• 한국지능시스템학회논문지
• /
• 제27권1호
• /
• pp.50-58
• /
• 2017

비선형 시스템 제어에 TSK 퍼지 모델을 이용하는 연구가 많다. 그러나 비선형 시스템을 TSK 퍼지 모델로 표현하기 위해서는 대상 시스템의 비선형 동특성 방정식을 알고 있거나 시스템으로부터 실험으로 입출력 공간에 충분히 분포된 데이터를 얻을 수 있어야 한다. 본 논문에서는 비선형 시스템의 TSK 퍼지 모델링에 계단 입력 응답과 GA만을 이용하는 방법을 제안한다. 연구 대상인 시스템은 제어 입력에 비선형인 경우와 출력에 비선형인 두 경우로 하였다. 제어 입력에 비선형인 경우 여러 입력 값에 대한 계단 입력 응답 데이터들로 모델링 하며, 제어 입력에 비선형인 경우에는 계단 입력 응답 데이터와 제어 입력 값이 0인 경우 응답 데이터를 이용하여 모델링 한다. 또한 제안한 방법으로 구해진 TSK 퍼지 모델로부터 퍼지 제어기를 설계하는 방법도 제시한다. 제안한 방법들을 예제들에 적용하여 모의 실험한 결과 원하는 제어 결과를 얻을 수 있었다.

• Journal of Power Electronics
• /
• 제12권1호
• /
• pp.98-103
• /
• 2012

This paper presents a digital pulse width modulator (DPWM) with a reduced digital modulation delay (a transport delay of the modulator) during the transient response of power converters. During the transient response operation of a power converter, as a result of dynamic variations such as load step-up or step-down, the closed loop controller will continuously adjust the duty cycle in order to regulate the output voltage. The larger the modulation delays, the larger the undesired output voltage deviation from the reference point. The three conventional DPWM techniques exhibit significant leading-edge and/or trailing-edge modulation delays. The DPWM technique proposed in this paper, which results in modulation delay reductions, is discussed, experimentally tested and compared with conventional modulation techniques.

• Journal of Power Electronics
• /
• 제15권6호
• /
• pp.1577-1583
• /
• 2015

In this research, a combined adaptive-robust current controller is developed for non-minimum-phase DC-DC converters in a wide range of operations. In the proposed nonlinear controller, load resistance, input voltage and zero interval of the inductor current are estimated using developed adaptation rules and knowing the operating mode of the converter for the closed-loop control is not required; hence, a single controller can be employed for a wide load and line changes in discontinuous and continuous conduction operations. Using the TMS320F2810 digital signal processor, the experimental response of the proposed controller is presented in different operating points of the buck/boost converter. During transition between different modes of the converter, the developed controller has a better dynamic response compared with previously reported adaptive nonlinear approach. Moreover, output voltage steady-state error is zero in different conditions.

• Journal of international Conference on Electrical Machines and Systems
• /
• 제2권3호
• /
• pp.342-348
• /
• 2013

As a number of wind power generation systems have been installed in power systems in the world, frequency fluctuations due to output power variations from wind farms have become a serious problem. Battery systems have been studied for smoothing the output variations and decreasing the resulting frequency fluctuations. Among these studies, efficient design of battery systems is one of the most important subjects from a point of view of cost. This paper presents a comparative analysis of the smoothing effect between the conventional moving average method and a new method based on frequency response analysis.

• 한국전산구조공학회:학술대회논문집
• /
• 한국전산구조공학회 2006년도 정기 학술대회 논문집
• /
• pp.275-282
• /
• 2006

System algorithms estimated by deterministic input may occur the error between predicted and actual output. Especially, actual system can't predict the exact outputs due to uncertainty and tolernce of input parameters. A single output to a set of inputs has a limited value without the variation. Hence, we should consider various scatters caused by the load assessment, material characteristics, stress analysis and manufacturing methods in order to perform the robust design or etimate the reliability of structure. The system design with uncertainty should perform the probabilistic structural optimization with the statistical response and the reliability. This method calculated the probability distributions of the characteristics such as stress by combining stress analysis, response surface methodology and Monte Carlo simulation and got the probabilistic sensitivity. The sensitivity of structural response with respect to in constant design variables was estimated by fracture probability. Therefore, this paper proposed the probabilistic reliability design method for fracture of uncorved freight end beam and the design criteria by fracture probability.

• 한국자동차공학회논문집
• /
• 제1권3호
• /
• pp.1-11
• /
• 1993

An experimental study was carried out to evaluate the characteristics of transient performance of carburettered gasoline engine under rapid accelerating transient driving conditions. In order to evaluate the characteristics of transient performance quantitatively, the concept of dead time $t_d$ response delay time $t_r$ are introduced. Performance parameters such as air mass fiowrate Gat, engine speed N, manifold boost pressure Pb, and output torque T are measured simultaneously during the rapid opening of the throttle valve by the stepping motor. During the rapid opening of the throttle valve, air mass fiowrate Gat is increased immediately without delay time, but response of engine revolution N, and output torque T are delayed. Therefore hesitation, and stumble phenomena are occurred. Dead time $t_d$ and response delay time $t_r$ of engine revolution N, which is extremely delayed comparing to other performance parameters, are respectively 0.2-0.3sec., 3.0-4.6sec., and dead time rate $t_d/{\Delta}t$ and response delay time rate $t_r/{\Delta}t$ are linearly increased with the throttle valve opening rate ${\theta}$ during the acceleration from 12 degree to 20 degree at 1250rpm.

• 한국기술혁신학회:학술대회논문집
• /
• 한국기술혁신학회 2003년도 춘계학술대회
• /
• pp.5-17
• /
• 2003

This paper examines the effects of IT technology capital and R&D stock's variation on the growth of Korea's industries with the empirical approaches. We analyze the Granger causality and Impulse response function analysis among the Korea's industrial real output, IT technology capital, and R&D stocks. When it comes to this research conclusion, we know that IT technology capital and R&D stock's shocks affect the growth of Korea's industrial sector in terms of increasing in the real output growth rate.

• Journal of the Korean Data and Information Science Society
• /
• 제18권2호
• /
• pp.301-314
• /
• 2007

The aim of this paper is to deal with a method to construct a separate fuzzy regression model with crisp input and fuzzy output data using a best response function for the center and the width of the predicted output. Also we introduce the crisp mean and variance of the predicted fuzzy value and also give some examples to compare a performance of the proposed fuzzy model with various other fuzzy regression model.

• 전기학회논문지
• /
• 제62권6호
• /
• pp.767-781
• /
• 2013

In this paper, we proposes the AC input voltage and current sensorless control scheme to control the input power factor and DC output voltage of the three-phase Z-source PWM rectifier. For DC-link voltage control which is sensitive to the system parameters of the PWM rectifier, fuzzy-PI controller is used. Because the AC input voltage and current are estimated using only the DC-link voltage and current, AC input voltage and current sensors are not required. In addition, the unity input power factor and DC output voltage can be controlled. The phase-angle of the detected AC input voltage and estimated voltage, the response characteristics of the DC output voltage according to the DC voltage references, the FFT results of the estimated voltage and current, efficiency, and the response characteristics of the conventional PI controller and fuzzy-PI controller are verified by PSIM simulation.

• 한국통신학회:학술대회논문집
• /
• 한국통신학회 1984년도 추계학술발표회논문집
• /
• pp.82-87
• /
• 1984

A 2-D digital filter with rational frequency response can be expanded into an infinite sequence of filterins operations. Each filtering operation can be implemented by convolution with a Low-order 20D finite-extent impulse response. If a convergence constraint is satisfied, the sequence of estimates will approach the desired output signal. In practice, as the number of iterations is finite, the frequency response implemented by iterative computations is an approximation to the desired rational frequency response.