• Transactions of the Korean hydrogen and new energy society
• /
• v.30 no.5
• /
• pp.455-464
• /
• 2019

Experiments were conducted to investigate the sensitivity of steel plate oxidation with temperature in a simulated furnace. Used steel plates were a general steel and a high tensile steel. Porous media burner (PM burner) used in model furnace was made for uniform temperature profile. The surrounding temperature was controlled by adjusting the flow rate of the mixture in the combustor. Oxide layer analysis was performed using SEM image analysis and EDS line scanning. Both steel sheets showed a tendency to increase the thickness of the steel sheet surface oxide layer as the temperature increases, and it was confirmed that the flaking phenomenon in surface oxidation layer appeared when the temperature was above a certain temperature.

• Nuclear Engineering and Technology
• /
• v.55 no.10
• /
• pp.3659-3664
• /
• 2023

The electrochemical behavior of dissolved hydrogen (H₂) was investigated at a Pt electrode in a high temperature LiOH-H₃BO₃ solution. The diffusion current of the H₂ oxidation was proportional to the concentration of the dissolved H₂ as well as the reciprocal of the temperature. In the polarization curve, a potential region in which the oxidation current decreases despite an increase in the applied potential between the H₂ oxidation and the water oxidation regions was observed. This potential region was interpreted as being caused by the formation of a Pt oxide layer. Using the properties of the Cl^- ion that reduces the growth rate of the Pt oxide layer, it was confirmed that there is a correlation between the Cl^- ion concentration and the transient current of the H₂ oxidation.

• Journal of Korean Society of Water and Wastewater
• /
• v.31 no.4
• /
• pp.347-356
• /
• 2017

Oxidation of erythromycin, sulfamethazine and sulfathiazole by ozone was experimentally investigated to see the effects of background water quality such as ultrapure water, humic acid and biologically treated wastewater and water temperature on the removal rate, consequently to provide design information when the ozone treatment process is adopted. Initial concentration of the antibiotics was spiked to $10{\mu}g/l$ and ozone dose was 1, 2, 3, 5, 8 mg/l. While the removal rate of erythromycin under ultrapure water background by ozone oxidation was over 99%, that under humic acid and biologically treated wastewater background was markedly reduced to the range of 59.8%~99% and 17.0%~99%, respectively. When water temperature is decreased from $20^{\circ}C$ to $4^{\circ}C$, the removal rate is reduced from the range of 17.0%~99% to the range of 9.4%~97.4% under biologically treated wastewater background. The effects of background and temperature on the removal rate of sulfamethazine and sulfathiazole were similar to erythromycin, but the degree was different. Therefore, it is concluded that the background of water to be treated as well as water temperature should be taken into consideration when the design factor such as ozone dose is determined to meet the treatment objective in the ozone treatment process.

• KSBB Journal
• /
• v.22 no.4
• /
• pp.244-248
• /
• 2007

The treatment of a model wastewater containing high concentration, 10 $g/{\ell}$, of phenol in an integrated wet oxidation-aerobic biological treatment was investigated. Partial wet oxidation under mild operating conditions was capable of converting the original phenol to biodegradable organic acids such as maleic acid, formic acid and acetic acid, the solution of which was subjected to the subsequent aerobic biological treatment. The wet oxidation was carried out at 150$^{\circ}C$ and 200$^{\circ}C$ and the initial pH of 1 to 12. The high temperature of 200$^{\circ}C$ and the acidic initial condition in the wet oxidation led to effluents of which biodegradability was higher in the subsequent biological oxidation process, as assessed by chemical oxygen demand (COD) removal. Homogeneous catalyst of $CuSO_4$ was also used for increasing the oxidation rate in the wet oxidation at 150$^{\circ}C$ and initial pH of 3.0. However, the pretreatment with the catalytic wet oxidation resulted in effluents which were less biodegradable in the aerobic biological process compared to those out of the non-catalytic wet oxidation at the same operating conditions.

• Journal of the Korean Chemical Society
• /
• v.28 no.2
• /
• pp.102-108
• /
• 1984

The catalytic oxidation of CO has been investigated on $ZnCe_{1+y}O_2$ at temperatures from 300 to $500^{\circ}C$ under various P_{CO} and PO_2 conditions. The oxidation rates have been correlated with 1.5-order kinetics: first order with respect to CO and 0.5 order with respect to O2. CO appears to be absorbed essentially on the O lattice of $ZnCe_{1+y}O_2$ as a molecular species, while $O_2$ adsorbs on an O vacancy as an ionic species. The conductivity data show that CO adsorption contributes electron to the conduction band and the adsorption process of $O_2$ withdraws it from an O vacancy. The oxidation mechanism and the defect model of $ZnCe_{1+y}O_2$ are inferred at given temperature and $PO_2'$s from the agreement between the conductivities and kinetic data. It is suggested that CO absorption is the rate-controlling.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.33 no.11
• /
• pp.876-885
• /
• 2009

Char oxidation experiments were performed with a sub-bituminous roto-middle coal in the Drop Tube Furnace (DTF) at atmospheric pressure condition. While temperatures varied between 900, 1100, 1400 $^{\circ}C$, particle size, mass, particle temperature, and CO/$CO_2$ concentration were obtained to be used for kinetic analysis of the char oxidation. This study addresses several different methods to analyze the char consumption rate, which are classified as energy balance method, ash-traced mass method, flue-gas based method, and particle size based method. The char consumption rate obtained with such methods was compared with the results of Monson et al.$^{(24)}$ While there are some differences between them because of differences in experimental apparatus and parameters to be measured, the kinetic results seems to be reasonable enough to be incorporated in a numerical modeling of coal combustion.

• Environmental Sciences Bulletin of The Korean Environmental Sciences Society
• /
• v.10 no.S_3
• /
• pp.149-155
• /
• 2001

In recent years, rapid technological advances in the textile and dyeing industry have yielded benefits to society but have also generated new and significant environmental problems. The treatment alternatives applicable for the removal of color vary, depending upon the type of dye wastewater Advanced oxidation processes are considered to provide more permanent merits. One of these oxidation treatments attracting much attention is photocatalytic oxidation, which uses TiO$_2$ due to its non-toxic, insoluble liquid as well as a highly reactive nature under UV irradiation. This study sets out to demonstrate the effect of photocatalyst dosage, dye concentrations, pH and light intensity on color removal efficiency under aerobic conditions. The results of this study show Rhodamine B(RhB) was not decolorized when a dye solution was exposed only to air or treated by TiO$_2$ only In the presence of both TiO$_2$ and UV light, however, the presence of RhB decreased up to 95 % within 60minutes. The more addition TiO$_2$ and the more diluted dye solution, showed a higher removal rate.

• Journal of The Korean Society of Inherited Metabolic disease
• /
• v.22 no.1
• /
• pp.1-8
• /
• 2022

Long-chain fatty acid oxidation disorders (LC-FAOD) are an autosomal recessive inherited rare disease group that result in an acute metabolic crisis and chronic energy deficiency owing to the deficiency in an enzyme that converts long-chain fatty acids into energy. LC-FAOD includes carnitine palmitoyltransferase type 1 (CPT1), carnitine-acylcarnitine translocase (CACT), carnitine palmitoyltransferase type 2 (CPT2), very long-chain acyl-CoA dehydrogenase (VLCAD), long-chain 3-hydroxyacyl-CoA dehydrogenase (LCHAD), and trifunctional protein (TFP) deficiencies. Common symptoms of LC-FAOD are hypoketotic hypoglycemia, cardiomyopathy, and myopathy. Depending on symptom onset, the disease can be divided as neonatal period, late infancy and early childhood, adolescence, or adult onset, but symptoms can appear at any time. The neonatal screening test (NBS) can be used to identify the characteristic plasma acylcarnitine profiles for each disease and confirmed by deficient enzyme analysis or molecular testing. Before introduction of NBS, the mortality rate of LC-FAOD was very high. With NBS implementation as routine neonatal care, the mortality rate was dramatically decreased, but severe symptoms such as rhabdomyolysis recur frequently and affect the quality of life. Triheptanoin (Dojolvi^®), the first drug for pediatric and adult patients with molecularly confirmed LC-FAOD, has recently been approved by the US Food and Drug Administration in 2020. In this review, the diagnosis of LC-FAOD and treatment including triheptanoin are summarized.

• Korean Journal of Food Science and Technology
• /
• v.47 no.5
• /
• pp.561-566
• /
• 2015

Effect of the addition of egg yolk lecithin at a concentration of 350 mg/kg on iron-catalyzed autoxidation and chlorophyll-photosensitized oxidation of a water/canola oil emulsion (W/O) during storage at $25^{\circ}C$ was studied based on headspace oxygen consumption and hydroperoxide production. Changes in the phospholipid (PL) composition of the emulsion were determined by high performance liquid chromatography. Headspace oxygen consumption and hydroperoxide content of the emulsion increased with storage time, and addition of egg yolk lecithin did not have any significant effect on these parameters during iron-catalyzed autoxidation and chlorophyll-photosensitized oxidation of the emulsion. PL content of the emulsion decreased during both oxidations, and the degradation rate was higher during autoxidation than during photosensitized oxidation. Phosphatidylcholine content ratio tended to increase during autoxidation. The results suggest that egg yolk lecithin in canola oil emulsion behaves differently during iron-catalyzed autoxidation and chlorophyll-photosensitized oxidation.

• Electrical & Electronic Materials
• /
• v.8 no.1
• /
• pp.71-76
• /
• 1995

The thermal oxidation of Ge$_{0.2}$Si$_{0.8}$ in wet ambient has been investigated by Rutherford Backscattering Spectrometry(RBS). A uniform Ge$_{0.2}$Si$_{0.8}$O$_{2}$ oxide is formed at temperatures below 650.deg. C for polycrystalline and below 700.deg. C for single crystalline substrates. At higher temperatures Ge becomes depleted from the oxide and finally SiO$_{2}$ oxide is formed with Ge piled-ub behind it. The transition between the different oxide types depends also on the crystallinity of Ge$_{0.2}$Si$_{0.8}$. When a uniform Ge$_{0.2}$Si$_{0}$8/O$_{2}$ oxide grows, its thickness is proportional to the square root of the oxidation time, which suggests that the rate noting process is the diffusive transport of oxidant across the oxide. It is believed the oxidation is controlled by the competition between the diffusion of Ge or Si in Ge$_{0.2}$Si$_{0.8}$ and the movement of oxidation front.t.oxidation front.t.