unavoidable. In this paper a compounding approach to protecting SBS thermoplastic rubbers against ozone is described. An explanation is offered for why a protective effect Is observed only when certain combinations of additive are used. SBS elastomers are the most affordable class of thermoplastic rubbers. To achieve finished products resistant to ozone and without compromising the light colours often demanded, recourse must be made to blending with other saturated elastomers or replacement by hydrogenated (SEBS) types. The latter is a significantly more expensive alternative. Under laboratory conditions where the rate of ozone attack is increased by several decades, unprotected SBS begins to crack within a few hours. Several different protective agents are examined here, the best of which, a cyclic enol ether, $Vulkazon^{(R)}$ AFD, can extend the resistance to any cracking to several weeks by the use of a few percent by weight of additive. The systems reported neither discolour the polymer nor stain other materials with which it may be in contact. Use of the protective systems described here could enable SBS elastomers to compete in many applications with the more expensive SEBS polymers.

• Journal of Environmental Health Sciences
• /
• v.35 no.6
• /
• pp.532-537
• /
• 2009

The tropospheric ozone production mechanism for the gas phase additive oxidation reaction of hydroxyl radical (OH) with isoprene (2-methyl-1,3-butadiene) has been studied using cavity ring-down spectroscopy (CRDS) at total pressure of 50 Torr and 298 K. The applicability of CRDS was confirmed by monitoring the shorter (~4%) ringdown time in the presence of hydroxyl radical than the ring-down time without the photolysis of hydrogen peroxide. The reaction rate constant, $(9.8{\pm}0.1){\times}10^{-11}molecule^{-1}cm^3s^{-1}$, for the addition of OH to isoprene is in good agreement with previous studies. In the presence of $O_2$ and NO, hydroxyl radical cycling has been monitored and the simulation using the recommended elementary reaction rate constants as the basis to OH cycling curve gives reasonable fit to the data.

• Journal of the Semiconductor & Display Technology
• /
• v.4 no.4 s.13
• /
• pp.19-26
• /
• 2005

The process optimization of ozone concentration and half life time was investigated in ultra pure water and alkaline solutions for the wet cleaning of silicon wafer surface at room temperature. In the ultra pure water,. the maximum concentration (35 ppm) of ozone was measured at oxygen flow rate of 3 liters/min and ozone generator power over 60%. The half life time of ozone increased at lower power of ozone generator. Additive gases such as $N_2$ and $CO_2$ were added to increase the concentration and half life time of ozone. Although the maximum ozone concentration was higher with the addition of $N_2$ gas, a longer half life time was observed with the addition of $CO_2$. When $NH_4OH$ of 0.05 or 0.10 vol% was added in DI water, the pH of the solution was around 10. The addition of ozone resulted in the half life time less than 1 min. In order to maintain high pH and ozone concentration, ozone was continuously supplied in 0.05 vol% ammonia solutions. 3 ppm of ozone was dissolved in ammonia solutions. The static contact angle of silicon wafer surface became hydrophilic. The particle removal was possible alkaline ozone solutions. The organic contamination can be removed by ozonated ultra pure water and then alkaline solution containing ozone can remove the particles on silicon surface at room temperature.

• Journal of Preventive Medicine and Public Health
• /
• v.39 no.1
• /
• pp.81-86
• /
• 2006

Background: A number of studies have reported associations between the ambient air pollution concentrations and various health outcomes. Especially, ozone is well known for primary risk factor of asthma attacks. The results of a recent study indicate that the size of the effect on health outcomes due to air pollution varied according to several conditions, including age, gender, race and the socioeconomic status. Therefore, this study was conducted to examine the associations of ozone with the childhood asthma hospitalizations as stratified by the socioeconomic status (SES) at the community level in Seoul, Korea, 2002. Methods: SES at aggregated levels was measured on the basis of average regional health-insurance rate per citizen in the area. We applied the generalized additive model to analyze the effect of ozone on asthma after controlling for the potential confounding variables that were capable of influencing the results. Results: Our analysis showed that the number of children who were hospitalized for asthma increased as the SES of the residence area decreased. The estimated relative risks of hospitalization for asthma, as stratified by the SES of the community level, were 1.12 (95% confidence interval 1.00-1.25) in districts with the highest SES levels, 1.24 (95% CI=1.08-1.43) within the moderate SES levels, and 1.32 (95% CI=1.11-1.58) in the districts with the lowest SES levels. Conclusions: Our analysis showed that exposure to air pollution did not equally affect the health status of individuals. This suggests that not only the biological-sensitivity markers, but also the SES of the subjects should be considered as potentially confounding factors.

• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.8
• /
• pp.767-773
• /
• 2010

In recent years, there has been considerable concern over the release of methyl tert-butyl ether (MTBE), a gasoline additive, into the aquifers used as potable water sources. MTBE readily dissolves in water and has entered the environment via gasoline spills and leaking storage tanks. In this study air stripping and ozonation of MTBE in aqueous solution were performed in a laboratory scale batch reacter. The mass transfer rate (N) was evaluated and a values about $1.24{\times}10^{-6}\;mol{\cdot}sec^{-1}$ was found. In the ozonation of MTBE a 8.3% decrease of the COD and a 6.5% decrease of the TOC lead to BOD/COD = 0.03. The peudo first-order rate constants of the ozonation of MTBE was $3.75{\times}10^{-5}\;sec^{-1}$. The resulting Ea of 4.80 kcal；mol-1 was observed for molecular ozone reactions.