• Journal of the Korean Geotechnical Society
• /
• v.23 no.10
• /
• pp.73-84
• /
• 2007

For standard piezocones with shoulder filter elements immediately behind the cone tip, general dissipation curves show monotonically decreasing pore pressure from the initial value. However, dilatory dissipation behavior, showing a temporary increase in pore pressure followed by a decrease in the hydrostatic pressure, has been observed in lightly overconsolidated cohesive soils $(1. This unusual dissipation behavior was reported mostly in heavily overconsolidated ground and previous researches were limited to such cases. In this study, the mechanism of dilatory dissipation in lightly overconsolidated cohesive soils was investigated. The relativities of the ground properties evaluated from the CPTu data to the dilatory dissipation were analyzed. And, finite difference analyses on dissipation after cone penetration were performed. It was found that dilatory dissipation occurs in lightly overconsolidated soils since the higher excess pore pressure at the cone face propagates upward to the shoulder filter. Also, it was shown that the ratio of initial excess pore pressure at the cone face to that of the shoulder filter $({\Delta}u_{1i}/{\Delta}u_{2i})$, which is related to overconsolidation ratio (OCR) and hydrostatic pressure $(u_0)$, affects the dilatory dissipation.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.3 no.1
• /
• pp.65-72
• /
• 1983

Dry sand specimens for both normally consolidated and overconsolidated triaxial compression tests were prestressed on the path with five different coefficients of earth pressure 1.0, 3/4, 0.55, $K_0$ and 1/3. Deformation resistance of normally consolidated sand increased with increasing the initial stress for all coefficients of earth pressure during consolidation, and the deformation modulus at a certain initial stress showed a tendency to increase with increasing the coefficient of earth pressure. And deformation moduli($E_i$, $E_{50}$), were found to be proportional to the $n_{th}$ power of initial stresses[${\sigma}_{m0}{^{\prime}}$, ${\sigma}_{10}{^{\prime}}$, ${\sigma}_{30}{^{\prime}}$, $({\sigma}_1-{\sigma}_3)_0$] for both isotropically and anisotropically normally consolidated samples, where n varied from 0.37 to 0.92. Overconsolidated sand with the higher overconsolidation ratio showed the higher deformation modulus. It is concluded that the $K_0$-anisotropically consolidated triaxial compression test is necessary to obtain the more accurate value of in-situ deformation modulus.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.9
• /
• pp.71-78
• /
• 2011

Cement treating technique, such as deep mixing method, has been used widely to stabilize the dredged clayey soil for many years. Despite of its effectiveness in treating soil by cement, several efforts have also been made to try to reduce the side effect of the cement that used to stabilize the dredged clay. However, authors considered that more detailed study on the physical and mechanical properties of lean-mixed soil-cement has been required to establish the design procedure to apply the practical problems. Therefore, in this study, the curing time and mixing ratio was used as key parameters to estimate the physical and mechanical properties including long-term behavior. The unconfined strength of lean-mixed soil-cement increase continuously during curing period, 270 days, while increasing rate becomes low in ordinary cement-treated dredged clay. We also concluded that cement-treated dredging clay shows apparent quasi overconsolidation behavior even in low cement proportion. By this study, fundamental approach was carried out for effective reuse of very soft dredged clayey soil both in mechanical and environmental aspect. It can be also expected that this study can propose a basic design data to use the lean-mixed soil cement.